CS Paper Radar

Asymmetric quantum error correction efficiently tackles application-specific noise effects

Abhishek Yadav, Peter K. Schuhmacher, Michael Epping

cs.ET quant-ph ·submitted 2026-09-07 08:54 UTC · v2
published

Abstract

Noise is a major challenge for current quantum computers. It can be broadly categorized into bit-flip and phase-flip errors. These two types do not necessarily affect the executed algorithm, thus also the application, in the same way. We illustrate this general effect for the example of the quantum approximate optimization algorithm (QAOA) applied to a small instance of the flight-gate assignment (FGA) problem. We compare bit-flip and phase-flip Pauli noise under both layer-level and gate-level noise models, using two circuit decompositions of the same ideal QAOA unitary: a CNOT-based decomposition and a native-RZZ decomposition. For the six-qubit FGA instance considered here, bit-flip noise produces a larger degradation in the optimized QAOA performance across the investigated circuit depths and noise models. The asymmetry is most pronounced in the layer-level and native-RZZ simulations. We explain this behavior through the commutation and propagation properties of the errors and their effects on the final computational-basis measurements. Since these mechanisms are not specific to the considered FGA instance, we expect similar noise asymmetries to arise in other Ising-based QAOA applications, although this remains to be investigated. We then exploit these insights to tackle noise particularly efficiently using asymmetric error-correcting codes. As an illustration, we use the quantum parity code (QPC), a generalization of the 9-qubit Shor code, and show that a smaller asymmetric code can achieve nearly the same improvement as a larger symmetric choice. This suggests that allocating error-correction resources according to algorithmic noise sensitivity, rather than physical error rates alone, can be beneficial even when the physical noise is symmetric. Finally, we discuss how information about the noise obtained through calibration can be exploited in our approach.

Comment
23 pages, 9 figures, 1 table. Accepted version
Journal ref
Mathematics 2026, 14(21), 4011
DOI
10.3390/math14214011

Closest papers

Nearest neighbours by meaning across the whole index.

Toward Fault-Tolerant Variational Optimization: QAOA under [[4,2,2]] Error Detection

cs.ET quant-ph ·2026-09-07 ·Matteo Robert Child, Emanuele Dri, Giacomo Vitali, Chiara Vercellino, Alberto Leporati
similarity 0.72
Abstract

We present a partially fault-tolerant implementation of QAOA based on the $[[4,2,2]]$ error-detection code, targeting the Max-Cut problem on a square graph. Our main contribution is a novel ancilla-mediated logical $R_{ZZ}$ gate enabling interactions between qubits in different $[[4,2,2]]$ blocks. We evaluate unencoded and encoded circuits under five noise models, with both all-to-all and grid-routed connectivity, using the Cirq and qsimcirq frameworks with parallel CPU execution. Post-selection on stabilizer measurements consistently improves the probability of sampling optimal bitstrings, with five measurements providing the strongest benefit. These results support error-detection as a practical near-term strategy for improving the quality of variational quantum algorithms.

0.25

Beyond the Mean Gap: What Transferred-Angle QAOA Retains on a Superconducting Processor

cs.AI quant-ph ·2026-11-07 ·Sanim Yousuf Fahim, Mohammad Arif Hossain
similarity 0.69
Abstract

Hardware executions of the quantum approximate optimization algorithm (QAOA) are often validated by comparing the device's mean cost with a simulation, a check that can miss what matters for optimization. Under global depolarization, the mean normalized gap and the floor-corrected probability of every set of bitstrings, the optimum included, retain the same fraction of their noiseless improvement over uniform sampling. We test this prediction with depth-2, transferred-angle QAOA circuits for binary subproblems of an alternating-direction decomposition on the IBM Heron processor \texttt{ibm\_marrakesh}, with and without dynamical decoupling and twirling. At 12 qubits, the main-family circuits retained 29\% to 46\% of their mean-gap improvement but only 5\% to 15\% of their probability of the optimum, lower on at least nine of ten instances per run. Near-optimal bitstrings were lost about as much as the optimum, whereas the avoidance of poor bitstrings was retained best. In the first submission, a device-matched noise model reproduced the pattern but overestimated the retention of the optimum five- to eightfold. On a rugged planted family, the device found the optimum in 62\% of 768-shot blocks (noiseless: 98\%), within the range of local heuristics. Validations of optimization circuits should report retention of the optimum and of near-optimal sets.

