CS Paper Radar

Impact of Synchronization Offsets and CSI Feedback Delays on Coherent Joint Transmission in Distributed MIMO-OFDM

Kumar Sai Bondada, Daniel J. Jakubisin, R. Michael Buehrer

eess.SP ·submitted 2026-10-23 18:25 UTC · v1

Abstract

This paper studies the impact of synchronization offsets and CSI feedback delay on coherent joint transmission (CJT) in distributed MIMO-OFDM systems. Unlike conventional co-located MIMO, distributed CJT is highly sensitive to transmitter-dependent synchronization impairments because coherent combining requires phase, frequency, and timing alignment across geographically separated transmitters. Received signal models are derived for residual timing offsets, carrier frequency offsets (CFOs), sampling clock offsets (SCOs), phase noise, and channel variations accumulated during channel state information (CSI) feedback delay. The corresponding spectral efficiency (SE) expressions quantify the degradation in capacity due to loss in coherent-combining gain caused by residual phase rotations, inter-carrier interference (ICI), and precoder misalignment. The SE expressions are numerically evaluated to determine synchronization requirements for maintaining negligible SE degradation, yielding the following findings: a Gaussian-distributed start-time jitter with a standard deviation below 10\% of the sampling period results in negligible SE degradation, with the SE loss decreasing from 0.68\% at an SNR of 0 dB to 0.17\% at 40 dB. A normalized CFO standard deviation of 0.001 also results in negligible ICI-induced degradation, with the SE loss increasing from 0.05\% at an SNR of 0 dB to 2\% at 40 dB. At an SNR of 26 dB, limiting the SE loss to 5\% yields feasible operating points with clock-error standard deviations up to 50 ppb, Doppler-delay products up to 0.1, and phase-tracking error standard deviations up to $40^{\circ}$ at carrier frequency of 3.5 GHz with 30 kHz sub-carrier spacing with 15.36 MHz sampling rate.

Closest papers

Nearest neighbours by meaning across the whole index.

Localization MSE Analysis for Cooperative OFDM-ISAC

cs.IT eess.SP ·2026-11-02 ·Kaitao Meng, Kawon Han, Christos Masouros
similarity 0.58
Abstract · 6 pages, 3 figures, submit to IEEE for possible publication

This paper develops a receiver-specific mean-squared-error (MSE) framework for cooperative integrated sensing and communication (ISAC) localization using random orthogonal frequency-division multiplexing (OFDM) payloads. It captures local peak perturbations and incorrect ambiguity-peak acquisition for two classical receiver processing schemes: matched filtering (MF) and reciprocal filtering (RF). For scatterers well separated in delay, we quantify how frequency spread and interference induced by symbol-energy fluctuations affect local delay errors under MF. RF removes symbol-dependent weighting but amplifies noise for low-energy symbols. Payload-conditioned joint Gaussian delay profiles yield peak-selection probabilities, which combine with nonlinear multistatic fusion errors to approximate position MSE while accounting for network geometry. Numerical results illustrate receiver-dependent estimation errors and the benefits of frequency-dependent constellation allocation.

0.08

Synchronization-Oriented Multi-Radius BMOCZ for Non-Coherent Short-Packet Communications

eess.SP ·2026-10-26 ·Hamoud Abdelbasset Hamidouche, Riadh Ouzane, Salah Eddine Zegrar, Huseyin Arslan
similarity 0.58
Abstract

Modulation on conjugate-reciprocal zeros (MOCZ) is a promising candidate for blind short-packet communication (SPC) in future wireless systems; however, its performance is sensitive to timing and frequency synchronization errors. In this paper, we propose a novel scheme named multi-radius binary MOCZ (MR-BMOCZ). This method introduces a new root placement strategy that enhances diversity in the autocorrelation domain. The resulting structure enhances the autocorrelation properties of the transmitted waveform, leading to improved timing offset (TO) estimation. Moreover, the multi-radius construction distributes the signal energy over a larger set of radii, hence reducing the peak-to-average power ratio (PAPR). The resulting waveform also exhibits a distinctive spectral structure that is exploited for carrier frequency offset (CFO) estimation and correction, yielding lower normalized mean square error (NMSE) compared with BMOCZ-based schemes. Simulation results over additive white Gaussian noise (AWGN) and fading channels demonstrate that MR-BMOCZ achieves superior synchronization performance while maintaining comparable bit error rate (BER) and block error rate (BLER) performance. Consequently, the proposed scheme offers a synchronization oriented extension of BMOCZ for robust non-coherent SPC.

