CS Paper Radar

AVD: A Multi-Sensor Teleoperated Wheelchair Platform with Safety-Aware Control

Namai Chandra, Madhur Thareja, Boby George

cs.RO ·submitted 2026-11-16 08:26 UTC · v1

Abstract

Electric wheelchairs predominantly rely on manual joystick interfaces, which present critical barriers to independent mobility for individuals with severe motor and visual impairments. This paper presents AVD (Autonomous Vehicle Drive), a dependable teleoperation architecture for assistive mobility that unifies perception, communication, embedded control, and remote supervision in a single low-cost platform built entirely from commercially available hardware. The central engineering contribution is a safety-oriented design framework: control authority follows a static hierarchy, a manual emergency stop and the occupant's joystick pre-empt remote commands, and the on-board sensing layer has stop-only authority. The compute design partitions primary and safety functions and specifies a heartbeat-driven safe-state transition for the fault cases considered. The sensing stack this framework depends on is characterized against measured data: per-channel acquisition latency, a 2,025-scan LiDAR degradation campaign spanning five target configurations and a control under water mist, airborne dust, and direct aperture occlusion, and attitude measurements across static inclines to 47 degrees. The lowest pooled environmental-condition mean retained 76.6% of the clear-baseline forward-sector yield, and no scan lost the sector completely. A logged vibration-induced inertial dropout occurred while LiDAR and camera logging continued, illustrating complementary channel behavior. The result is a documented prototype and an explicit validation path for a deployable wheelchair implementation.

Closest papers

Nearest neighbours by meaning across the whole index.

A Multi-Layer Navigation System for Smart Wheelchairs with a Limited Input Interface

cs.RO ·2026-10-28 ·Piero Simonetto, Anna Polato, Francesco Pasti, Muhammad Rameez ur Rahman, Sebastiano Vascon +4 more
published similarity 0.63
Abstract · 8 pages, 6 figures, 3 tables. Presented at IROS 2026 (IEEE/RSJ International Conference on Intelligent Robots and Systems); to appear in the…

Smart wheelchairs are robotic devices that gather information from the surroundings and allow people to safely drive through various environments. They usually rely on the interpretation of high-level user's intentions, typically decoded through human-robot interface (HRI) or brain-machine interface (BMI). However, navigating in an unknown environment and accurately understanding user commands remain significant challenges. Misinterpretation of commands or the environment can lead to user frustration, distrust of the system, or even unsafe situations. In this paper, we present a novel Multi-Layer Navigation System (MLNS) for a smart wheelchair that enables navigation in unknown environments while interpreting and safely contextualizing user's intentions even in the case of limited and faulty commands. The stack relies on a Virtual Sensors-Driven Potential Fields (ViSPF) method for obstacle detection that accounts for the wheelchair's actual size, a Model Predictive Control (MPC) module for trajectory generation, and an open-vocabulary computer vision algorithm for target identification. Finally, a system based on Priority Queue (PQ) was implemented for target selection. We validated our system on a real smart wheelchair with experiments involving 10 participants without disabilities, including scenarios with faulty input interfaces. The results demonstrate the robustness and effectiveness of our system in real-world environments, proving its potential for practical applications in assistive technologies.

0.36

An Affordable AI-Integrated Smart Cane for Multimodal Mobility Assistance of Visually Impaired Users

cs.AI cs.CVcs.CYcs.RO ·2026-09-12 ·Ali Akarma, Adeel Ahmad, Toqeer Ali Syed
similarity 0.61
Abstract

Visual impairment affects over 2.2 billion people worldwide, yet conventional white canes cannot detect elevated hazards or provide semantic environmental context. Existing AI-assisted navigation systems typically rely on expensive hardware or cloud connectivity, limiting accessibility in resource-constrained settings. This paper presents an affordable (\$88 USD), fully offline AI-integrated smart cane designed for multimodal mobility assistance on an ultra-low-power Raspberry Pi Zero 2W. The system fuses RGB vision sensing with Time-of-Flight (ToF) distance estimation, pairing an INT8-quantized SSD MobileNet V1 model with distance-aware vibrotactile feedback and real-time audio alerts. To ensure operational robustness on constrained hardware, a multiprocessing architecture isolates sensor acquisition, neural inference, and haptic feedback into independent processes with fail-safe sensing support. Experimental evaluation across indoor mobility scenarios demonstrates a macro-averaged F1-score of 0.82 (precision: 0.85, recall: 0.81), a mean end-to-end latency of 330\,ms, and a peak power draw of 2.8\,W. A preliminary usability study with 12 participants (SUS: 78.5, NASA-TLX) demonstrated positive user perception and enhanced obstacle awareness. The proposed prototype validates the feasibility of deploying privacy-preserving, edge-native assistive intelligence for cost-sensitive mobility assistance.

