CS Paper Radar

Low-altitude aircraft will reshape noise exposure across global cities

Tianjing Feng, Jian Kang

eess.AS ·submitted 2026-09-24 13:12 UTC · v1
unusual

Abstract

Just as motorisation made road traffic a defining noise source of the twentieth-century city, low-altitude aircraft may reshape urban acoustic exposure in the twenty-first. Yet how this noise interacts with existing sound environments and three-dimensional urban form across global cities remains unclear. We modelled identical low-altitude aircraft operations across ten urban districts spanning all inhabited continents. Horizontal exposure varied markedly across and within cities, depending on road noise conditions and urban morphology, which also strongly influenced overall attenuation. Some semi-enclosed spaces with low noise levels before low-altitude aircraft operations experienced increases above 20 dB(A), creating pronounced local contrasts in urban noise exposure. Vertically, exposure varied with height and acoustic visibility to the flight route, creating vertical exposure inequalities between storeys, façades and buildings at comparable heights. These findings show that low-altitude aircraft can reshape noise exposure across global cities, requiring route assessment to distinguish newly exposed from already exposed areas and to account for three-dimensional exposure.

Closest papers

Nearest neighbours by meaning across the whole index.

FDTD Model of Noise Pollution from an AI Data Center

cs.LG physics.comp-ph ·2026-10-10 ·Gavin Buxton
similarity 0.63
Abstract

The sudden growth in AI data centers is raising numerous environmental concerns. Low-frequency noise pollution is a concern for local residents, that may not just be an annoyance but also carry significant health impacts. An FDTD model of sound propagation over the topography near an AI data center is presented. The topography plays a large role in the level of noise pollution, with areas of sudden elevation on either side of the river near the AI data center more susceptible to high noise levels, while areas further afield largely protected from noise pollution by the topography. Understanding the role that topography plays in noise pollution, and capturing the noise pollution in specific topographies, can help identify areas where noise mitigation strategies might be best employed.

0.22

Evaluation of Acoustic Noise Level and Impulsiveness Inside Vehicles in Different Traffic Conditions

cs.NI ·2026-09-25 ·Daniel Flor, Danilo Pena, Hyago Lucas Oliveira, Luan Pena, Vicente A. de Sousa, +1 more
publishedhighly cited similarity 0.56
Abstract

Recently, the issue of sound quality inside vehicles has attracted interest from both researchers and industry alike due to health concerns and also to increase the appeal of vehicles to consumers. This work extends the analysis of interior acoustic noise inside a vehicle under several conditions by comparing measured power levels and two different models for acoustic noise, namely the Gaussian and the alpha-stable distributions. Noise samples were collected in a scenario with real traffic patterns using a measurement setup composed of a Raspberry Pi Board and a microphone strategically positioned. The analysis of the acquired data shows that the observed noise levels are higher when traffic conditions are good. Additionally, the interior noise presented considerable impulsiveness, which tends to be more severe when traffic is slower. Finally, our results suggest that noise sources related to the vehicle itself and its movement are the most relevant ones in the composition of the interior acoustic noise.

0.73

From Sound to Occupancy: Privacy-Aware Audio Sensing for Buildings

cs.SD cs.LG ·2026-11-08 ·Myeongwon Chae, Seonghyuk Son
code/data similarity 0.47
Abstract · 19 pages, 4 figures, 7 tables. Code: https://github.com/AaronChae/occupancy-audio-privacy

Occupancy-based controls regulate lighting and HVAC according to whether a space is in use. Passive infrared (PIR) sensors, the most common choice, respond to motion and can report an occupied room as vacant when its occupants remain still. Sound offers an alternative cue, since seated occupants type, turn pages and cough, but microphones raise privacy concerns. We therefore study a two-stage design: an on-device encoder maps each second of audio to a short embedding, and a server-side temporal model turns the stream of embeddings into an occupancy state. To our knowledge, no publicly available dataset pairs office audio with occupancy labels, so we evaluate the two stages separately on public data. The encoder is trained on synthetic scenes that mix empty-room recordings, room impulse responses, office sounds and read speech, and tested on unseen rooms, recordings and speakers for whether a second contains a sound made by a person. On 11 real office recordings (DCASE 2013) it reaches an AUC of 0.87, against 0.76 for log-mel statistics. Attacks on the transmitted embeddings recover at most 1% of the spoken words, against 94% from log-mel frames, but still identify the speaker among 40 in 69 to 77% of the utterances. Noise-floor normalization with adversarial training, an 8-dimensional embedding, or sending only class probabilities lowers this to 38 to 55% without hurting detection. On HPDmobile, which pairs home occupancy labels with an amplitude envelope of the audio, a causal temporal model pretrained with a hierarchical contrastive loss matches hand-crafted features (AUC 0.75) and does better when only one labelled day per home is available. These results make the two-stage design a practical basis for privacy-aware acoustic occupancy sensing, with speaker identity as the one leak still to close.