0.24

Synchronization and Channel Estimation of OTFS with RF Impairments

eess.SP ·2026-08-20 ·Sanoopkumar P. S., Mohsen Bayat, Stephen McWade, Arman Farhang
similarity 0.58
Abstract · Invited paper accepted for presentation at the 2026 IEEE 27th International Workshop on Signal Processing Advances in Wireless Communication…

Orthogonal Time Frequency Space (OTFS) modulation is a promising waveform for future wireless networks. However, its resilience to RF impairments remains relatively understudied. Low-cost RF front ends are crucial for next-generation wireless systems, yet their performance is often degraded by RF impairments such as transmit IQ imbalance (IQI), phase noise (PN), timing offset (TO), and carrier frequency offset (CFO). Hence, this paper addresses the estimation and compensation of these RF impairments in OTFS systems under high mobility. A unified system model is developed that incorporates TO, CFO, PN, IQI and other channel effects into an effective channel representation. Using the pilot with cyclic prefix (PCP), a low-peak to average power ratio (PAPR) pilot suitable for OTFS, we propose a pilot-aided synchronization and estimation framework. The dual periodicity of PCP is exploited in our proposed TO estimation technique. A maximum-likelihood-based technique is also proposed to jointly estimate the CFO and effective channel using a complex exponential basis expansion model (CE-BEM). Finally, a linear detection model is formulated in the delay-Doppler domain to mitigate residual interference caused by RF impairments. Our simulation results corroborate the efficacy of our proposed synchronization and channel estimation techniques.

0.24

Timing Misalignment and Its Impact on OTFS and Other Delay-Based Waveforms

eess.SP ·2026-10-13 ·Badr Eddine Ouakouak, Salah Eddine Zegrar, Hüseyin Arslan
top venuebenchmarkhot direction similarity 0.58
Abstract · Published in: IEEE Transactions on Communications. Date of Publication: 01 September 2026. Volume: 74. Page(s): 13657 - 13671. no ISSUE numb…

The shift towards 6G wireless networks calls for advanced waveforms to support emerging applications such as ultra-reliable and massive machine-type communications. Among the proposed candidates, OTFS, ODDM, OTSM, and OCDM share the common feature of exploiting the delay domain for data transmission. While these waveforms offer significant advantages in high-mobility and sensing scenarios, their integration into multi-user uplink systems reveals a critical challenge: timing misalignment (TM). Unlike OFDM, where residual timing offsets translate into phase rotations, delay-based waveforms experience actual shifts of resources, whose impact we investigate in this work. We show that the aforementioned waveforms can be unified under a time-invariant setup through a common input--output relation, which enables a unified analysis of TM in uplink resource allocation. The results reveal a fundamental trade-off between interference mitigation and guard overhead in the presence of TM. We further benchmark the observed behavior against OFDM under Doppler spread as a reference impairment and highlight the analogy between TM in delay-based allocation and Doppler spread in frequency-based allocation. The results show that delay-based waveforms can maintain a net performance advantage over OFDM in the considered setup. Beyond this unified Doppler-free analysis, we evaluate the joint impact of Doppler spread and TM on each waveform individually. We also investigate BER performance and show how coding can mitigate the resulting interference. This study therefore establishes a problem framework that motivates the development of future compensation and scheduling strategies for practical multi-user operation of delay-based waveforms.

0.44

Robust Beamforming and Power Allocation for Coherent Cell-Free Massive MIMO with Residual Calibration Errors

eess.SP ·2026-08-11 ·Mingjun Sun, Xidong Mu, Shaochuan Wu, Chongjun Ouyang, Hyundong Shin
similarity 0.55
Abstract

This paper investigates robust downlink transmission to tolerate calibration aging in time-division duplex cell-free massive multiple-input multiple-output (CF-mMIMO) systems with residual calibration errors (RCEs). Unlike existing studies that typically treat RCEs as static impairments, we develop a time-evolving RCE model that characterizes the joint effects of residual phase mismatches, residual carrier frequency offsets, and oscillator phase noise. Based on this model, two practical processing architectures are considered: instantaneous calibrated-channel-based robust beamforming (BF) and statistical beamformed-channel-based robust power allocation (PA). For both architectures, tractable achievable rate lower bounds are derived, which explicitly reveal the impact of calibration aging on coherent combining, BF-gain uncertainty, and inter-user interference. Using these lower bounds as design metrics, we formulate an effective weighted sum-rate (EWSR) maximization problem over the data transmission interval, so that the resulting BF and PA designs can account for the temporal evolution of RCEs rather than a single calibrated instant. To efficiently solve the resulting problems, a Gauss--Legendre quadrature-based weighted minimum mean square error (WMMSE) optimization framework is developed, where both robust BF and PA are updated in an access point (AP)-block manner with closed-form solutions under per-AP power constraints. Simulation results demonstrate that: i) the proposed algorithms exhibit stable convergence; ii) the proposed robust BF and PA schemes achieve higher EWSR by explicitly accounting for calibration aging than their non-robust counterparts; and iii) robust BF achieves higher spectral efficiency (SE), whereas robust PA provides a more favorable tradeoff between SE and implementation cost in terms of computational complexity and fronthaul overhead.