0.23

A Hardware-Partitioned micro-ROS Mini-Vehicle for Operator-Supervised Neural Driving

cs.RO ·2026-10-11 ·Gustavo Claudio Karl Couto, Eric Aislan Antonelo, Gabriel George Zipperer
code/data similarity 0.60
Abstract

We present a low-cost miniature Ackermann vehicle for embedded neural-driving research, organized as a hardware-partitioned perceive-decide-act agent: an ESP32 camera node streams frames over Wi-Fi to a host computer, where neural inference and state estimation run, while an ESP32-S3 chassis controller executes safety-critical actuation in a 100 Hz per-wheel proportional-integral-derivative (PID) loop beneath a micro-ROS client. The partition isolates real-time control and safety on the vehicle while learning-based components run off-board, supervised by an operator from a gamepad. We characterize the complete pipeline during real closed-loop neural driving. Wireless sensing, rather than neural inference, dominates latency, with a 59.5 ms median capture-to-actuation delay; the platform absorbed wireless variability by holding the last safe command under a firmware watchdog, operating across twelve autonomous sessions with zero collisions or manual interventions; and encoder-inertial-measurement-unit (IMU) fusion cut odometry loop-closure error by 22%. These results indicate that carefully partitioned microcontroller-class vehicles support reproducible experiments in embedded AI, wireless control, and operator-supervised autonomous driving. The platform software is open source.

0.33

Cognitive and Behavioural Effects of Haptic Feedback for ROV Teleoperation in Hazardous Environments

cs.RO cs.HCeess.SY ·2026-11-04 ·Joshua Brown, Ildar Farkhatdinov, Michael Jenkin
published similarity 0.58
Abstract · Accepted for IEEE Telepresence 2026

Teleoperating a Remotely Operated Vehicle (ROV) in complex underwater environments presents unique challenges. Dynamic, three dimensional obstacles and unseen water currents pose real risks to expensive robotic hardware in environments in which recovery can be next to impossible. This paper explores the cognitive effects of haptic feedback to improve vehicle safety in such environments. An in-water study is analysed with a ROV exposed to controlled cross-currents, with environmental information presented via a soft and vibrating haptic touchpad. Results demonstrate that while encountering an unseen cross-current significantly increases an operator's physical and temporal demand, the introduction of haptic feedback mitigates these factors and improves self-assessed performance. Interestingly, the haptic condition also produced the highest levels of mental demand and operator frustration. Despite this increased mental workload, operators drove the ROV significantly faster when receiving haptic cues compared to the current-only condition, indicating a higher level of user confidence. Ultimately, these findings suggest that while haptic feedback may initially require more cognitive processing to interpret unseen hazards, it successfully enhances operator awareness and promotes more confident navigation in hazardous environments.

0.27

Revisiting Direct Control: A Field Evaluation of Sensor Fusion Efficacy in Teleoperating Full-Scale Autonomous Vehicles via Bird's Eye View

cs.RO cs.HC ·2026-10-26 ·Stanisław Kuczma, Sławomir K. Tadeja, Michał R. Nowicki
published similarity 0.58
Abstract · Accepted at 2026 IEEE/RSJ International Conference on Intelligent Robots and Systems (IROS)

In autonomous driving, robot teleoperation serves as a critical safety fallback mechanism, requiring operators to assume direct control in the event of system failure. While recent research has pivoted toward high-level supervisory control or simulation-based studies, these approaches often fail to capture the physical dynamics and sensory demands of driving a full-scale vehicle. To address this gap, we evaluated the impact of spatial data representation on operator performance using a real car-sized vehicle in a field experiment with $N = 18$ participants. We compared three visualization interfaces: (i) a standard camera feed baseline, with two bird's-eye views (BEV) from (ii) a raw LiDAR point cloud, and (iii) a sensor fusion of LiDAR and camera data streams. Contrary to prior passive observation studies suggesting that sensor-fusion BEV may hinder awareness, our active-control results demonstrate that such representation significantly outperforms the standard LiDAR BEV in perceived usability ($p \leq 0.0001$) and cognitive task load ($p = 0.01$, NASA-TLX score: 34.58/100) while also being significantly better than the Camera-only view ($p = 0.043$). The fused interface also led to statistically significant reductions in task completion time ($p = 0.0461$) and superior usability (SUS: 77.9/100) compared to those of the Camera-only and LiDAR-only views. By synthesizing objective performance data with comprehensive subjective assessments, we demonstrate that BEV fusion maximizes safety margins while minimizing the operator's mental demand. These findings challenge existing teleoperation conventions and provide an empirically validated approach for designing robust remote piloting systems.

