CS Paper Radar

Over-The-Air Extreme Learning Machines with Nonlinear Stacked Intelligent Metasurfaces

Kyriakos Stylianopoulos, Mattia Fabiani, Giulia Torcolacci, Davide Dardari, George C. Alexandropoulos

eess.SP cs.LG ·submitted 2026-08-27 13:50 UTC · v1

Abstract

The recently envisioned goal-oriented communications paradigm requires machine learning inference to be performed directly on wirelessly transferred data. This paper presents an eXtremely Large (XL) Multiple-Input Multiple-Output (MIMO) system that operates as an Extreme Learning Machine (ELM) to execute Over-The-Air (OTA) binary classification. To reduce hardware complexity, the receiver is equipped with cascaded metasurfaces terminating in a single radio-frequency chain. A front metasurface layer applies a fixed nonlinear response to the incoming signal, acting as the ELM's activation function. Subsequent tunable linear metasurface layers physically approximate the trained network weights directly in the wave domain. Numerical evaluations across diverse datasets showcase that our XL MIMO architecture achieves classification accuracy comparable to idealized digital models, thereby proving the viability of low-complexity, wave-domain OTA learning.

Comment
To be presented at Int. Workshop Signal Process. Adv. Wireless Commun. (SPAWC), Athens, Greece, Sept. 2026

Closest papers

Nearest neighbours by meaning across the whole index.

XL MIMO Extreme Learning Machines: Wave-Domain Inference with Stacked Metasurfaces

eess.SP cs.ETcs.LG ·2026-10-26 ·Kyriakos Stylianopoulos, Mattia Fabiani, Davide Dardari, George C. Alexandropoulos
similarity 0.85
Abstract · Submitted for journal publication

The recently envisioned goal-oriented communications paradigm requires machine learning inference to be performed directly on wirelessly transferred data, by splitting neural network computations between the transmitter, the Receiver (RX), and the wireless channel. Such approaches aim to offload large portions of the computation onto the channel itself, which is often controlled by reconfigurable MetaSurfaces (MSs). Typical MS-parametrized systems, however, enable only limited computation offloading in the wave domain, usually corresponding to a single neural network layer, due to adverse channel fading effects and the almost linear operation of the channel and conventional MS models. In this paper, we demonstrate that an eXtremely Large (XL) Multiple-Input Multiple-Output (MIMO) system equipped with Stacked Intelligent MSs (SIM) at the RX side, together with a single antenna and its accompanying radio-frequency chain, may act as a two-layer neural network operating exclusively over the air. The first (uncontrollable) network layer corresponds to the transformations offered by wireless fading, while the second (controllable) layer is implemented via SIM operations. In particular, only the first, front-end MS layer needs to exhibit nonlinear response to serve as an activation function. Leveraging the Extreme Learning Machine (ELM) framework, the proposed XL MIMO system architecture is shown to be a universal approximator, and the optimal linear-SIM-based combining is derived in closed form, allowing for fast training even and partial signal observability. Numerical evaluations across diverse datasets showcase that the proposed XL-MIMO-ELM framework achieves classification accuracy comparable to idealized digital models, thereby, proving the viability of low complexity, wave-domain neural computations.

0.38

The Computing Channel: How Modulation Programs the Airwaves

cs.DC ·2026-09-10 ·Saeed Razavikia, Carlo Fischione
similarity 0.61
Abstract

Distributed computing and distributed artificial intelligence require frequent exchanges of intermediate results, although many applications need only an aggregate rather than messages from individual devices. Conventional systems recover each message before computing the aggregate, whereas over-the-air computation (OAC) exploits simultaneous transmission to obtain it directly. However, dominant OAC implementations rely on analog signaling, creating a mismatch with finite-precision data and digital communication procedures. This article presents digital function-oriented communication, in which finite-alphabet symbol representations and receiver decisions are jointly designed so that multiple-access superposition encodes the desired function without recovering individual inputs. We introduce its computational-constellation principle, main design approaches, extensions, and implementation challenges. Federated edge learning illustrates how the framework can reduce user-dependent data-bearing resources while operating directly on quantized model updates.

