CS Paper Radar

A Three-Axis Rydberg Atomic Receiver Model for Polarization-Based Direction-of-Arrival Sensing

Bangyan Xia, Bo Tan

eess.SP ·submitted 2026-10-13 14:21 UTC · v1
benchmark

Abstract

This paper develops a three-axis Rydberg atomic receiver model for direction-of-arrival (DoA) estimation of the radio frequency (RF) signal source. Three nominally orthogonal RF local oscillators (LOs), each assigned a distinct frequency offset, project the weak incident RF field into resolvable complex beat coefficients in the optical readout. A beat-vector observation is obtained by adopting a response calibration mechanism that maps the coefficients onto the three axes of the Cartesian coordinate system. For a known circularly polarised RF signal, this observation induces a direction-dependent Rydberg steering vector, enabling maximum-likelihood DoA estimation. The pro posed procedure translates the Rydberg beat-vector front end into a highly sensitive RF field DoA sensor. Simulation results show that trace-level beat extraction supports the proposed DoA sensing workflow and provides a basis for comparison with a traditional vector antenna (VA) benchmark.

Closest papers

Nearest neighbours by meaning across the whole index.

Linear Dynamic Range Extension for Rydberg Atomic Receiver via Band-Limited Reconstruction

eess.SP cs.IT ·2026-11-13 ·Meng Fang, Lebin Chen, Jun-Rong Chen, Ming-Min Zhao, Bin-Bin Wei
similarity 0.62
Abstract · 6 pages, 7 figures

Rydberg-atom receiver offers a promising approach to radio-frequency (RF) signal reception in wireless communication and sensing systems, combining high sensitivity with the potential for broad frequency coverage. However, the limited linear dynamic range (LDR) of the atomic system causes nonlinear distortion at high input signal levels, thereby restricting the receiver's effective linear input range. To address this issue, we analyze the mechanisms underlying nonlinear distortion in Rydberg atomic receivers and propose a physics-informed band-limited iterative reconstruction (PI-BLIR) method. Specifically, by exploiting the known nonlinear atomic response and signal bandwidth prior, we formulate a constrained maximum-likelihood problem to reconstruct the distorted complex intermediate-frequency (IF) waveform. With the bandwidth constraint absorbed into the frequency-domain parameterization, the constrained maximum-likelihood problem is transformed into an unconstrained optimization problem, which is solved using gradient descent. The proposed method relies solely on digital post-processing and requires no changes to the local-oscillator (LO) field strength, optical parameters, or atomic operating conditions. Simulation results demonstrate that PI-BLIR extends the receiver's LDR by more than 14 dB and enhances the demodulation performance of the atomic receiver.

0.19

Fundamental CRB-Rate Tradeoff of Rydberg Atomic Receivers for Integrated Sensing and Communication

eess.SP ·2026-10-06 ·Yin Zhang, Jiayi Zhang, Bokai Xu, Jieao Zhu, Bo Ai
similarity 0.58
Abstract

Integrated sensing and communication (ISAC) is a key technology for next generation wireless networks, requiring highly sensitive, compact receiver front ends with multiband coverage. Rydberg atomic receivers (RARs) provide a promising architecture that satisfies these requirements owing to their high sensitivity and continuous frequency tuning capability. Unlike in classical ISAC systems utilizing orthogonal resource allocation, executing concurrent multi band tasks within a single atomic ensemble relies on shared energy state transitions. Owing to this shared structure, the communication and sensing tradeoff in RAR-based ISAC introduces an atomic-response tradeoff beyond the classical subspace and deterministic-random tradeoffs. This paper studies a multi-branch RAR (MB-RAR) architecture for joint communication and radar sensing. By solving the five level Lindblad master equation at the local oscillator (LO) biased operating point and linearizing the communication and sensing radio frequency (RF) signals as small perturbations, we obtain the double-sideband dynamic signal response of the MB-RAR. The model reveals two intrinsic constraints. First, increasing the coupling laser strength broadens the response bandwidth but can weaken the atomic response. Second, strengthening one branch's LO can suppress the other branch's conversion gain through the shared Rydberg state, even when the latter's LO bias remains fixed, which is termed the inter band gain inhibition (IBGI). Based on these mechanisms, we formulate the achievable Cramér--Rao bound (CRB)-rate region and develop a rate-constrained joint search over coupling strength and LO power allocation. Numerical results validate the proposed response model and show that joint optimization provides a more complete characterization of the achievable CRB-rate region.

