CS Paper Radar

MambaLoc: Lightweight Indoor Localization Using Cross-Modal Knowledge Distillation

Mohab Bahnassy, Omar Saqr, Hamada Rizk, Moustafa Youssef

cs.AI cs.NI ·submitted 2026-11-07 00:49 UTC · v1
published

Abstract

Accurate indoor localization on resource-constrained edge devices remains challenging due to the tension between modeling fidelity and computational efficiency. Wi-Fi Channel State Information (CSI) enables low-cost deployment using existing Wi-Fi infrastructure but is heavily distorted by multipath propagation. Transformer-based solutions mitigate these effects but their quadratic complexity limits real-time edge deployment. Ultra-Wideband (UWB) provides geometrically precise ranging yet requires dedicated infrastructure. We present MambaLoc, a cross-modal distillation framework that improves the accuracy-efficiency balance in CSI-based localization. MambaLoc uses a linear-time Selective State Space Model (Mamba) as a lightweight CSI student, guided during training by a UWB-Transformer teacher. A Feature Alignment Module bridges the representational gap between heterogeneous RF modalities, allowing the CSI model to inherit UWB-derived geometric structure without UWB hardware at inference. A probabilistic Gaussian Mixture regression head models multi-modal spatial ambiguity from multipath effects, avoiding the physically implausible averaging of deterministic regression. Evaluations on a real-world dataset show MambaLoc achieves a median localization error of 0.230 m, reducing error by 22.2% over a standalone Mamba baseline, while requiring 65.1% fewer FLOPs and 58% lower inference latency than Transformer-based approaches.

Journal ref
M. Bahnassy, O. Saqr, H. Rizk, and M. Youssef, "MambaLoc: Lightweight Indoor Localization Using Cross-Modal Knowledge Distillation," Proceedings of the 27th IEEE International Conference on Mobile Data Management (MDM), 2026, pp. 177-183
DOI
10.1109/MDM71479.2026.00030

Closest papers

Nearest neighbours by meaning across the whole index.

Ray-Traced Augmentation for Signal Strength Based Localization

cs.NI ·2026-08-24 ·Jihoon Og, Ningze Sun, Ioanis Nikolaidis, Omid Ardakanian
similarity 0.70
Abstract · 28 pages

Indoor localization based on Wi-Fi typically relies on extensive collection of real-world received signal strength (RSS) fingerprints, making deployment costly and time-consuming. We present a ray-tracing-based framework that reduces this reliance by generating synthetic RSS fingerprints from a building model. We first calibrate the building model using a small amount of real RSS fingerprints through Bayesian optimization, followed by per-access-point calibration to account for residual errors in simulated RSS values. The calibrated model is then used to generate a large augmented dataset of synthetic RSS fingerprints at arbitrary locations. To effectively exploit these data for localization, we introduce novel binary and multivalued representations of RSS values and a ResNet-based localization architecture that supports cross-band fusion of 2.4 and 5 GHz measurements. We evaluate our localization method on a real campus building against a diverse set of four baselines. When trained exclusively on synthetic data, the proposed method with multivalued representation and upstream cross-band fusion achieves a mean localization error of 3.05m on a real-data test set, outperforming the best baseline by 33.6%. The results demonstrate that calibrated ray-tracing-based simulation can substantially reduce the need for real RSS fingerprints while enabling accurate deep-learning-based indoor localization.

0.13

Physics-Informed WiFi Sensing for Robust 3D Human Pose Estimation in Mobile and Cross-Environment Settings

eess.SP ·2026-08-25 ·Kaixuan Huang, Yuanbo Chen, Guangjin Pan, Shiyi Mu, Tao Yu +2 more
similarity 0.67
Abstract · 12pages 6figures

Device-free human pose estimation using commodity WiFi signals has emerged as a promising paradigm for pervasive sensing in mobile computing systems. However, existing approaches often suffer from severe performance degradation when deployed across heterogeneous environments due to complex multipath propagation and domain shifts in wireless signals. In this paper, we present a physics-informed WiFi sensing framework for robust 3D human pose estimation under mobile and cross-environment settings. Our approach explicitly models wireless signal propagation characteristics and incorporates multipath-aware attention to capture environment-dependent signal variations. To further improve generalization, we introduce a disentangled representation learning scheme that separates pose-related features from environment-specific factors, enabling effective cross-domain adaptation without requiring extensive retraining. We implement our system using commodity WiFi devices and evaluate it on multiple public benchmarks, including Person-in-WiFi-3D and MM-Fi, as well as real-world deployments across diverse indoor environments. Experimental results demonstrate that our framework significantly improves robustness and generalization performance compared to state-of-the-art methods, particularly under cross-environment scenarios. These results highlight the potential of physics-informed wireless sensing for enabling reliable, scalable, and infrastructure-free human-centric applications in mobile computing systems.

