CS Paper Radar

Beyond the Flat Seafloor: A Closed-Form Two-View Constraint to Aid Sidescan Sonar Reconstruction

Kalin Norman, Joshua G. Mangelson

cs.RO cs.CV ·submitted 2026-09-21 18:17 UTC · v1
published

Abstract

Sidescan sonar is a common sensor for both manned and autonomous marine exploration and mapping, yet very few methods build upon or exploit the geometric projection model of the sensor. As sidescan sonar is limited to a 1D range measurement, many approximations are frequently used, including the long-standing assumption of a flat seafloor. Rather than make similar approximations, this paper focuses on a multi-view geometry based approach and formalizes a two-view geometric constraint and proves that a shared feature is constrained to a locus within the intersection of a sphere and a plane. In addition, we characterize what governs the size of the ambiguity locus through Monte Carlo simulation that is grounded in real aperture and mounting geometry for both a surface vessel and an underwater vehicle. We translate additional simulations of relative trajectories for both vehicle platforms into concrete survey-planning guidance. Our results show that locus length is strongly governed by elevation misalignment, and peaks at a moderate oblique crossing angle of approximately 20 degrees, with minimal locus lengths obtained at near parallel and anti-parallel passes.

Comment
Copyright 2026 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media. This work was accepted for publication in the Proceedings of IEEE OCEANS 2026 Monterey

Closest papers

Nearest neighbours by meaning across the whole index.

Active Mapping of Underwater Litter Using Camera-Sonar Fusion

cs.RO ·2026-09-30 ·David Rete, Patrick Boros, Lucian Busoniu
published similarity 0.62
Abstract

Marine litter is a growing threat to the underwater ecosystem, driving demand for autonomous survey methods that can locate debris efficiently over large areas. Existing survey methods typically follow predefined paths or operate with a single sensing modality, typically a camera (with image quality suffering in poor-visibility conditions) or sonar (usually noisy and low-resolution). We present an active mapping framework in which a forward-looking sonar and a camera both feed into a shared Bayesian occupancy map, and an optimization problem is solved at each step to decide on the next best view. Candidate viewpoints are scored by a two-term utility that balances exploration of uncertain regions via voxel entropy against exploitation of likely objects. Each sensor is characterized by range- and bearing-dependent detection and false-alarm probability tables determined from data. We evaluate the approach in a realistic underwater simulator, demonstrating that active mapping finds objects faster than a lawnmower coverage pattern, and that the dual-sensor approach works better than using either of the individual sensors.

0.33

AquaBEV: Monocular Underwater BEV Occupancy with 3D Sonar Supervision

cs.RO cs.CV ·2026-09-03 ·Trung Tien Dong, Shengji Jin, Chen Chen, Yi Sheng, Xiaomin Lin
benchmark similarity 0.61
Abstract

Autonomous underwater robots are widely used for exploration, monitoring, and inspection, where safe navigation depends on understanding the surrounding free and occupied space. Bird's eye view (BEV) occupancy provides such a representation, but predicting it from a single underwater RGB image is difficult due to limited, unreliable geometric cues from appearance alone. 3D imaging sonar offers complementary geometric measurements to supervise this task. We introduce AquaBEV, a monocular underwater occupancy model that predicts local BEV occupancy from a single RGB image, using paired 3D imaging sonar as geometric supervision during training. AquaBEV maps visual features into a calibration free polar representation and applies causal decoding along the range dimension before reconstructing the prediction in Cartesian BEV coordinates. A controlled underwater occupancy benchmark was established, adapting representative occupancy methods to the same RGB to sonar task under a unified protocol. AquaBEV achieves 31.4 Visible IoU and 38.6 Observed IoU, 4.0% and 4.3% relative improvements over the strongest transferred baseline.

