CS Paper Radar

Model Predictive Control of Wind Turbines: A Model-Oriented Review of Prediction Models, Control Objectives, and Nonlinear Aerodynamic Formulations

Roya Khalili-Amirabadi, Mohsen Jalaeian-Farimani, Mahdi Ghane

eess.SY math.DSmath.OC ·submitted 2026-10-22 13:58 UTC · v1
published

Abstract

Model predictive control (MPC) has been applied to wind-turbine regulation with markedly different internal prediction models, ranging from linearized low-order turbine models to nonlinear, aeroelastic, floating, and data-driven predictors. This review organizes the literature primarily by the model propagated by the controller and treats model order, predictor representation, MPC formulation, control objective, and validation plant as separate descriptors. Primary studies show that low-order linear or piecewise-affine predictors are attractive for constrained power and speed regulation, whereas flexible drivetrain, structural, and floating models are needed when drivetrain twist, tower motion, blade loads, or platform dynamics are explicit control quantities. Nonlinear and economic MPC studies further demonstrate coordinated pitch/torque control across broad operating regions, while preview, repetitive, and data-driven formulations address wind prediction, periodic loads, and model mismatch. Particular attention is given to aerodynamic pitch dependence: variable-pitch turbine dynamics can be non-affine with respect to applied pitch, and the term NMPC alone does not prove that the original nonlinear pitch map is retained inside the optimizer. The review therefore adopts a conservative, equation-based classification for direct nonlinear applied-pitch propagation. Here, direct nonlinear applied-pitch propagation means that the applied pitch at each prediction step is evaluated inside the original nonlinear aerodynamic map, rather than replacing that dependence by a linearized, scheduled, piecewise-affine, or learned surrogate. The literature supports a remaining integration challenge at the intersection of flexible drivetrain prediction, nonlinear aerodynamic pitch treatment, explicit constraints and load objectives, and validated adaptive or learned model correction.

Comment
Khalili-Amirabadi, R., Jalaeian-Farimani, M., & Ghane, M. (2026). Model Predictive Control of Wind Turbines: A Model-Oriented Review of Prediction Models, Control Objectives, and Nonlinear Aerodynamic Formulations. Journal of Intelligent Monitoring and Control Systems, 1(1): 35-41. https://doi.org/10.65098/jimcs.01.2026.35.41
DOI
10.65098/jimcs.01.2026.35.41

Closest papers

Nearest neighbours by meaning across the whole index.

Data-Driven Surrogate-Model for Real-Time Loads Prediction in Floating Wind Farms

eess.SY ·2026-10-13 ·Federico Bellini, Majid Ebrahimi, Alessandro Fontanella, Marcus Becker, Jan-Willem Van Wingerden +2 more
similarity 0.64
Abstract

This work presents a data-driven load-surrogate modelling framework for real-time control of floating offshore wind farms. The proposed methodology uses mid-fidelity simulations performed with OpenFAST and FAST.Farm together with MLife fatigue analysis to generate Damage Equivalent Load (DEL) datasets of floating wind turbines under wake steering conditions. A two-stage surrogate modelling approach is adopted: first, a Feed-Forward Neural Network (FFNN) is trained using data from simulations of a single floating wind turbine, while a second stage corrects the residual error between the FFNN predictions and FAST.Farm simulations using either Gaussian Process Regression (GPR) or an additional FFNN. The results show that the proposed framework can estimate DELs with errors generally below 15% for tower base bending moment, blade root bending moment, yaw bearing moment, and fairlead tension, while maintaining computational times compatible with real-time applications. The study also highlights the challenges related to generalization of the load-surrogate model under varying environmental and control conditions, especially for large floating wind farms. Overall, the proposed methodology demonstrates the potential of surrogate-based DEL estimation for load-aware floating wind farm control applications.

