CS Paper Radar

Evaluation of Acoustic Noise Level and Impulsiveness Inside Vehicles in Different Traffic Conditions

Daniel Flor, Danilo Pena, Hyago Lucas Oliveira, Luan Pena, Vicente A. de Sousa,, Allan Martins

cs.NI ·submitted 2026-09-25 15:54 UTC · v1
publishedhighly cited

Abstract

Recently, the issue of sound quality inside vehicles has attracted interest from both researchers and industry alike due to health concerns and also to increase the appeal of vehicles to consumers. This work extends the analysis of interior acoustic noise inside a vehicle under several conditions by comparing measured power levels and two different models for acoustic noise, namely the Gaussian and the alpha-stable distributions. Noise samples were collected in a scenario with real traffic patterns using a measurement setup composed of a Raspberry Pi Board and a microphone strategically positioned. The analysis of the acquired data shows that the observed noise levels are higher when traffic conditions are good. Additionally, the interior noise presented considerable impulsiveness, which tends to be more severe when traffic is slower. Finally, our results suggest that noise sources related to the vehicle itself and its movement are the most relevant ones in the composition of the interior acoustic noise.

Journal ref
Sensors 2022, 22(5), 1946
DOI
10.3390/s22051946

Closest papers

Nearest neighbours by meaning across the whole index.

Low-altitude aircraft will reshape noise exposure across global cities

eess.AS ·2026-09-24 ·Tianjing Feng, Jian Kang
unusual similarity 0.56
Abstract

Just as motorisation made road traffic a defining noise source of the twentieth-century city, low-altitude aircraft may reshape urban acoustic exposure in the twenty-first. Yet how this noise interacts with existing sound environments and three-dimensional urban form across global cities remains unclear. We modelled identical low-altitude aircraft operations across ten urban districts spanning all inhabited continents. Horizontal exposure varied markedly across and within cities, depending on road noise conditions and urban morphology, which also strongly influenced overall attenuation. Some semi-enclosed spaces with low noise levels before low-altitude aircraft operations experienced increases above 20 dB(A), creating pronounced local contrasts in urban noise exposure. Vertically, exposure varied with height and acoustic visibility to the flight route, creating vertical exposure inequalities between storeys, façades and buildings at comparable heights. These findings show that low-altitude aircraft can reshape noise exposure across global cities, requiring route assessment to distinguish newly exposed from already exposed areas and to account for three-dimensional exposure.

0.32

FDTD Model of Noise Pollution from an AI Data Center

cs.LG physics.comp-ph ·2026-10-10 ·Gavin Buxton
similarity 0.52
Abstract

The sudden growth in AI data centers is raising numerous environmental concerns. Low-frequency noise pollution is a concern for local residents, that may not just be an annoyance but also carry significant health impacts. An FDTD model of sound propagation over the topography near an AI data center is presented. The topography plays a large role in the level of noise pollution, with areas of sudden elevation on either side of the river near the AI data center more susceptible to high noise levels, while areas further afield largely protected from noise pollution by the topography. Understanding the role that topography plays in noise pollution, and capturing the noise pollution in specific topographies, can help identify areas where noise mitigation strategies might be best employed.

0.22

Supervised Source Separation of Electric Vehicle Interior Noise Using a Hybrid Transformer Architecture

cs.SD cs.LGeess.AS ·2026-10-23 ·Philipp Diel, Zhuo Cao, Arne Hildenbrand, Marco Günther, Stefan Pischinger +2 more
similarity 0.49
Abstract

