CS Paper Radar

Performance Evaluation of Emerging Networks of Quantum Repeaters: Analysis and Simulation

Kobi Ravid, Javad Ghaderi, Gil Zussman

cs.NI ·submitted 2026-10-02 04:08 UTC · v1

Abstract

Emerging experimental quantum network deployments are based on collaborations between research institutions and rely on telecommunications fiber infrastructure. Currently, such networks consist of mostly Dual Input Repeaters (DIRs) and can be viewed as composed of (mostly) line graphs. In order to evaluate the performance of such networks (e.g., in terms of Entangled Pair Rate, EPR, and average Fidelity) we developed a custom quantum network simulation platform that takes into account both the quantum and classical network components. To support the verification of the simulation results, we develop a novel approach for performance analysis of DIRs. We compare the simulation results to the analytical results for DIRs and to prior results for repeaters with more than two inputs. We observe that although the expected memory utilization cannot be bounded, \emph{a small DIR memory size is sufficient and leads to minimal performance degradation}. For line networks with a single repeater and $3$ repeaters, we explore the dependency of incoming and outgoing memory size requirements on the number of nodes (network size), their connectivity (fiber length) and various quantum error settings (amplitude damping and phase flip channels). We evaluate the \emph{EPR} and the \emph{average Fidelity} for a sub-network of a deployed network with $3$ repeaters, using two alternative paths. We show that as the number of nodes increases or when the fiber lengths between nodes differ significantly, additional node memory is needed to maintain the same EPR (qubits are stored for longer duration to allow completion of entanglement across the network). We also show that the memory size should be above some minimum threshold to allow EP creation (EPR $>0$) as pair selection and swapping completion propagate across the network.

Closest papers

Nearest neighbours by meaning across the whole index.

Practical wavelength selection for quantum-augmented networks over shared optical fiber

cs.CR quant-phcs.NI ·2026-10-14 ·Nitin Jha, Prateek Paudel, Abhishek Parakh
theory similarity 0.65
Abstract

In a quantum augmented network, sharing optical fiber with classical traffic requires quantum wavelength selection to balance logical fidelity, block acceptance, and classical data reception. Here we develop a wavelength-selection framework for an error-corrected three-stage quantum communication protocol. Under a thermal-background model with independent errors, an ideal one-photon receiver, and ideal recovery, we derive an accepted qubit channel and a key-independent lower bound on logical entanglement fidelity. Combining this bound with block acceptance gives an entanglement-fidelity yield bound, which we maximize over evaluated wavelengths subject to fidelity and classical link-budget requirements. For the Steane [[7,1,3]] code at 5 km per traversal and -10 dBm per classical channel, the largest fidelity certificate occurs near 1537 nm, whereas the largest yield bound occurs near 1551 nm. Along the 1.25 Gb/s classical link budget with 0.2% base error, the optimized yield bound falls below 10^-6 near 10 km per traversal, while fidelity remains certified at 0.99 or higher at longer spans. These results distinguish fidelity and yield constraints and identify certified operating regions for quantum-augmented networks sharing optical fiber.

0.18

Utility-Based Path Selection and Configuration in Quantum Networks via Layered Shortest Paths

cs.NI quant-ph ·2026-09-14 ·Leonardo Bacciottini, Subhransu Maji, Don Towsley, Gayane Vardoyan
theory similarity 0.63
Abstract · 13 pages

A path in a quantum network is a chain of repeaters that distributes entanglement between two users. Selecting a path requires balancing the rate and quality (e.g., fidelity) of the delivered entanglement, but these quantities, unlike standard routing metrics, compose non-additively. The problem is compounded by link-level configuration choices (e.g., distillation rounds or emitter brightness tuning), each trading rate against fidelity, so that a path's performance depends jointly on its route and its per-link settings. We cast this joint path selection and configuration problem as a shortest path computation on a layered graph whose layers track discretized end-to-end fidelity. A single run returns the full rate fidelity Pareto frontier, from which the path maximizing any nondecreasing utility function of rate and fidelity can be selected. We prove that for certain utility functions (including the secret key rate of BB84), the method is a fully polynomial time approximation scheme, returning a near-optimal path within a specified tolerance. We further characterize exactly when cheaper scalarization-based routing suffices: it is optimal for utility functions with convex fidelity profiles, but can be arbitrarily suboptimal otherwise (e.g., for step-like, sigmoidal utilities), whereas the layered method remains reliable in all cases.

