CS Paper Radar

SecDT: A Profile-Based Security Layer for TRDP Communications

Erlantz Alonso, Igor Lopez, Jasone Astorga

cs.CR cs.NI ·submitted 2026-09-02 20:16 UTC · v2
published

Abstract

The Train Real-time Data Protocol (TRDP) is widely used on rolling stock but it provides limited native support for cryptographic protection. Furthermore, the multicast traffic profile used in TRDP Process Data to exchange critical information between onboard subsystems makes the introduction of cryptographic protection a challenge. This paper presents a lightweight security layer for secure TRDP communication that implements a number of security profiles built around modern cryptographic algorithms. This additional layer relies on an On-board Key Management System (OKMS) for both security profile negotiation, dynamic key distribution and key lifecycle management. The security profiles allow for cryptographic agility and flexibility, ranging from simple authentication to Authenticated Encryption with Associated Data (AEAD) algorithms. The security profile negotiation procedure guarantees all TRDP End Devices (ED) on a common Communication ID (ComID) share the same security profile and can therefore process each other's messages. A prototype implementation based on mbedTLS and Arm Platform Security Architecture (PSA) was developed and evaluated. Experimental results demonstrate manageable overhead, suitable for the real-time and time-sensitive communication found on rolling stock.

Comment
In proceedings of IEEE Future Networks World Forum 2026

Closest papers

Nearest neighbours by meaning across the whole index.

Secure Aggregate Encryption with Identity-Based Authentication for Multi-Vendor FPGA Cloud Deployment

cs.CR ·2026-10-08 ·Mukta Debnath, Krishnendu Guha, Debasri Saha, Amlan Chakrabarti, Susmita Sur-Kolay
similarity 0.63
Abstract

Secure deployment of FPGA bitstreams in heterogeneous multi-vendor cloud infrastructures requires scalable authorization, authenticated device access, and bitstream protection throughout the deployment lifecycle. Existing approaches typically address these functions through separate mechanisms, increasing coordination and key management requirements. This paper presents SAEID, a secure FPGA deployment framework that integrates aggregate authorization, certificate-free identity-based device authentication, and identity bound bitstream verification within a pairing based cryptographic framework, with symmetric cryptography used for session binding and AES 256 GCM based bitstream protection. Building on AgEID, an aggregate encryption scheme that enables individual decryption for authorized FPGA devices, SAEID extends the underlying framework to heterogeneous multi vendor deployments by supporting multiple FPGA vendors and IP providers, capability-aware authorization, and dynamic device membership. SAEID provides protection against unauthorized access to future deployments after device revocation and to prior deployments by newly enrolled devices, while retaining constant-size aggregate ciphertexts within each vendor domain and individual decryption. Experimental results demonstrate the practical performance of SAEID, with identity-based device authentication completing in approximately 4.35 ms and device membership updates requiring 4.95 to 5.09 micro seconds for device addition. The aggregate-encryption component exhibits scalable behavior with increasing device-set size. The complete SAEID software decryption path was also validated on a physical ZC702 Cortex A9 platform, requiring 191.126 ms. These results demonstrate scalable aggregate authorization with bounded authentication and dynamic-membership overhead for secure multi-vendor FPGA deployment.

0.25

Vaulted Passkeys: A Device-Bound Proposal for Authenticated Credential Export and Import

cs.CR ·2026-08-13 ·Pol Henarejos
similarity 0.58
Abstract

Hardware authenticators deliberately resist private-key extraction, yet replacement, disaster recovery, and controlled migration create a legitimate need for portability. Existing guidance for device-bound credentials commonly reduces recovery risk by registering an additional authenticator before failure. That creates an independent credential registration and requires replacement hardware to exist in advance; it is redundancy, not a backup of the original credential. This paper addresses the resulting recovery gap by exporting protected credential state while the source is available and restoring it to hardware acquired later, without cloning a complete authenticator or exposing plaintext private keys to routine desktop software. We propose Vaulted Passkeys, a device-bound architecture in which a random 256-bit Kvault protects authenticated PKV1 credential envelopes through HKDF-separated keys and four explicit AEAD profiles. The design separates enrollment from export/import and the required vault from optional identity. We contribute a role-separated system model, wire format, threat analysis, implementation mapping, and falsifiable evaluation plan. The prototype demonstrates feasibility but is neither a formal security proof nor a proposed final standard.

