CS Paper Radar

A State Augmented Approach to Paralle Modeling in High-Level Synthesis

Nicholas Kovacs, Hao Zheng

cs.AR ·submitted 2026-10-27 01:39 UTC · v1
benchmark

Abstract

High-level synthesis (HLS) can schedule only the concurrency made legal by its input description. For feedback-coupled designs, a sequential behavioral model can obscure the architectural state boundaries and hazard resolution needed for efficient overlap. We develop an explicit architectural modeling methodology based on synchronous sequential processes that start in lockstep and synchronize completion before repeating. Persistent state, communication, and feedback control are represented in C++, while HLS schedules and binds operations within that structure. A five-stage RV32I processor illustrates three consequential modeling decisions: which version of a value a consumer reads, when it consumes that value, and how architectural memory actions map to port operations. On a Kintex UltraScale+ FPGA, the CPI-optimized configuration achieves 1.221 cycles per instruction at 220 MHz, compared with 4.000 for an algorithmic HLS baseline and 1.575 at 242 MHz for an Ibex reference. An area-optimized configuration reduces LUTs by 65\% and registers by 47\%, with 9.7\% more benchmark cycles and a 250 MHz achieved clock. These results demonstrate a separation between designer-controlled architecture and tool-controlled scheduling.

Closest papers

Nearest neighbours by meaning across the whole index.

TPCS: A Cycle-Level Simulation Paradigm with Native Execution Semantics for RTL Modeling and Generation

cs.AR ·2026-10-09 ·Chengzhen Meng, Xiaoyu Li, Chen Bai, Zhenyu Zhang, Hongjun Dai
similarity 0.67
Abstract · Submitted to IEEE TC

The growing diversity of domain-specific architectures and microarchitectural designs demands fast and accurate evaluation methods during early design stages. However, existing approaches suffer from a fundamental trade-off: high-level simulators offer speed but lack fidelity, while RTL-based tools provide accuracy at the cost of significant simulation overhead. This gap limits efficient pre-RTL microarchitecture exploration. Therefore, we propose Transaction-Pruned Cycle Simulation (TPCS), a novel modeling and simulation framework. It serves as a unified intermediate abstraction spanning microarchitecture modeling, cycle-accurate simulation, and synthesizable RTL implementation. TPCS organizes combinational logic as transaction-based function invocations and leverages host CPU control flow to naturally prune inactive logic, eliminating the need for explicit event scheduling or signal tracking. This enables cycle-accurate simulation with significantly improved performance. TPCS preserves structural correspondence with RTL and supports automatic generation of synthesizable designs. TPCS achieves 36$\times$-42$\times$ speedups over parallel Verilator on SMP systems and 3.4$\times$-7.2$\times$ over single-threaded Verilator on accelerators, with cycle-level waveform agreement on the evaluated traces. The generated RTL demonstrates comparable timing and area to handcrafted implementations, with relative changes of -4.7\% to +2.6\% in clock period and -3.3\% to +4.0\% in standard-cell area. By bridging the abstraction gap between high-level modeling and RTL design, TPCS enables a unified and agile pre-RTL workflow, allowing efficient microarchitecture exploration with both high performance and implementation fidelity.

0.30

SYNTLOG: FSM Benchmarks Evaluation for FPGA

cs.AR ·2026-08-24 ·Samary Baranov, Danila Gorodecky
benchmark similarity 0.65
Abstract

We introduce a curated benchmark collection of \num{101} FSM descriptions organized into five size classes (\emph{small}, \emph{medium}, \emph{large}, \emph{huge}, \emph{super-huge}), spanning tens to thousands of states and up to hundreds of inputs and outputs. Using these benchmarks we compare an architecture-independent synthesis tool SYNTLOG against Xilinx Vivado at the synthesis (technology-mapping) level, under six optimization strategies. We compare three post-synthesis parameters: number of LUTs, number of logic levels, and runtime. SYNTLOG in area-driven mode uses substantially fewer LUTs than Vivado's area baseline at every size ($-45\%$ to $-66\%$), and its delay-driven mode is simultaneously shallower in logic depth than Vivado's default synthesis mode. SYNTLOG synthesis includes embedded functional validation. Runtime of SYNTLOG is faster by one to two orders of magnitude than Vivado synthesis. The proposed tool synthesizes and validates every \emph{huge} and \emph{super-huge} circuit in minutes, whereas Vivado fails to terminate on these designs after hours.

