CS Paper Radar

Track-conditioned Residual Frequency Estimation For Low-resolution FMCW Radar

Huy Trinh, George Shaker

eess.SP ·submitted 2026-09-24 17:26 UTC · v1

Abstract

Low-resolution FMCW radar normally forms a complete range-Doppler representation before detection and tracking. After association, however, the tracker already predicts the target's next range and radial velocity. We propose track-conditioned residual estimation (TCRE), which removes the predicted moving-target phase before spectral formation, summarizes each 64-sample chirp by four coherent complex sums, and estimates the remaining beat-frequency and Doppler-frequency errors from phase progression. We account for the first-order fast-time and slow-time coupling of a moving target and derive the local phase-unwrapping region and three-receiver local information bound. Four summaries retain 93.77 percent of the zero-residual fast-time information while reducing the retained representation by a factor of 16. In 5,000 matched 60-GHz cluttered simulations, TCRE reduces range RMSE by 32.8 to 46.3 percent and velocity RMSE by 58.6 to 71.0 percent relative to a fully specified same-prior residual ZFFT.

Closest papers

Nearest neighbours by meaning across the whole index.

Waveform Bandwidth and Frequency Diversity in FDA-MIMO Range-Angle Estimation: A CRLB Perspective

eess.SP ·2026-10-28 ·Guoqing Xia, Qu Luo, Yu Liu, Pei Xiao, Cicek Cavdar +1 more
theory similarity 0.64
Abstract · 14 pages, 10 figures

Frequency-diverse array multiple-input multiple-output (FDA-MIMO) radar introduces range-dependent phase diversity through element-dependent carrier-frequency offsets, in addition to the delay information carried by transmitted waveforms. This paper develops a bandwidth-aware Cramer-Rao lower bound (CRLB) framework to characterize how these two mechanisms jointly affect range-angle estimation. Starting from a Nyquist-rate sampled observation model that retains waveform delays and FDA frequency offsets, we derive an equivalent Fisher information matrix (EFIM) after eliminating an unknown quasi-static complex scattering coefficient as a nuisance parameter. We derive closed-form CRLB approximations that reveal the interplay between waveform root-mean-square (RMS) bandwidth and FDA frequency diversity. A three-factor decomposition of the squared normalized cross-information further characterizes range-angle coupling. Results show that when increased independently, both waveform RMS bandwidth and FDA frequency diversity reduce the range CRLB, but FDA frequency diversity increases the angle CRLB at fixed nonzero waveform bandwidth, whereas waveform RMS bandwidth reduces it. Additionally, under a fixed aggregate spectral budget, the range CRLB exhibits an interior maximum, whereas the angle CRLB increases monotonically with the FDA spectral-allocation fraction. Numerical results corroborate the closed-form approximations and the predicted trends.

0.34

Continuous-Phase Frequency-Hopping MIMO Signaling and Processing for ISAC

eess.SP ·2026-10-16 ·Yi Wang, Xianxiang Yu, Jing Yang, Tao Fan, Linlong Wu +2 more
similarity 0.63
Abstract · 22 pages, 13 figures, including appendices

Frequency-hopping MIMO integrated sensing and communications (FH-MIMO-ISAC) supports agile multidimensional signaling but faces challenges in phase-continuous transmission, demodulation without channel-phase information, and coherent processing of multi-frequency echoes. We propose a continuous-phase frequency-hopping (CP-FH) MIMO ISAC waveform with matched communication and radar processing. Information is conveyed jointly by frequency combinations and continuous-phase-modulation symbols. CPM phase accumulation and frequency-hopping linear-frequency-modulation phase compensation maintain phase continuity and reduce spectral leakage. We derive exact inter-element orthogonality conditions, residual cross-correlation bounds, and a bound on averaged transmit-beampattern ripple. For communication, projection-energy demodulation requires no channel-phase information and approximates least-squares detection under weak inter-branch correlation. It separates frequency-combination search from CPM-symbol decisions, reducing complexity while retaining direct joint-search decisions. For radar, structure-matched coherent processing combines space-time-frequency matched filtering, velocity-consistent Doppler focusing, and frequency-aperture focusing to form a three-dimensional coarse-range--velocity--fine-range response. It reduces Doppler-mismatch loss and extra detections from periodic range grating lobes in conventional pulse-Doppler processing. We further derive the joint range response, output signal and noise powers, and receive beampattern. The analysis characterizes target-discrimination limits under periodic ambiguity and shows that the proposed processor preserves frequency-aperture range resolution and full-aperture angular resolution, with equal output noise power under the stated conditions.

