CS Paper Radar

ZeroTouch: Tactile-Supervised Visual Contact Estimation for Contact-Rich Manipulation

Dmitriy Kosenkov, Daniia Zinniatullina, Miguel Altamirano Cabrera, Iana Zhura, Mikhail Derevianchenko, Dzmitry Tsetserukou

cs.RO ·submitted 2026-09-18 13:03 UTC · v1

Abstract

Reliable robotic grasping benefits from estimating the evolving physical interaction and selecting a grasp-dependent compression target. Tactile sensors provide direct interaction measurements but require dedicated hardware at deployment. We introduce ZeroTouch, a tactile-supervised framework that predicts dense contact deformation, the instantaneous six-axis wrench, and a grasp-dependent desired compression target from wrist RGB observations, gripper state, and local gravity direction. Tactile measurements are used only as privileged supervision during training and are not required at deployment. On the full validation set, the complete architecture reduces normal-force MAE from 2.017 N for a state-only baseline to 0.531 N. In physical evaluation with 20 trials per condition, ZeroTouch achieves 95% success on an unseen object, 80% in a seen-object/unseen-grasp condition, and 90% under a content/load shift. Under the same evaluation protocol, OpenVLA achieves 25%, 40%, and 55%, while SmolVLA achieves 10%, 25%, and 35%, respectively.

Closest papers

Nearest neighbours by meaning across the whole index.

TouchSight: Bare-Handed Tactile Prediction from Egocentric Video via Generative Visual Augmentation

cs.CV cs.AI ·2026-09-17 ·Danyan Zhou, Jinxuan Lu, Jiawei Lin, Tianxing Chen, Chuqiao Lyu +1 more
hot directionhighly cited similarity 0.78
Abstract

Tactile signals provide direct contact and force measurements that are essential for understanding physical interactions and enabling dexterous robotic manipulation. However, tactile sensing requires direct measurement at contact interfaces, making large-scale data collection reliant on intrusive, costly, and restrictive instrumentation. We present TouchSight, a monocular egocentric vision framework for dense full-hand contact force prediction that leverages 500 hours of pressure-glove recordings and extensive hand-object interaction (HOI) data. To address the appearance gap between gloved training data and bare-hand real-world scenarios, we construct TwinTouch-20H: 20 hours of paired visual data in which generative video models re-render gloved recordings as bare-hand observations against new backgrounds while preserving the original measured tactile labels. TouchSight predicts dense force from both gloved and generated bare-hand videos, outperforms prior contact prediction methods on OakInk2, qualitatively generalizes to natural bare-hand egocentric videos from unseen datasets, and improves consistently as glove supervision scales. These results demonstrate that dense tactile signals can be recovered from egocentric vision alone, without tactile instrumentation at capture time.

0.46

PredTac: Learning Contact-Rich Manipulation with Predicted Touch

cs.RO ·2026-09-14 ·Weijia Fan, Daqiang Guo
similarity 0.77
Abstract · 8 pages, 4 figures

Contact-rich manipulation benefits from tactile feedback, yet physical tactile sensors introduce hardware, calibration, synchronization, and maintenance costs that complicate policy learning and deployment. We formulate predicted touch as an alternative to measured tactile input and present PredTac, a framework that learns to infer tactile states from causal visual observations and robot states and uses the predicted touch as an explicit interface for policy learning and execution. A tactile predictor is first trained with tactile supervision and then used to provide contact information without requiring measured tactile input during downstream policy training or execution. We evaluate PredTac across three contact-rich manipulation tasks in simulation and on a real robot, and further examine how policy performance depends on the predicted contact content. In simulation goal-offset evaluations, predicted-touch policies achieve 27.0%, 52.0%, and 44.7% success on USB, Barbed-spike, and Valve, respectively, improving over the visual baseline by 8.0-13.7 percentage points. On the real robot, predicted-touch ACT achieves 70.0%, 50.0%, and 90.0% success on USB insertion, Barbed extraction, and Valve rotation, respectively, with a three-task mean of 70.0%, approaching measured-touch ACT at 72.2% and substantially outperforming visual ACT at 21.1%. Fixed-policy interventions further show that performance is sensitive to the spatial structure of predicted contact, with spatial rearrangement at fixed value distributions reducing Valve success by 10.7 percentage points. These results demonstrate that predicted touch can provide useful contact information for contact-rich manipulation without requiring tactile sensing as a policy input.