0.21

Native FPGA Hard-Block Implementation from High-Level Synthesis

cs.AR ·2026-11-18 ·Mohamed Bouaziz, Mahmoud A. Elshenawy, Krishnan B. Iyer, Abdurauf Abdurakhmanov, Ammar M. Seliaman +1 more
similarity 0.64
Abstract

High-level synthesis (HLS) maps computations to FPGA hard blocks, yet often leaves their arithmetic modes, internal registers, and cascade links idle and recreates them in the fabric, costing area and timing. We present a C++ template library that reaches native hard-block implementations without modifying the HLS compiler. Templates fix source patterns, and an automatic flow picks scheduling settings and verified RTL patches. On AMD Versal, our matrix multiplication uses 2.4--4.5x fewer lookup tables (LUTs) than AutoSA systolic arrays at equal or higher estimated throughput. Our INT8 matrix--vector units reach the three multiply--accumulates per DSP of hand-written FINN RTL, versus at most 1.29 for HLS libraries. In hls4ml, Allo, and Stream-HLS, the templates cut LUTs by up to 2.7x and DSPs by up to 2x.

0.12

Can Agents Design Better Chips with a Higher Level Abstraction?

cs.AI cs.AR ·2026-09-17 ·Zijian Ding, Yang Zou, Yizhou Sun, Jason Cong
publishedbenchmarkcode/data similarity 0.63
Abstract · 7 pages, ICCAD'26 special session

Large Language Model (LLM) agents are increasingly being explored for chip design, but most existing approaches operate directly at RTL. We ask whether agents can design better chips by leveraging higher-level abstractions. We compare Direct RTL Design, Agent-based HLS Design, Post-Compiler HLS Refinement, and Post-HLS RTL Refinement, and combine Agent-based HLS Design with Post-HLS RTL Refinement as Agent-based HLS with RTL Refinement (AHRR). We use FPGAs as a practical, easy-to-deploy platform for end-to-end evaluation, but note that the design-flow tradeoffs we study are largely independent of the target technology. Across a diverse 11-tasks benchmark suite, AHRR achieves a 2.6$\times$ geometric-mean speedup over Direct RTL Design across our benchmark suite. Case studies show that HLS distills design knowledge into abstractions that agents can leverage, while RTL refinement recovers lower-level optimization opportunities. Together, these results make AHRR a promising workflow for agentic chip design. The code and evaluation artifacts are available at https://github.com/ZijD/AHRR.

0.36

LLM Agent-Based Design of RISC-V CPUs with FPGA-in-the-Loop Evaluation

cs.AR cs.AI ·2026-10-29 ·Leo Itoh, Junichiro Kadomoto
code/data similarity 0.63
Abstract · 5 pages, 6 figures, 2 tables. Submitted to IEEE ISCAS 2027. Code and data: https://github.com/kadomoto-lab/llm-cpu-fpga-loop

Long-run RTL simulation of CPU candidates can take hours, while short diagnostic runs may miss performance degradation that emerges later in execution. This evaluation cost can delay design decisions in LLM-agent-based CPU development. We present a development environment in which LLM agents implement CPU candidates on an FPGA and use on-board performance measurements to guide design decisions. We applied it to the human-supervised development of a single-cycle RV32I core into a three-wide out-of-order RV32IM core. The final design reaches 5.61 CoreMark/MHz at 130 MHz on a Artix-7 FPGA. For the same CPU candidate running 8,000 CoreMark iterations, FPGA evaluation, including implementation, was 9.6x faster than single-threaded RTL simulation. In one case, board measurements revealed long-run performance degradation in a candidate that improved in a short diagnostic run. The result guided candidate selection and led to RTL-based root-cause analysis and a fix.

