CS Paper Radar

Delay-Doppler Duality: Simplifying Exact Equalization of Zak-OTFS in Time or in Frequency

Mudasir Ahmad Sheikh, Robert Calderbank

cs.IT eess.SP ·submitted 2026-10-12 01:06 UTC · v1

Abstract

The Zak-OTFS carrier waveform is a pulse in the delay-Doppler (DD) domain, and given the input-output (I/O) relation at one DD point in a frame, we can predict the I/O relation at all other points. While it is simple to acquire the effective wireless channel with Zak-OTFS, the cost of embracing inter-carrier interference is equalization complexity. The cost of linear minimum mean-square error (LMMSE) equalization grows cubically with the frame size. We describe how to use channel knowledge to reduce equalization complexity. For any pulse shaping filter, and for fractional delays and Dopplers, we show that the DD channel matrix is unitarily similar, through the discrete Zak transform, to a time-domain (TD) matrix that is a weighted sum of cyclic delay and Doppler operators, where the weights are the taps of the effective channel. We also obtain a dual frequency-domain (FD) form through an additional Fourier transform. The TD matrix is banded with a width set by the delay spread that is independent of the Doppler spread, whereas the FD matrix is banded with a width set only by the Doppler spread. We design a receiver that reads off the two widths from the channel estimate, selects the cheaper domain, and solves the banded system exactly, using a bordered Cholesky factorization that treats the quasi-periodic wrap-around without sacrificing degrees of freedom. Filters that decay slowly need a few preconditioned conjugate gradient steps. We show that the complexity of equalization becomes linear in the frame size. Simulations match direct DD-LMMSE error rates with three to four orders of magnitude fewer multiplications. A single receiver handles channels with very different delay and Doppler characteristics.

Comment
12 pages, 9 figures, 3 tables

Closest papers

Nearest neighbours by meaning across the whole index.

Low-complexity Equalization of Zak-OTFS Via Neumann Series

eess.SP cs.IT ·2026-10-07 ·Vineetha Yogesh, Saif Khan Mohammed, Sandesh Rao Mattu, Ronny Hadani, Robert Calderbank
similarity 0.77
Abstract

We describe a general method for selecting an orthonormal basis of carrier waveforms that aligns the basis with delay / Doppler characteristics of a wireless channel. We show that our method enables low-complexity equalization for two channels of practical interest. The first is satellite communication and the second is communication from a ground station to an unmanned aerial vehicle (UAV). After Doppler compensation both scenarios are characterized by a first line of sight (LOS) path with zero delay and zero Doppler shift, and a second weaker path. We show that our method is robust to fractional delay and Doppler shifts. We consider orthonormal bases of carrier waveforms that are obtained from the pulsone basis of Zak-OTFS carrier waveforms by applying a generalization of the discrete affine Fourier transform (GDAFT). This family of waveforms includes AFDM and other modulations proposed for 6G. What distinguishes these bases is that the carrier waveforms are common eigenvectors of some maximal commutative subgroup S of a Heisenberg-Weyl group of discrete delay and Doppler shifts. We describe how to choose S to mitigate the damaging effects of interference between carriers. We represent the wireless channel by delay-Doppler taps and observe that a channel tap located within S multiplies every waveform by a complex phase. If all channel taps are located within S, then the channel multiplies every waveform by a complex phase, and a single tap equalizer supports reliable communication. This is the case for a linear time-invariant (LTI) channel, where S is the group of discrete time shifts and the carrier waveforms are discrete tones (OFDM). In general, we choose the subgroup S to maximize the diagonal component of the channel energy.

0.30

On Diagonalizable Delay-Doppler Channels and Their Diagonalizing Waveforms

cs.IT eess.SP ·2026-08-31 ·Sirui Li, Cheng Du, Yu Zhu
similarity 0.73
Abstract · Submitted to Information Theory Workshop (ITW) 2027

In doubly selective channels, the joint delay and Doppler dispersion generally induces coupling among transmitted symbols, thereby increasing receiver equalization complexity. Nevertheless, by using appropriately designed waveforms, channels with certain delay-Doppler (DD) supports can be diagonalized for one-tap equalization. The whole picture of such DD supports and their corresponding waveforms is still unclear, except for several examples identified in literature. In this paper, under cyclic-prefix (CP)-based block transmission and assuming that the modulation waveforms form an orthonormal basis, we identify all such channel supports by an elementary expression, and derive the corresponding waveforms in closed form.