0.23

ReFINE: Scheduling of Distillation and Coding for Rate-Fidelity Tradeoff in Quantum Networks

cs.ET quant-ph ·2026-09-17 ·Narges Alavisamani, Matthieu Bloch, Moinuddin Qureshi
similarity 0.61
Abstract

In quantum networks, nodes are connected via sharing of Einstein-Podolsky-Rosen (EPR) pairs, ideally with high fidelity and high rate. However, the fidelity of EPR pairs degrades due to imperfect generation and decoherence errors. Entanglement Distillation is a method that increases the fidelity but operates probabilistically and may destroy all involved EPR pairs upon failure. This failure reduces available EPR pairs for application use, thereby decreasing the service rate. Quantum Error Correction (QEC) is another mechanism to protect EPR pairs against error by forming what we term as Coding-Enhanced Memory (CEM). While effective, CEM requires extra time and resources to form the code, which also reduces the service rate. Existing methods often use static combinations of distillation and CEM, ignoring demand variations. This results in a low service rate without significant fidelity gain. Limited resources together with this rate-fidelity tradeoff make it essential to schedule when to run distillation, form CEM, or serve requests. We propose ReFINE, a demand-aware preemptive scheduler that based on application requirements either serves an available EPR pair immediately or preserves it in CEM. This selective use of CEM, only when needed, enables a better balance for rate-fidelity tradeoff than always using CEM. Between request arrivals, ReFINE either schedules distilling EPR pairs or forming CEM to protect distilled pairs, following one of the three priority policies: ReFINE-D (Distillation-First) first generates EPR pairs for distillation and then forms the CEM, prioritizing service rate. ReFINE-M (Memory-First) first forms the CEM, then generates the EPR pairs for distillation, prioritizing fidelity. ReFINE-C (Concurrent) performs both distillation and CEM formation concurrently, balancing between fidelity and service rate.

0.11

Optimal Entanglement Routing in Quantum Repeater Chains: Beyond Fixed Operation Order and Purification Schedule

cs.NI quant-ph ·2026-09-29 ·Aikaterini Mandilara, Antonia Tsili, Dimitris Syvridis, Konstantinos Christodoulopoulos
theory similarity 0.61
Abstract · 21 pages, 9 figures

Entanglement routing establishes entangled pairs between distant nodes of a quantum network by purifying and swapping pairs generated on elementary links. Existing methods typically restrict the decision space along two axes: the operation order, often fixed to purify-then-swap (PtS), and the purification schedule of each link, often restricted to pumping. Focusing on linear repeater chains with finite link capacities, we relax both restrictions and study the maximization of the expected end-to-end throughput subject to a fidelity threshold under two quantum-noise models. We develop a unified capacity-aware optimization framework comprising an exact mixed-integer linear program (MILP) under PtS, instantiated with either pumping or general tree purification schedules, and an exact dynamic program (DP) over arbitrary operation orders. Under symmetric Pauli noise, we prove that pumping converges to a fidelity strictly below unity, imposing a capacity-independent feasibility bound and a maximum chain length on every pumping-based PtS method, whereas general tree schedules yield a capacity-dependent bound. We further prove that post-swap purification never increases the throughput, so a free operation order can only increase feasibility. Numerical evaluations confirm the bounds: tree schedules serve over 90\% of the requests that pumping cannot at moderate fidelity thresholds; within the pumping class, a free operation order recovers much of this advantage; but once links use tree schedules, the tree-based MILP and the order-exact DP serve identical request sets throughout. Operation order and purification schedule are thus substitutes, with the purification schedule the dominant factor governing feasibility under symmetric Pauli noise.

0.24

Distributing Quantum Circuits Using Pre-Distributed Entanglement Pairs over Quantum Networks

cs.ET quant-ph ·2026-10-19 ·Yukun Yang, Ranjani G. Sundaram, Himanshu Gupta
publishedbenchmark similarity 0.60
Abstract · 9 pages, 4 figures. Full author version revised after acceptance; includes the cost-aware entanglement consumption section omitted from the …

Distributing quantum circuits across a network of quantum devices is a recent approach to improve the scalability of quantum computation. Entangled pairs of qubits distributed across network nodes are used as a communication resource for executing inter-node (remote) gates. However, establishing these entanglement pairs incurs significant latency, and doing so during the circuit's execution may lead to the decoherence of logical qubits. Instead, it may be beneficial to distribute certain entanglement pairs before the circuit is executed. Thus, we consider the problem of distributing a quantum circuit across a quantum network containing some pre-distributed entanglement pairs and seek to minimize the execution time of the circuit. We address this problem in three steps. First, given the quantum network and (optionally) a probability distribution over training circuits, we determine a set of pre-distributed entanglement pairs under a specified budget. Second, we compute a qubit-to-memory allocation that minimizes the expected execution time given these pre-distributed resources. Finally, we identify any additional entanglement pairs required during execution, generate them concurrently, and execute the circuit gates. We evaluate our methods on a broad range of benchmark circuits.

