CS Paper Radar

Sparse Rotatable Arrays (SRA): Unifying Array Aperture and Antenna Directivity for Wireless Communications

Ailing Zheng, Qingqing Wu, Xiyuan Liu, Wen Chen

cs.IT ·submitted 2026-08-12 05:22 UTC · v2

Abstract

Sparse rotatable array (SRA) is a novel reconfigurable antenna architecture that jointly exploits sparse aperture configuration and antenna directivity to enhance spatial resolution for future wireless communications. Specifically, SRA activates a subset of rotatable antennas over a large candidate aperture and adjusts their boresight directions, thereby creating a directionally selective sparse aperture with reduced hardware requirements and enhanced spatial flexibility. In this paper, we investigate an SRA-aided multi-group communication system, where users are organized into spatial groups with different service requirements. We develop a group-aware SRA design framework by jointly optimizing the sparse-aperture allocation, RA orientations, and transmit beamforming to maximize the weighted max-min signal-to-interference-plus-noise ratio (SINR). Then, we characterize the operating principles of SRA and reveal that sparse aperture improves spatial resolution by enlarging the effective array aperture, while antenna directivity suppresses inter-group coupling through directional control, thereby enabling simplified group-wise beamforming structures. Guided by these insights, we develop a structured low-complexity alternating optimization algorithm that embeds a closed-form projected group-center RA orientation rule into the sparse-aperture allocation and beamforming design. The proposed algorithm combines analysis-guided initialization, sampled multi-start antenna-allocation search, and bisection-based second-order cone programming for beamforming. Numerical results show that the proposed SRA design closely approaches fully-shared SRA benchmarks and significantly outperforms compact subarray and omni sparse-array schemes.

Closest papers

Nearest neighbours by meaning across the whole index.

Sparse Rotatable Arrays (SRAs) for Cell-Free MIMO: Network-Wide Design of Antenna Activation and Panel Orientation

cs.IT ·2026-11-15 ·Ailing Zheng, Qingqing Wu, Xiyuan Liu, Wei Feng, Wen Chen +1 more
benchmark similarity 0.72
Abstract

This paper investigates a sparse rotatable array (SRA)-enabled cell-free multiuser multiple-input multiple-output (MIMO) system. Under a network-wide antenna activation budget, distributed access points (APs) select active antenna elements from their installed arrays and adjust panel orientations, enabling joint control of sparse array apertures and antenna directivity. To avoid frequent hardware reconfiguration in response to instantaneous channel variations, we formulate a two-timescale stochastic optimization problem to maximize the expected minimum-user rate. Long-term antenna activation and panel orientations are optimized based on user spatial distributions and statistical channel state information (CSI), while short-term precoders adapt to instantaneous CSI. Under line-of-sight (LoS) propagation, we derive the optimal single-user antenna allocation, characterize the two-user max-min signal-to-interference-plus-noise ratio (SINR) and establish conditions for discrete activation and panel rotation to attain the continuous-position benchmark, and obtain a closed-form multi-AP zero-forcing (ZF) allocation benchmark under a continuous antenna-count relaxation. For the general mixed-integer nonconvex stochastic problem, we develop an alternating algorithm based on sample-average approximation (SAA), integrating uplink-downlink (UL-DL) duality for short-term precoding, weighted minimum mean-square error (WMMSE) surrogates for panel-orientation optimization, and multi-start greedy search for antenna activation. Numerical results demonstrate that the proposed design outperforms the fixed-array benchmark, improves all-user service reliability with fewer active antennas, and adapts effectively to nonuniform user spatial distributions.

0.23

Flexible Beamforming via Fluid Antenna Array: From Discrete to Continuous Array

cs.IT ·2026-10-25 ·Jingyuan Xu, Yuanhui Wu, Zhentian Zhang, Zaichen Zhang, Tuo Wu +4 more
similarity 0.65
Abstract · 12 pages, 9 figures. Submitted to IEEE Transactions on Wireless Communications

Fluid antenna arrays (FAAs) reconfigure their effective aperture by activating radiation ports from a dense set of candidate positions within a finite physical region, thereby offering geometry diversity beyond conventional fixed arrays. This paper studies arbitrary-direction far-field beam synthesis with a planar FAA. Since a fixed array adapts its beamforming weights on a predetermined spatial sampling structure, its ability to match desired beam patterns is limited when both the aperture and the number of active elements are constrained. To exploit the geometry diversity of the FAA, we propose a coarse-to-fine scheme that couples discrete port selection with continuous joint refinement. In the coarse stage, a fast Fourier transform (FFT) based phase retrieval step converts the amplitude-only beam specification into an aperture-compatible complex target, after which an FFT-tailored greedy method selects the active ports and least squares initializes their complex weights. In the fine stage, a projected adaptive moment estimation procedure jointly refines the continuous port positions and beamforming weights while enforcing the minimum interelement spacing. For the evaluated two-beam configuration, the proposed scheme increases the mainlobe energy fraction from 35.73% to 48.92% and reduces the peak sidelobe level from -2.30 dB to -3.83 dB relative to a fixed array with the same aperture and active-port count.