0.36

The Effects of Air-Conditioning and Road-Traffic Noise on Perceived, Cognitive, and EEG Responses in a University Classroom

cs.HC ·2026-10-02 ·Yuanzhi Su, Cynthia Hou
similarity 0.46
Abstract · 28 pages,14 figures

Air-conditioning and road-traffic noise are common in classrooms, and their effects are often judged by cognitive performance. However, a sound that leaves performance unchanged may still be perceived differently or alter brain activity. In a within-participant design, this study tested whether perceived, cognitive, and EEG responses are consistent, and whether perceived and EEG responses distinguish conditions that performance does not. Sixteen students completed cognitive tasks in a university classroom under air-conditioning and road-traffic noise, each played back at 55, 60, and 65 dBA. Participants rated acoustic appraisal and perceived workload after each condition, and EEG was recorded during the tasks. The results show that cognitive performance did not differ significantly between conditions in any task. By contrast, noise was rated louder, less pleasant, and more arousing than a no-noise control, and all three ratings varied with sound level; perceived workload was also higher under noise. Task-period EEG power also showed significant differences between sources or levels in specific tasks and scalp regions. Within participants, relative EEG band power covaried mainly with loudness and pleasantness; louder and less pleasant ratings coincided with higher relative theta and lower relative gamma power. Associations with arousal and performance were rare, and none were found for workload. The three response types were thus only partly consistent, and perceived responses and EEG distinguished conditions that performance did not. Non-significant performance differences do not mean the conditions were equivalent for students. Assessments of air-conditioning and road-traffic noise in classrooms should therefore consider perceived responses alongside cognitive performance, with EEG providing complementary information on neural activity during tasks.

0.32

Enhancing 3GPP Urban Channel Models For Terrestrial-to-Non-Terrestrial Communication

eess.SP ·2026-08-28 ·Gerhard Schreiber, Chenrui Sun, Joerg Schaepperle, Le-Hang Nguyen, Thorsten Wild
code/data similarity 0.46
Abstract

We have developed enhanced models for large-scale channel parameters intended for terrestrial-to-non-terrestrial (NTN) communication in Urban environments for supporting devices above ground levels, such as drones. The models are formulated as functions of terminal height above ground and elevation angle, applicable to S-Band and Ka-Band frequencies. To ensure realistic models, an open-source 3D scene generator was utilized to create a diverse set of urban scenes across Europe. Sionna ray-tracing was employed to generate path-gain samples for outdoor terminals, covering a range of heights up to 300 meters and elevation angles up to 90°. Our proposed analytical functions show excellent agreement to ray-tracing data for line-of-sight (LOS) probability, shadow-fading (SF), and clutter-loss (CL). Furthermore, a comparative coupling gain analysis with existing 3GPP models reveals notable differences, particularly caused by smaller CL and higher LOS probabilities from proposed models. Designed for ease of use, these models can be seamlessly integrated into simulation tools, offering a practical solution for researchers and engineers.

0.35

Cost of Decibel-Domain Averaging of Line-of-Sight States in Aerial Coverage Analysis

eess.SP ·2026-11-12 ·Ismail Guvenc
similarity 0.46
Abstract · 5 pages, 2 figures, 2 tables

Uncrewed aerial vehicle (UAV) coverage studies routinely average the line-of-sight (LoS) and non-line-of-sight (NLoS) path loss in the decibel domain, weighted by their probabilities. Since the conditional path-loss distribution is bimodal, the resulting mean path loss describes no physical link. We give the error of this mean path loss, relative to the path loss that corresponds to the mean received power, in closed form. We quantify it by ray tracing an ITU-R P.1410 city, supplying the averaged model with the exact LoS probability so that no parameter error contributes. Our numerical results show that the averaged path loss is 6.6 dB higher than the path loss of the mean received power and lies within 2 dB of only 6.2% of the links. It moves the coverage-optimal altitude from 1764 m to 778 m and understates the outage probability by up to 0.198.

0.24

Acoustic UAV Detection in Battlefield Scenarios: Handling Noise, Domain Shift, and Weak Labels

cs.SD cs.AIcs.CV ·2026-08-14 ·Vadym Vilhurin, Volodymyr Sydorskyi, Andrii Shevtsov
similarity 0.45
Abstract

Passive acoustic sensing offers a critical, cost-efficient, and, crucially, passive alternative for detecting small unmanned aerial vehicles. However, the practical deployment of acoustic systems is discouraged by extreme environmental noise and sensor-induced domain shift caused by heterogeneous hardware. This paper addresses these challenges by introducing a robust framework optimized for real-world battlefield conditions. We propose the integration of Per-Channel Energy Normalization (PCEN) and attention-based pooling to enhance feature extraction under low signal-to-noise ratio scenarios. We further propose a domain-aware training strategy that leverages auxiliary classes and multi-microphone data to mitigate cross-domain performance degradation. Evaluated on a unique dataset of combat-zone recordings from the Ukrainian frontlines, our approach significantly outperforms existing baselines, increasing the F1 score from 55.4% to 78.6%. This paper was originally presented at the International Conference on Military Communication and Information Systems (ICMCIS), organized by the Information Systems Technology (IST) Scientific and Technical Committee, IST-224-RSY - the ICMCIS, held in Bath, United Kingdom, 12-13 May 2026.

0.04

Sensing Bone-Conducted Speech with Earbuds

eess.AS ·2026-09-02 ·Christoph Weyer, Peter Jax
published similarity 0.44
Abstract · 14 pages, 12 figures, journal

Clear capture of the wearer's own voice (OV) is essential when using earbuds for mobile communication. However, OV capture remains challenging in noisy environments. Bone-conducted (BC) speech, which can be sensed as vibrations of the earbud housing, can be used to improve OV capture. However, neither bandwidth nor spatial characteristics of OV-induced earbud vibrations have been analyzed in detail, despite both characteristics being relevant, e.g., for sensor choice and placement. This study investigates both characteristics, based on measurements with two earbud models. Spectrally, results indicate that OV-induced earbud vibrations exhibit a low-pass characteristic, with a steep roll-off of -93 dB per decade above 400 Hz. Thus, sensors with comparatively low noise floors are required to sense the vibrations above \SI{1}{\kilo\hertz}. Spatially, results indicate that the earbuds mainly vibrate in and out of the ear canal entrance, with high consistency between subjects and fits. Simulations confirm that this enables capture of the high-power vibrations below 400 Hz by a single-axis sensor with less than 1.5 dB mean attenuation.

0.39