0.12

Foundation Models for Wireless Localization: Pretraining, Adaptation, and Utilization

eess.SP ·2026-08-31 ·Guangjin Pan, Jiajia Guo, Zheng Xing, Hui Chen, Chao-Kai Wen +2 more
similarity 0.66
Abstract · 4 pages, 1 table. This work has been submitted to the IEEE for possible publication

Accurate wireless localization is a key enabler for 6G networks, yet remains challenging under diverse and rapidly changing propagation conditions. Model-based methods degrade when multipath channels are non-resolvable and model mismatches occur, while supervised deep learning demands large labeled datasets and generalizes poorly to new deployments. Inspired by foundation models (FMs) in language and vision, this article presents a unified framework for FM-based wireless localization that learns transferable channel representations from large-scale unlabeled channel state information and adapts to new environments with minimal or even no supervision. We review the fundamentals of FMs, compare the FM paradigm with existing localization approaches, and introduce a three-stage framework spanning large-scale pretraining, localization-oriented fine-tuning, and context-augmented inference, together with the location-aware applications it enables. Ray-tracing-based case studies show improved positioning accuracy and cross-environment generalization. Finally, we present an outlook on key research directions toward AI-native networks for wireless localization.

0.21

AWM: An All-in-One Wireless Foundation Model for Multi-User Channel Acquisition and Localization Without Downstream Tuning

eess.SP ·2026-10-16 ·Zirui Chen, Ziqing Xing, Zhaoyang Zhang, Hongning Ruan, Zili Wang +1 more
similarity 0.66
Abstract

Wireless foundation models (WFMs) seek to unify diverse wireless tasks and scenarios, yet existing methods still rely on task- or scenario-specific components or deployment-time fine-tuning. This paper presents an all-in-one wireless model (AWM), a WFM that unifies multi-user channel acquisition and localization, despite their distinct data modalities and functional objectives. We reveal that user location and channel state information (CSI) at different frequencies can be viewed as attribute-specific measurements of the same wireless link. By introducing in-scenario same-attribute reference pairs as prompts, AWM converts heterogeneous attributes into alignable relativity representations, formulating intra-band channel interpolation, inter-band channel prediction, and wireless localization as unified wireless-state transformations. Further, a multi-task MateFormer is developed to perform source-attribute relativity extraction, cross-attribute relativity alignment, and target-attribute synthesis within a unified architecture, avoiding task-specific output heads or downstream fine-tuning. Comprehensive experiments demonstrate the effectiveness of model unification, including substantial gains from cross-task knowledge sharing, seamless generalization to unseen scenarios, and an efficient closed-loop service for mobile users.

0.19

LocAttMamba: A Low-Complexity Mamba Framework with Attention-Based Multi-AP Fusion for Indoor Localization

cs.NI ·2026-10-05 ·MohammadMahdi Ghadaksaz, Mohammad Farzanullah, Melike Erol-Kantarci
benchmark similarity 0.66
Abstract

Accurate and low-complexity indoor localization is important for location-based services in fifth generation (5G) and sixth generation (6G) networks, where positioning devices operate under limited computational budgets and non conditions. Indoor localization has been studied widely using traditional signal-level localization approaches. However, these techniques often show degraded performance in on-line-of-sight (NLoS) scenarios. Recently, artificial intelligence (AI)-based techniques, including transformers, have been applied to address these challenges. While transformer-based architectures can capture the dependencies within the measurements collected from distributed access points (APs), their high computational complexity results in a large number of multiply-accumulate operations and long inference time. In contrast, lightweight recurrent and convolutional models trade this cost for degraded accuracy. In this paper, we propose LocAttMamba, a low-complexity localization framework in which the channel impulse response (CIR) and time-based features of each AP are processed by a separate Mamba encoder with near-linear complexity, and the resulting per-AP embeddings are fused through a multi-head attention layer that weights each AP according to its importance at every time step. The framework jointly predicts the user location and its per-axis uncertainty, which is refined through a post-hoc calibration step. We evaluate the proposed framework using two real-world 5G and ultra-wideband (UWB) measurement datasets. Our numerical results reveal that LocAttMamba obtains a mean two-dimensional (2-D) positioning error of 1.004 m and 0.599 m, respectively, on 5G and UWB datasets, outperforming the second-best benchmark by 9.79% and 5.82%, while requiring the fewest multiply-accumulate operations among all evaluated models and being 4.4-16 times faster than the transformer-based benchmarks.