0.30

User Association and Transmit Beamforming for Rotatable Antenna-Enabled LAE Networks

eess.SP ·2026-09-28 ·Bowen Yao, Chao Zhang, Ying-Chang Liang
similarity 0.64
Abstract

This paper investigates rotatable antenna (RA)-enabled low-altitude economy (LAE) networks, where multiple base stations (BSs) are deployed to serve both terrestrial and aerial users. Unlike conventional fixed orientation antennas, RAs can adjust their boresights to serve users at diverse azimuth and elevation angles, thereby providing three-dimensional (3D) coverage. To improve the performance of LAE networks, we formulate a network sum-rate maximization problem that jointly optimizes user association, transmit beamforming, and RA orientations. However, in such LAE networks, aerial users are often visible to multiple BSs through line-of-sight (LoS) links, making user association and interference management particularly challenging. Moreover, user association and RA orientations are closely coupled: user association affects the RA pointing directions, while the RA orientations in turn reshape the channel conditions for user association. To solve this problem, we propose an alternating optimization (AO) algorithm that integrates weighted minimum mean-square error (WMMSE) for transmit beamforming, projected gradient ascent updates for user association, and Frank-Wolfe updates for RA orientations. Furthermore, we develop a discrete candidate-scanning scheme that replaces continuous orientation optimization with a finite search to reduce computational complexity. We also propose an antenna block-based scheme to reduce the number of orientation variables. Simulation results show that the proposed joint design achieves a higher sum-rate than the fixed antenna orientation and nearest BS association benchmarks. Moreover, the candidate-scanning and block-based schemes achieve approximately 89.9% and 94.3% of the performance with high transmit power, respectively, while reducing the complexity of orientation updates.

0.17

Pinching Antenna-Assisted Full-Duplex Communication Systems

cs.IT ·2026-09-24 ·Xuan Li, Xianfu Lei, Mingjiang Wu, Sotiris A. Tegos, Panagiotis D. Diamantoulakis +1 more
similarity 0.63
Abstract

Full-duplex (FD) communication theoretically doubles spectral efficiency. Despite this potential, its practical performance is primarily constrained by severe self-interference (SI) and co-channel interference. Moreover, conventional fixed antenna arrays suffer from limited spatial flexibility, resulting in insufficient spatial isolation for SI suppression. To address this issue, this letter proposes an FD architecture assisted by pinching antenna systems (PASS). By dynamically adjusting transmit and receive antenna positions, the system enables large-scale channel reconfiguration, thereby synergizing with the base station (BS) beamforming to suppress SI and enhance the desired signal reception. To demonstrate the potential of PASS for FD communication, we formulate a weighted sum-rate maximization problem that jointly optimizes antenna positions, BS beamforming, and power allocation. To tackle this non-convex problem, we reformulate it using the weighted minimum mean square error (WMMSE) framework and develop an efficient alternating optimization (AO) algorithm to iteratively update the optimization variables. Simulation results reveal that the proposed PASS-assisted FD architecture significantly outperforms conventional fixed antenna arrays, achieving substantial sum-rate gains while effectively mitigating SI to enable FD operation.

0.14

Fast Tuning of Pinching Antenna-Assisted ISAC Systems via User Clustering

eess.SP ·2026-10-05 ·Ruizhi Niu, Ali Bereyhi
publishedbenchmark similarity 0.63
Abstract · This work has been accepted for publication in the Proceedings of the IEEE Global Communications Conference (GLOBECOM) 2026

Pinching-antenna systems (PASSs) offer a great degree of flexibility for integrated sensing and communications (ISAC) by adapting the pinching locations for both communication channel reshaping and sensing-beam steering. Despite that, direct location optimization in PASSs is high-dimensional and non-convex, making their fast reconfiguration difficult in practice. This work proposes a low-complexity PASS-assisted ISAC design based on user clustering. Instead of direct optimization of pinching locations, the elements on each waveguide are distributed over multiple segments, where each segment serves a cluster of users or targets. This alternative configuration reduces the location tuning problem to a low-dimensional weight allocation task, which can be efficiently addressed via a gradient based method. We propose a low-complexity iterative algorithm, in which the digital precoder is updated via an equivalent weighted mean squared error minimization, and pinching locations are updated via weight allocation and projection. Our numerical experiments show that the proposed design can significantly enhance the communication-sensing trade-off of ISAC systems over the benchmark designs with modest computational cost. The results highlight the potential gain of deploying PASS-assisted transceiver in practical ISAC systems.

