CS Paper Radar

SonicNudge: Controlled Displacement of Hovering UAVs via Estimator-Controller Coupling

Shaocheng Luo, Ashir Raza, Haocheng Meng, David Hunt, Miroslav Pajic

eess.SY cs.RO ·submitted 2026-08-26 03:03 UTC · v2

Abstract

UAV displacement attacks have traditionally relied on spoofing sensors that directly report position or translational motion, such as GNSS and optical flow. In this work, we introduce SonicNudge, a new attack primitive that instead targets the gyroscope and shows that low-level inertial errors can be transformed into controlled displacement of hovering or slow-moving UAVs. The attack exploits estimator--controller coupling: a small gyroscope perturbation by ultrasonic resonance can persist as an attitude-estimation bias, and the flight controller can convert this biased estimate into a shifted hover point. This behavior is especially relevant to UAV tasks that require hovering, station-keeping, slow approach, or precise final alignment, such as perimeter denial, inspection, docking, landing alignment, and close-proximity operation, where meter-scale position errors can be operationally meaningful. We analyze this attack primitive in a PX4-style flight stack and validate it through 81 simulation runs and more than 10 indoor/outdoor physical experiments, showing that displacement is governed by estimator weighting, bias observability, and closed-loop position correction. Our study suggests that UAV and vehicle-system security should look beyond direct navigation spoofing and pay closer attention to low-level inertial errors and estimator--controller coupling as a subtle but important attack surface.

Closest papers

Nearest neighbours by meaning across the whole index.

Phantom Navigator: Stealthy and Precise Unmanned Aerial Vehicle Redirection with Real-Time Tracking and GPS Spoofing

cs.RO eess.SY ·2026-08-26 ·Haocheng Meng, Shaocheng Luo, Songqiao Xie, Miroslav Pajic
similarity 0.65
Abstract

Redirecting unmanned aerial vehicles (UAVs) from their intended mission trajectories has been an active area of research. However, existing UAV redirection attacks lack reliability, precision, and covertness for a targeted diversion. They primarily rely on physical capture, communication hijacking, or sensor spoofing. Yet, physical interception is costly, offers only a single opportunity for success, and poses a high risk of collateral damage; network-based attacks demand deep technical expertise and access to encrypted communication channels; and sensor spoofing techniques typically fall short in achieving the accuracy and robustness required to steer a UAV toward a specified target. Consequently, we propose Phantom Navigator, a UAV redirection attack to mislead drones to a designated spoofing target, covertly and precisely. Our approach combines offline pre-redirection reachability analysis, which provides high-fidelity estimates of achievable redirect ranges, with an online closed-loop, stealthy execution layer that ensures successful redirection in practice. Based on this approach, we build a physical attack platform equipped with a LiDAR--camera detection, tracking, and spoofing stack that performs real-time identification, pose estimation, and computation of targeted spoofing signals to covertly and accurately redirect victim UAVs to a designated location. We demonstrate the effectiveness of our redirection methodology and the attack implementation in real-world case studies.

0.33

CAPTURER: A Dexterous Aerial Manipulator for Dynamic and Precise Grasping across Diverse Environments

cs.RO ·2026-10-29 ·Meng Wang, Jindou Jia, Sicheng Zhou, Zeshuai Chen, Kexin Guo +2 more
similarity 0.59
Abstract

As a representative form of embodied robotic interaction, aerial grasping requires close coordination between the aerial platform and manipulator. Most existing systems perform aerial grasping with static or slowly moving targets under fixed scenarios. Dynamic and precise grasping across different conditions introduces additional challenges, including target motion, localization drift, dynamic coupling, and external disturbances. In this work, we present CAPTURER, a dexterous aerial manipulator for centimeter-level grasping across diverse environments. To achieve the challenging goal, we first develop an onboard perception system for state estimation and target detection. Drift correction and global pose transformation are introduced to improve target localization during flight. A cooperative motion planner is proposed to coordinate the mobility of the aerial platform with the dexterity of the manipulator according to the relative target state. To maintain grasping accuracy under disturbances, we design a disturbance-rejection controller to compensate for dynamic coupling, model uncertainty, and external disturbances. The capability of CAPTURER is validated through indoor and outdoor experiments with both static and moving targets. The results demonstrate that CAPTURER achieves centimeter-level grasping accuracy for a marker pen measuring only 1.5 cm in diameter at flight speeds exceeding 1.5 m/s.

