CS Paper Radar

CLIS-MPPI: Closed-Loop Model Predictive Path Integral Control With Initial-State Sampling Under Execution Delay

Zidong Liu, Xu Chen

cs.RO ·submitted 2026-10-15 04:37 UTC · v1

Abstract

Sampling-based motion planning such as Model Predictive Path Integral (MPPI) control has become attractive for robotics due to its ability to handle nonlinear dynamics and non-smooth objectives without gradient information, while leveraging parallel rollout computation for real-time performance. However, in real-world robotic systems, the optimized control input is often applied after a non-negligible planning delay, causing a mismatch between the state used in forward simulation and the actual state at control execution, which can significantly degrade planning accuracy and may even lead to unsafe behavior such as collisions. This paper proposes Closed-Loop MPPI with Initial-State Sampling (CLIS-MPPI), which explicitly addresses execution-time state mismatch by modeling planning delay as a distribution over plausible execution-time initial states, performing rollout optimization from sampled initial states, and applying a rollout-based local feedback correction during control execution. The proposed method is validated through real-world experiments on a 6-DoF UR5e manipulator in a narrow-passage task involving obstacle avoidance and end-effector target reaching. Across 5 real-world runs of the same task, standard MPPI collided in 2 runs, whereas CLIS-MPPI remained collision-free in all 5 runs. Averaged over all collision-free runs for each method (3 for MPPI and 5 for CLIS-MPPI), CLIS-MPPI reduced the average task completion time from 25.4s to 24.4s and the average end-effector path length from 0.456 m to 0.425 m. It also reduced the overall joint-position and joint-velocity root mean square errors (RMSEs) from 0.100 rad and 0.108 rad/s to 0.017 rad and 0.011 rad/s, respectively. These results demonstrate improved safety, planning-execution consistency, and motion smoothness.

Comment
65th IEEE Conference on Decision and Control (CDC 2026)

Closest papers

Nearest neighbours by meaning across the whole index.

Reachability-Guided Sequential Quadratic Programming-Guarded Model Predictive Path Integral for Safe Nonlinear Predictive Control

cs.RO eess.SY ·2026-10-03 ·Alexandre Didier, Jason J. Choi, Namhoon Cho, Claire J. Tomlin, Melanie N. Zeilinger
similarity 0.77
Abstract

Safe robot control often requires combining long-horizon performance optimization with hard state and input constraints, but existing approaches tend to address this tradeoff partially. Sampling-based model predictive control (MPC) methods such as model predictive path integral (MPPI) are effective in handling nonlinear and nonconvex environments, yet their finite-sample rollouts and unconstrained weighted-average update can return an unsafe control. Deterministic nonlinear MPC can explicitly incorporate constraints, but its real-time safety and performance depends strongly on warm starts and local convergence. Hamilton--Jacobi reachability (HJR) provides rigorous safety certificates, but offline value-function computation remains practical only for reduced-order models. We propose ReSQ-MPPI, a reachability-informed generation--refinement architecture that combines these complementary strengths. An HJR value function computed offline for a reduced-order model guides online MPPI sampling toward safe, promising trajectory candidates. The MPPI solution is then refined by a small number of sequential quadratic programming (SQP) iterations in a full-order MPC problem. A key observation is that the standard MPPI inference step is an unconstrained weighted least-squares problem; ReSQ-MPPI replaces it with a constrained MPC refinement that recovers the MPPI update when it is feasible and minimally modifies it otherwise. Simulations in cluttered navigation and autonomous racing environments demonstrate that ReSQ-MPPI improves safety and performance over standalone MPPI, MPC, and reachability-filtered sampling-based control baselines.

