CS Paper Radar

Observability Analysis for Fusion of Doppler Measurements in Multistatic Radar Near the Tx-Rx Baseline

Rong Yang, Yaakov Bar-Shalom, Leung Hong Huat Michael

eess.SY eess.SP ·submitted 2026-08-28 02:14 UTC · v1
published

Abstract

This paper studies multistatic measurement fusion when a target lies within the Tx--Rx (Transmitter-Receiver) baseline ambiguity zone, with particular emphasis on configurations involving two closely spaced stationary Tx--Rx pairs. Such configurations provide overlapping detectable regions and extend the effective detection range compared with sparsely spaced multistatic systems. However, in this region, the accuracy of range and bearing measurements degrades rapidly, and Doppler measurements often remain the only reliable information source. As a result, target trajectory estimation becomes highly challenging, with observability being marginal or even completely lost. To address this problem, the observability of target trajectories is analyzed under various conditions, enabling system designers to assess system performance in advance. A Doppler-only measurement fusion approach is then developed, employing a multiple-initial-point Maximum Likelihood (ML) nonlinear estimator for initial state estimation, followed by dynamic state updates using an Extended Kalman Filter (EKF). Simulation results are presented and shown to be consistent with the observability analysis.

Comment
7 pages, 12 figures. published on 29th International Conference on Information Fusion, Trondheim, Norway, June 2026

Closest papers

Nearest neighbours by meaning across the whole index.

Doppler-Only Extended Target Tracking in a Distributed Antenna System

eess.SP ·2026-10-01 ·Baptiste Sambon, Gilles Monnoyer, Luc Vandendorpe, Claude Oestges
similarity 0.70
Abstract · Submitted to IEEE 105th Vehicular Technology Conference: VTC Spring 2027

In modern radar and Integrated Sensing and Communication (ISAC) systems, the conventional point-scatterer assumption becomes increasingly inaccurate due to higher spatial resolution. In this context, Extended Target Tracking (ETT) has grown interest in recent years. However, most existing ETT works are designed for monostatic systems due to the fine time synchronisation or per-node antenna arrays required for ranging and angle estimation in multistatic scenarios. In contrast, this paper proposes a novel approach to extended target tracking in a distributed antenna system, where only bistatic Doppler frequency measurements are available. Doppler-only tracking is particularly attractive as it avoids the two aforementioned issues. To address this Doppler-only extended target tracking problem, we develop a modified Rao-Blackwellised Particle Filter (RBPF) that replaces the standard Kalman update with a particle-specific Extended Kalman Filter update followed by a relinearisation step, handling the non-linearities of both the rigid extended target dynamics and the observation model. Numerical simulations show the effectiveness of the proposed algorithm for accurate extended target tracking under this Doppler-only setting.

0.49

Performance Evaluation of Mobile Target Sensing and Tracking Across Multiple Sensing Modes

eess.SP ·2026-10-10 ·Necati Kagan Erkek, Marco Di Renzo, Arman Shojaeifard, Kunjan Shah, Mohammad Heggo +1 more
similarity 0.66
Abstract

Moving extended-target sensing and tracking are studied in a beamformed PRS/OFDM ISAC framework. The target is modeled as a rigid cluster of scatterers whose Tx--target--Rx echoes coherently combine in a MIMO scattering channel. Delay, azimuth/elevation, and Doppler are estimated using PRS matched filtering with delay centroiding, single-cluster 2D-MUSIC, and FFT-based Doppler estimation, then used for independent localization and EKF-based tracking. The framework is evaluated in monostatic and bistatic modes under target-directed, receiver-directed, and omnidirectional beamforming. Simulation results show that EKF tracking reduces the aggregate 3D RMSE from 1.61 m to 1.38 m relative to independent localization. Target-directed beamforming substantially improves tracking accuracy, achieving 1.38 m RMSE compared with 5.91 m and 8.38 m for omnidirectional and receiver-directed beamforming, respectively. The results highlight the importance of target-aware beam management, delay-angle-Doppler fusion, and sensing geometry for mobile-target tracking in ISAC networks.

0.35

Reliable Doppler Estimation in Asynchronous Moving ISAC Devices via IMU Integration

eess.SP ·2026-09-30 ·Zaman Bhalli, Jacopo Pegoraro, Gianmaria Ventura, Paolo Casari, Michele Rossi
similarity 0.66
Abstract · 6 pages, 5 figures. Submitted to IEEE VTC2027-Spring

We present an Integrated Sensing And Communication (ISAC) framework for the joint estimation of the Doppler frequency of a passive mobile target in a bistatic scenario with clock-asynchronous nodes and where the Receiver (RX) is static but the Transmitter (TX) is mobile. In such a setup, previous geometric solutions are integrated with an Inertial Measurement Unit (IMU) device at the TX, coming up with a truly joint data fusion and estimation algorithm based on extended Kalman filtering. The approach jointly estimates the target Doppler frequency, along with the speed and direction of motion of the TX and it is robust to the unavailability of static paths between the TX and RX pair, a condition that makes previous solutions ineffective. The developed extended Kalman filter strikes a balance between the accuracy of ISAC and the IMU reliability. The proposed solution is validated via numerical simulations, obtaining a median Doppler error of 1.2% with a smartphone-grade IMU under realistic operating conditions.

