CS Paper Radar

Performance Evaluation of Mobile Target Sensing and Tracking Across Multiple Sensing Modes

Necati Kagan Erkek, Marco Di Renzo, Arman Shojaeifard, Kunjan Shah, Mohammad Heggo, Yasser Mestrah

eess.SP ·submitted 2026-10-10 03:39 UTC · v1

Abstract

Moving extended-target sensing and tracking are studied in a beamformed PRS/OFDM ISAC framework. The target is modeled as a rigid cluster of scatterers whose Tx--target--Rx echoes coherently combine in a MIMO scattering channel. Delay, azimuth/elevation, and Doppler are estimated using PRS matched filtering with delay centroiding, single-cluster 2D-MUSIC, and FFT-based Doppler estimation, then used for independent localization and EKF-based tracking. The framework is evaluated in monostatic and bistatic modes under target-directed, receiver-directed, and omnidirectional beamforming. Simulation results show that EKF tracking reduces the aggregate 3D RMSE from 1.61 m to 1.38 m relative to independent localization. Target-directed beamforming substantially improves tracking accuracy, achieving 1.38 m RMSE compared with 5.91 m and 8.38 m for omnidirectional and receiver-directed beamforming, respectively. The results highlight the importance of target-aware beam management, delay-angle-Doppler fusion, and sensing geometry for mobile-target tracking in ISAC networks.

Closest papers

Nearest neighbours by meaning across the whole index.

Practical Hardware-Efficient ISAC: Enabling Multi-Target Sensing With Few RF Chains

eess.SP ·2026-10-12 ·Zhenkun Zhang, Cunhua Pan, Hong Ren, Jun Tang, Dongming Wang +1 more
theory similarity 0.70
Abstract

Hybrid analog--digital arrays reduce hardware cost in integrated sensing and communications (ISAC), but spatial compression and beam-dependent scan responses complicate multi-target estimation with few radio-frequency (RF) chains. To address these challenges, this paper proposes a burst beam-scanning multiple-input multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) framework that reuses downlink reference signals for joint range, radial-velocity, elevation, and azimuth estimation. Specifically, a structured global--local dual-tensor estimator separates targets by using scanning observations and refines their parameters from selected-beam RF-chain responses, with delay--Doppler signatures maintaining cross-stage target correspondence. The recovered subarray responses yield closed-form elevation and azimuth estimates through exact sum--difference relations, avoiding small-angle approximations and fine angular grid searches. To further improve Doppler accuracy, spatial-mask-aided weighted least squares exploits the longer inter-burst temporal aperture while resolving phase ambiguity using intra-burst estimates. The joint multi-target Cramér--Rao lower bound (CRLB) and corresponding three-dimensional (3D) positioning bound are also derived to characterize estimation performance. Simulation results show that the proposed scheme achieves near-CRLB estimation accuracy at high transmit powers and centimeter- to millimeter-level 3D positioning with only four RF chains, while maintaining low computational cost.

0.12

Doppler-Only Extended Target Tracking in a Distributed Antenna System

eess.SP ·2026-10-01 ·Baptiste Sambon, Gilles Monnoyer, Luc Vandendorpe, Claude Oestges
similarity 0.69
Abstract · Submitted to IEEE 105th Vehicular Technology Conference: VTC Spring 2027

In modern radar and Integrated Sensing and Communication (ISAC) systems, the conventional point-scatterer assumption becomes increasingly inaccurate due to higher spatial resolution. In this context, Extended Target Tracking (ETT) has grown interest in recent years. However, most existing ETT works are designed for monostatic systems due to the fine time synchronisation or per-node antenna arrays required for ranging and angle estimation in multistatic scenarios. In contrast, this paper proposes a novel approach to extended target tracking in a distributed antenna system, where only bistatic Doppler frequency measurements are available. Doppler-only tracking is particularly attractive as it avoids the two aforementioned issues. To address this Doppler-only extended target tracking problem, we develop a modified Rao-Blackwellised Particle Filter (RBPF) that replaces the standard Kalman update with a particle-specific Extended Kalman Filter update followed by a relinearisation step, handling the non-linearities of both the rigid extended target dynamics and the observation model. Numerical simulations show the effectiveness of the proposed algorithm for accurate extended target tracking under this Doppler-only setting.