0.19

Adaptive Antenna Element Activation for Multiuser Uniform Spherical Arrays

eess.SP ·2026-09-18 ·Ao Li, Cunhua Pan, Wang Liu, Hong Ren, Jiangzhou Wang
similarity 0.63
Abstract

Uniform spherical arrays provide full-space coverage. However, owing to directional element patterns, full-array transmission activates many elements that contribute little to a given user, resulting in increased system overhead and inefficient power allocation. To address this issue, this letter proposes an adaptive element activation strategy for multiuser uniform spherical arrays that reduces the number of physically active elements while satisfying individual user rate requirements. The proposed strategy constructs a user-specific candidate sequence according to the angle between each element boresight and the user direction. At each iteration, it selects, among the unsatisfied users, the user-element connection that provides the largest improvement in the aggregate rate deficit. Simulation results show that fewer than half of the elements are sufficient for a single user to achieve 80% of its full-array rate, while fewer than 70% are sufficient to achieve the full-array rates of all users in multiuser scenarios. Moreover, the proposed strategy consistently requires a lower active-element ratio than the baseline methods across all tested configurations.

0.20

Joint Discrete Pinching-Antenna Activation and Beamforming Design for Efficient PASS-ISAC

eess.SP ·2026-10-02 ·Joshua Ogundiya, Animesh Yadav, Octavia Dobre
published similarity 0.63
Abstract · 6 pages, 5 figures, accepted for publication in the proceeding of the IEEE CCNC-2027

Pinching-antenna systems (PASS) offer flexible radiation points for integrated sensing and communication (ISAC), but existing designs largely assume continuous antenna placement, which may be impractical with pre-installed hardware. We investigate a discrete-activation multi-waveguide PASS-ISAC system that selects sparse transmit and receive pinching antennas (TPAs/RPAs) from predefined locations. We formulate a communication-rate maximization problem by jointly optimizing beamforming and TPA/RPA activation under transmit-power, activation, and sensing signal-to-noise ratio (SNR) constraints. To solve this nonconvex problem, we develop a low-complexity joint discrete pinching-antenna activation and beamforming optimization (JDPABO) algorithm based on alternating optimization, successive convex approximation, and reweighted $\ell_1$ minimization. Simulations show that JDPABO approaches continuous-placement performance at low sensing SNR requirements and outperforms fixed activation schemes with sparse PA activation.

0.25

Achievable Rate Region Characterization of Rotatable Antenna-assisted Interference Channel

cs.IT ·2026-10-16 ·Junran Pei, Guangji Chen, Qingqing Wu, Qiaoyan Peng, Wei Cai
similarity 0.63
Abstract

This paper characterizes the achievable rate region of a rotatable antenna (RA)-assisted multiple-input single-output (MISO) interference channel. We exploit the additional spatial degrees of freedom (DoFs) offered by the dynamic orientation of RAs to simultaneously enhance the desired signal and suppress interference, thereby significantly enlarging the achievable rate region of the interference network. To this end, we invoke the rate-profile technique to formulate a sum-rate maximization problem for jointly optimizing the transmit beamforming and the array rotation, subject to the practical mechanical constraints of the RAs. For the special case of a two-receiver scenario, we introduce the concept of subspace correlation coefficient to derive closed-form solutions for the optimal RA rotation angles and transmit beamforming vectors. Inspired by the insights obtained in the two-receiver special case, we propose an efficient two-step optimization framework to obtain a high-quality solution for the general multi-receiver case. In particular, the array rotation angle of each transmitter is optimized to minimize the leakage interference to non-associated receivers. With the optimized array rotation angles, the optimal transmit beamforming is obtained by invoking the second order cone programming based approach. Numerical results demonstrate that the proposed solution achieves near-optimal performance and that integrating RAs effectively simplifies transceiver designs by enabling simple maximum ratio transmission (MRT) beamforming with negligible performance loss.

0.24