0.32

An Optical Pathway to Movable Rydberg Atomic Quantum Receivers

eess.AS ·2026-08-31 ·Qihao Peng, Qu Luo, Lixia Xiao, De Mi, Neng Ye +4 more
unusual similarity 0.57
Abstract

This paper develops an optically movable Rydberg atomic quantum receiver (RAQR), in which the probe and coupling beams are steered within each vapor cell to dynamically reconfigure the effective radio-frequency (RF) sensing position without mechanical actuation. A closed-form equivalent baseband model is derived by separating the atomic transduction coefficient, optical steering phase, and cell-center array response into distinct factors and the accuracy of the resulting model is validated against numerical solutions of the Lindblad master equation. Based on the derived model, we reveal two complementary channel-shaping mechanisms, including intrinsic beam-pattern shaping through RF-to-optical transduction and per-cell phase control enabled by optical displacement. To further exploit these capabilities, a non-convex sum-rate maximization problem is formulated over the optical positions and local oscillator design and solved via an alternating optimization framework with analytical gradients. Simulation results validate the derived model and demonstrate substantial performance gains enabled by optical movability, highlighting its potential as a programmable receiver architecture for future wireless networks.

0.39

BER-Aware Joint Parameter Optimization of Rydberg Atomic Quantum Receivers

eess.SP ·2026-09-03 ·Akash Kumar Mandal, Ming Shen
similarity 0.55
Abstract

Rydberg-atom quantum receivers (RAQRs) offer highly sensitive RF reception, but their communication performance depends jointly on atomic response, optical transduction, receiver noise, bandwidth, and wireless-channel conditions. This paper develops a BER-aware communication-theoretic framework for superheterodyne RAQR-assisted wireless communication, linking four-level Rydberg-atom dynamics and coherent optical detection to multipath propagation and digital communication performance. Closed-form instantaneous and average SNR and BER expressions are derived for square Gray-coded $M$-QAM over correlated Rayleigh fading. The RAQR operating point is then jointly optimized over atomic, optical, RF, and geometric parameters using analytical block-wise updates within a fixed-point procedure subject to physical and bandwidth constraints. Numerical results demonstrate substantial gains in low-power reception, bandwidth utilization, robustness to detuning, fading and delay spread, outage, and communication coverage compared with conventional, advanced, and fixed-point RAQR receivers. The results demonstrate that BER-aware joint optimization translates the intrinsic sensitivity of Rydberg-atom sensing into tangible communication-level gains.

0.46

Continuous Wideband Multicarrier Rydberg Atomic Quantum Receiver

eess.SP ·2026-11-04 ·Qihao Peng, Qu Luo, Maged Elkashlan, Cunhua Pan, Pei Xiao +3 more
theory similarity 0.55
Abstract

This paper investigates continuous wideband orthogonal frequency-division multiplexing (OFDM) reception using an auxiliary (AUX)-assisted five-level Rydberg atomic quantum receiver (RAQR) with a single microwave local oscillator (LO), without requiring additional atomic reception transitions or LO frequency combs. By exploiting Floquet theory, the proposed framework characterizes the dynamic atomic response at finite signal-LO detunings without relying on a quasi-static Taylor expansion around the LO operating point. Specifically, closed-form radio-frequency (RF)-to-electrical conversion expressions are derived from the Lindblad master equation under weak-probe and weak-signal approximations. Building on these expressions, an equivalent multicarrier communication model is established, revealing the inherent frequency selectivity of the atomic response and the resulting subcarrier-dependent amplitude and phase distortions. RAQR-aware zero-forcing (ZF) equalization is developed to enable reliable OFDM reception. Furthermore, analytical results reveal how LO and AUX driving influence the atomic response through dressed-state splitting and energy-level shifts. An upper bound on the LO-referenced half-power span is derived, and an approximately $18$-dB reduction in center-response power per bandwidth doubling is established in the AUX-free strong-LO regime. Simulation results validate the analytical response model and reveal pronounced subcarrier-dependent amplitude and phase variations across over $10$~MHz, highlighting the potential of RAQRs as wideband receiving front ends for future wireless communications.