0.25

EgoTac: In-the-wild Tactile Prediction from Egocentric Vision

cs.CV cs.RO ·2026-08-15 ·Wenkang Zhang, Chengbo Yuan, Zicheng Zhang, Zhengxue Cheng, Yang Gao
top venuecode/datahighly cited similarity 0.76
Abstract · NeurIPS 2026 Accepted. Project Page: https://egotac.github.io/

Touch is fundamental to dexterous manipulation, yet most egocentric human data increasingly used for robot learning lacks tactile information. Directly collecting large-scale tactile data is challenging due to sensor limitations, while human video data is abundant, contact-rich, and easily scalable. This motivates a natural question: can tactile signals be inferred purely from vision? To address this, we introduce EgoTac, a generalizable model that predicts rich tactile information directly from egocentric human videos. EgoTac is trained on a unified corpus of over 5.7M image-tactile pairs, covering both continuous force measurements and binary contacts. By learning from this diverse dataset, EgoTac captures nuanced touch dynamics across varied interactions. Experiments demonstrate strong performance: in-domain prediction achieves an average force error below 0.06N. On out-of-domain contact prediction benchmarks, EgoTac consistently outperforms the state-of-the-art contact estimator. It also captures the rise and fall patterns of real tactile data and enables zero-shot predictions on unconstrained real-world videos. Scaling analyses further reveal that both data diversity and volume improve performance steadily. Overall, EgoTac provides a scalable pathway to extract tactile priors from egocentric human videos, enabling broadly applicable tactile-aware robot learning. Related resources can be found at https://egotac.github.io/ .

0.86

Tactus: Tactile & Pose Sensing Glove for Natural Dexterity Data Collection

cs.RO cs.AIcs.ARcs.LG ·2026-10-29 ·Li Guan, Rachael Granberry, Sahar Aseeri, Sahar Rostami, Taylor Niehues +99 more
similarity 0.76
Abstract · 9 pages

Collecting naturalistic human manipulation demonstrations with accurate contact force and hand pose is essential for robot dexterous manipulation policy and foundational world model learning - yet no existing wearable platform provides both calibrated fingertip force sensing and occlusion-resilient hand tracking in a form factor that preserves natural manipulation behavior. We present Tactus, a textile-integrated sensing glove that co-optimizes three design pillars: (1) a thin, conformal 3D-knit form factor (1.5 mm fingertip stackup) designed to minimize interference with natural manipulation, (2) strategically placed capacitive tactile sensors at manipulation-relevant regions informed by empirical contact studies, and (3) IMU-fused pose tracking that maintains accuracy through the hand-object occlusions where manipulation data is most valuable. Tactus includes a documented calibration pipeline for cross-glove consistency and per-session calibration for subject-dependent correction. To enable objective comparison, we introduce standardized benchmarking protocols for tactile force regression and hand pose estimation, and apply them to Tactus and two commercially available tactile gloves - to our knowledge the first quantitative cross-platform evaluation of this kind. Tactus resolves a minimum detectable force of 0.59 N at 95% confidence, 1.6 - 2.7x lower than the commercial baselines, and with 0.87 cross-participant consistency, while our pose tracking sustains 11.0 mm fingertip keypoint relative error during manipulation, when occlusion is heaviest. We show that these combined signals support object property estimation, slip detection, and representative recording of hand-object interaction - yielding demonstration data with the fidelity required for contact-aware manipulation policies and world models.

0.21

Robot Learning with Visual Predicted Force

cs.RO cs.AI ·2026-10-03 ·Haonan Chen, Feiyang Wu, Yuxiang Ma, Mustafa Mete, Pengfei Ye +9 more
similarity 0.75
Abstract · 9 pages, 8 figures. Project Website: https://visual-force.github.io/

Force-aware manipulation typically relies on specialized force or tactile sensors. We show that force-aware manipulation can instead be achieved through visual force prediction from the deformation of a compliant Fin Ray gripper. Our approach trains two models. First, we train a visual force estimator on calibration data and use it to annotate task demonstrations with force estimates. Second, we train an action--force proposal policy on these force-augmented demonstrations to jointly generate candidate robot actions and their associated forces. At test time, we sample candidate actions and the forces they are expected to produce, then execute the action whose predicted force is closest to a target from the demonstrations. We evaluate our approach on berry picking, empty-can grasping, in-hand reorientation, and plug insertion. Our results show that visual force prediction can guide inference-time action selection for contact-rich manipulation without requiring force or tactile sensors at deployment.