0.31

Fast Whittle Maximum-Likelihood Parametric Spectrum Estimation for Weather-Radar Doppler Moments

eess.SP ·2026-10-06 ·Tworit Dash, Alexander Yarovoy
published similarity 0.62
Abstract · 4 figures, 1 table

The computational cost of Whittle maximum-likelihood parametric spectrum estimation (PSE) for short-dwell weather-radar Doppler moment retrieval is addressed. PSE can reduce finite-sample bias, especially for short coherent processing intervals and broad spectra, but repeated likelihood evaluations make direct use expensive. A fast implementation of the finite-sample Gaussian Doppler model is introduced by writing the likelihood in terms of closed-form autocorrelation lags and synthesizing the model spectrum and analytic derivatives by fast Fourier transforms (FFTs) on the same N-point grid as the periodogram. The estimator is extended to jointly estimate total power, normalized mean Doppler frequency, and normalized spectral width. Monte Carlo simulations with 1000 noise realizations show that the fast PSE keeps the accuracy advantage of the original PSE, while objective-level timing confirms the reduction from dense lag-to-frequency synthesis to FFT-based evaluation.

0.36

Doppler-aided Position-Velocity Tracking of Hidden Objects using mmWave Radar

cs.RO cs.CV ·2026-10-25 ·Yerin Cheon, Kush Garg, Akshat Dave
benchmark similarity 0.61
Abstract · 8 pages, 8 figures

Safe indoor operation requires autonomous tracking of objects that are not directly visible to the robot. Optical non-line-of-sight (NLoS) methods depend on ambient lighting and scene geometry or on weak multi-bounce returns that need long acquisitions. Millimeter-wave (mmWave) radar offers an attractive alternative: walls act as reflectors for mmWave signals, and frequency-modulated continuous-wave (FMCW) radars enable fast, practical measurement of range, angle, and velocity. However, the low resolution of these radars leads to spatially ambiguous observations. The Doppler information, although particularly sensitive to target motion, remains underexplored in indoor NLoS localization: existing methods emphasize spatial representations and either collapse or discard the Doppler dimension before learning. To leverage the complete Range-Azimuth-Doppler (RAD) information, we acquire the first indoor NLoS radar dataset that pairs sequential RAD measurements with synchronized position and velocity ground truth under controlled variations in motion: 576 sequences totaling 720,856 frames across 12 trajectories of a mobile robot moving along varying speeds, starting positions, and material configurations. We then formulate NLoS tracking as sequential position-velocity estimation rather than frame-wise localization: a shared 3-D encoder processes the full RAD representation of consecutive frames, separate recurrent branches estimate position and velocity, and post-inference refinement combines the two into a motion-consistent trajectory. Our method achieves 8.95cm position and 1.75cm/s velocity errors on held-out trajectories and generalizes to unseen scenarios involving a moving human target. Together, our dataset and tracker establish a benchmark for tracking hidden moving targets with a low-cost radar.

0.19

Dual-Parabola Interpolator: A Low-Bias Peak Estimator for Distributed Radar Synchronization

eess.SP ·2026-11-10 ·Matteo Pardi, Giulio Meucci, Francesco Mancuso, Anna Lisa Saverino, Amerigo Capria
similarity 0.61
Abstract · 6 pages, 7 figures. Submitted for peer review as a conference paper

Coherent distributed radar processing requires accurate wireless synchronization. Two-way time transfer (TWTT) obtains reception timestamps from sampled matched-filter peaks, but interpolation bias limits accuracy even when noise is reduced by higher signal-to-noise ratio (SNR) or averaging. Three-point parabolic interpolation is attractive for its simple, explicit formula; reducing its bias generally requires more elaborate fitting, such as higher-order polynomials, or a model tailored to a particular peak shape. A practical alternative should retain this simplicity and interpretability while approaching the low bias of more flexible fits. We propose the Dual-Parabola Interpolator (DPI), which combines two parabolic estimates from five amplitude samples near the matched-filter peak. An adaptive weight cancels the leading interpolation error without requiring a waveform-specific peak model or a correction table. Simulations over flat and standardized multipath channels show bias comparable to a five-point quartic fit, with essentially the same standard deviation as the other interpolators and an execution cost close to a three-point parabolic fit. This combination is useful for TWTT in urban or other multipath settings, where channel distortion prevents reliance on a nominal peak shape.

