CS Paper Radar

Capacity of Multi-Layer Manhattan-Grid UAV Corridors Served by Terrestrial 5G NR Networks

Saad Masrur, M M Sadman Shafi, Md Sharif Hossen, Ismail Guvenc

eess.SP cs.PF ·submitted 2026-11-06 05:49 UTC · v1

Abstract

Advanced air mobility (AAM) is expected to organize unmanned aerial vehicle (UAV) traffic into corridors at multiple altitudes. In this paper, we study the downlink (DL) and uplink (UL) capacity of a multi-layer Manhattan-grid corridor mesh served by a terrestrial fifth-generation (5G) new radio (NR) macro network. The corridor spacing and the numbers of layers, UAVs, and base stations are configurable. We combine the 3GPP aerial channel and antenna models, correlated UAV mobility, and frequency-selective fading with an NR physical-layer abstraction that includes channel aging and link adaptation. Results show that UAVs above 90 m experience a DL signal-to-interference-plus-noise ratio (SINR) about 17 dB below that of ground users, and that a dense macro network with $10^\circ$ downtilt leaves 17-29% of corridor positions without DL service under full-buffer load, regardless of corridor spacing. On a common layout, the carrier frequency (700 MHz, 3.5 GHz, or 7.2 GHz) changes the UAV SINR by less than 0.5 dB, since the corridor links are strongly interference-limited. The UL is the bottleneck: at 85% satisfaction, a 20 MHz carrier supports only about 3.4-4.1 UAVs/km$^2$ with 4 Mb/s of UL video per UAV.

Comment
Under Review

Closest papers

Nearest neighbours by meaning across the whole index.

Beyond RSRP Coverage: UAV Serviceability in Interference-Limited Urban 5G NR Networks

eess.SY ·2026-09-18 ·Md Sharif Hossen, Vijay K. Shah, Ismail Guvenc
similarity 0.73
Abstract · 6 pages, 4 figures

Reference signal received power (RSRP) is commonly used to assess 5G cellular coverage, but it may substantially overestimate the connectivity available to cellular-connected unmanned aerial vehicles (UAVs) under strong inter-cell interference (ICI). As a UAV ascends, reduced blockage can strengthen the serving signal, while increased line-of-sight visibility to neighboring sectors can intensify ICI. This paper develops a trajectory-aware, 3GPP-based system-level framework for evaluating UAV radio serviceability during a three-dimensional flight in an urban 5G New Radio network. The framework jointly evaluates RSRP, reference signal received quality (RSRQ), and signal-to-interference-plus-noise ratio (SINR) in a 19-site, 57-sector deployment. We introduce the concept of coverage-serviceability gap to quantify the difference between RSRP availability and joint service availability. Under RSRP, RSRQ, and SINR thresholds of -100 dBm, -18 dB, and 0 dB, respectively, an inter-site distance (ISD) of 500 m provides 99.9% RSRP availability but only 13.6% joint service availability, yielding a coverage-serviceability gap of 86.3 percentage points. With RSRQ and SINR thresholds of -22 dB and -6 dB, respectively, joint availability increases to 55.0% and 63.1% for ISDs of 500 m and 1000 m, respectively. These results demonstrate that RSRP-based coverage substantially overestimates joint UAV serviceability under both evaluation configurations, with SINR remaining the limiting metric.

0.45

Low-Altitude Platform Stations for Dense Urban Connectivity

eess.SY ·2026-09-09 ·German Svistunov, Azim Akhtarshenas, Matteo Bernabè, David López-Pérez
similarity 0.69
Abstract

This paper evaluates the downlink performance of 5G non-terrestrial networks (NTNs) realized via low-altitude platform station (LAPS)-mounted base stations, and compares it against conventional 5G terrestrial network (TN) in a realistic dense urban scenario. Using a 3GPP-compliant multi-cell hexagonal layout with 19 sites and 57 sectors, we model LAPS altitudes ranging from 100 to 1000 m and evaluate the average effective signal-to-interference-plus-noise ratio and user throughput via system-level simulations. Results show that LAPS-based NTN deployments can significantly outperform terrestrial 5G in per-user throughput, provided the LAPS altitude is properly chosen to balance increased line-of-sight probability against inter-beam interference.