0.04

A Lightweight and Post-Quantum Secure Framework for IEC 61869-9 Sampled Value Communication

cs.CR eess.SY ·2026-08-22 ·S. M. Suhail Hussain, Arman Ahmad, Mohammad Tayyab, Shaik Mullapathi Farooq
similarity 0.58
Abstract

Securing IEC 61869-9 Sampled Values (SV) is challenging because process-bus communication must satisfy stringent real-time constraints while supporting standardized high-rate publication profiles. This paper presents an experimentally validated security framework that combines lightweight per-frame authentication for operational SV traffic with post-quantum-capable key establishment protocol. For message integrity, the proposed method applies field-selective authentication employing optimized Chaskey-12 to reduce per-packet computational overhead. For trust establishment, the paper introduces an ML-KEM-based pairwise authentication and key-establishment procedure. The pairwise protocol is analyzed in the Quantum Random Oracle Model and is also verified with AVISPA tool under the Dolev-Yao adversarial model. A C-based publisher/subscriber prototype is implemented on a two-node process-bus testbed. Performance is evaluated across the eight IEC 61869-9 SV packet profiles using HMAC-256, AES-GMAC-128, Blake-2s, Chaskey-12, and a compiler-optimized Chaskey-12 implementations. These results indicate that optimized Chaskey-12 achieves ~90% lower latency than HMAC on SV packets. The proposed security framework is a practical and scalable candidate for protecting IEC 61869-9 SV traffic on resource-constrained digital-substation devices.

0.11

Not Discrete Enough: On the Inherent Insecurity of dTPMs for Measured Boot

cs.CR ·2026-08-13 ·Christian Werling, Tahmid Zahin, Jean-Pierre Seifert
top venueposition similarity 0.57
Abstract · Published in: 2025 Annual Computer Security Applications Conference Workshops (ACSAC Workshops)

Measured Boot, a mechanism enabled through Trusted Platform Modules (TPMs), is commonly used for passwordless protection of data-at-rest, aiming to protect data when the device is lost or stolen. Microsoft's standpoint is neutral on which way a TPM should be implemented: Firmware-based TPMs (fTPMs) are viewed as more economical but less secure. Despite the inherent susceptibility to bus sniffing attacks, discrete TPMs (dTPMs) are still seen as the gold standard, as many deliver better on-paper tamper resistance. It is often argued that attacks against the bus can be mitigated by bus encryption and, ideally, mutual authentication between the CPU and TPM. This position paper aims to emphasize another inherent, difficult-to-mitigate attack against dTPMs that was originally shown against a TPM 1.1 over 20 years ago: We demonstrate that even brief physical access to a TPM 2.0 and the ability to boot from an attacker-controlled system enable an attacker to reset and replay arbitrary measurements, thereby allowing an attacker to unseal, for example, a disk encryption key solely protected by the TPM. While there have been attacks against fTPMs, too, we argue that their practical attack surface is fundamentally smaller. Bus protection techniques can be used to protect dTPMs, but only guard against passive attacks. After all, we argue that, from a security standpoint, firmware TPMs, or any TPM internal to the SoC, are superior to discrete (external) ones. Lastly, in order for dTPM-based setups to provide meaningful protection of sealed secrets, configurations must require a user-provided PIN or password along with the Measured Boot configuration.

0.29

AXON: A ROS 2 RMW with Shared-Memory/QUIC Transport and QKD/ML-KEM Key Establishment

cs.RO ·2026-09-09 ·Sergio Sánchez de la Fuente, Miguel Ángel González-Santamarta, Francisco Javier Rodríguez-Lera, Vicente Matellán Olivera, Ángel Manuel Guerrero-Higueras
similarity 0.57
Abstract · 8 pages, 1 figure, 1 table

Robot Operating System 2 (ROS 2) standardizes application code against a middleware interface (RMW) whose reference implementations are built on the Data Distribution Service (DDS). We present AXON, an alternative ROS 2 RMW implementation that separates transport policy by deployment scope. A Rust core and C++ adapter use POSIX shared-memory rings for same-host communication, QUIC for remote communication, and a daemon for discovery and graph synchronization. We then describe two fail-closed TLS 1.3 key-establishment configurations for remote traffic. The classic configuration offers only the hybrid X25519MLKEM768 group, preventing negotiation of a classical-only group. The qkd configuration imports a 256-bit key obtained through the ETSI GS QKD 014 API as a pairwise external PSK and offers no Diffie-Hellman group. Its default messages10 strategy additionally protects remote application messages with AES-256-GCM, rotating KME material after ten outgoing messages and using a fresh nonce per envelope; session relies on QUIC protection alone. The external-PSK path requires a narrow extension to rustls, now bundled with AXON. We define the threat model, distinguish peer authentication in the two configurations, and delimit the implementation-level validation from ROS 2 conformance, comparative performance, and physical-QKD validation.