0.18

Finite sample guarantees of MPPI: suboptimality, sample complexity and closed-loop guarantees

eess.SY math.OC ·2026-11-17 ·Changyi Lei, Dragan Nesic, Ye Pu
theoryhot direction similarity 0.73
Abstract

This paper considers model predictive path integral (MPPI) control for nonlinear finite-horizon optimal control problems with bounded inputs, allowing nonconvex and nonsmooth costs. We prove theoretical guarantees that quantify the suboptimality caused by positive temperature and finite sampling on MPPI and establish their implications for closed-loop guarantees. Specifically, we derive a suboptimality bound for infinite-sample MPPI that characterizes the effects of temperature and prior coverage, followed by a high-probability finite-sample approximation error bound that reveals the dependence on sample size, temperature, and cost variability. By incorporating these bounds into a terminal-constraint-free MPC framework, we further establish semi-global practical recurrence of the closed-loop system. Numerical examples involving a four-link planar manipulator illustrate the temperature-sampling tradeoff and the influence of prior quality on approximation accuracy and closed-loop performance.

0.31

Real-Time Dynamics-Based Torque-Sampling MPPI for Compliant and Force Aware Manipulation

cs.RO ·2026-09-02 ·Euncheol Im, Taehyun Kim, Yonghwan Oh, Myotaeg Lim, Yisoo Lee
published similarity 0.73
Abstract · 8 pages, 6 figures. Accepted to the IEEE/RSJ International Conference on Intelligent Robots and Systems (IROS 2026)

This study proposes a novel Model Predictive Path Integral (MPPI)-based task-space control framework. The proposed framework explicitly solves rigid-body dynamics within a real-time MPC formulation and enforces safety constraints, enabling accurate motion and force control that yields compliant behaviors for safe and effective physical interaction of robotic manipulators in unstructured environments. By leveraging MPPI, the proposed framework efficiently handles nonlinear dynamics that are difficult to solve with conventional MPC approaches in real-time. Furthermore, we develop a torque-sampling-based control architecture that enables efficient exploitation of GPU-based parallelization, resulting in effective compliant and force-aware behaviors. As a result, the proposed framework achieves a solver update rate of over 166 Hz with a 0.18 s prediction horizon, and its performance is validated through real-world experiments on a 7-DoF manipulator.

0.38

Safety-aware Model Predictive Path Integral Control with Signal Temporal Logic

cs.RO eess.SY ·2026-08-25 ·Yiqi Zhao, Taekyung Kim, Hideki Okamoto, Bardh Hoxha, Jyotirmoy V. Deshmukh +2 more
similarity 0.72
Abstract

Safety-aware motion planning remains a challenge in robotics, especially when missions are time-critical and are under complex specifications. In this paper, we propose safety-aware-stl-mppi, a computationally efficient sampling-based receding-horizon planning framework designed to promote satisfaction of constraints expressed in Signal Temporal Logic (STL). Our approach encodes discrete-time STL formulas into candidate time-varying control barrier functions (CBF), which are integrated into a model predictive path integral (MPPI) controller. Our method inherits the benefits of low computational cost from an efficiently parallelizable sampling based planner and utilizes CBF for constraints expressed in STL. We compare against several MPPI baselines using four artificial Mars Rover planning case studies with a diverse environment and cost setups, where we show our method consistently achieving high safety and efficiency. We show a quadcopter planning experiment with NVIDIA Isaac Lab.

0.16

Hybrid Feedback Sampling for Sample-Efficient Model Predictive Control

cs.RO eess.SY ·2026-08-19 ·Chaoyi Pan, Zeji Yi, John Zhang, Zachary Manchester, Guannan Qu +1 more
similarity 0.70
Abstract · 15 pages, 6 figures

Thanks to its parallelizability and flexibility, sampling-based Model Predictive Control (MPC) has become widely popular for controlling real-world robotic systems. However, for high-dimensional and open-loop unstable dynamical systems, the required number of samples to improve the control sequence will grow exponentially with the horizon, leading to poor sample efficiency and numerical instability. This paper investigates the instability of shooting methods in sampling-based MPC and shows that the optimal sampling proposal distribution can be realized by sampling with an optimized feedback policy. We refer to this algorithm as Feedback Sampling MPC (FS-MPC). FS-MPC involves a hybrid sampling design which balances local and global search based on the system stability and the available computation budget. Our theoretical analysis shows that our hybrid sampling approach achieves faster convergence than standard MPPI and better optimality than standard feedback sampling. Empirically, in diverse contact-rich control tasks like humanoid loco-manipulation and dexterous manipulation, we show that FS-MPC successfully tackles dynamically unstable tasks where standard sample-based approaches struggle, and strictly outperforms feedback policies alone. Finally, we validate our method on humanoid robot locomotion and manipulation tasks in the real world.