0.26

Joint Air Corridor and BS Coverage Planning for Large-Scale High-Density Low-Altitude Aerial Networks via Channel Knowledge Maps

eess.SP ·2026-11-10 ·Jiaxuan Li, Yilong Chen, Yuan Guo, Fan Liu, Jie Xu
similarity 0.69
Abstract

This paper studies the joint air corridor and base station (BS) coverage planning problem for high-density low-altitude aerial networks supported by terrestrial cellular infrastructures. In the considered system, unmanned aerial vehicles (UAVs) operate within a structured air corridor planned over a grid-based airspace, and each BS serves selected corridor grid cells by sharing its communication resources among all UAVs therein. Each BS's traffic load depends on both the number of covered corridor cells and the UAV density, thereby affecting the communication rate available to each UAV. We exploit the channel knowledge map (CKM) to characterize the channel gains between BSs and candidate airspace cells and evaluate desired signals and inter-cell interference for environment-aware offline planning. Based on CKM, we jointly optimize the corridor layout and BS coverage to minimize a weighted objective balancing corridor length and the supportable average UAV density along the entire corridor, subject to minimum communication rate requirements for all UAVs along the air corridor. The joint design is formulated as a mixed-integer linear program (MILP), which can be optimally solved using off-the-shelf solvers. For large maps, we develop a scalable suboptimal algorithm based on Lagrangian relaxation and A* search. Specifically, we incorporate BS resource constraints into A* corridor search via Lagrangian relaxation, and then jointly optimize BS coverage and UAV density along the generated corridors under the original rate constraints. Numerical results demonstrate the benefits of the proposed joint design in supporting high-density UAV operations and show that the proposed algorithm obtains high-quality solutions with substantially reduced computation time.

0.15

Joint Energy Efficiency and Fairness Optimization for D2D Communications in Aerial-Ground Integrated Heterogeneous Networks

cs.NI ·2026-09-21 ·Chuan-Chi Lai, Ang-Hsun Tsai, Shang-Long Wu
published similarity 0.64
Abstract · 15 pages, 5 figures. Accepted for publication in IEEE Transactions on Vehicular Technology. ©2026 IEEE. Personal use of this material is per…

This study investigates an Aerial-Ground Integrated Heterogeneous network (AGIHN) architecture that combines terrestrial macro base stations and unmanned aerial vehicles (UAVs) serving as aerial base stations to enhance uplink access for macrocell users. To address the complex uplink resource allocation challenge for multiple device-to-device (D2D) communication pairs, we propose a low-complexity Multi-Channel Rate-Fair (MCRF) algorithm. Distinct from traditional exclusive allocation methods, MCRF supports shared reuse, enabling multiple D2D pairs to simultaneously multiplex on the same resource block, thereby significantly improving spectral efficiency. To manage the severe intra-tier interference arising from this non-orthogonal sharing, a heuristic Interference Avoidance (IA) strategy is integrated to ensure the transmission quality of D2D users. The proposed framework jointly optimizes system throughput, user fairness, and energy efficiency without requiring computationally intensive offline training. Simulation results demonstrate distinct performance advantages depending on the reuse mode: Compared to traditional single-channel exclusive reuse schemes, MCRF achieves massive gains, increasing D2D energy efficiency and throughput by approximately 397% and 542%, respectively. Furthermore, relative to multi-channel benchmarks (e.g., MCRR), the proposed algorithm optimizes the efficiency-fairness trade-off, enhancing the fairness index by 7.43% while maintaining a robust fairness score exceeding 0.6 in interference-prone environments.

0.46

Enhancing Vehicular Network Performance Through Integrated RSU and UAV Deployment

eess.SP ·2026-09-02 ·Muhammad Ismail, Syed Luqman Shah, Fazal Muhammad, Zeeshan Shafiq
published similarity 0.63
Abstract · Published in: 2023 18th International Conference on Emerging Technologies (ICET) https://doi.org/10.1109/ICET59753.2023.10375046

The increasing density of connected vehicles can place substantial pressure on fixed roadside infrastructure, particularly when the available communication resources become insufficient to accommodate temporary traffic surges. This paper investigates auxiliary unmanned aerial vehicle (UAV) assistance as a flexible mechanism for improving service availability and throughput in vehicular networks. Two representative network configurations are considered. In the first, an auxiliary UAV (UAVa) supplements two fixed roadside units (RSUs), whereas in the second, UAVa assists a heterogeneous infrastructure comprising one RSU and one UAV. Vehicle service is determined according to node coverage, the line-of-sight (LoS) probability of aerial links, and a prescribed signal-to-interference-plus-noise ratio (SINR) requirement. The resulting framework enables UAVa to accommodate eligible vehicles that cannot be adequately served by the primary infrastructure as the network load increases. Simulation results show that, under the considered configurations, the aerial nodes benefit from more favorable propagation conditions and achieve higher throughput than the fixed terrestrial RSU. Moreover, the introduction of UAVa increases the available service capacity under high vehicular loads, both for a purely terrestrial baseline and for a network already supported by an aerial node. These results demonstrate the potential of auxiliary UAV assistance as a flexible load-relief mechanism for capacity-constrained vehicular networks.