0.36

Target Localization and Self-Calibration in a Multistatic Radar System

eess.SP ·2026-08-16 ·Ahmad Musallam, Husheng Li
publishedtheory similarity 0.65
Abstract

Target localization in a multistatic radar system, where multiple receivers cooperate to improve target positioning accuracy, has many applications, including cooperative simultaneous localization and mapping (SLAM) and autonomous robot networks. A key challenge in these applications is the uncertainty in the position and orientation (pose) of the radar receivers due to platform mobility. This work investigates the achievable improvements in both target localization and receiver pose estimation by deriving the Cramer-Rao lower bound (CRLB) for a multistatic radar system performing bistatic range and bearing measurements. We propose an alternating weighted least-squares algorithm that jointly optimizes target and receiver parameters. Monte Carlo simulations demonstrate that the algorithm performance approaches the CRLB for low to moderate noise levels.

0.52

Practical Hardware-Efficient ISAC: Enabling Multi-Target Sensing With Few RF Chains

eess.SP ·2026-10-12 ·Zhenkun Zhang, Cunhua Pan, Hong Ren, Jun Tang, Dongming Wang +1 more
theory similarity 0.64
Abstract

Hybrid analog--digital arrays reduce hardware cost in integrated sensing and communications (ISAC), but spatial compression and beam-dependent scan responses complicate multi-target estimation with few radio-frequency (RF) chains. To address these challenges, this paper proposes a burst beam-scanning multiple-input multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) framework that reuses downlink reference signals for joint range, radial-velocity, elevation, and azimuth estimation. Specifically, a structured global--local dual-tensor estimator separates targets by using scanning observations and refines their parameters from selected-beam RF-chain responses, with delay--Doppler signatures maintaining cross-stage target correspondence. The recovered subarray responses yield closed-form elevation and azimuth estimates through exact sum--difference relations, avoiding small-angle approximations and fine angular grid searches. To further improve Doppler accuracy, spatial-mask-aided weighted least squares exploits the longer inter-burst temporal aperture while resolving phase ambiguity using intra-burst estimates. The joint multi-target Cramér--Rao lower bound (CRLB) and corresponding three-dimensional (3D) positioning bound are also derived to characterize estimation performance. Simulation results show that the proposed scheme achieves near-CRLB estimation accuracy at high transmit powers and centimeter- to millimeter-level 3D positioning with only four RF chains, while maintaining low computational cost.

0.12

Phase-Coherent Doppler-Only Sensing for D-MIMO ISAC

eess.SP ·2026-09-16 ·Silan Karadag, Musa Furkan Keskin, Navid Amani, Nikita Lyamin, Annelie Wyholt +1 more
similarity 0.64
Abstract

This paper studies phase-coherent Doppler-only sensing for bandwidth-limited sub-6 GHz D-MIMO ISAC. We consider a multistatic system with one transmitter and multiple synchronized single-antenna receivers, and develop noncoherent and coherent maximum-likelihood estimators together with their position error bounds. The analysis shows that noncoherent sensing relies only on Doppler and cannot localize static targets, whereas phase-coherent processing exploits carrier phase to provide additional position information. Simulations confirm the bounds and show that coherent processing significantly improves localization accuracy in the considered narrowband setting.

0.41

Distributed Target Tracking using Radar Networks

eess.SP eess.SY ·2026-08-19 ·Shao-Hsuan Hung, Raj Thilak Rajan
benchmarktheory similarity 0.62
Abstract

Distributed target tracking is essential for scalable and robust sensing systems, as it enables multiple radar nodes to cooperatively estimate a target state without relying on a centralized fusion center. In this paper, we present a fully distributed framework for single-target tracking in frequency-modulated continuous-wave (FMCW) radar networks. Each monostatic radar node observes local range and Doppler measurements and exchanges information only with neighboring nodes. Two consensus optimization-based estimators are developed. First, a Distributed Maximum A Posteriori (D-MAP) estimator is formulated for batch-based tracking, where prior state information is incorporated and the resulting optimization problem is solved using consensus-based alternating direction method of multipliers (ADMM). Second, a Distributed Extended Kalman Filter (D-EKF) is proposed for recursive tracking, where each node performs local prediction and correction followed by consensus ADMM-based information exchange. We derive the posterior Cramér-Rao lower bound (PCRLB) as a theoretical performance benchmark. Our simulation results show that D-MAP improves the accuracy of the estimation over the distributed maximum-likelihood baseline. These results demonstrate that the proposed framework provides a scalable and robust alternative to centralized radar tracking, given only local inter-node communication.

0.16

Range Ambiguity Identification and Elimination by Leveraging Temporal Broadening Effect for THz Sensing

eess.SP ·2026-10-14 ·Saira Rafique, Ahmed Naeem, Chong Han, Huseyin Arslan
similarity 0.61
Abstract · Submitted to IEEE Transactions on Vehicular Technology (TVT); currently under review

High pulse repetition frequency (PRF) operation improves Doppler unambiguous sensing but reduces the maximum unambiguous range of a terahertz (THz) pulsed radar. Echoes from targets beyond this range can be incorrectly associated with subsequent transmitted pulses, causing the targets to appear at shorter ranges. This paper proposes a receiver-side framework that exploits the THz-specific temporal broadening effect as a distance-dependent signature to resolve range ambiguity. For each detected echo, the receiver applies broadening-matched filtering with references corresponding to candidate target ranges. The filter outputs are combined across pulses with Doppler compensation, and the largest normalised combined response identifies the ambiguity order needed to recover the true target range. The selected reference is then reused to reduce mismatch loss in subsequent range and velocity estimation. Simulations under known atmospheric conditions, with targets occupying distinct apparent-delay bins, demonstrate reliable range recovery beyond the conventional unambiguous interval. Range estimation errors conditioned on correct ambiguity-order identification, together with the reported velocity estimation errors, approach their corresponding derived Cramér--Rao bounds. The method preserves a fixed transmitted pulse shape, PRF, and sampling rate, at the expense of a higher signal-to-clutter-plus-noise ratio requirement for ambiguity identification relative to the evaluated diversity-based techniques.

0.25