0.19

GLocFM: A Geometry-Aware Foundation Model for 3D Indoor Wireless Localization

eess.SP cs.AI ·2026-08-10 ·Chenghong Bian, Chaozheng Wen, Hongze Chen, Jun Zhang
similarity 0.65
Abstract · 13 pages, single column

Learning-based wireless localizers often fail to utilize geometric information about the propagation environment, limiting their ability to exploit non-line-of-sight (NLoS) propagation and generalize across scenes. To bridge this gap, we propose GLocFM, a Geometry-aware Localization Foundation Model, which jointly exploits WiFi measurements and scene geometry represented as a 3D point cloud. We formulate localization as a maximum-likelihood (ML) estimation problem, where the goal is to find a transmitter position that maximizes the likelihood of the wireless observations conditioned on the scene geometry. The likelihood of a candidate transmitter position is calculated by a learned scoring function that matches the observed delay--angle-of-arrival (AoA) spectrum against the spectrum predicted for that candidate. A hierarchical scene encoder extracts propagation-relevant features to produce geometric priors for LoS and one-bounce reflection paths. For scenarios with imperfect synchronization, we further introduce a time-of-flight (ToF)-robust GLocFM model to handle unknown ToF offsets. GLocFM is trained on a multi-modal synthetic indoor localization dataset comprising 221 diverse scenes whose associated wireless signals are generated using Sionna RT. On both synthetic and the NeRF$^{2}$ dataset based on real measurements, GLocFM reduces mean 3D localization error relative to one of the state-of-the-art localization baselines by 49.5\% and 48.8\%, respectively. Ablations across different number of receiver, bandwidths, and array sizes further demonstrate the effectiveness and robustness of the proposed framework.

0.40

Channel2World: A Wireless Foundation Model for RF Environment Representation

eess.SP ·2026-08-18 ·Hyung-Joo Moon, Joonkyu Jang, Kwang Soon Kim, Seong-Lyun Kim, Robert W. Heath +1 more
similarity 0.65
Abstract · 13 pages, 10 figures

Wireless channels are commonly treated as link-specific observations, although their multipath structure is governed by the surrounding radio-frequency (RF) environment. In this paper, we propose Channel2World, a wireless foundation model that learns a reusable environment-level representation from multiple-input multiple-output (MIMO) channel-position observations. The model aggregates channels collected within the same base-station-centered environment into a wireless world embedding using a Transformer-based encoder. The encoder is pretrained through context-query prediction, where context channels condition user equipment (UE) position and relative path-gain prediction for disjoint query channels. After pretraining, the encoder is frozen and used as a task-agnostic environment-conditioning module for downstream wireless models, enabling adaptation to unseen environments without site-specific fine-tuning. To learn an environment-level latent space that generalizes across deployments, we pretrain Channel2World using ray-tracing data from 26,000 environments, with approximately 5,000 channel measurements per environment. Evaluations on UE localization, beam-domain channel state information (CSI) reconstruction, and RF-observable geometry reconstruction show that the learned embeddings provide effective conditioning in unseen environments. For localization and CSI reconstruction tasks, embedding-based conditioning outperforms or remains competitive with site-specific fine-tuning, although fine-tuning requires task-specific labeled data and additional gradient-based adaptation. The embeddings also support the reconstruction of dominant reflector structures, indicating their utility as reusable environmental priors across tasks.

0.43

Interpretable Physics Informed WiFi Indoor Localization: Learning an Effective Access Point Geometry and Using It to Prune

cs.AI cs.LG ·2026-09-26 ·Arshia Eftekhari zadeh, Rezvan Nasiri, Hadi Moradi
similarity 0.65
Abstract

Deep learning models can achieve high accuracy for indoor localization, but their black-box nature limits interpretability and the reuse of learned information. We propose a hierarchical deep learning framework for WiFi fingerprint-based indoor localization that jointly predicts user location and learns an effective geometry of the surrounding access points (APs). Physics-informed decoders infer this geometry directly from RSSI measurements and labelled user positions, without requiring the true AP coordinates during training. The learned geometry is then used to rank and prune APs. On the UJIIndoorLoc dataset, the proposed chained model achieves a mean 3D localization error of 7.07 m, reducing error by 26% to 36% compared with baseline models. Previously published methods evaluated on the same official split report errors 10.6% to 31.0% higher. Pruning 35% or 50% of the APs causes only a small loss in localization accuracy. The inferred geometry also enables Fisher-information-based AP ranking even when fingerprint databases do not contain surveyed AP coordinates. Experiments on the Tampere/TUT and UTSIndoorLoc datasets show that geometry-guided AP selection performs comparably to selectors built directly from labelled data. These results show that physics-informed interpretability can improve indoor localization while also supporting effective feature selection.

0.07