0.12

Multi-Model Over-the-Air Federated Learning via Transceiver Beamforming and Device Grouping

eess.SP cs.IT ·2026-11-05 ·Chong Zhang, Min Dong, Ben Liang, Ali Afana, Yahia A. Eldemerdash Ahmed
top venue similarity 0.60
Abstract · 16 pages, 6 figures. Accepted by IEEE Transactions on Wireless Communications, 2026

This paper considers uplink communication design for training multiple independent machine learning models via wireless federated learning. To reduce communication delay, we utilize multi-antenna beamforming and propose a multi-model over-the-air (M-OTA) uplink transmission and aggregation method for simultaneous training of multiple models. Devices are formed into groups for local model training based on the model assignments per communication round and simultaneously perform OTA aggregation over a multi-access channel. Based on the M-OTA transmission and reception process, we formulate a joint optimization of transmit and receive beamforming and device grouping over $T$ communication rounds to maximize the training convergence rates of all models. We analyze the per-model optimality gap, which captures the impact of noisy aggregation and inter-model interference on the learning performance. We further show that the $T$-round joint optimization problem can be decomposed into per-round online optimization to devise solutions. Following this, we propose a device grouping strategy that explores channel correlation among devices to maximize OTA aggregation performance. Furthermore, we present a low-complexity iterative algorithm for joint transmit-receive beamforming with closed-form updates. Simulation shows that our proposed M-OTA approach substantially outperforms the conventional single-model sequential OTA approach and other commonly used beamforming schemes.

0.31

Over-the-Air Federated Learning in Heterogeneous Mobile Wireless Networks

cs.LG cs.DCmath.OC ·2026-09-26 ·Ming Xiang, Nicolò Michelusi, Yonina C. Eldar, Lili Su
published similarity 0.59
Abstract · MobiHoc 2026 (the 27th International Symposium on Theory, Algorithmic Foundations, and Protocol Design for Mobile Networks and Mobile Comput…

Over-the-air computation has emerged as a scalable and efficient solution for deploying federated learning algorithms in wireless networks by exploiting waveform superposition for simultaneous model aggregation. Most existing work struggles with heterogeneous fading channels. These approaches either enforce unbiased updates from all devices or allow partial device contributions, requiring careful tuning of the convergence bound to mitigate bias under specific fading models. However, the former significantly amplifies receiver noise due to the weakest channel, whereas the latter is sensitive to fading model mismatch and converges only to a biased objective. To tackle these challenges, we propose FedOAG, which employs algorithmic components to automatically satisfy energy constraints via gradient normalization and evenly mix devices' updates through implicit gossiping. Importantly, FedOAG does not require transmission from all devices, nor does it rely on a specific fading model or knowledge of time-varying statistical channel distributions. We show that FedOAG converges to a stationary point of an unbiased non-convex objective at the best possible rate $O(1/\sqrt{T})$ for any stochastic first-order method. We corroborate our analysis with numerical experiments over dynamic wireless conditions on real-world datasets.

0.19

Non-Coherent Over-the-Air Federated Learning: Protocol, Convergence, and Device Scheduling

cs.IT cs.LGeess.SP ·2026-09-08 ·Haifeng Wen, Nicolò Michelusi, Osvaldo Simeone, Yang Yang, Hong Xing
theory similarity 0.59
Abstract · 13 pages, 8 figures, submitted for possible journal publication

To mitigate the scalability bottleneck in the radio access network (RAN) in federated edge learning (FEEL), over-the-air federated learning (AirFL) exploits waveform superposition over multiple-access channels (MACs) for analog model aggregation. However, coherent AirFL typically relies on stringent PHY-layer conditions such as accurate channel state information (CSI), tight time/frequency synchronization, and frequent transceiver calibration for signal alignment. However, these requirements, if not impossible to be met, incur substantial communication and computation overhead. In this paper, we propose a non-coherent AirFL (NCAirFL) protocol over a broadband single-antenna MAC, leveraging binary dithering, unbiased non-coherent detection, and long-term error feedback to waive the need for instantaneous CSI. For NCAirFL with general smooth non-convex objectives and a constant learning rate, we establish a convergence bound achieving the convergence rate in the same order of $\mathcal{O}(1/\sqrt{T})$ as communication-ideal FedAvg, where $T$ is the total number of communication rounds. To further improve communication efficiency under data and wireless resource heterogeneity, we also derive a lower bound on the expected single-round objective decrease in the global loss conditioned on device scheduling, building upon which a surrogate objective function is obtained for jointly optimal device selection and power control. Experimental results on MNIST and CIFAR-10 corroborate that NCAirFL achieves learning performance close to FedAvg in practical settings, with the proposed device scheduling policy substantially accelerating convergence.

