CS Paper Radar

Diffused-Beam Laser-Diode LiFi Under Realizable Receiver, Noise, and Safety Constraints: Design-Space Analysis and an Open Cross-Verified Simulation Framework

Hussain Ahmad, Saleem Aslam, Ammara Nasim, Syed Muhammad Talha Gillani, Toheed Omer

eess.SP cs.NIcs.PF ·submitted 2026-08-15 13:49 UTC · v1
code/data

Abstract

Link-budget studies of indoor optical wireless systems frequently assume receiver parameter sets--large photodetector area, large transimpedance, and wide bandwidth simultaneously--that violate basic circuit constraints, and noise budgets that omit dominant amplifier and laser noise. This paper develops a realizability-constrained design-space analysis of a diffused-beam laser-diode (LD) LiFi link anchored to a hardware prototype. The analysis couples the generalized Lambertian channel of a holographic-diffuser source to a receiver model that enforces the transimpedance-amplifier gain-bandwidth/capacitance constraint and carries a complete noise budget: shot, feedback-resistor thermal, input current noise, capacitance-driven voltage-noise gain, and laser relative intensity noise (RIN). Against this budget we evaluate unipolar M-PAM under two FEC tiers (7%-overhead hard-decision at $3.8 \times 10^{-3}$, 20%-overhead soft-decision at $2 \times 10^{-2}$), first-bounce diffuse multipath, and a quantitative extended-source eye-safety assessment. The full model predicts 140 Mb/s net at the prototype's demonstrated 14-m range with 6.7 dB margin (OOK, HD tier), 240 Mb/s at the zero-margin 4-PAM/SD reach boundary of 14.0 m, and 480-558 Mb/s at 5 m--a factor 3.9-6.6 below what the same link yields under a naive textbook budget, quantifying how strongly idealized assumptions inflate LiFi projections. First-bounce analysis shows the downfacing-source/up-facing-receiver geometry confines multipath to a worst-case LOS-to-diffuse ratio of 4.2 dB and delay spreads below 0.13 ns, and the 500-mW source remains a factor $\ge 7.8$ under the Class-1 eye-safety limit. All models are released as an ns-3 module and Python engine backed by automated testing.

Comment
15 pages, 16 figures, Journal

Closest papers

Nearest neighbours by meaning across the whole index.

Laser-Diode LiFi With Diffused-Beam Optics: System-Level Modeling and a Cross-Validated ns-3 Simulation Framework

eess.SP cs.NI ·2026-08-11 ·Hussain Ahmad, Syed Muhammad Talha Gillani, Toheed Omer, Saleem Aslam
publishedcode/data similarity 0.75
Abstract · 8 pages, 15 figures, Journal

Laser diodes (LDs) promise an order-of-magnitude bandwidth advantage over light-emitting diodes for indoor optical wireless access, but reported prototype studies frequently leave the gap between hardware demonstrations and system-level performance unquantified. This paper develops a complete, reproducible system model of a diffused-beam LD LiFi transceiver - a 500-mW laser source beam-shaped by a holographic diffuser, an intensity-modulation/ direct-detection (IM/DD) receiver, and adaptive M-QAM signaling - and embeds it in two cross validated simulators: an open ns-3 module providing full-stack network simulation (channel, PHY, ARQ MAC, Net Device, IP/UDP/TCP) and a Python link-level engine used for Monte Carlo validation of all analytical error models. Starting from a hardware prototype that transferred data, real-time voice, and images over a 14-m line-of-sight link, we identify and close the technical gaps typical of prototype-class reports: serial-interface throughput ceilings misread as optical-link capacity, absent noise modeling, unmeasurable error floors, and unexamined beamwidth/coverage trade-offs. The framework shows that the same optical front end, freed of its 2-Mbaud UART bottleneck and driven at its 250-MHz electrical bandwidth, supports 930 Mb/s net at 14 m under a $3.8 \times 10^{-3}$ HD-FEC threshold with 16-QAM, scales to 1.86 Gb/s at 5 m with 256-QAM, and sustains on-off keying to 23.3 m; a $20^\circ$ diffuser covers a 4.2-m-radius cell of a standard room at desk height. Network simulations over the ns-3 stack yield saturation goodput within 7% of the PHY line rate and sub-0.11-ms 99th-percentile latency at 70% load. All models, code, and figures are released for reproduction.

