CS Paper Radar

Tools for Reducing Service Time in Near-Term Quantum Networks

Jake Smith, Thomas R. Beauchamp, Scarlett Gauthier, Oumayma Bouchmal, Stephanie Wehner

cs.NI quant-ph ·submitted 2026-08-21 10:19 UTC · v1
published

Abstract

Architectures have been proposed to control entanglement generation in multi-user quantum networks. To allow time for local operations and classical communication at end nodes, these architectures insert fixed separations between consecutive batches of entanglement generation attempts. This reduces network utilization when attempts fail, leaving the network idle during the scheduled separation. To address this limitation, we propose a novel method to reclaim this idle time by shortening the scheduled separation between attempts while respecting hardware constraints. The method uses an analytical execution model to optimize the separation and reduce the total network service time of an application. Evaluations within the Arqon architecture show network service time reductions of up to 42 minutes (7.6%) for single applications and 16-29 minutes (26-30%) per application when co-scheduled. The approach applies broadly to quantum network architectures that share hardware between entanglement generation and local operations, and the method can be used online by network schedulers.

Comment
Accepted for publication at IEEE Quantum Week 2026. 10 pages, 3 figures, 2 tables

Closest papers

Nearest neighbours by meaning across the whole index.

Online Scheduling and Distribution of Quantum Circuits over Quantum Networks

cs.ET quant-ph ·2026-10-19 ·Yukun Yang, Himanshu Gupta
published similarity 0.76
Abstract · 8 pages, 5 figures. Full author version revised after acceptance; the QCNC 2026 version was shortened to meet the conference page limit

Emerging quantum networks enable distributed quantum computing (DQC) by interconnecting modest, noisy quantum processors. However, practical deployments face tight memory budgets, probabilistic entanglement generation, and decoherence, all while serving multiple users. In realistic settings -- cloud execution, iterative/interactive workloads and concurrent jobs -- circuits do not arrive in a single batch but as a stream. This creates a fundamentally online problem: the system must react to stochastic arrivals, balance latency and throughput, and remain stable under varying loads without foresight of future jobs. We study Online Scheduling and Distribution of Quantum Circuits (OS-DQC) and formalize the online scheduling problem for quantum networks: circuits arrive over time and must be executed without knowledge of future arrivals. At each event time (arrival or completion), the system decides which waiting circuits to launch and how to place their qubits, while accounting for congestion from in-flight circuits and constraints due to finite memories and decoherence. The objective is to minimize the mean completion time and makespan under these physical and resource constraints.

0.33

Distributing Quantum Circuits Using Pre-Distributed Entanglement Pairs over Quantum Networks

cs.ET quant-ph ·2026-10-19 ·Yukun Yang, Ranjani G. Sundaram, Himanshu Gupta
publishedbenchmark similarity 0.72
Abstract · 9 pages, 4 figures. Full author version revised after acceptance; includes the cost-aware entanglement consumption section omitted from the …

Distributing quantum circuits across a network of quantum devices is a recent approach to improve the scalability of quantum computation. Entangled pairs of qubits distributed across network nodes are used as a communication resource for executing inter-node (remote) gates. However, establishing these entanglement pairs incurs significant latency, and doing so during the circuit's execution may lead to the decoherence of logical qubits. Instead, it may be beneficial to distribute certain entanglement pairs before the circuit is executed. Thus, we consider the problem of distributing a quantum circuit across a quantum network containing some pre-distributed entanglement pairs and seek to minimize the execution time of the circuit. We address this problem in three steps. First, given the quantum network and (optionally) a probability distribution over training circuits, we determine a set of pre-distributed entanglement pairs under a specified budget. Second, we compute a qubit-to-memory allocation that minimizes the expected execution time given these pre-distributed resources. Finally, we identify any additional entanglement pairs required during execution, generate them concurrently, and execute the circuit gates. We evaluate our methods on a broad range of benchmark circuits.