0.04

2D Coprime Pilots for Delay-Doppler Sensing in OFDM-ISAC Systems

eess.SP ·2026-10-08 ·Guanping Shang, Zeyan Zhuang, Anzheng Tang, Shenghui Song, Chi-Ying Tsui
similarity 0.54
Abstract · This paper has been submitted to IEEE journal

Integrated Sensing and Communication (ISAC) is envisioned to endow future 6G systems with seamless sensing capabilities. To support efficient sensing with minimum communication overhead, sparse pilots embedded within communication frames have emerged as a promising solution. Along this line of research, existing studies have achieved engaging results in maximizing the unambiguous sensing region. However, jointly maximizing the sensing region and sensing accuracy remains challenging due to the lack of a unified performance metric and an effective pilot design framework. This paper jointly optimizes the unambiguous sensing region and sensing accuracy for estimating delay-Doppler (DD) parameters in Orthogonal Frequency Division Multiplexing (OFDM)-ISAC systems, where sensing mutual information (SMI) is adopted as a unified performance metric to characterize the overall sensing capability. Specifically, the joint optimization is formulated as an SMI maximization problem by systematically resolving sensing ambiguity and optimizing sensing accuracy. In particular, based on the generalized Bezout identity, we derive a 2D (timefrequency) coprime condition, which, as far as the authors know, is the first necessary and sufficient condition to achieve the unique estimation of DD parameters in the literature. Under this unambiguous condition, we further propose an Adam-Guided Iterative Refinement (AGIR) algorithm to optimize the sensing accuracy. Numerical results demonstrate the advantage of the proposed framework over existing designs, owing to the freedom offered by the 2D coprime condition in optimizing the sensing accuracy.

0.43

Hardware-friendly Baseband Design and Performance Analysis for LEO Broadband LoS-MIMO Systems

eess.SP ·2026-10-14 ·Peixin Zhang, Fengkui Gong, Guo Li, Tony Q. S. Quek
similarity 0.54
Abstract · 6 pages, 5 figures

High-frequency and broadband line-of-sight multiple-input multiple-output (LoS-MIMO) is a key solution for massive space-to-Earth data downlinks. However, in low Earth orbit (LEO) scenarios, it faces spatial rank deficiency from time-frequency coupling correlation and clock deviations from distributed oscillators. This paper establishes a dynamic effective channel throughput (ECT) framework incorporating waterfall characteristics of forward error correction. A hardware-friendly OFDM-based transceiver architecture with subband-adaptive truncation and dynamic timing recovery to achieve robust spatial decoupling is proposed. Through rigorous closed-form derivations, the equivalent signal-to-interference-plus-noise ratio (SINR) under joint errors is quantified, and an optimal scheduling algorithm combining truncation with variable coding and modulation is proposed to maximize ECT. Simulations confirm that the design circumvents outages caused by spatial notches with low complexity, stably enhancing the potential average throughput of a single dual-polarized beam to over 100 Gbps, providing a reliable theoretical foundation and baseband solution for next-generation high-throughput satellites.

0.23

Asynchronous Cell-Free Wireless Networks

eess.SP ·2026-10-15 ·Hossein Maleki, Angel Lozano, Hamid Jafarkhani
benchmark similarity 0.54
Abstract

This paper introduces intentional symbol-level asynchronicity as an interference-management mechanism for the uplink of cell-free networks. Rather than treating timing offsets as impairments, user-specific delays are deliberately assigned to reduce multiuser interference and improve spectral efficiency. A scalable receiver architecture is devised with synchronous channel-estimation pilots, asynchronous data transmission, bounded matched-filter sampling, and windowed combining. The delay assignment is formulated by means of a conflict metric that measures the severity of multiuser interference and is solved through a low-complexity greedy algorithm. As a benchmark, an exact method is also formulated for small and moderate network sizes using mixed-integer linear programming. Numerical results with both rectangular and root-raised-cosine pulses confirm that considerable performance improvements are feasible relative to synchronous transmissions, even with small delay codebooks and short observation windows.

0.30