0.37

Low-level optimizations in high-level HDLs: Is there a benefit?

cs.AR ·2026-09-29 ·Oliver Keszocze, Tjark Petersen, Arved Friedemann, Matthias Bo Stuart
code/data similarity 0.62
Abstract · The corresponding source code is available on GitHub: https://github.com/keszocze/mac-clash-iwsbp26

This paper explores the applicability of functional programming to the design of Application-specific Integrated Circuits (ASICs). We investigate the impact of designing ASICs using high-level, abstract Hardware Description Language (HDL) features versus employing low-level optimizations on the area of the synthesized circuits. The aim is to determine whether using low-level optimizations is beneficial and, if so, whether it is worth the added implementation effort. To carry out the investigation, we implement an unsigned bit-serial multiply-accumulate (MAC) unit in 16 different configurations using the functional HDL Clash. We make use of both low-level bit-manipulation techniques as well as Clash's high-level constructs for circuit design. The experimental evaluation shows that some high-level constructs of Clash have negligible influence on the resulting circuit size, suggesting that using the full power of functional programming is a viable approach to hardware design. To evaluate the impact of the used HDL itself, we also implemented versions of the MAC in Verilog. The experiments clearly show that there seems to be an inherent overhead in using Clash compared to Verilog code written by a seasoned engineer.

0.51

Minimum RISC-V: Maximum FPGA Efficiency

cs.AR ·2026-10-15 ·Martin Langhammer, Bogdan Pasca, Gregg Baeckler
published similarity 0.62
Abstract

RISC-V processors are now widely available for FPGAs, with most FPGA vendors replacing their proprietary soft-CPU architectures with this instruction-set architecture (ISA). Although contemporary FPGAs are increasingly resource- and feature-rich, a soft processor system---including memory---often occupies a disproportionately large footprint and delivers only modest performance relative to the potential of the target device. In this work we first design a lightweight but deeply pipelined RISC-V core that can run above 700 MHz in a mid-range device and that is capable of retiring one instruction per clock under ideal conditions. We then develop and demonstrate a new optimization method that compiles the final application binary and a specialized processor instance contemporaneously. The method expands each instruction into an application-specific encoding, removes unused datapath and decode logic during synthesis, and yields cores that remain assembler-compatible with the original program while no longer being binary-compatible with a general-purpose RISC-V. We implement example designs on RV32I (base integer), RV32M (integer multiply), and RV32F (single-precision floating-point) configurations. Our optimized RISC-V is as small as 170 ALMs and closes timing at 775 MHz in an Altera Agilex-5 device. Finally, we show that these processors can be packed into a deterministic area and stepped-and-repeated continuously without material impact on performance, enabling predictable multi-core density planning.

0.35

BOOMerang: Autonomous Translation from RTL to Microarchitectural Simulators and Back

cs.AR ·2026-11-19 ·Ferran Hermida-Rivera, Jack Toubes, Angela Cui, Chengyi Lux Zhang, Sagar Karandikar
similarity 0.61
Abstract

High-level simulators like gem5 are often used to test and demonstrate novel architectural techniques. While these simulators provide high research productivity, they generally lack the means to provide detailed feedback on the realizability of a hardware design. Furthermore, these simulators can frequently fall out-of-sync with the detailed performance characteristics of real hardware designs, which is usually the responsibility of dedicated engineers/teams in industry. While RTL implementation can address these challenges, it can be even more difficult to translate simulator code to high-quality RTL by hand without a large team. In this work, we architect and evaluate agentic loops that automate both parts of the RTL vs. high-level simulator workflow that is critical to high-quality architecture research. Our loops (1) automatically generate accurate high-level models of RTL implementations of CPU designs (BOOM) in a battle-tested microarchitecture simulation framework (gem5) and (2) automatically translate new microarchitectural features implemented in the high-level simulator back to RTL faithfully. Targeting the first loop at autonomously building a gem5 model for the Berkeley Out-of-Order Machine (BOOM) core, we generate a simulator with IPC within 3% of the RTL, meeting targets pursued for simulators in industry, in only 2 days. We use our second loop to automatically translate 72 features from this aligned gem5 simulator into RTL in the BOOM core, while maintaining its low IPC error. Combining translated optimizations together yields a 25% performance improvement for the BOOM core RTL implementation in SPECint 2017, demonstrating that having these loops for moving between high-level simulation and RTL enables actual improvement of processor performance. The agentic loops we developed and the simulators and RTL we generated will be available in open-source.

0.26