0.26

Evaluating the Effect of the Order of Optimization Passes in Quantum Circuit Optimization

cs.ET quant-phcs.PF ·2026-09-24 ·Xiao-Ting Michelle To, Nils Quetschlich, Amr Elsharkawy, Martin Schulz, Robert Wille +1 more
publishedbenchmark similarity 0.68
Abstract · Accepted for publication at IEEE International Conference on Quantum Computing and Engineering 2026

Quantum circuit optimization is critical for mitigating the noise inherent in current quantum hardware. Quantum compilers typically sequentially apply multiple optimizations (also called ``optimization passes'') to improve the circuit. The impact of the order in which these passes are executed has yet been largely unexplored. This paper investigates the significance of the order of optimization passes within quantum circuit compilation, specifically analyzing interactions between different optimization methods and quantifying their mutual influences. Using Qiskit's compiler, we systematically evaluate pairwise combinations of 16 selected optimization passes, measuring circuit depth and gate count across various benchmark circuits. Our findings indicate dependencies between certain optimization passes, demonstrating that the order of the passes affects the optimization quality. In some cases, the worse performing sequence can be corrected through repeated pass application. %such that they are as good as the best performing one by extending the sequence. Experiments on multi-pass sequences show that more than two optimization passes may have an impact on each other but that this always links to the previously found pairwise effects. We observe that it is important to initially choose the best order of optimization passes to get the best possible optimization for the given circuit. The experiments reveal some factors which are important to choose the best, or at least a good, order; among those, the resulting optimization sequence depends the most on the native gate set.

0.34

Measurement-Efficient Differentiable Quantum Architecture Search for Combinatorial Optimization

cs.LG quant-ph ·2026-10-07 ·Lukas Theißinger, Thore Gerlach, Christian Bauckhage
top venuebenchmarkcode/data similarity 0.67
Abstract · 6 pages, 2 figures. Accepted at the 2026 IEEE 2nd International Conference on Quantum Artificial Intelligence (QAI). Code and data: https://…

Differentiable quantum architecture search (DQAS) is a promising framework for the automated design of quantum circuits, particularly for variational quantum optimization algorithms. However, its practical deployment on quantum hardware is limited by the large number of circuit measurements required during optimization, making hardware execution costly. In this work, we show that for a broad class of combinatorial optimization problems and commonly used rotational gate parameterizations, the measurement cost of DQAS can be significantly reduced without changing the optimization objective. We derive the proposed measurement reduction scheme theoretically and validate it experimentally on 3-SAT and MaxCut benchmark problems. Our approach reduces the requested gradient measurement cost by about 39 to 41% while introducing only negligible classical post-processing overhead, lowering the practical cost of executing DQAS on quantum hardware.

0.43

QAOA for Layered Architecture Recovery: Feasibility, Limits, and the Role of Decomposition

cs.SE ·2026-11-06 ·Julien Cardinal, Andrew Chedid, Imen Benzarti, Ghizlane El Boussaidi, Christophe Pere +1 more
similarity 0.66
Abstract

Layered architecture recovery (LAR) reconstructs a system's architectural layers from its package dependencies, and is defined as a combinatorial optimisation problem solved with classical search. We investigate whether the Quantum Approximate Optimization Algorithm (QAOA) can be applied to LAR, and with what practical limitations. We formulate LAR as a Quadratic Semi-Assignment Problem, transform it into a Quadratic Unconstrained Binary Optimisation (QUBO) problem in which each package is penalised unless it is assigned to exactly one layer, and encode it as an Ising Hamiltonian solved by QAOA. To reach instances beyond the qubit budget of a single circuit, we also apply an impact-guided decomposition that solves the problem as a sequence of smaller sub-problems. We evaluate the approach on three real Java systems ($15$, $18$, and $24$ qubits), studying the effect of circuit depth and sampling budget (RQ1), a comparison with a classical Tabu Search baseline (RQ2), robustness to simulated quantum noise (RQ3), and the decomposition (RQ4). We find that monolithic QAOA is feasible and accurate on the two smaller systems but fails on the $24$-qubit instance, that the sampling budget rather than circuit depth governs its accuracy, and that it is competitive with but does not outperform Tabu Search. Decomposition restores reliable recovery on the $24$-qubit instance, raising the optimal rate from $6.7\%$ to $93.3\%$; its accuracy is governed by the size of each sub-problem and, unlike the monolithic pipeline, improves as the sampling budget is reduced. Our results indicate that, in the current noisy intermediate-scale regime, problem decomposition, rather than larger circuits or more sampling, is the key to applying QAOA to software architecture recovery.