0.72

Statistical Inference-Based Channel Estimation for LD-Driven Visible Light O-OFDM Systems in the Presence of Relative Intensity and Input-Signal-Dependent Shot Noise

eess.SP ·2026-09-14 ·Shubham Saxena, Karra Sreeman Reddy, Suraj Srivastava, Subrahmanya Swamy Peruru, Aditya K. Jagannatham +1 more
benchmarktheory similarity 0.55
Abstract

Laser diode (LD)-based luminaires are gaining increasing attention in automotive applications and are expected to extend to residential and commercial environments, creating opportunities for high-bandwidth visible light communication (VLC) systems. However, practical LD-based VLC links are impaired by input-signal-dependent shot noise (ISDSN), relative intensity noise (RIN), and thermal noise, which affect reliable channel estimation (CE). This work investigates their joint impact on receiver-side CE in a single-input single-output (SISO) optical orthogonal frequency division multiplexing (OOFDM) VLC system under a statistically random channel model. A statistical inference framework is developed in which the receiver exploits observed signal variations to estimate the channel under optical impairments. Closed-form expressions are derived for least squares (LS), maximum likelihood (ML), maximum a posteriori probability (MAP), minimum mean square error (MMSE), and linear MMSE (LMMSE) estimators. In addition, the Bayesian Cramer-Rao lower bound (BCRLB) is derived to benchmark mean square error (MSE) performance. Monte Carlo simulations for direct current-biased O-OFDM (DCO-OFDM) and asymmetrically clipped O-OFDM (ACO-OFDM) validate the analysis. Results show substantial CE degradation under the joint presence of ISDSN and RIN, while the MMSE estimator consistently achieves the lowest MSE, demonstrating strong potential for robust and adaptive receiver operation in practical VLC systems.

0.37

Low-complexity Soft-decision LLR Calculations for Next-generation IM-DD Systems with RIN

eess.SP ·2026-08-20 ·Felipe Villenas, Yunus Can Gültekin, Alex Alvarado
published similarity 0.51
Abstract

The demand for higher speeds in intra-data center interconnects will eventually require high-order pulse amplitude modulation (PAM) combined with soft-decision (SD) forward error correction (FEC). The laser relative intensity noise (RIN) is an important noise impairment that limits the performance of high-speed intensity-modulation (IM) and direct-detection (DD) systems, as it induces a channel with signal-dependent noise. In this paper, we show that an accurate calculation of the log-likelihood ratios (LLRs) is critical for the performance of the SD-FEC decoder in RIN-dominated IM-DD systems. First, we show that assuming signal-independent additive white Gaussian noise (AWGN) statistics to compute LLRs results in a significant penalty in performance. As an alternative, we propose a low-complexity piecewise linear approximation of the exact LLRs of Gray-coded PAM-4 and PAM-8 for the RIN-dominated IM-DD channel. We show using the generalized mutual information that our approximation results in no performance loss versus using exact LLRs, unlike the AWGN-like assumption. Furthermore, we validate the analysis with bit error rate (BER) performance of SD decoding. We show that our approximation matches the BERs achieved using exact LLRs. Therefore, our approximation avoids a BER error floor penalty of up to 7.2 times using an extended Hamming code with PAM-4, and up to 2.41 dB of optical modulation amplitude penalty using high-code-rate low-density parity-check codes with PAM-8 for the same target BER.

0.33

Analysis of Non-Separable Scattering in WDM-Based NLoS Holographic MIMO

eess.SP ·2026-10-02 ·Ashutosh Prajapati, Prathapasinghe Dharmawansa, Italo Atzeni
theory similarity 0.48
Abstract · Submitted to IEEE Wireless Communications Letters

Although scattering is inherently non-separable, holographic multiple-input multiple-output channels are commonly modeled using separable scattering across the source and receiver. In this paper, we investigate non-separable scattering in a non-line-of-sight holographic line model based on wavenumber-division multiplexing. We model its power spectral factor (PSF) using a bivariate von Mises-Fisher (vMF) distribution and introduce a non-separability parameter. We prove that the marginal densities flatten and their Kullback--Leibler divergence from the uniform distribution decreases monotonically with non-separability. Using majorization theory, we further establish that an upper bound and an approximation at low signal-to-noise ratio (SNR) of the ergodic spectral efficiency increase monotonically. Numerical results validate the analysis and demonstrate the performance gains of non-separable scattering over its separable counterpart.

0.28

Scattering-Mediated NLOS Ultraviolet Communication: Channel Characterization, Modeling, and Data Transmission

eess.SP ·2026-10-12 ·Jian Shao, Tilahun ZerihunGutema, Wasiu O. Popoola
similarity 0.47
Abstract

Solar-blind ultraviolet (UV) optical wireless communication (OWC) enables non-line-of-sight (NLOS) transmission through atmospheric scattering. This work presents a comprehensive experimental and simulation study of a 100 m outdoor UVC link with comparative measurements under LOS-blocked and open-field conditions. The results show that LOS-blocked scattering-mediated links exhibit substantially higher path loss and narrower bandwidth than corresponding open-field measurements, highlighting the impact of residual LOS components in practical diffused beam UVC experiments. A photon-tracing Monte Carlo (MC) framework incorporating realistic transmitter/receiver characteristics and obstacle geometry is further developed to reproduce the measured channel characteristics with high accuracy. Despite the severe path loss and pulse broadening effects, reliable 20-200 kbps transmission is experimentally demonstrated over the 100 m LOS-blocked link using on-off keying (OOK) and pulse-position modulation (PPM), representing the longest-distance and highest-data-rate experimental demonstration of an explicitly LOS-blocked scattering-mediated UVC link reported to date.