0.34

SonarVoxNet: Diver Detection in 3D Bounding Box using 3D Sonar

cs.RO ·2026-10-01 ·Eugene Park, Jiwon Lee, Seyoung Kan, Trung Dong, Xiaomin Lin +1 more
similarity 0.60
Abstract

Autonomous underwater vehicles (AUVs) assisting human divers must continuously track not only the diver's 3D position but also their full-body orientation. However, vision-based perception is unreliable underwater, and forward-looking sonar -- despite being widely used -- discards the elevation information needed for orientation estimation, posing a fundamental limitation. Recently commercialized 3D sonar preserves elevation but produces sparse, noisy returns, and existing detectors are built for dense LiDAR data and for targets that remain upright and rotate only about the yaw axis (e.g., vehicles, pedestrians), making them unable to represent a freely pitching and rolling diver. To address this gap, we present two contributions. First, SonarVoxNet adapts a voxel-based encoder and an anchor-free center-based detection head to 3D sonar data, replacing the conventional yaw-only rotation representation with a continuous 6D rotation parameterization to predict full 9-DoF oriented bounding boxes -- to our knowledge, the first 3D sonar diver detector to do so. Second, Diver3D is the first public 3D sonar dataset with full 3D orientation labels for divers in diverse, non-upright poses, collected at a natural cave-diving site. Through controlled ablations over the backbone and detection head, we show that the dominant factor behind accurate 3D sonar-based diver detection is the transition from yaw-only rotation to full-SO(3) rotation. This transition substantially improves detection accuracy and reduces orientation error. These results demonstrate that full-body diver orientation is recoverable from 3D sonar alone, laying the groundwork for future work on diver pose estimation and diver-robot interaction.

0.09

SURGE: Sonar-fUsed Reconstruction and localization via image-gated Graph Estimation

cs.RO ·2026-10-05 ·Mohammed Ibrahim M, Vallabh Deogaonkar, Trung Dong, Jane Shin, Abhilash Somayajula +1 more
similarity 0.60
Abstract

Remotely operated vehicles (ROVs) are widely used to explore and inspect underwater environments such as caves, shipwrecks, and submerged infrastructure. These missions require accurate 3D understanding of the surrounding environment, which depends on both reliable vehicle localization and metric scene reconstruction. However, external positioning is often unavailable underwater, requiring small ROVs to rely primarily on onboard perception. Optic vision provides rich visual and geometric information but suffers from scale ambi- guity and trajectory drift, whereas 2D imaging sonar provides metric range but incomplete 3D geometry. Existing underwater reconstruction approaches typically address these limitations separately or assume known sensor poses, leaving localization and reconstruction disconnected. We present SURGE, a camera sonar framework that jointly estimates the ROV trajectory and target location by integrating visual and acoustic observations within a factor graph, then uses the recovered metric poses for sonar Gaussian splatting. Experiments on real underwater RGB sonar observations show that SURGE substantially improves localization consistency over conventional vision based pose estimation and produces a more compact, natively metric reconstruction than RGB Gaussian splatting baselines.

0.12

RTISSLAM-3D: Full 6-DoF SLAM With an In-Air 3D Imaging Sonar

cs.RO ·2026-10-15 ·Jan Steckel, Vincent Katter, Wouter Jansen
similarity 0.60
Abstract

Echolocating bats navigate dense forests using sonar alone, and in-air 3D imaging sonars now capture the entire frontal hemisphere with every pulse. Sonar SLAM, however, has so far been planar: current systems estimate a 2D trajectory and discard the elevation information in the sonar images, an assumption that does not hold on rough and sloped terrain such as a forest floor. In this paper, we introduce RTISSLAM-3D, a novel 6-DoF SLAM system for a wheeled robot that carries an in-air 3D imaging sonar, an IMU and wheel encoders. A CFAR detector on the sphere reduces every sonar image to a sparse set of 3D detections, which we use for a 3D acoustic odometry that models the shape of the sonar beam, for place recognition with polar submap descriptors, and for the verification of loop closures by 3D registration, all combined in a 6-DoF pose graph with attitude factors. We evaluated RTISSLAM-3D on a 545m drive through a forest, with a 3D lidar SLAM as reference. The loop closures reduced the horizontal error of the acoustic odometry from 1.74m to 0.28m, with a height error of 0.12m, and 94.6% of the resulting 3D sonar map lies within 0.3 m of the lidar map.

