CS Paper Radar

ZD-AOMDV: A New Routing Algorithm for Mobile Ad-Hoc Networks

Nastooh Taheri Javan, Reza Kiaeifar, Bahram Hakhamaneshi, Mehdi Dehghan

cs.NI ·submitted 2026-08-21 08:18 UTC · v1
publishedhighly cited

Abstract

A common characteristic of all popular multi-path routing algorithms in mobile ad-hoc networks, such as AOMDV, is that the end to end delay is reduced by utilization of parallel paths. The competition between the neighboring nodes for obtaining a common channel in those parallel paths is the reason for end to end delay increment. In fact, due to medium access mechanism in wireless networks, such as CSMA/CA, data transmissions even through two node-disjoint paths are not completely independent and each path will affect the other one. In this paper we have modified the AODV protocol which results in selection of zone-disjoint paths, to the extent feasible, and as a result we achieve less end to end delay. The efficiency of the proposed protocol has been evaluated on different scenarios and there has been a noticeable improvement in the packet delivery ratio and also in the reduction of end-to-end delay comparing to AOMDV.

Closest papers

Nearest neighbours by meaning across the whole index.

IZM-DSR: A New Zone-Disjoint Multi-path Routing Algorithm for Mobile Ad-Hoc Network

cs.NI ·2026-11-15 ·Nastooh Taheri Javan
publishedhighly cited similarity 0.76
Abstract

Some of multi-path routing algorithms in MANETs use multiple paths simultaneously. These algorithms can attempt to find node-disjoint to achieve higher fault tolerance. By using node-disjoint paths, it is expected that the end-to-end delay in each case should be independent of each other. However, because of natural properties and medium access mechanisms in ad hoc networks, such as CSMA/CA, the endto-end delay between any source and destination depends on the pattern of communication in the neighborhood region. In this case some of the intermediate nodes should be silent to reverence their neighbors and this matter increases the end-toend delay. To avoid this problem, multi-path routing algorithms can use zone-disjoint paths instead of node-disjoint paths. In this paper we propose a new multi-path routing algorithm that selects zone-disjoint paths, using omnidirectional antenna. We evaluate our algorithm in several different scenarios. The simulation results show that our approach is very effective in decreasing routing overhead and end-to-end delay.

0.41

Using Zone-Disjoint Multi-Path Routing Algorithm for Video Transmission over Ah-Hoc Networks

cs.NI ·2026-08-20 ·Ali Asghar Khavasi, Nastooh Taheri Javan
published similarity 0.68
Abstract

Finding multi-path routes in ad hoc networks due to their grid topology seems to be a trivial task, but because of CSMA/CA effects in these networks found paths are not completely disjoint unless an appropriate algorithm have taken into account. If such an algorithm provided and designed carefully it could improve multi-path video transmission over these kinds of networks. By using node-disjoint paths, it is expected that the end-to-end delay and BER in each case should be independent of each other. However, because of natural properties and medium access mechanisms in ad hoc networks the end-to-end delay and also BER between any source and destination depends on the pattern of communication in the neighborhood region. In this case some of the intermediate nodes should be silent to reverence their neighbors and this matter increases the end-to-end delay. To avoid this problem, multi-path routing algorithms can use zone-disjoint paths instead of node-disjoint paths. In this paper we demonstrated a new multi-path routing algorithm that selects zone-disjoint paths that in addition used for video multi-path transmission over ad hoc networks. It is shown that by using this new algorithm along with choosing an appropriate scheme for video transmission over discovered paths, our approach receives enhanced results comparing previously used algorithms.

0.35

EDAP: An Efficient Data-Gathering Protocol for Wireless Sensor Networks

cs.NI ·2026-10-02 ·Arash Nasiri Eghbali, Nastooh Taheri Javan, Mehdi Dehghan
publishedhighly cited similarity 0.55
Abstract

Directed Diffusion (DD), uses mechanisms such as data aggregation and in-network processing to suppress the additional data overhead however there is no guarantee that paths from nearby sources join after a few hops. Also for path construction, each source floods a distinct exploratory data (ED) packet through the network which is not necessary for nearby sources. In this paper an efficient data-gathering protocol (EDAP) is proposed to address the problems of late-aggregation and distinct ED-flooding through using a virtual sink (VS) node nearby the sources which plays the role of sink node and broadcasts local interest messages and routed gathered data toward destination. Also in this protocol, multiple paths are constructed between virtual sink and the sink node which leads to load-balancing and increase in the life-time of the network nodes. Our routing protocol can produce more than one disjoint or braided path and spread the gathered data properly between constructed paths according to their length and remaining energy. Simulation results shows that in this way a significant amount of energy can be saved and the network lifetime will be increased considerably (up to 75% better than DD).

0.60

Energy-Efficient Geographic Multicast Routing in Cognitive Wireless Sensor Networks

cs.NI ·2026-10-31 ·Farzan Heidari, Farzaneh Heidari
similarity 0.50
Abstract

Energy consumption is a major design concern in wireless sensor networks. Cognitive radio provides opportunistic access to licensed spectrum, while multicast routing allows several destinations to share forwarding paths. In this paper, we propose two geographic multicast routing protocols for cognitive wireless sensor networks, CCast and PCast. CCast combines multicast-tree construction with a latency-oriented spectrum-selection metric. PCast uses a normalized link-power cost to select routes and can avoid regions where primary users occupy lower-frequency bands. Both protocols use local neighbor information and destination coordinates, without requiring a complete network-topology map. Simulations compare the proposed protocols with geographic multicast routing (GMP) and multiple unicast routing. In simulations, CCast and PCast reduce energy consumption by 21\% and 26\% relative to GMP, at the cost of longer per-destination routes and higher delivery delay.