0.39

Channel Estimation for OFDM via Delay-Doppler Refinement

cs.IT ·2026-09-09 ·Mingcheng Nie, Hao Chang, Xiaoqi Zhang, Junkai Liu, Wibowo Hardjawana +2 more
similarity 0.64
Abstract

In this paper, we propose a novel channel estimation (CE) algorithm for orthogonal frequency division multiplexing (OFDM) systems that exploits the unique characteristics of the delay-Doppler (DD) domain channel. Specifically, the time-frequency (TF) domain input-output relationship (IOR) is derived in a compact form by focusing solely on the non-zero elements of the TF domain channel matrix. Based on this compact IOR, a coarse TF domain CE is first performed using a linear minimum mean square error estimator. Then, the resultant TF domain estimates are transformed to the DD domain through a unitary transformation for further refinement. We reveal that the effective DD domain channel matrix can be viewed as an aggregation of multiple DD domain channel responses with different phase shifts. This allows us to devise a threshold-based estimation for DD domain channel parameters with high accuracy. The estimated DD domain channel parameters are then applied to form a refined estimate of TF domain channel. Our numerical results demonstrate that the proposed method can achieve substantial performance gains over conventional OFDM channel estimation techniques under the same pilot deployment.

0.25

Sensing Fast and Distant Targets in Fractional Overspread Channels with Zak-OTFS and Modular Arithmetic

eess.SP cs.IT ·2026-10-29 ·Andrea Novero, Mudasir Ahmad Sheikh, Danish Nisar, Saif Khan Mohammed, Michele Zorzi +1 more
similarity 0.63
Abstract · 14 pages, 8 figures, 4 tables

Delay-Doppler (DD) modulations, such as Zak-transform-based orthogonal time frequency space (Zak-OTFS) modulation, represent the channel as a sparse set of delay and Doppler shifts, which makes them well suited for radar sensing. Sensing with a single DD frame, however, is unambiguous only when the channel spread factor, i.e., the product of the delay and Doppler spreads, is less then one. Long-range mobility scenarios, including drones, airplanes, low Earth orbit (LEO) satellites, and underwater acoustic links, typically violate this crystallization condition, so that a single frame aliases the target delays, Doppler shifts, or both. Existing methods add a time-frequency pilot to a conventional DD frame, resolve the aliasing in only one dimension, and assume integer delays and Doppler shifts. We propose a frame design that combines multiple DD bases with different delay and Doppler periods, which together cover an overspread channel with fractional delays and Doppler shifts, using the same bandwidth and frame size. We show that modular arithmetic on the peak positions uniquely recovers each target by pairing the peaks through their common projection and their gains, and we derive the condition under which this pairing is ambiguous. We implement the design with two superimposed Zak-OTFS frames and propose two receivers: dual-frame sensing (DS), which performs the joint detection directly, and DS with cross-pilot cancellation (DS-XC), which additionally cancels the cross-pilot interference, re-estimates the gains by joint least squares, and removes ghost targets. Both receivers maintain a detection rate close to one as the spread factor grows, and DS-XC also achieves the lowest false-alarm rate and channel estimation error among all the compared systems. In a 100 km drone scenario, DS-XC outperforms all baselines, with a complexity that grows near-linearly with the time-bandwidth product.

0.22

Optimized Mirabbasi-Martin Pulse Shaping Filter for Higher-Order Modulation in Zak-OTFS

cs.IT eess.SP ·2026-11-12 ·Naveed Bin Nazir, Ananthanarayanan Chockalingam
similarity 0.63
Abstract · Submitted to IEEE journal for possible publication

The performance of Zak-OTFS modulation depends critically on the delay-Doppler (DD) domain pulse shaping filter, which must support both accurate channel estimation and reliable data detection. Filters reported in the Zak-OTFS literature fall short in bit error rate (BER) performance for higher-order modulation due to sensitivity to model-free channel estimation errors and pilot-data interference. Motivated by this, in this paper, we introduce a separable two-dimensional Mirabbasi-Martin (MM) filter for Zak-OTFS and propose a filter coefficient optimization framework that minimizes the aggregate sidelobe energy while preserving the compact structure of the MM prototype. By trading exact Nyquist nulls for high localization, the optimized MM filter exhibits no sidelobes with the narrowest $-40$ dB DD domain pulsewidth compared to sinc, Gaussian, and GS pulses. This compactness of the optimized filter tightly confines the pilot energy within the pilot region of the embedded frame, ensuring that the full response is captured for model-free channel estimation while significantly reducing pilot-data interference. This yields both an improved estimation performance and a significantly improved BER performance for higher-order QAM. For the proposed filter, we derive closed-form expressions for the effective DD domain channel and the covariance of the receive-filtered noise, which drastically reduce simulation run times. Our simulation results demonstrate that the optimized MM filter achieves significantly better uncoded/coded BER performance for higher-order QAM compared to that of sinc, Gaussian, and GS filters. For example, for 64-QAM with M=32, N=48, rate-1/2 convolutional code, and TDL-A channel model with fractional DDs, the optimized MM filter achieves a coded BER of 3x10^{-4} at an E_b/N_0 of 40 dB, while the sinc, Gaussian, and GS filters exhibit error floors above 10^{-2}.