The interior sound of an electric vehicle is a superposition of several distinct noise contributions - wind noise, tire noise, powertrain (electric drive unit and inverter) noise, and auxiliary-drive noise - whose relative balance governs both the overall loudness and the perceived sound quality in the vehicle interior. Decomposing a recorded vehicle interior signal into these source contributions is a prerequisite for targeted acoustic engineering, but requires effortful measurement campaigns as well as expertise in the field of transfer path analysis. This work formulates the decomposition as a supervised, binaural source-separation problem with four target source contributions and adapts a hybrid time-spectrogram transformer architecture, originally developed for music demixing, to the domain of sound source separation for technical systems. To disambiguate source contributions, conditioning is introduced in the form of operating-state information, including electric drive speed, electric drive load, vehicle speed, and auxiliary-drive speed. Since isolated real-world reference stems are costly to obtain, the model is trained on a physics-based parametric data generator that synthesizes labeled component sounds from randomized virtual-vehicle hardware configurations and driving scenarios, so that the ground-truth contribution of each source is known by construction. Validation on both synthetic and measured vehicle interior sounds probes the achieved separation performance and underscores the feasibility of applying the proposed method for acoustic contribution analysis in technical systems.

0.26

The Hearpiece Database of Binaural Room Impulse Responses and Driver Responses on KEMAR

eess.AS ·2026-11-04 ·Tong Xiao, Reinhild Roden, Matthias Blau, Simon Doclo
similarity 0.49
Abstract · 13 pages, 7 figures, 5 tables. Database and MATLAB loading script available at https://doi.org/10.5281/zenodo.23667308

This document describes the measurement setup, signal processing, data organization, and MATLAB file format of a database of acoustic responses measured on a Knowles Electronics Manikin for Acoustic Research (KEMAR) using the Hearpiece, a multi-microphone, multi-driver in-ear research device. The data include binaural room impulse responses (BRIRs) and Hearpiece driver responses, together with center-microphone room impulse responses and a loopback impulse response of the playback and recording system. The BRIRs cover two Hearpiece configurations, three room conditions, three independent insertions per configuration, and 24 horizontal source directions. The database supports reproducible research on binaural and hearing-device signal processing, with potential applications in speech enhancement, spatial filtering and source separation, dereverberation, active noise and occlusion control, and acoustic feedback cancellation. The database, MATLAB loading script, and technical documentation are publicly available at https://doi.org/10.5281/zenodo.23667308.

0.35

The Effects of Air-Conditioning and Road-Traffic Noise on Perceived, Cognitive, and EEG Responses in a University Classroom

cs.HC ·2026-10-02 ·Yuanzhi Su, Cynthia Hou
similarity 0.48
Abstract · 28 pages,14 figures

Air-conditioning and road-traffic noise are common in classrooms, and their effects are often judged by cognitive performance. However, a sound that leaves performance unchanged may still be perceived differently or alter brain activity. In a within-participant design, this study tested whether perceived, cognitive, and EEG responses are consistent, and whether perceived and EEG responses distinguish conditions that performance does not. Sixteen students completed cognitive tasks in a university classroom under air-conditioning and road-traffic noise, each played back at 55, 60, and 65 dBA. Participants rated acoustic appraisal and perceived workload after each condition, and EEG was recorded during the tasks. The results show that cognitive performance did not differ significantly between conditions in any task. By contrast, noise was rated louder, less pleasant, and more arousing than a no-noise control, and all three ratings varied with sound level; perceived workload was also higher under noise. Task-period EEG power also showed significant differences between sources or levels in specific tasks and scalp regions. Within participants, relative EEG band power covaried mainly with loudness and pleasantness; louder and less pleasant ratings coincided with higher relative theta and lower relative gamma power. Associations with arousal and performance were rare, and none were found for workload. The three response types were thus only partly consistent, and perceived responses and EEG distinguished conditions that performance did not. Non-significant performance differences do not mean the conditions were equivalent for students. Assessments of air-conditioning and road-traffic noise in classrooms should therefore consider perceived responses alongside cognitive performance, with EEG providing complementary information on neural activity during tasks.