0.25

Joint Effects of Node Density, Propagation, Wi-Fi Generation, and Transport Protocol on WLAN Performance: An ns-3 Study

cs.NI ·2026-09-24 ·Leonel Olimpio Silima
unusual similarity 0.48
Abstract

Wireless local area network (WLAN) performance is jointly shaped by medium contention, propagation, Wi-Fi configuration, and transport-layer behavior. This study evaluates IEEE 802.11g and IEEE 802.11ax in a single-access-point uplink topology, comparing UDP and TCP under Friis, LogDistance, and cascaded Friis-Nakagami propagation models. The factorial design spans 5 to 50 stations, six access-point distances from 5 m to 50 m, and three random seeds. Of 1,080 scheduled executions, 1,073 produced valid CSV outputs; seven runs terminated with internal ns-3 and cppyy segmentation errors and were excluded. Across the global scenario summaries, TCP FlowMonitor packet delivery ratios (PDRs) range from 0.994 to 0.997, whereas UDP PDRs range from 0.298 to 0.731. The highest mean aggregate throughput is 2.619 Mb/s for TCP under the configured IEEE 802.11ax mode with Friis propagation; UDP reaches 25.854 Mb/s in the same topology. These results show that packet delivery ratio, throughput, delay, and fairness must be considered together. FlowMonitor metrics are IP-flow observations, so the study does not establish application-level delivery or isolate optional IEEE 802.11ax multi-user mechanisms.

0.27

Random Access and Localization in Cell-Free User-Centric Networks with Multipath Channels

cs.IT eess.SP ·2026-09-10 ·Simon Tarboush, Eleni Gkiouzepi, Giuseppe Caire
similarity 0.46
Abstract

In a wireless network, the initial/random access mechanism (RACH) allows idle/new users to join the network and (possibly) request allocated transmission resources for subsequent traffic. Building on our own previous work, for cell-free user-centric networks, we consider location-dependent random access codebooks such that users in a certain geographic area (location) make use of the corresponding set of random access preambles (codewords). We expand our previous work in two ways: (1) we consider multipath channels with line-of-sight (LoS) propagation within a given radius; (2) we consider two different approaches. The first makes use of Zadoff-Chu (ZC) sequences and GLRT detection to cope with the unknown delay, and it is conceptually similar to the 3GPP 2-step RACH specification (here extended to the cell-free case). The second builds on our previous work on multisource approximate message passing (AMP). For both schemes, we also consider a novel near Maximum-Likelihood approach for localization of the random access users directly from the detected RACH preambles, implicitly using angle of arrival and time difference of arrival information embedded into the LoS components. Simulation results show that the AMP approach achieves generally better performance for random access user detection, while both approaches have similar localization capability with a slight superiority for the frequency-domain scheme.

0.53

Is Collision-Free Backoff Worth It in Wi-Fi?

cs.NI ·2026-09-03 ·Mohammad Yousefi, Francesc Wilhelmi, Boris Bellalta
similarity 0.46
Abstract · 8 pages, 5 figures, 3 tables. Submitted to the 17th IFIP Wireless and Mobile Networking Conference (WMNC 2026)

The Distributed Coordination Function (DCF)---the underlying channel access protocol in Wi-Fi, based on Carrier Sense Multiple Access with Collision Avoidance (CSMA/CA) and Binary Exponential Backoff (BEB)---is simple and effective, but its performance can degrade with increasing contention due to collisions. Collision-free backoff algorithms replace randomization with deterministic channel access, potentially improving efficiency and predictability. But are collision-free methods, with all their implications in terms of protocol design, sufficient to improve Wi-Fi performance under realistic non-full-buffer traffic with both uplink and downlink transmissions? We investigate this question by comparing three collision-free algorithms, CSMA/ECA (ECA), CSMA/E2CA (E2CA), and deterministic backoff (DetBO), with standard and single-stage BEB. Using system-level simulations, we evaluate full-buffer traffic, non-full-buffer ON/OFF traffic with both uplink and downlink transmissions, and coexistence with legacy BEB stations. Under full-buffer traffic, collision-free operation provides only modest throughput gains, up to 6.3\%. With non-full-buffer traffic, delay is governed primarily by the contention window (CW) rather than by collision avoidance, and collision-free access can even degrade performance under downlink-heavy traffic. Stations fall back to a random backoff at least 93\% of the time, so a collision-free schedule rarely forms outside the AP.

0.27

Identification Codes for Ad Hoc Networks: Use Cases and Challenges

cs.NI ·2026-10-05 ·Athin Mohan, Roberto Ferrara, Christian Deppe
unusual similarity 0.46
Abstract · 10 pages with 4 figures

In this study, we focus on large-scale ad hoc networks characterized by a high node density. To achieve energy efficiency, the devices must minimize their data transmission, thereby reducing the total number of bits sent and the associated energy consumption. We consider using ID codes for the address field in the MAC layer and reduce the header size. The work explores a range of use cases and challenges that demonstrate the benefits of incorporating these ID codes into packet routing mechanisms for ad hoc networks, thereby providing a foundation for understanding their applicability and the necessary design adaptations.

0.30