0.65

Geometry-Aware Multi-UAV Full-Duplex Communication: System Design and Experiment

cs.IT ·2026-09-27 ·Tao Yu, Kiyomichi Araki, Tomohiro Mogi, Yasushi Hada, Kei Sakaguchi
published similarity 0.62
Abstract · accepted by IEEE Transactions on Vehicular Technology

The deployment of unmanned aerial vehicle (UAV) systems relies on high-performance yet lightweight wireless links between UAVs and ground stations (GSs). This paper presents a geometry-aware multi-UAV in-band full-duplex (MU-IBFD) communication system that uses high-gain directional antennas and separated uplink/downlink channels to convert self-interference into controllable co-channel interference (CCI) between UAVs, thereby avoiding energy-intensive self-interference cancelers on UAVs. We also derive a geometry-aware CCI model and define a reliable operating region (ROR) in the 3D airspace, within which the SINR requirement is satisfied. A prototype consisting of two UAVs and a GS is developed, and field trials are conducted. The measured CCI as a function of UAV positions agrees well with the theoretically predicted non-ROR region, and the downlink capacity significantly exceeds that of a conventional time-division duplex (TDD) with omni-directional scheme and higher transmit power and approaches that of ideal IBFD in most of the airspace. A proof-of-concept 4K/60p video transmission further demonstrates the practical potential of the proposed MU-IBFD system.

0.34

Joint Communication and Sensing in Aerial Corridors: A Novel Stochastic Geometry Framework

cs.IT ·2026-10-01 ·Harris K. Armeniakos, Petros S. Bithas, Athanasios G. Kanatas, Harpreet S. Dhillon
published similarity 0.61
Abstract · accepted for presentation in 2026 IEEE GLOBECOM

In unmanned aerial vehicle (UAVs) networks, joint communication and sensing (JCAS) is emerging as a key enabler to support extended and continuous communication and sensing capabilities for sixth-generation (6G) services among UAVs operating in swarms. Within this framework, aerial corridors provide a structured environment for supporting coordinated and reliable operations. In this paper, a comprehensive frame- work is presented to investigate the JCAS coverage probability (CP) of a UAV-base station (BS) in an aerial corridor populated by UAV-user equipments (UEs). The corridor is modeled as a finite cylinder, within which a fixed number of UAV-UEs are spatially distributed according to a three-dimensional (3D) binomial point process (BPP). The UAV-BS is assumed to be equipped with a realistic 3D third generation partnership project (3GPP) antenna pattern and exploits radar sensing capabilities to track a known UAV-UE. Subsequently, the tracked UAV-UE is assumed to perform uplink communication with the UAV-BS. Accordingly, the JCAS CP at the UAV-BS is analyzed under the presence of clutter and uplink communication interference, and exact-form analytical expressions are derived. To the best of our knowledge, this is the first work to develop a stochastic geometry framework for the rigorous analysis of JCAS performance in aerial corridors, with UAV-UE locations modeled as a 3D BPP. Among several insights, results show that increasing the directivity of the UAV-BS antenna beams leads to notable JCAS performance gains, particularly for shorter UAV corridors.

0.53

Uplink Enhancement for Low-Altitude UAVs via Active RISs Under Existing Cellular Infrastructure

eess.SP ·2026-11-05 ·Weicong Chen, Chao-Kai Wen, Wankai Tang, Yiping Zuo, Xiao Li +1 more
publishedtheory similarity 0.61
Abstract · Minor Revision - IEEE Transactions on Communications

The proliferation of low-altitude aerial Internet of Things applications, such as UAV-based sensing/monitoring, demands high-performance uplinks, yet terrestrial-optimized cellular networks with downtilted base station (BS) antennas form coverage holes that severely degrade aerial uplink. To address this challenge without modifying infrastructure, active reconfigurable intelligent surfaces (RISs) are introduced. Unlike existing studies with complicated active RIS optimizations, we conduct a detailed noise analysis to simplify the transmission design. By deploying one active RIS per BS sector to fully exploit multi-sector reception, we develop a joint sector maximal signal combining scheme that improves signal quality through diversity gain. Active RISs introduce amplifier noise, raising questions about their net benefit. We derive an upper bound on the power ratio between RIS-introduced noise and BS-inherent noise, revealing that the impact of RIS noise is negligible under typical operating conditions. Based on this insight, we maximize a derived lower bound of the received signal-to-noise ratio by sequentially designing the amplitude and phase of reflection coefficients with closed-form expressions. Simulation results validate the theoretical analysis on negligible RIS-introduced noise in typical systems and demonstrate that under the same array gain, a larger RIS size rather than a higher reflection gain is preferred for enhancing the low-altitude uplink transmission.

0.35