0.25

Touch-JEPA: Tactile Representation Learning from Hand-Object Video with Limited Tactile Supervision

cs.CV ·2026-10-20 ·Minseong Kweon, Qiao Feng, Yiming Huang, Lingjie Liu
code/data similarity 0.75
Abstract · Project Page: https://touch-jepa.github.io

Understanding contact and tactile magnitude in hand-object interaction is a key step toward physically intelligent systems, yet learning such representations is limited by the cost and restricted coverage of tactile measurements. We present Touch-JEPA, a framework for learning tactile representations from hand-object videos with limited tactile supervision. We first introduce a self-supervised pretraining objective that learns from video alone without tactile supervision. Using video-derived hand geometry, Touch-JEPA predicts masked visual features at corresponding hand-surface locations from spatial and temporal context, encouraging the representation to capture latent contact dynamics. We then extend this formulation to joint representation learning, where masked prediction is applied to all videos while tactile supervision is available only for a labeled subset, grounding the shared representation in measured contact and magnitude. With self-supervised pretraining alone, simple supervised readouts on frozen Touch-JEPA features outperform supervised baselines in contact discrimination and tactile magnitude estimation across three human-hand benchmarks, and transfer to robotic hands without robot tactile training data. Joint learning with limited tactile supervision further improves contact and magnitude estimation on the human-hand benchmarks. Together, these results show that hand-object video can provide scalable self-supervision for tactile representation learning, while limited tactile measurements provide complementary physical grounding.

0.21

CARD: Contact-Anchored Retargeting for Dexterous Manipulation

cs.RO ·2026-10-27 ·Cunxi Dai, Botao He, Francois R Hogan, Wei Pan, Rao Fu +5 more
similarity 0.74
Abstract · Project webpage: https://card-retargeting.github.io/

Humans are dexterous, but traditional data collection paradigms such as teleoperation, kinesthetic teaching, and wearable exoskeletons force humans to act through the robot embodiment, bottlenecking their dexterity. Retargeting can avoid this. However, existing methods purely translate kinematics and ignore the real-world contact dynamics essential for task success. We present CARD: Contact-Anchored Retargeting for Dexterous Manipulation, a simulator and object-free framework that retargets human demonstrations to robot actions by explicitly preserving contact force targets. CARD unifies human data sources including video, motion capture, and tactile gloves via a shared hand--contact representation and generates explicit contact force targets in addition to kinematics. To maintain these contact targets during hardware open-loop replay, CARD also introduces a tactile tracking controller. For video which does not contain an explicit tactile source, we present Vid-HACO, our video-to-contact model that sets a new state of the art. Across our video, glove, motion-capture data and the GRAB dataset, CARD maintains contact on $43$--$78\%$ of contact frames, while kinematic and object-aware retargeting methods maintain contact on $<10\%$ and $22.5\%$ of the frames respectively. Further, integrating our formulation into physics-based retargeting improves strict task success from 12\% to 32\% on GRAB dataset. Finally, we show that our tactile tracker is critical to reproduce demonstrated forces during hardware replay. These results establish that contact preservation via CARD is a scalable interface for transferring human dexterity to robots.

0.39

DexRemo: A Force-Sensing Hand Platform and Task Suite for Contact-Rich Removal Manipulation

cs.RO cs.LG ·2026-11-11 ·Liman Wang, Hanyang Zhong, Sun Zhaole, Wenting Cao, Babar Jamil +3 more
publishedbenchmark similarity 0.74
Abstract · Accepted for publication in IEEE Transactions on Robotics (T-RO), 2026. Project website: https://dexremo.github.io

Many manipulation tasks require separating adhered, embedded, contaminated, or mechanically constrained targets. We study this setting as removal manipulation, where progress depends on evolving contact states that are only partially observable from vision and kinematics. We introduce DexRemo, a three-finger robotic hand with high-force actuation, modular fingertips, and three-axis fingertip force sensing, together with a nine-scenario real-robot task suite spanning adhesive detachment, surface cleaning and self-cleaning, and occluded retrieval. To make multi-finger force observations easier to fuse, we express fingertip forces in a shared wrist-centered frame, giving force components consistent geometric meaning across fingers and time. Using an Action Chunking Transformer backbone, policies fuse multi-view vision, proprioception, fingertip pose, and force observations to predict closed-loop action chunks from demonstrations. Evaluation uses six core benchmark tasks for controlled fingertip-input and force-frame ablations, plus three extension scenarios for additional held-out coverage. Across these evaluations, the learned policies achieve consistent removal performance, and ablations show that wrist-frame forces, especially with fingertip pose, improve stability and generalization over local-frame force inputs and no-force baselines. Project website: https://dexremo.github.io

0.24