0.19

Hybrid Sequential Feedback Optimization for Wind Farm Power Maximization

eess.SY math.OC ·2026-09-15 ·Shijie Huang, Sergio Grammatico
published similarity 0.58
Abstract · Accepted to the 65th IEEE Conference on Decision and Control (CDC 2026)

This paper considers feedback optimization for optimal steady-state operation of nonlinear discrete-time systems when the steady-state input-output map and its sensitivity are expensive to compute. We propose a hybrid extension of sequential feedback optimization (SFO) that augments the model-based SFO gradient with correction terms through a convex combination with summable diminishing weights. Two variants are studied: one based on recursive least-squares (RLS) sensitivity estimation, and another on extremum seeking control (ESC) gradient estimation. Under contractivity and smoothness assumptions, we show that both hybrid schemes preserve the convergence of SFO to a neighborhood of the optimal steady state. The proposed methods are validated through a wind farm power maximization problem using a medium-fidelity model, demonstrating improved early transient performance compared to pure SFO.

0.36

WPBench: A Comprehensive Benchmark for Wind Power Forecasting

cs.LG cs.AI ·2026-09-21 ·Yuhan Zhu, Jilin Hu, Xinying Cai, Yingshan Li, Li Ma +5 more
top venuebenchmark similarity 0.58
Abstract · Accepted by ICDE 2027

Accurate, reliable, and deployable wind power forecasting is critical for power system dispatch, renewable energy integration, and electricity market operations. Progress in this field hinges on the ability to empirically and comprehensively benchmark forecasting methods. Yet existing benchmarks fall short of supporting systematic evaluation in four key aspects: 1) limited coverage of wind power scenarios across turbine scale, variable composition, and spatial structure; 2) incomplete coverage of forecasting model families; 3) evaluation metrics misaligned with wind power requirements; and 4) limited structure-aware diagnostics beyond individual temporal patterns. To address these limitations, we propose WPBench, a comprehensive, fair, and extensible benchmark for wind power forecasting. WPBench integrates 26 public datasets organized by turbine scale and variable composition, spanning single-turbine, multi-turbine, univariate, and multivariate settings. Under unified processing, training, and evaluation protocols, it benchmarks 19 representative models covering traditional methods, deep temporal models, spatio-temporal models, and foundation models. Beyond point-wise errors, WPBench assesses forecast-curve fidelity and computational efficiency, and delivers structure-aware diagnostics across temporal, variable-dependency, and spatial-dependency perspectives. Together, these capabilities enable systematic model comparison across diverse wind scenarios and provide a reusable platform for future research.

0.56

Distributed Model-Free Turbine Repositioning for Wake Overlap Minimization in Floating Offshore Wind Farms

eess.SY math.DS ·2026-10-06 ·Zekai Chen, Ryozo Nagamune
similarity 0.57
Abstract · This paper has been submitted to the American Control Conference (ACC) 2027

This paper presents a model-free method for turbine repositioning control in floating offshore wind farms. The method uses a distributed online optimization framework to mitigate the wake effect. Conventional approaches rely on centralized, model-based control architectures, which suffer from poor practical feasibility. To overcome this limitation and address nonconvexity and inaccessible gradient information, we incorporate physics-informed knowledge of wake dynamics into the control system design. We demonstrate the effectiveness of the proposed method by comparing it with a centralized, model-based baseline in mid-fidelity simulations. Results indicate that the proposed method achieves slightly better performance while significantly reducing computational cost.

0.23

Fast-varying Natural Frequencies and Damping Ratio Identification for Linear Time-Varying System

cs.LG ·2026-09-17 ·Melisa Bozaci, Alice Cicirello
unusual similarity 0.57
Abstract · Preprint submitted to Mechanical Systems and Signal Processing

This work proposes a physics-enhanced machine learning approach for the system identification of Linear Time-Varying (LTV) systems under time-varying operating conditions in terms of fast-varying natural frequencies and damping ratios by combining a long short-term memory network with an Extended Kalman Filter (EKF). The proposed approach uses vibration data (displacement and velocity measurements), domain knowledge of modal damping ratios, and a physics-based model that can yield an approximate natural frequencies time-dependency model. The approach is validated using synthetic data generated from a finite element model of a 2-blade offshore wind turbine under realistic environmental and operating conditions. This system displays fast time-varying frequencies due to operating conditions, whose identification is particularly challenging because of the wind and wave loading. The robustness of the proposed approach is assessed under assumed incorrect system information (e.g. damping ratio). The proposed approach is evaluated across different environmental and operating conditions to show its applicability to different operating regimes. The results show the approach can accurately identify the selected fast-varying natural frequency, 1st Fore-Aft (FA-1) mode, with a maximum root mean square error of 0.0012 Hz. The results demonstrate that the model trained on EKF estimates depends on accurate damping values, whereas the model trained on physics-based data exhibits robustness to incorrect damping assumptions. The approach is extended to damping ratio identification for the selected mode by estimating the root mean square error between models trained on EKF estimates and physics-based data. The results show that the approach can yield a good approximation of the FA-1 mode damping ratio using grid search, offering an improvement over covariance-driven stochastic subspace identification.