0.32

Wireless Physical-Layer Foundation Models: Architectures, Learning Paradigms, Applications, and Deployment

eess.SP ·2026-08-20 ·Mohammad Cheraghinia, Davide Buffelli, Liu Li, Mohammad Alhellani, Jaron Fontaine +4 more
hot direction similarity 0.56
Abstract

Foundation models, i.e., large neural networks pretrained on broad unlabeled data and adapted to many downstream tasks, have reshaped natural language processing and computer vision and are now being explored for the wireless physical layer. Wireless Physical-Layer Foundation Models (WPFMs) aim to learn transferable representations of signals such as channel state information (CSI), in-phase and quadrature (IQ) samples, and spectrograms so that a single pretrained backbone can support tasks ranging from channel estimation and prediction to localization and sensing while using limited task-specific data. This paper provides a dedicated review of WPFMs from learning design to practical deployment. We first establish the theoretical background, covering the neural architectures used for wireless signals, the self-supervised pretraining paradigms of masked modeling, contrastive learning, and generative pretraining, and the fine-tuning strategies that adapt pretrained models to downstream tasks. We then introduce a taxonomy that organizes existing models along five dimensions: architecture family, input modality and tokenization, pretraining objective, model scale and deployment target, and generalization capability. Building on this basis, we review applications across telecommunications, localization, and sensing, and, for each domain, analyze deployment feasibility by mapping model size to the memory, compute, and latency budgets of representative wireless hardware. Finally, we discuss model compression and efficient deployment, summarize the cross-cutting challenges, and outline open research directions. Our goal is to provide a reference that connects pretraining, architecture, and fine-tuning with the practical constraints of wireless systems.

0.47

Budget-Aware Federated Dual-Side Channel Estimation for Hybrid mmWave Massive MIMO

eess.SP ·2026-08-14 ·Jiawei Chen, Ruining Fan, Mouli Chakraborty, Avishek Nag, Anshu Mukherjee
similarity 0.56
Abstract

This work studies communication-constrained federated dual-side channel state information (CSI) estimation in hybrid millimeter-wave (mmWave) massive multiple input multiple output (MIMO) systems. Accurate CSI recovery is challenging because hybrid beamforming yields compressed and noisy observations, while repeated model exchange in federated learning (FL) makes communication efficiency strongly dependent on estimator size. Rather than developing a new federated optimization algorithm, we focus on estimator design under standard federated averaging (FedAvg) and study how to use a limited parameter budget effectively under repeated model exchange. Based on this perspective, we propose a budget-aware recalibrated refinement network (BARRNet), which combines a compact residual backbone with lightweight channel-wise recalibration for dual-side CSI refinement. Simulation results show that BARRNet achieves a better normalized mean squared error (NMSE)--communication tradeoff than the backbone-only control and heavier convolutional neural network (CNN) baselines. At 5 dB SNR, for the -13 dB DL NMSE target, it reduces the cumulative communication required by 28.9\% relative to the architecture-matched backbone-only control. These results indicate that communication-efficient federated CSI estimation depends not only on model compactness, but also on how limited model capacity is used under repeated model exchange.

0.04

Practical Deep Learning-Based Block Demapping for mmWave MIMO Systems

cs.AR ·2026-11-08 ·Syed Asrar ul haq, Jesus O. Lacruz, Joerg Widmer, Sumit J. Darak
published similarity 0.56
Abstract · Submitted for publication to IEEE Transactions on Wireless Communications

Deep learning is expected to play a central role in 6G systems, by enabling data-driven physical layer designs that can adapt to practical wireless impairments. This is particularly important for millimetre-wave (mmWave) multiple-input multiple-output (MIMO) systems, which are strongly affected by residual channel distortions, interference, and hardware non-idealities that are difficult to capture with analytical models. In this paper, we propose a deep learning-based soft demapper that performs block-wise processing of received symbols instead of conventional symbol-wise detection. The demapper employs a one-dimensional convolutional neural network to learn temporal structure induced by practical propagation and hardware effects, while producing soft bit outputs compatible with soft-decision decoding stages. The proposed approach is trained and evaluated for a 4$\times$4 wideband mmWave MIMO system at 60~GHz, using an over-the-air dataset collected across multiple days and settings. Experimental results demonstrate consistent improvements over a conventional soft-decision demapper, including up to a 2.6$\times$ reduction in bit error rate for 16QAM and up to a 17.6$\times$ reduction for 64QAM under real over-the-air mmWave MIMO conditions. The proposed demapper is further implemented on a Zynq RFSoC platform using a reconfigurable convolution engine and fixed-point arithmetic, achieving an approximately 34.3$\times$ speedup compared to a processor-based implementation, and demonstrating that learning-based demapping can be deployed efficiently on resource-constrained edge hardware.

0.32