0.27

Channel Estimation for OTFS Systems With Overspread Doppler Shifts

cs.IT cs.ET ·2026-08-12 ·Preety Priya, Yi Hong, Emanuele Viterbo
top venue similarity 0.62
Abstract

In this paper, we consider an orthogonal time frequency space (OTFS) system in time-varying channels with overspread Doppler shifts, typically found in non-terrestrial multi-satellite links. The overspread Doppler shifts with magnitude greater than half of the subcarrier spacing, result in aliased Doppler shifts in the delay-Doppler (DD) domain due to the OTFS modulo operation. This makes channel estimation very challenging and the traditional channel estimation methods become ineffective. To address this challenge, we propose a DD training frame and a two-stage channel estimation method. The training frame comprises a cosine pilot signal and a pilot symbol. In the first stage of the channel estimation, the pilot symbol in the DD domain is utilized to estimate the delays, aliased Doppler shifts, and channel gains of the propagation paths. In the second stage, the received time domain signal is converted into the frequency domain to detect the peaks of all the Doppler shifts using the cosine pilot signal. Then, we present a threshold-based method to pair the estimated actual Doppler shifts with their corresponding delays and channel gains. The complexity of the proposed channel estimation is also discussed. Finally, the performance of the proposed channel estimation is validated in terms of the normalized mean square error (NMSE) and bit error rate (BER) in various scenarios.

0.29

Grid-Refinement SBL for AFDM Channel Estimation Under Fractional Delay and Fractional Doppler Channels

eess.SP ·2026-10-30 ·Qu Luo, Limin Liu, Zhe Li, Qihao Peng, Haowei Wu +1 more
published similarity 0.61
Abstract

This paper investigates channel estimation for affine frequency division multiplexing (AFDM) systems over channels with fractional delay and fractional Doppler (FDFD) shifts. An exact FDFD channel model is first established, and the corresponding input--output relationship is also derived. To address the FDFD-induced delay--Doppler coupling, a first-order linear approximation grid-refinement sparse Bayesian learning (FLA-GR-SBL) method is developed. To further remedy the convergence and stability issues caused by the limited accuracy of the first-order approximation, we propose a two-dimensional grid-approximation SBL (2D-GA-SBL) algorithm, which iteratively refines the delay--Doppler grid and thereby characterizes the channel more accurately. Simulation results demonstrate that the proposed algorithms significantly outperform existing on-grid and off-grid SBL benchmarks in terms of both normalized mean square error (NMSE) and bit error rate (BER).

0.38

Ultra-High Resolution Method for Multipath Within a Co-Delay-Doppler Bin in DFT-P-OCDM

cs.IT ·2026-09-04 ·Mingxuan Han, Weile Zhang, Feifei Gao
similarity 0.59
Abstract

Communication systems can reuse their transmitted signals for sensing without dedicated radar transmissions. For an established DFT-preprocessed orthogonal chirp division multiplexing (DFT-P-OCDM) waveform, this task becomes difficult when several physical paths in a doubly selective channel fall into the same co-delay-Doppler bin. In this case, the number of resolvable delay classes inferred from the pilot may be smaller than the number of physical paths within the co-bin. This mismatch increases the difficulty of path number determination, fractional Doppler offset estimation, and channel reconstruction. We derive a pointwise relationship between the input and output in the DFT preprocessed Fresnel (DPF) domain for doubly selective channels with multiple paths within the co-delay-Doppler bin. Based on this input and output relation, we propose the two stage ultra high resolution (TSUR) framework. The first stage uses pilots of the phase progression to estimate delay, while the second stage uses the leakage samples to estimate the Doppler and the number of paths within each delay class. Furthermore, we derive CRLBs and analyze how the pilot configuration trades sensing resolution and communication recovery. Simulation results demonstrate that TSUR resolves same delay paths within a co-delay-Doppler bin, remains robust to exist delay offsets, and achieves lower fractional Doppler estimation errors than sequential extraction and off-grid baselines.

0.25