0.30

Stochastic Sequential Feedback Optimization for Wind Farm Control under Time-Varying Inflow

eess.SY math.OC ·2026-10-02 ·Shijie Huang, Sergio Grammatico
benchmark similarity 0.57
Abstract

We consider steady-state optimization of nonlinear dynamical systems under time-varying stochastic operating conditions, where the objective is an expected-value function over the current operating-condition distribution, so that changes in the distribution induce a moving stochastic optimum. To address this problem, we propose stochastic sequential feedback optimization (S2FO), which combines projected feedback-gradient updates with sequential sensitivity estimates obtained by linearizing the plant at realized stochastic operating conditions. We analyze the closed-loop performance of S2FO through expected dynamic regret, instantaneous tracking in expectation, and almost-sure convergence under diminishing step sizes. We then apply the method to wind farm power maximization under time-varying stochastic inflow. Simulations on a benchmark layout and on a realistic offshore wind farm show that S2FO improves average power generation when persistent wake interactions are present, and that its advantage decreases as wind-direction variability increases.

0.15

Control of hybrid wind-wave energy systems using reinforcement learning

eess.SY ·2026-08-11 ·Zechuan Lin, Kemeng Chen, Maosen Fan, Xiaofan Li, Xi Xiao +1 more
similarity 0.56
Abstract

Integrating wave energy converters (WECs) with floating offshore wind turbines (FOWTs), to form hybrid wind-wave energy (HWWE) systems, is a promising approach to achieve further cost reduction for offshore renewable energy. In such systems, the control of the integrated WECs plays an important role, with the potential to generate additional wave energy while simultaneously suppressing floating platform motion. However, HWWE systems are characterized by complex dynamics, making accurate modelling only viable through numerical simulation, and posing significant challenges for control design. This paper proposes a reinforcement learning (RL) control framework for HWWE systems, in which the real-time control policy is learned directly through interactions with high-fidelity simulation. A numerical model is established for a HWWE system consisting of an IEA 15 MW wind turbine, a VolturnUS semi-submersible platform, and three torus-type WECs, which is then employed as the RL training environment. Control performance is evaluated in terms of both wave energy generation and platform motion reduction, two competing objectives, from a Pareto perspective. It is shown that the proposed RL controller achieves substantial Pareto improvements over conventional control strategies, e.g., over 75\% higher wave energy capture at the same platform motion level, or nearly 50\% lower motion at the same energy capture level, thereby significantly extending the attainable performance boundary of HWWE systems.

0.04

Nonlinear Model Predictive Control for Trajectory Tracking of Differentially Flat Fixed-Wing Aerial Systems

cs.RO ·2026-08-21 ·Nishanth Bobbili, Pratyaksh Rao, Luca Morando, Luca Masci, Giuseppe Loianno
similarity 0.56
Abstract

Planning and control of fixed-wing Unmanned Aerial Vehicles (UAVs) are challenging due to nonlinear dynamics, aerodynamic limits, and environmental disturbances. Differential flatness offers a principled way to generate fast, feasible trajectories, but its use has largely been confined to model-free controllers, which lack predictive capabilities and demand tuning. In this paper, we propose a unified framework that integrates differential flatness-based trajectory generation with Nonlinear Model Predictive Control (NMPC), combining computationally efficient planning with predictive, constraint-aware control. To further improve robustness, we introduce a wind-aware sampling strategy embedded within the NMPC framework, enabling the generation of dynamically feasible reference trajectories that proactively account for wind disturbances while strictly enforcing aerodynamic and control input constraints. We validate the proposed framework through extensive simulations and real-world flight experiments, demonstrating improved tracking accuracy and robustness for complex trajectories, particularly when using the proposed wind-aware sampling strategy under strong wind conditions.

0.21