0.47

Sample-Efficient Model Predictive Control via Proximal Policy Optimization

eess.SY ·2026-11-17 ·Jiarui Wang, Sina Sharifi, Mahyar Fazlyab
similarity 0.69
Abstract

Sampling-based model predictive control (MPC) enables real-time control of complex nonlinear systems but often incurs substantial computational costs due to repeated trajectory simulations. In this paper, we bridge policy optimization in reinforcement learning and sampling-based MPC to improve computational efficiency through sample reuse. Starting from a KL-regularized distributional formulation of trajectory optimization, we derive an exact performance-difference identity based on a signed exponential advantage function. This identity motivates two algorithms, PPO-MPPI and SPO-MPPI, which adapt proximal policy optimization techniques to sampling-based MPC, enabling multiple optimization updates using previously evaluated trajectories without additional forward simulations. We establish population-level monotonic improvement guarantees for both methods and prove convergence to first-order stationarity for PPO-MPPI under fixed-covariance Gaussian sampling distributions. Experiments on quadruped velocity tracking and quadrotor path tracking demonstrate that the proposed methods achieve competitive control performance at substantially lower computational cost than multi-stage sampling approaches. Our results establish a principled connection between policy optimization and sampling-based MPC and highlight the potential of trajectory reuse for sample-efficient predictive control.

0.29

Laguerre-MPPI

eess.SY ·2026-11-18 ·Yusuke Tahori, Masaki Inoue, Hayate Irie, Tomohiro Taki, Takashi Hatano
theoryhot direction similarity 0.69
Abstract

Model Predictive Path Integral control (MPPI) is a sampling-based control method that handles nonlinear dynamics and non-convex costs without gradient information. Since MPPI samples the entire input sequence, longer prediction horizons lead to a higher-dimensional sampling space, potentially degrading control performance. This paper proposes Laguerre-MPPI, which parameterizes the control input sequence using discrete-time Laguerre basis functions and samples the basis coefficients. The resulting search dimension is independent of the prediction horizon. Hence, a longer prediction horizon does not require more samples to maintain the sampling density. For linear systems with quadratic costs, we derive a closed-loop stability condition in the infinite-sample limit. Under finite sampling, we provide a closed-form expression for the limit of the ratio of the effective sample size to the number of samples. We also show that the upper bound of this limit for Laguerre-MPPI is no lower than that for conventional MPPI. Numerical experiments demonstrate smoother inputs in obstacle avoidance and maintained performance over long horizons. Moreover, they verify the lower bound on the number of samples given by the finite-sample analysis.

0.28

PoliMop: Policy-in-the-Loop Motion Planning in 3D Spaces for Mobile Robots

cs.RO ·2026-11-13 ·Yael Fassbind, Valentin N. Hartmann, Huang Su, Yijiang Huang, Stelian Coros
similarity 0.68
Abstract · 8 pages, 5 figures. Videos and code: https://ariael21.github.io/polimop.html

Reaching a goal state in a complex environment often requires a robot to overcome challenging terrain and obstacles. Which routes are accessible depends on the robot's physical design, the control policy it uses, and how it modifies its surroundings. We present a kinodynamic rapidly-exploring random tree (RRT) planner that uses physics simulation to exploit skills encoded in the control policy, which allows it to find a path in the scene with respect to the robot's capabilities. The planner samples states from a reduced state space in 3D around the scene and expands the RRT toward each sample using policy rollouts. We guide sampling with a preplanned path for a simple mass-point model to focus exploration on promising regions leading toward the goal state, reducing planning time by up to 63%. Simulation experiments with quadrupeds, humanoids, and wheeled robots demonstrate that our approach supports drop-in integration of various robots and control policies, exploiting their physical and policy capabilities without modifying the underlying planning algorithm. Predefined environmental modifications, such as placing a plank across a gap to build a bridge, will automatically be picked up by the planner as the robot's reachable space expands.

0.24