0.46

Resource-Aware Scheduling for Distributed Quantum Computing

cs.NI ·2026-10-21 ·Connor Howe, Raghav Mundada, Jake O'Shaughnessy, Ibrahim Abdullahi, Ali Anwar
similarity 0.71
Abstract

Distributed quantum computing (DQC) is a promising near-term approach for executing circuits that exceed the capacity of a single quantum processing unit (QPU). Prior work has made significant progress on circuit partitioning and reconstruction, but practical DQC requires more than cutting a circuit into smaller pieces. A runtime system must determine whether to execute the circuit intact, cut it for sequential execution on one QPU, or distribute it across multiple QPUs, while accounting for queueing, communication, reconstruction, and hardware constraints. We present a resource-aware scheduler for DQC that compares these execution alternatives at runtime using explicit models of QPU execution, communication, and host-side reconstruction, together with hardware-informed timing derived from simulated IBM QPUs. By treating communication and reconstruction as first-class scheduling costs, the scheduler selects execution plans using a more realistic view of end-to-end overhead than cutting-only approaches. Across our experiments, reconstruction accounts for over 83% of cutting overhead, distributed execution reduces P90 latency by up to 39% relative to uncut single-QPU execution, and scheduling overhead itself remains negligible, never exceeding 0.038% of end-to-end job latency. Together, these results show that DQC must be treated as a runtime scheduling problem over both quantum and classical resources, not just circuit partitioning.

0.15

ReFINE: Scheduling of Distillation and Coding for Rate-Fidelity Tradeoff in Quantum Networks

cs.ET quant-ph ·2026-09-17 ·Narges Alavisamani, Matthieu Bloch, Moinuddin Qureshi
similarity 0.70
Abstract

In quantum networks, nodes are connected via sharing of Einstein-Podolsky-Rosen (EPR) pairs, ideally with high fidelity and high rate. However, the fidelity of EPR pairs degrades due to imperfect generation and decoherence errors. Entanglement Distillation is a method that increases the fidelity but operates probabilistically and may destroy all involved EPR pairs upon failure. This failure reduces available EPR pairs for application use, thereby decreasing the service rate. Quantum Error Correction (QEC) is another mechanism to protect EPR pairs against error by forming what we term as Coding-Enhanced Memory (CEM). While effective, CEM requires extra time and resources to form the code, which also reduces the service rate. Existing methods often use static combinations of distillation and CEM, ignoring demand variations. This results in a low service rate without significant fidelity gain. Limited resources together with this rate-fidelity tradeoff make it essential to schedule when to run distillation, form CEM, or serve requests. We propose ReFINE, a demand-aware preemptive scheduler that based on application requirements either serves an available EPR pair immediately or preserves it in CEM. This selective use of CEM, only when needed, enables a better balance for rate-fidelity tradeoff than always using CEM. Between request arrivals, ReFINE either schedules distilling EPR pairs or forming CEM to protect distilled pairs, following one of the three priority policies: ReFINE-D (Distillation-First) first generates EPR pairs for distillation and then forms the CEM, prioritizing service rate. ReFINE-M (Memory-First) first forms the CEM, then generates the EPR pairs for distillation, prioritizing fidelity. ReFINE-C (Concurrent) performs both distillation and CEM formation concurrently, balancing between fidelity and service rate.

0.11

Towards Reproducible Evaluation of Distributed Quantum Circuit Partitioning Algorithms

cs.DC quant-ph ·2026-08-27 ·Javier Vela-Tambo, Davud Azizov, Tian Guo
code/data similarity 0.66
Abstract · Accepted at IEEE QCE 2026 Workshop: Distributed Quantum Computing Systems and Infrastructure

Distributed Quantum Computing (DQC) addresses the physical scaling limitations of monolithic quantum processors by networking modular Quantum Processing Units (QPUs). Efficient execution of quantum algorithms on DQC architectures requires compiling them across QPUs while minimizing inter-QPU communication bottlenecks, primarily through circuit partitioning. However, current evaluations of state-of-the-art partitioning heuristics focus primarily on the total entanglement cost of the partitions, failing to capture the broader structural and temporal overheads introduced by distributed network constraints. This paper addresses this evaluation gap by applying established monolithic benchmarking metrics to partitioned distributed circuits to quantify the performance impact of network constraints. Using an open-source, automated evaluation pipeline, we systematically assess diverse partitioning algorithms across standardized workloads and quantum network topologies. Our empirical results reveal that partitioning algorithms with comparable entanglement costs can still introduce drastically different physical execution penalties. By exposing these hidden trade-offs, such as severe increases in circuit depth and substantial reductions in gate density, this study demonstrates that comprehensive circuit-level metrics are essential for guiding the future design of DQC compilers.