0.31

Over-the-Scene Computation: Illumination-Programmed Functional Sensing of Unresolvable Populations

cs.IT cs.ET ·2026-11-05 ·Seyed Mohammad Azimi-Abarghouyi, Christopher G. Brinton
similarity 0.60
Abstract

Decisions about dense populations depend on how much will cross a boundary by a deadline and when the first member arrives. Conventional radar forms a range-Doppler map, whose cells add noise and whose detections merge unresolved members. We introduce over-the-scene computation, where illumination makes the scene compute such functionals without resolving members. With random echo phases, a correlator's mean output energy sums member reflectivities weighted by a kernel set by the waveform and template. The waveform's ambiguity function is this computation's transfer function, determining computable functionals and their noise cost. One readout aggregates members over a small delay-Doppler area but along a line segment growing with duration, longest for the chirp of matching slope among constant-envelope waveforms. Members predicted to share a range lie on such a line, so a chirp's mean beat spectrum is the predicted range profile at a look-ahead horizon set by its rate. For unbiased estimation, a Cramer-Rao bound over all equal-energy waveforms favors resolving members above unit signal-to-noise ratio (SNR) and grouping weaker ones into unit-SNR sets. At 0.65 members per cell, -10 dB member SNR, and one sweep, the chirp's bin sum inside the boundary comes within 16% of this bound in root-mean-square error and, with 77 times fewer samples per horizon, outperforms every unbiased estimator from a coherent processing interval of equal dwell, bandwidth, and energy. No finite set of waveform-template probes determines an unconstrained Rayleigh-fluctuating population's first arrival, but bisection localizes it if first arrivals outweigh later arrivals' sidelobes.

0.34

A Four-Branch Radar Target Simulator with Fractional Delay on a PlutoSDR

eess.SP ·2026-11-11 ·Florian Euchner, Stephan ten Brink
code/data similarity 0.60
Abstract

Repeatable test setups support the development and evaluation of integrated sensing and communications (ISAC) hardware and algorithms. Commercial radar target simulators are expensive, while sub-6 GHz ISAC experiments often need only tens of megahertz of bandwidth within their available spectrum allocation. This makes simpler, low-cost test hardware attractive. We present a low-cost, open-source radar target simulator based on an ADALM-Pluto without hardware modification, supporting four independently configurable targets and analog bandwidths up to 56 MHz. The FPGA generates echoes with independent delays, Doppler shifts and gains, using fractional-delay filters for sub-sample adjustment. For motion-consistent echoes, delay and carrier phase are updated together to reproduce both changing range and frequency-dependent Doppler shifts. Over-the-air measurements demonstrate simultaneous echoes, sub-sample delay adjustment, and smooth target motion between sample positions. The FPGA source, firmware and on-device web interface are publicly available.

0.38

Prediction-Induced Sparsity for Tracked FMCW Radar: A Track-Conditioned Event-Gap FPGA Architecture

eess.SP ·2026-10-30 ·Huy Trinh
similarity 0.59
Abstract

Tracked FMCW radar already carries a prediction of the next target state, yet the downstream digital hardware is commonly provisioned for a fixed spectral search. We present prediction-induced sparsity (PIS), a tracked-mode architecture that uses the prior before event formation and hardware scheduling. The predicted beat is derotated to an innovation-centred coordinate, while tracker covariance is propagated to a bounded residual support K. Sparse level-crossing packets are then executed by an exact event-gap resonator engine with a shared complex processing element and K-dependent state/coefficient memory. On a public FMCW dataset, causal prior-only con- ditioning reduces event records by 33.1% on average, and the representative fixed-point stream is bit-exact in RTL. And on an Artix-7 implementation, reducing physical support from 129 to 23 states lowers LUT and BRAM use by 65.0% and 88.1%, respectively, and reduces measured VCCINT power by 19.9% at matched throughput. The results show how tracking uncertainty can become a hardware-capacity implication for future adaptive radar accelerators.

0.28