0.31

Communication-Oriented Channel Characteristics of Holographic Curvature-Reconfigurable Apertures

eess.SP ·2026-09-29 ·Hang Lin, Shu Sun, Hangsong Yan, Qiuming Zhu
published similarity 0.47
Abstract

This letter investigates the joint impact of array curvature and mutual coupling (MC) on holographic curvature-reconfigurable apertures. An analytical framework is developed to characterize spatial correlation, coupling-aware reference directivity, and spectral efficiency. Under the small-curvature regime, we establish a relation linking inter-element distances to coupling perturbations and spatial-mode eigenvalues. Simulation results reveal asymmetric spectral-efficiency variations between transmit- and receive-side array curvature with MC, while their no-MC difference is consistent with zero under hemispherical isotropic scattering. Results based on the 3rd Generation Partnership Project clustered delay line-B channel angular/power profile, together with colored-noise sensitivity analysis, further show that the effects of curvature and receive-side coupling depend on the propagation angular distribution and receiver-noise covariance. These findings highlight the importance of jointly accounting for array geometry, mutual coupling, and receiver noise when evaluating curved holographic multiple-input multiple-output links.

0.57

Analytical Channel Modeling and Stability Aware Optimization of Optical Inter Satellite Links

cs.IT physics.optics ·2026-09-15 ·Hossein Safi, Ziheng Wang, Stijn Mast, Harald Haas, Iman Tavakkolnia
top venue similarity 0.46
Abstract

Optical inter-satellite links (OISLs) are key enablers for high-capacity space networks and next-generation satellite constellations. However, their extreme directionality makes link reliability highly sensitive to platform-induced pointing jitter, which causes random misalignment between the transmitter and receiver beams. In this paper, we develop a tractable closed-form statistical channel model for point-to-point OISLs subject to independent pointing errors at both terminals. Accurate Gaussian main-lobe approximations are applied to the transmitter far-field pattern and receiver coupling efficiency. This transforms the diffraction-based channel response into closed-form expressions for the channel-gain distribution, outage probability, and ergodic capacity. The analytical results are validated through Monte Carlo simulations and used to study the impact of terminal stability, beam divergence, and link margin on OISL performance. The results show that outage probability is governed by the weaker terminal in terms of pointing stability, while improving only the stronger terminal provides minimal additional benefit. In contrast, the ergodic-capacity penalty depends on the combined stability of both terminals, revealing a fundamental distinction between reliability and throughput metrics. The proposed framework provides practical design guidelines for selecting beam parameters and specifying pointing and tracking requirements under varying levels of platform instability.

0.30

An Efficient Correlation-based Evaluation of the GN-Model for General Multi-Span Optical Systems

eess.SP ·2026-10-08 ·Y. Jiang, Y. Gao, P. Poggiolini
similarity 0.46
Abstract · The paper is identical to a manuscript submitted to JLT in October 2026

Accurate and computationally efficient evaluation of non-linear interference (NLI) remains challenging in multi-band WDM systems comprising heterogeneous spans and nonidentical channels. In such systems, channels may have distinct spatial power profiles and multi-subcarrier structures. Spans may use different fiber types with span-dependent dispersion and loss profiles. These systems may further employ general amplification schemes, including forward and backward Raman amplification. Inter-channel stimulated Raman scattering and multiple lumped gain or loss elements may also be present. In this encompassing framework, we provide an efficient decomposition of the GN-model NLI contributions. We show that the NLI power spectral density at any frequency across the WDM comb is fundamentally driven by the spatial auto- and cross-correlations of the channels' spatial power profiles or, equivalently, by the corresponding energy spectra. For this reason we call this formalism the `correlation GN-model', or cGN. Once these correlations or spectra have been computed, the remaining calculations reduces to a fast, well-behaved one-dimensional numerical integral. Moreover, cGN fully accounts for coherent interference of NLI in every pair of spans. Such coherence is often neglected or approximated in existing analytical and semi-analytical GN-model formulations, although it can increase the NLI by several dB. In short, the cGN framework applies to any general systems over any band and any bandwidth, with very high computational efficiency. It is capable of providing the frequency spectrum of NLI at multiple frequencies across each channel or subcarrier. Its accuracy is very high because virtually no approximations are invoked. The cGN framework is available as freely downloadable software from the European Union Zenodo website.

0.25