0.28

Non-Binary Detector Error Models

cs.IT quant-ph ·2026-11-19 ·Stefano Tinelli, Francisco Lázaro, Francisco García Herrero
theoryhot direction similarity 0.66
Abstract

A key challenge in fault-tolerant quantum error correction (QEC) is that the syndrome extraction circuits are themselves faulty. Such circuit-level noise is commonly described by a detector error model (DEM). In Stim and in almost all related works, DEMs are binary: every non-binary circuit error (e.g., CNOT gate), is decomposed into independent binary error mechanisms. In this work, we introduce non-binary DEMs, in which each fault location of the syndrome extraction circuit is modeled by one random variable over its original alphabet, e.g., the 16 two-qubit Pauli errors after a CNOT gate. We also propose a split-merge-regroup transformation that builds a compact non-binary DEM from any Clifford circuit by merging the error components that flip the same detectors and observables. Non-binary DEMs represent any Pauli channel exactly, whereas binary DEMs are exact only for channels that factorize into independent binary parts. When the channels factorize, we prove that binary and non-binary DEMs are equivalent under degenerate quantum maximum-a-posteriori (MAP) decoding, but not under quantum MAP decoding. Although the variables are non-binary, belief propagation (BP) still exchanges a single scalar message per edge. Our numerical results with surface, color and bivariate bicycle codes show that non-binary DEMs have two main advantages. First, their Tanner graphs have four to five times fewer edges, which is advantageous for hardware implementations. Second, their performance under BP, with and without OSD post-processing, is better than that of their binary counterparts, and BP with OSD runs up to $9.4\times$ faster in a CPU.

0.39

Quantum computers will not be that different: A blueprint for quantum computer architecture at scale

cs.AR quant-phcs.NIeess.SY ·2026-09-17 ·Torsten Hoefler, Matthias Troyer
similarity 0.65
Abstract

Quantum computers are technologically novel and unusual, but at system scale they should be engineered using many of the same principles that govern classical heterogeneous accelerators. This paper argues that utility-scale quantum architecture is primarily a cost-performance problem across a coupled quantum-classical system, leading to a blueprint for scalable quantum processing unit (QPU) design. Our architecture blueprint is organized around clean logical abstractions, hiding details and complexity of physical qubit modalities below the instruction set architecture (ISA) boundary, and specializes recurring functions aggressively to minimize the cost for utility scale quantum computations. Its low-level implementation through specialized local hardware for control, readout, and quantum error correction (QEC) closely resembles the architecture of high-performance network stacks. One of our main insights is that the design principles and the resulting architecture closely follow established practice from classical computing and networking.

0.37

Beyond QAOA: A Review of AI and Quantum Computing for Adaptive Combinatorial Optimization

cs.LG quant-phmath.OC ·2026-10-08 ·Hoong Chuin Lau
surveyposition similarity 0.64
Abstract · 36 pages, 5 figures, 7 tables; supplementary evidence matrix included as ancillary file. v2: clarified terminologies, co-optimization defini…

Near-term quantum approaches to combinatorial optimization are limited by qubit counts, circuit fidelity, sampling cost, and the difficulty of encoding constraints, while machine learning is increasingly used to configure and control quantum optimization workflows. We call such workflows adaptive: decisions conventionally fixed in advance, from formulation and penalties to shot budgets, backends, and whether to invoke a quantum processor at all, are made by learned policies that respond to the instance, the progress of the solve, or the hardware. This review examines three paradigms, AI for quantum optimization, quantum for AI-driven optimization, and AI-quantum co-optimization, and organizes the literature by the decision being learned rather than by application. A structured search identified a 119-paper corpus, of which 67 papers form an evidence core coded in detail. The evidence is considerably stronger for AI-assisted quantum optimization than for the reverse direction: learning already reduces quantum evaluations, improves initialization, supports decomposition and penalty control, and mitigates noise, whereas evidence that quantum computation improves learned optimizers remains largely confined to small-scale simulation. Experimental controls are thin: of 52 studies in the three paradigms, 22 include no classical baseline, the quantum contribution is fully isolated in 10 of 24 where an ablation applies, and the median largest experiment uses 16 qubits. We introduce an M0-M5 evidence hierarchy, from simulation to practical quantum advantage, and find no broadly convincing result at the highest level. We argue that scaling is increasingly a systems problem: the question is not only whether a problem fits on a quantum processor, but how classical and quantum resources should be allocated across the optimization process.

0.14