0.50

Phase-Coherent Doppler-Only Sensing for D-MIMO ISAC

eess.SP ·2026-09-16 ·Silan Karadag, Musa Furkan Keskin, Navid Amani, Nikita Lyamin, Annelie Wyholt +1 more
similarity 0.67
Abstract

This paper studies phase-coherent Doppler-only sensing for bandwidth-limited sub-6 GHz D-MIMO ISAC. We consider a multistatic system with one transmitter and multiple synchronized single-antenna receivers, and develop noncoherent and coherent maximum-likelihood estimators together with their position error bounds. The analysis shows that noncoherent sensing relies only on Doppler and cannot localize static targets, whereas phase-coherent processing exploits carrier phase to provide additional position information. Simulations confirm the bounds and show that coherent processing significantly improves localization accuracy in the considered narrowband setting.

0.42

Observability Analysis for Fusion of Doppler Measurements in Multistatic Radar Near the Tx-Rx Baseline

eess.SY eess.SP ·2026-08-28 ·Rong Yang, Yaakov Bar-Shalom, Leung Hong Huat Michael
published similarity 0.66
Abstract · 7 pages, 12 figures. published on 29th International Conference on Information Fusion, Trondheim, Norway, June 2026

This paper studies multistatic measurement fusion when a target lies within the Tx--Rx (Transmitter-Receiver) baseline ambiguity zone, with particular emphasis on configurations involving two closely spaced stationary Tx--Rx pairs. Such configurations provide overlapping detectable regions and extend the effective detection range compared with sparsely spaced multistatic systems. However, in this region, the accuracy of range and bearing measurements degrades rapidly, and Doppler measurements often remain the only reliable information source. As a result, target trajectory estimation becomes highly challenging, with observability being marginal or even completely lost. To address this problem, the observability of target trajectories is analyzed under various conditions, enabling system designers to assess system performance in advance. A Doppler-only measurement fusion approach is then developed, employing a multiple-initial-point Maximum Likelihood (ML) nonlinear estimator for initial state estimation, followed by dynamic state updates using an Extended Kalman Filter (EKF). Simulation results are presented and shown to be consistent with the observability analysis.

0.22

Delay-Doppler Sensing Performance Analysis for MIMO-OFDM ISAC Systems

eess.SP ·2026-09-01 ·Peishi Li, Rang Liu, Qian Liu, Ming Li
published similarity 0.64
Abstract · Accepted by IEEE Globecom 2026

In communication-centric integrated sensing and communication (ISAC), delay-Doppler sensing reuses data-bearing orthogonal frequency division multiplexing (OFDM) signals rather than dedicated radar probing waveforms. Consequently, the resulting range-Doppler map (RDM) is shaped not only by target parameters, but also by communication-symbol randomness and, in multi-antenna transmissions, by spatial beamforming. While existing analyses have largely focused on single-antenna OFDM-ISAC, the delay-Doppler sensing behavior of multi-antenna OFDM-ISAC remains insufficiently understood. This paper analyzes a multi-input multi-output (MIMO)-OFDM-ISAC system in which multiple data streams jointly illuminate a sensing target. We derive second-order moment expressions for the RDM under matched filtering (MF) and reciprocal filtering (RF), and use them to characterize the dynamic range (DR). The analysis reveals two key multi-stream effects. First, under MF, the random superposition of multiple beamformed streams creates an additional RDM floor beyond the modulation-dependent and receiver-noise terms; therefore, constant-modulus signaling no longer eliminates the data-induced pedestal as in single-antenna OFDM-ISAC. Second, under RF, the matched-angle data-induced floor is removed, but the noise floor is amplified according to the reciprocal-power statistics of the beamformed target illumination. These results show that the user-target angular geometry directly governs the MF/RF tradeoff: MF is more robust under weak illumination, whereas RF can achieve a higher DR when reciprocal-noise amplification is mild. Numerical results validate the analysis and demonstrate the distinct geometry-dependent behaviors of MF and RF.