0.16

A Novel Space-Time Coding Architecture for Rydberg Atomic Quantum Receiver-Based Systems

cs.ET ·2026-09-01 ·Asifa Zannat, Milad Abolpour, Dani Korpi, Mikko A. Uusitalo, Mikko Valkama +1 more
similarity 0.53
Abstract · 5 pages, 3 figures, under review at IEEE

Rydberg atomic quantum receivers (RAQRs) offer high sensitivity and wide tunability, but their magnitude-based readout yields a nonlinear model incompatible with conventional complex-valued multi-input multi-output (MIMO) processing. We propose a low-complexity space-time coding framework for point-to-point RAQR-assisted MIMO links. Data symbols are encoded using real orthogonal designs, while strong-reference heterodyne reception yields an equivalent real-valued linear model. The preserved orthogonality enables matched filter symbol-wise detection without matrix inversion or vector search. An analytical bit error probability expression is derived, proving the proposed scheme achieves the full transmit-receive diversity. Simulations validate the analysis and demonstrate improved performance over spatial multiplexing benchmarks.

0.36

Physics-Aware Power Optimization for Rydberg Quantum Arrays via Barankin Bound Minimization

cs.IT ·2026-10-07 ·Yixiao Li, Jiayi Zhang, Bokai Xu, Yin Zhang
similarity 0.52
Abstract · 7 pages, 5 figures, IEEE GlobeCom 2026

Rydberg-atom quantum uniform linear arrays (RAQ-ULAs) offer a promising sensing architecture for direction-of-arrival (DOA) estimation in terahertz (THz) beam alignment. Existing studies often model the quantum receiver as a macroscopic linear block and rely on the Cramer-Rao bound (CRB) for array evaluation or power allocation. However, as a local variance bound, the CRB cannot capture threshold breakdown caused by spatial ambiguities in low-signal-to-noise-ratio (SNR) regimes. This paper proposes a physics-aware power optimization framework for RAQ-ULAs based on stochastic Barankin bound minimization. We derive a closed-form stochastic multipoint Barankin bound (BRB) matrix under a low-SNR integrability condition and introduce an arcsine-prior calibration to characterize bounded-domain error saturation. By incorporating a Lindblad-guided electromagnetically induced transparency (EIT) readout model, we couple the ambiguity-sensitive BRB with photon shot noise, power broadening, and laser Rabi frequencies. A CRB-optimized analytical baseline is further derived to expose the limitation of local-SNR-based allocation. To solve the resulting nonconvex problem, we develop a backtracking majorization-minimization (MM) algorithm with a Lipschitz-based quadratic surrogate. The algorithm ensures monotonic decrease and converges to a feasible stationary point. Simulations show that the proposed framework predicts threshold breakdown more accurately than the CRB and enlarges the reliable operating region under severe THz attenuation.

0.33

Lightweight Single-Antenna Direction-of-Arrival Estimation for Curvilinear Trajectories in Mobile Embedded Systems

eess.SP ·2026-08-12 ·Nour Zidi, Jérémie Voix, Pascal Giard, Lokman Sboui
similarity 0.52
Abstract

Accurate direction-of-arrival (DOA) estimation is valuable for spatially selective communication in noisy industrial environments. This work investigates a lightweight single-antenna framework in which receiver motion forms a virtual aperture. The receiver uses onboard inertial measurement unit (IMU) headings and two-way-ranging (TWR) measurements to a known fixed beacon, avoiding GPS, optical tracking, and high-precision external tracking of the mobile receiver. The curvilinear virtual-array MUSIC formulation is evaluated numerically using phase-coherent narrowband snapshots over arbitrary trajectories. Hardware experiments validate a range- domain TWR-IMU bearing estimator using corrected and averaged ranging observations. In a campaign of 100 consecutive four-revolution sweeps, all trials are retained. Phase-aligned accumulation recovers a 123 mm range-modulation amplitude, in close agreement with the measured 120 mm antenna lever arm. The single-sweep bearing precision is 8.2° absolute world-frame accuracy is limited by systematic BNO055 magnetometer drift in the motorized setup. The embedded bearing-estimation computation consumes 144.9 mJ per estimate, approximately 3 % of the measured cycle energy in the tested configuration. These results establish the feasibility of onboard range-domain bearing estimation and motivate future experimental validation of phase-coherent MUSIC during free-form mobile trajectories.

0.04