0.17

Cryptographically Secure Agent-to-Agent Communication in Multi-Agent Systems

cs.CR cs.MA ·2026-10-16 ·Karol Budzyn, Adrian Brodzik, Mateusz Szczepkowski
similarity 0.56
Abstract

Multi-agent systems (MAS) comprise AI agents that collaborate or compete to perform complex, distributed tasks. Their dynamic interactions create opportunities for threat actors to target and impersonate other agents, intercept messages, inject malicious prompts, and exfiltrate sensitive data while simultaneously complicating the detection of anomalous behavior through conventional monitoring. This paper surveys threats and cryptographic challenges in agent-to-agent communication and presents a zero-trust architecture integrating identity, transport security, message integrity, and monitoring. The architecture establishes agent identities via decentralized identifiers and task-scoped verifiable credentials backed by a permissioned ledger, enforcing least-privilege authorization. For transport security, it provides mutually authenticated, crypto-agile TLS with hybrid post-quantum key establishment, and evaluates KEMTLS with pre-distributed public keys to reduce handshake overhead. Signed CBOR envelopes preserve payload integrity across multi-hop exchanges, while zero-knowledge proofs verify declared task constraints without exposing underlying inputs. Context-aware monitoring of inter-agent messages, tool activity, and execution telemetry informs the setting of risk-based trust thresholds and supports the detection of behavioral anomalies. Together, these mechanisms provide an integrated framework for securing and auditing agent communication, with implications for other agentic protocols and prospective 6G semantic communication.

0.05

Automotive HSMs - Architectural Challenges and Security Implications

cs.CR cs.ARcs.ET ·2026-08-25 ·Krishna Teja Medam, Austin Bruce
similarity 0.56
Abstract

Automotive electronic control units (ECUs) increasingly depend on hardware-rooted security to protect software integrity, authenticity, and lifecycle management in the presence of remote and physical threats. Hardware Security Modules (HSMs) have become a key building block in automotive system-on-chips (SoCs), providing isolated cryptographic services, secure key storage, and controlled execution under stringent real-time and cost constraints. This paper presents an architectural analysis of automotive HSMs and examines their role in establishing secure boot and hardware roots of trust. We first survey common HSM integration models used in production ECUs and discuss their flexibility and current automotive use cases. We then introduce realistic threat models to motivate hardware-backed security controls and analyze how HSM design choices influence secure boot chains of trust, secure storage, secure execution, and software signing mechanisms. Key tradeoffs between isolation, performance, updateability, and attack surface are discussed, with optional consideration of side-channel implications. The paper concludes by highlighting open challenges and future directions for scalable and resilient automotive hardware security. Finally, we discuss emerging challenges such as cryptographic agility and post-quantum readiness that are likely to shape the next generation of automotive HSM architectures.

0.20

SoK: Secure Software-Based Multi-Domain Data Segregation

cs.CR ·2026-09-07 ·Quang Cao, Peter Vinci, Nick Georghiou, Shane Phillips, Mathieu Philippe +1 more
survey similarity 0.55
Abstract

Modern mission-critical coordination demands seamless communication across multiple domains. Traditionally, Voice Communication Systems (VCS) have relied on physically separated Red/Black architectures to ensure voice and data segregation. While these hardware-based methods provide strong security assurances and remain foundational in high-security contexts, they can introduce significant complexity and scalability challenges as mission parameters expand into highly dynamic, multi-domain integrations. As defence, emergency response, and critical infrastructure operations increasingly require interoperable, flexible, and cost-efficient communication environments, there is a growing need to understand whether software-based approaches can provide comparable assurance while supporting modern operational requirements. This SoK characterises a transition to software-based Multi-Domain Data Segregation (MDDS) by integrating systems security, networking, and cryptography. Its goal is to consolidate existing research, identify shared architectural patterns, and address the security challenges facing next-generation high-assurance software-based VCS architectures. By assessing software-defined and virtualized approaches, this SoK supports the development of scalable, high-assurance VCS architectures that facilitate secure real-time coordination across diverse operational domains. Specifically, this SoK examines the security implications of Software-Defined Networking, Network Slicing, Separation Kernels, and Cross-Domain Solutions while addressing challenges posed by quantum computing through Post-Quantum Cryptography (PQC). This SoK provides a comprehensive analysis of the shift from hardware isolation to software segregation, serving as a crucial foundation for researchers and industry stakeholders aiming to enhance secure and adaptable VCS infrastructures for mission-critical operations.

0.19