0.14

Reliable Doppler Estimation in Asynchronous Moving ISAC Devices via IMU Integration

eess.SP ·2026-09-30 ·Zaman Bhalli, Jacopo Pegoraro, Gianmaria Ventura, Paolo Casari, Michele Rossi
similarity 0.64
Abstract · 6 pages, 5 figures. Submitted to IEEE VTC2027-Spring

We present an Integrated Sensing And Communication (ISAC) framework for the joint estimation of the Doppler frequency of a passive mobile target in a bistatic scenario with clock-asynchronous nodes and where the Receiver (RX) is static but the Transmitter (TX) is mobile. In such a setup, previous geometric solutions are integrated with an Inertial Measurement Unit (IMU) device at the TX, coming up with a truly joint data fusion and estimation algorithm based on extended Kalman filtering. The approach jointly estimates the target Doppler frequency, along with the speed and direction of motion of the TX and it is robust to the unavailability of static paths between the TX and RX pair, a condition that makes previous solutions ineffective. The developed extended Kalman filter strikes a balance between the accuracy of ISAC and the IMU reliability. The proposed solution is validated via numerical simulations, obtaining a median Doppler error of 1.2% with a smartphone-grade IMU under realistic operating conditions.

0.36

Path-Specific Geometric-Stochastic Channel Model for Scattering from ISAC Targets: A Unified Measurement-Based Characterization of Robots, Humans, and Automobiles at 28 GHz

cs.IT ·2026-10-25 ·Neeraj Varshney, Jelena Senic, Jack Chuang, Samuel Berweger, Steve Blandino +3 more
similarity 0.63
Abstract

This paper develops a channel model for scattering from a broad class of integrated sensing and communication (ISAC) targets-robots, humans, and automobiles-based on a unified measurement campaign at 28~GHz. Nine targets are characterized from numerous transmitter--receiver configurations per target, spanning full bistatic and aspect angles and thus covering backward to forward scattering. Repeated acquisitions are collected for each configuration to capture target motion and dynamics, yielding nearly 117\,000 acquisitions in total. Measurements are collected with a 2~GHz-wide channel sounder equipped with a 256-element phased-array antenna, followed by digital beamforming and super-resolution processing for reliable extraction of multiple paths in delay and 2D angle, with average estimation errors of 0.1~ns and 0.2$^\circ$ respectively. From these measurements, we reduce a \emph{path-specific} channel representation in which the scattering is modeled as a cluster of paths whose center is defined by the bistatic specular \emph{geometry}; the cluster shape is described \emph{stochastically}. To ensure physically grounded spatio--temporal consistency, extracted paths are mapped to incident points on the target, each with an associated radar cross section (RCS) that is compatible with the 3GPP TR~38.901 ISAC channel model, and are subsequently mapped back to path properties for channel synthesis. The resulting statistical distributions are well behaved, physically interpretable, and consistent across targets, geometries, and motion. Comparison between measured and synthesized channel realizations demonstrates close agreement in pathloss trends and fluctuation behavior. Together, these results yield a high-fidelity, measurement-derived channel representation suitable for ISAC simulation, target modeling, and system design.

0.28

Phase-Coherent Multistatic Sensing under Phase Noise in Distributed ISAC

eess.SP ·2026-10-20 ·Musa Furkan Keskin, Silan Karadag, Navid Amani, Nikita Lyamin, Annelie Wyholt +1 more
similarity 0.62
Abstract

We investigate phase-coherent multistatic sensing in distributed ISAC systems where spatially separated access points (APs) share a common, non-ideal local oscillator (LO) impaired by phase noise (PN). In the presence of a single transmit AP and multiple receive APs with OFDM transmission, we derive the joint statistics of PN across receive APs and reveal its unique covariance structure that depends on target location through propagation delays of individual bistatic links. Based on this statistical characterization, we carry out a Cramér-Rao bound analysis of three receiver models, namely PN-free, PN-aware and PN-ignorant, for both isotropic and non-isotropic targets. Simulation results verify the location-dependent statistics of PN in shared-LO distributed architectures while demonstrating how transmit power, LO quality, AP deployment and scattering characteristics affect multistatic localization.

0.11