0.46

EPR Count for Runtime Prediction in Distributed Quantum Computing

cs.DC quant-ph ·2026-09-30 ·Fatih E. Bilgen, Ozgur B. Akan
similarity 0.60
Abstract · 8 pages, 5 figures, conference

EPR-pair consumption is commonly used as a communication-cost objective in distributed quantum computing, but minimizing EPR cost does not necessarily minimize distributed execution time. Despite its widespread use, the reliability of EPR count as a runtime surrogate has received limited direct characterization across different workloads and communication conditions. This work addresses this gap by systematically evaluating the relationship between EPR cost and runtime over all balanced two-QPU mappings of QFT, QAOA, and CDKM circuits. The results show that mappings with identical EPR cost can have substantially different execution times, lower-EPR mappings can be slower, and minimum-EPR mappings can be runtime-suboptimal. The reliability of EPR count is strongly workload dependent and also changes with the communication operating regime: increasing EPR-generation latency amplifies runtime differences hidden by equal EPR cost, while increased communication concurrency can reduce the ability of EPR count to preserve runtime ordering. These results show that EPR count and execution time are related but distinct optimization objectives, and identify regimes in which explicit communication-aware runtime modeling is necessary.

0.16

Multi-Pair Fidelity-Aware Rate Allocation in a Quantum Network: Approximation Schemes

cs.NI ·2026-08-11 ·Zunzheng Zhang, Xuanli Lin, Zhaofeng Zhang, Nageswara S. V. Rao, Guoliang Xue
theory similarity 0.60
Abstract

Entanglement distribution in quantum networks must jointly account for limited link capacities, probabilistic entanglement swapping, and heterogeneous link fidelities. In this paper, we study multi-pair fidelity-aware rate allocation in quantum networks. We formulate three rate-allocation problems: rate sum, rate sum subject to minimum-rate constraints, and max-min fairness. Prior work has studied a special case of the rate sum problem, where all links have identical fidelity. This special case admits a polynomial-time algorithm. We prove that all three problems are NP-hard. We then study optimization versions of these problems which maximize the minimum end-to-end fidelity subject to throughput or fairness requirements. We present fully polynomial-time approximation schemes (FPTAS) for solving these optimization problems. Experiments on randomly generated networks demonstrate the computational effectiveness of the proposed schemes.

0.04

Quality-of-Transmission Estimation in Quantum Networks: Compute, Simulate, or Learn?

cs.LG quant-phcs.NI ·2026-10-16 ·Anis Bekri, Amar Abane, Van Sy Mai, Abdella Battou, Saddek Bensalem
similarity 0.60
Abstract

Future quantum networks will rely on control-plane decisions such as routing, scheduling, entanglement provisioning, purification, and memory allocation. Each decision depends on a timely and reliable estimate of the quality of the entanglement that a candidate path can deliver, with end-to-end fidelity as a central metric. Inspired by the optical-networking experience with quality-of-transmission (QoT) estimation, this article asks when a quantum controller should compute fidelity analytically, simulate it, or learn a surrogate model. The optical analogy is useful but incomplete: optical QoT estimation often predicts a scalar transmission margin, whereas quantum QoT estimation must account for probabilistic entanglement generation, random memory waiting times, decoherence, state consumption, and measurement constraints that can make fidelity a stochastic target. We propose a compute/simulate/learn framework for quantum QoT estimation and illustrate it with a simulation-based proof of concept. Our study shows that analytical composition can be sufficient in simple regimes, that simulation becomes necessary when stochastic memory effects shape the delivered fidelity distribution, and that lightweight learned surrogates can approximate simulator labels at much lower runtime cost for online control. We close with open challenges for deployment, including stochastic targets, sim-to-real transfer, data-generation cost, physics-informed learning, and generalization beyond individual paths to full network topologies.

0.18