0.16

Geometry-Driven Opti-Acoustic Co-Registration and View-Invariant Reflectivity Mapping for Side-Scan Sonar

cs.CV ·2026-08-24 ·Taqi Hamoda, Nuno Gracias
hot direction similarity 0.60
Abstract

Side-Scan Sonar (SSS) is a primary modality for large-scale underwater mapping, yet automated perception and cross-modal alignment are severely bottlenecked by acoustic complexities such as speckle noise, shadows, and extreme viewpoint dependencies. Traditional handcrafted descriptors and modern deep learning matchers fail to bridge the physical domain gap between optical and acoustic imagery without 3D geometric constraints. To overcome these limitations, we propose a novel geometry-driven framework for pixel-level opti-acoustic co-registration and view-invariant reflectivity mapping. Our method utilizes Structure-from-Motion (SfM) to reconstruct a dense 3D seafloor mesh, acting as a geometric anchor between the visual and acoustic domains. We introduce a First Bottom Return (FBR) extraction algorithm to dynamically correct non-linear altitude drift caused by uncalibrated SfM reconstruction. Furthermore, we apply an inverse Lambertian model and a dual-Gaussian weighting function to isolate the intrinsic seabed reflectivity, effectively neutralizing slant-range propagation loss and geometric view-dependence. By deterministically associating these isolated acoustic properties with optical pixels, our pipeline generates highly accurate, strictly co-registered multi-modal datasets. This automated, physics-guided approach eliminates the need for manual annotation and paves the way for advanced self-supervised learning in benthic habitat mapping.

0.37

CAVE-NAV: VLM-Based Autonomous 3D Navigation in Underwater Cave Environments

cs.RO ·2026-08-28 ·Zhenqi Wu, Yuanjie Lu, Yisheng Zhang, Miao Yu, Xuesu Xiao +2 more
similarity 0.59
Abstract

Autonomous navigation in underwater cave environments is essential for search-and-rescue operations, scientific exploration, and emergency egress. Traditional navigation systems commonly depend on dense visual features for localization and mapping. In underwater caves, however, visual degradation can undermine feature-based localization, sonar-based mapping may yield overly conservative obstacle representations, and communication constraints preclude real-time human guidance. To address these limitations, we propose an autonomous underwater cave navigation framework that leverages a vision-language model (VLM) with Chain-of-Thought (CoT) reasoning to infer navigable directions from environmental cues, including light intensity gradients, passage morphology, and geometric complexity, captured through multimodal inputs comprising RGB imagery, depth maps, and sonar-based vertical-clearance measurements, thereby supporting safe 3D navigation through confined cave passages. High-fidelity simulations across multiple cave topologies demonstrate that the proposed framework completes all evaluated end-to-end traversals without collisions while maintaining safe clearance from cave boundaries.

0.23

Odometry-Aided Real-Time Mapping for Underwater Robots Using Forward-Looking Sonar

cs.RO ·2026-09-21 ·Siyuan Du, Kanzhong Yao, Youdong Wang, Yingqi Liu, Qingwen Liu +3 more
similarity 0.58
Abstract · This work has been submitted to IEEE for possible publication

Reliable perception is essential for underwater vehicles operating in complex environments, where light attenuation and scattering often degrade visibility and compromise optical sensing. Forward-looking sonar (FLS) offers an alternative by providing high-frame-rate acoustic imaging under poor optical conditions. However, real-time FLS mapping remains challenging due to unresolved target elevation, spatially non-uniform noise, and fragmented target boundaries, which hinder feature extraction and introduce geometric ambiguity during projection. To address these challenges, we propose a cascaded feature reconstruction pipeline combining fast Fourier transform (FFT)-based denoising, fast multiscale constant false alarm rate (MCFAR) detection, and gradient-adaptive boundary connection to extract geometric features from degraded sonar images with low latency. We integrate attitude-aware geometric projection with incremental occupancy accumulation to construct a depth-referenced 2.5D map for local mapping in confined underwater environments. The sonar's vertical position is referenced to an external sensor, while target elevation is assigned under an explicit geometric assumption rather than measured directly by FLS. Experiments in a 3 m X 5 m pool demonstrate centimeter-scale planar mapping accuracy, with a root-mean-square error (RMSE) below 3 cm across three sequences and an average processing time of 42.4 ms per frame.

0.11