0.29

Human Situational Awareness and Workload during Heterogeneous Autonomous Vehicle Hazard Monitoring: A Cross-Platform Study

cs.HC ·2026-10-12 ·Ziyue Wang, Yang Xing, Argyrios Zolotas, Adolfo Perrusquia, Weisi Guo +1 more
similarity 0.57
Abstract

As autonomous ground and aerial vehicles become increasingly capable, human operators are transitioning from direct control to supervisory monitoring roles. Maintaining Situational Awareness (SA) during rare but safety critical hazard events remains a fundamental challenge, particularly when operators must monitor heterogeneous autonomous platforms with different spatial and cognitive demands. This study develops a unified experimental framework for investigating human SA and workload during supervisory monitoring of autonomous ground and aerial vehicles under hazard conditions. Eighteen participants completed six within-subject conditions combining three interface modalities, namely, visual-only, haptic-only, and visual-haptic, with two platform types, ground vehicle and aerial drone. SA was measured using Situation Awareness Rating Technique (SART), while workload was assessed using the NASA Task Load Index (NASA-TLX). The key findings are: 1) Aerial monitoring produced significantly lower overall SA, higher situational demand, and greater workload than ground monitoring, driven by elevated Demand and reduced Understanding rather than diminished Supply. 2) Workload was consistently coupled with situational demand across all conditions, suggesting a stable SA-workload mechanism. 3) Both haptic-only and visual-haptic significantly improved overall SA relative to visual-only without increasing workload, demonstrating that interface design can enhance awareness within the existing workload envelope. These findings establish a cross-platform behavioural baseline for designing multimodal interfaces that enhance operator SA without elevating workload in heterogeneous autonomous vehicle systems.

0.27

Toward Resilient Self-Driving Laboratories through Telerobotic Interventions

cs.RO ·2026-11-13 ·Ziheng Wu, Adrian Vecina Tercero, Andre A. Fatehi, Abhik Sarkar, Brian Giera +4 more
similarity 0.56
Abstract

Self-driving laboratories (SDLs) accelerate scientific research by integrating robotics, automated experimentation, and machine learning to execute experiments autonomously. Biology and chemistry have adopted these systems. However, increasing SDL complexity heightens susceptibility to unexpected faults in automated workflows, highlighting the need for efficient recovery mechanisms. In this study, we investigate telerobotic interventions to enhance SDL resilience against unexpected failures. We developed a teleoperation interface enabling human operators to resolve disruptions during automated tasks. The interface enables precise control of a six-degree-of-freedom (DOF) robotic arm (UR3e) using a 3D mouse (3Dconnexion SpaceMouse Pro). Two velocity-based controller strategies were evaluated: (i) a coupled mode mapping all six DOFs to the 3D mouse's central knob and (ii) a decoupled mode separating translational and rotational motions. To evaluate the framework, teleoperators intervened across three SDL fault scenarios. In the first study, comparative trials showed that the decoupled controller was associated with shorter completion times and reduced rotational motion. In a second study, teleoperators performed an aiming task with and without reference-path guidance. Users were more target-driven and risk-tolerant without guidance but showed behavioral differences under different guidance strategies. These findings suggest that controller configuration and reference-path design influence operator performance during SDL fault recovery, informing teleoperation interface optimization. This work demonstrates the potential feasibility of teleoperation as a human-in-the-loop recovery mechanism for SDL workflows, combining robotic precision with human adaptability and problem-solving. These findings also provide a foundation for future studies in shared autonomy and semi-autonomous intervention.

0.16

Tele-Traversability: Rethinking Traversability for Teleoperated Ground Robots in Terrain Navigation

cs.RO ·2026-09-17 ·Lewei Feng, Qi Chen, Wenshuo Wang, Xianghao Meng, Minh Kieu +4 more
similarity 0.56
Abstract

Teleoperation, a human-in-the-loop control scheme, allows a human operator to remotely command and guide a mobile robot to navigate in off-road environments, yet fluent and user-friendly tele-navigation requires an alignment of traversability evaluation between human and robot. In the teleoperation system, the human operator typically utilizes off-site incomplete and delayed feedback via a human-machine interface to make a judgment of traversability, while the robot makes such an evaluation based on in situ onboard sensory information, which could cause divergent traversability estimation and thus generate mismatched decisions and actions. Existing approaches for traversability modeling, estimation, and prediction are mainly derived from the view of robots, i.e., robot-centric, and are practically suitable for fully autonomous mobile robots, but neglect the influence of human operators. To address this problem, this paper extends the concept of traversability from robot-centric to human-centric by accounting for the operator's cognitive states, such as attention, workload, and risk tolerance or awareness, termed tele-traversability. We first revisit the definitions and roles of traversability in robotics and then extend them to teleoperation settings. Finally, we highlight future trends and open challenges of tele-traversability toward human-centric teleoperation systems.

0.28