0.32

Sensing Bone-Conducted Speech with Earbuds

eess.AS ·2026-09-02 ·Christoph Weyer, Peter Jax
published similarity 0.46
Abstract · 14 pages, 12 figures, journal

Clear capture of the wearer's own voice (OV) is essential when using earbuds for mobile communication. However, OV capture remains challenging in noisy environments. Bone-conducted (BC) speech, which can be sensed as vibrations of the earbud housing, can be used to improve OV capture. However, neither bandwidth nor spatial characteristics of OV-induced earbud vibrations have been analyzed in detail, despite both characteristics being relevant, e.g., for sensor choice and placement. This study investigates both characteristics, based on measurements with two earbud models. Spectrally, results indicate that OV-induced earbud vibrations exhibit a low-pass characteristic, with a steep roll-off of -93 dB per decade above 400 Hz. Thus, sensors with comparatively low noise floors are required to sense the vibrations above \SI{1}{\kilo\hertz}. Spatially, results indicate that the earbuds mainly vibrate in and out of the ear canal entrance, with high consistency between subjects and fits. Simulations confirm that this enables capture of the high-power vibrations below 400 Hz by a single-axis sensor with less than 1.5 dB mean attenuation.

0.39

Active noise cancellation extends the benefit of AI speech enhancement in real hearing-aid recordings

eess.AS ·2026-10-12 ·Andrew T. Sabin, Linkai Li
similarity 0.44
Abstract · 8 pages, 5 figures, 1 table

Active noise cancellation (ANC) is common in headphones but rare in hearing aids, and its value for understanding speech in noise is not established. Algorithms that improve signal-to-noise ratio (SNR) act only on the hearing aid's amplified path, while unprocessed sound also reaches the eardrum directly through the vent, limiting the SNR improvement that is realized. Our earlier simulations predicted that attenuating this direct path with ANC would substantially increase the benefit of such processing. We tested that prediction in three hardware conditions: a standard receiver-in-canal (RIC) hearing aid, and an ANC-capable RIC with ANC off and on. Each was fit to NAL-NL2 targets for an N3 hearing loss and recorded on KEMAR with an AI speech-enhancement algorithm (AI-SE) off and on, in seven realistic scenes above 70 dB SPL. Speech and noise spectra were estimated from each recording with a binary time-frequency mask derived from the clean speech. AI-SE produced a similar peak benefit of about 4 dB in the high frequencies in all three conditions, but that benefit stayed at or above 1 dB only above 1500, 600, and 130 Hz for the standard RIC, ANC RIC (ANC off), and ANC RIC (ANC on), respectively, closely tracking the measured attenuation of the direct path. With AI-SE on, ANC RIC (ANC on) improved SII-weighted SNR by 5.1 dB relative to the open ear, compared with 3.3 dB for ANC RIC (ANC off) and 1.6 dB for the standard RIC. With AI-SE off, enabling ANC added only 0.2 dB. ANC is therefore an enabling technology: on its own it added little, but by attenuating the direct path it allowed SNR-enhancing processing to deliver substantially greater benefit at the eardrum, extending that benefit to much lower frequencies.

0.21

"What's That Sound?": A Versatile, Robust, and Lightweight Convolutional Transformer for Environment Sound Recognition

cs.SD cs.LG ·2026-08-16 ·Julia Huang
published similarity 0.44
Abstract · 6 pages, 7 figures, published to IYRC Conference Proceedings

The conventional hearing aid is both costly and lim- ited in usage, as it is not intended to detect non-speech audio. Our objective is to develop a machine learning solution to provide a more accurate and affordable mechanism to identify surrounding sounds to improve the safety of the hearing impaired, i.e., if a car is honking behind pedestrians, or a gunshot is fired, and they need to move away from the source. By adding randomized augmentations to audio, concatenating a Mel-Frequency Cepstral Coefficients (MFCCs) diagram and a log-mel Spectrogram, and including Convolutional Neural Networks (CNNs) in a Trans- former architecture, the Randomized Audiomentational Layered Convolutional Transformers (RALCT) model efficiently extracts features from diversified audio representations. In addition, RALCT is small enough, with only approximately 310,000 parameters, to be deployed into mobile devices. Experimental results on the UrbanSound8K dataset resulted in an accuracy consistently over 93% for all variations of RALCT with the highest at 94.56%, reaching state-of-the-art levels. To leverage the capabilities of this technology, a mobile app is developed to be integrated with the model to provide real-time safety control. RALCT thus represents a robust, lightweight, affordable, and versatile deep learning tool to aid the navigation and safety of the hearing impaired.

0.23