0.21

Quantum Broker: QoS-Aware Distribution of Quantum Computations

cs.ET quant-phcs.SE ·2026-10-20 ·Giuseppe Bisicchia, Alessandro Bocci, Jose Garcia-Alonso, Juan Manuel Murillo, Antonio Brogi
benchmarkcode/data similarity 0.66
Abstract · 32 pages

Cloud-accessible quantum computing has made heterogeneous Quantum Processing Units (QPUs) available through provider platforms that differ in qubit technology, calibration state, queueing behavior, and pricing model. This heterogeneity makes execution management a quantum-engineering concern: a quantum circuit may be executable on several backends, but the resulting cost, latency, fidelity, and reproducibility depend on backend selection and on how measurement shots are allocated. This paper presents the Quantum Broker, an open-source and provider-agnostic framework for Quality-of-Service-aware quantum execution management. The framework operationalizes shot-wise distribution by exploiting the statistical independence of quantum measurement shots to dispatch a single circuit across multiple heterogeneous QPUs according to user-defined constraints and optimization objectives. It combines a modular execution architecture, interchangeable backend-profiling strategies, and the Quantum QoS Specification Language (QQSpec), a declarative language for expressing QoS requirements. Dispatch planning is supported by two solver backends: a mixed-integer linear-programming (MILP) solver, and a nonlinear dual-annealing solver. Experiments on benchmark quantum circuits and noisy simulator backends show that the Quantum Broker can produce feasible QoS-aware dispatch plans under heterogeneous backend conditions and can improve QoS satisfaction with respect to single-backend and naive multi-backend baselines. The results also expose a practical trade-off between planning time and dispatch quality, with the nonlinear solver producing higher-quality allocations at increased computational cost. Overall, the Quantum Broker provides an extensible execution-management layer for engineering portable, reproducible, and QoS-aware quantum software over fragmented quantum cloud infrastructures.

0.24

Entanglement Distribution in Quantum Switch Networks: Memory Limits and Achievability

cs.IT cs.NIquant-ph ·2026-10-20 ·Lei Hu, Alptug Aytekin, Stavros Mitrolaris, Mohamed Nomeir, Subhankar Banerjee +2 more
similarity 0.66
Abstract · The abstract was shortened to meet arXiv's character limit

We study the minimum persistent memory required to distribute a graph state through a quantum switch. Specifically, consider a central switch that assists $n$ remote users in distributing a graph state, using independently generated user-switch Bell pairs. Since Bell-pair generation is probabilistic, different links generally succeed at different times. When a Bell-pair is generated, the qubits may need to be stored in memory while waiting for other links to succeed. Recently, new protocols have been proposed to reduce this storage overhead by processing and releasing some switch qubits before all Bell links are available. However, these protocols do not characterize the minimum persistent switch memory required at each stage. Moreover, the local-cover method in the state-of-the-art Piecemaker protocol is computationally expensive for general target graphs. In this work, we characterize the minimum persistent switch memory required after any subset of users' Bell links are generated and processed. We then develop an online stabilizer-transition protocol that attains this limit, which can be implemented in polynomial time in the number of qubits $n$. Remarkably, this optimal protocol can provide substantial memory reductions over existing heuristic approaches. In particular, for the path graph $P_n$ over $n$ users, Piecemaker protocol requires at least $\lfloor n/2\rfloor$ qubits of peak persistent memory for \textit{every Bell-links generation order}, whereas under the order $(1,2,\ldots,n)$, our protocol requires only one persistent switch qubit. Finally, the same stabilizer-transition framework also provides a direct forward construction for sequential graph-state generation using the minimum number of quantum emitters, equal to the maximum of the height function.

0.13

QUASAR: Quantum Satellite Architecture and Routing Simulator

cs.NI ·2026-09-04 ·Yaliang Shi, Zi Wang, Bangguo Yuan, Gaojie Wu, Zhiwei Zhao
similarity 0.63
Abstract

The deployment of Low Earth Orbit (LEO) satellite constellations is an important step toward global-scale quantum networking. However, evaluating satellite quantum network protocols under spatiotemporal orbital dynamics and quantum physical constraints remains computationally expensive and challenging. In this paper, we propose QUASAR, a lightweight simulator for evaluating entanglement distribution in satellite-based quantum networks. QUASAR provides a decoupled architecture that integrates dynamic orbital topologies, time-varying optical transmittance, and quantum memory decoherence into network- layer attributes. To demonstrate its capabilities, we abstract and implement two representative hardware architectures: Simultaneous Downlink and On-Orbit Stitching. We further introduce an Entanglement Distribution Rate (EDR)-Aware Spatiotemporal Routing (EASR) heuristic as a reference workload. Our case study examines how QUASAR supports different satellite architectures, routing workloads, realistic orbital traces, concurrent requests, and scalable event-driven execution. With over 85% lower network-layer update latency than continuous polling, QUASAR provides a practical and extensible framework for future satellite quantum network protocol evaluation.

0.35