0.24

Detecting Formation-Preserving GNSS Spoofing of UAV Swarms through Transmitter Parallax in Pseudorange and Doppler

cs.CR eess.SP ·2026-11-19 ·Minseok Park, Joon Soo Yoo
similarity 0.59
Abstract · 16 pages, 7 main figures, 7 main tables. Includes supplementary appendices

Swarms of unmanned aerial vehicles (UAVs) detect Global Navigation Satellite System (GNSS) spoofing by checking the drones' reported positions against their known formation. Formation-preserving spoofing evades this check: in GNSS-WASP, one transmitter per satellite, a few kilometres away, shifts the whole swarm while keeping its formation. We show that such an attack still leaves a trace below the position level. Because the transmitters are close, each drone sees them under a slightly different angle, and this parallax bends the signal arrival times across a 90 m swarm by 20-40 cm for a transmitter at 5 km, whatever delays the attacker applies. We propose a likelihood ratio test that reads this trace from the pseudoranges and Doppler every drone already measures, with all clocks and attacker delays unknown and no extra antennas. In simulations with real GPS and Galileo orbits and white receiver noise, 16 drones detect GNSS-WASP at 5 km in 13-60% of 10 s windows in straight flight and in every window during a formation turn with a precise Doppler receiver, where the countermeasure proposed with GNSS-WASP detects at most 5%. The same test also catches single-transmitter and ground-array spoofing.

0.41

Towards Agile Vision-Based Multi-UAV Flight: Revisiting State Estimation

cs.RO ·2026-09-30 ·Michal Pliska, Matouš Vrba, Ondřej Víta, Martin Jiroušek, Viktor Walter +1 more
publishedbenchmark similarity 0.57
Abstract · This work has been accepted to the IEEE for possible publication (IROS 2026)

Agile multi-UAV flight requires accurate and low-latency onboard estimation of the kinematic states of neighboring UAVs for collision avoidance, motion coordination, etc. Most vision-based approaches rely on position-only measurements, inferring velocity and acceleration indirectly from displacement. We show that this introduces a fixed structural delay in the estimation of higher-order states, which limits the achievable agility. To address this, we propose to integrate tilt measurements, provided by a state-of-the-art visual detector, which inform about the thrust direction of co-planar multirotor UAVs. We benchmark four position-only and five pose-aware estimators, including a novel formulation of a linear thrust-constraining Kalman filter, on two real-world and one high-fidelity photorealistic simulated dataset over different levels of agility (3-21 m/s^2). In our setup, pose-aware estimation consistently reduces the average velocity and acceleration estimation errors by 40% and 57% across the three datasets with the proposed KF formulation outperforming the other estimators. Position-only filters exhibit a constant ~300 ms delay in acceleration step response independent of agility, whereas the tilt-constrained estimators operate near the physical response limit given by the camera frame-rate by observing the change in thrust direction before the displacement accumulates. In a closed-loop leader-follower simulated experiment with NMPC control, position-only estimation of the leader's state fails to facilitate stable hovering of the follower, while the proposed estimator enables tracking of lateral maneuvers exceeding 2g of acceleration.

0.26

Estimation-Aware Control on Quadrotor State Manifolds via Anisotropic Covariance Filtering

eess.SY ·2026-11-11 ·Daniel Engelsman, Itzik Klein
similarity 0.55
Abstract · 11 Pages, 14 Figures, 2 Tables

Conventional nonlinear flight controllers operate under the implicit assumption of reliable, high-confidence state feedback. During transient sensing degradation or partial unobservability, state estimation uncertainty is frequently misinterpreted as physical tracking error, triggering aggressive and parasitic corrective inputs. To mitigate this vulnerability, we propose a generalized Estimation-Aware (EA) control framework that directly incorporates real-time estimator confidence into control execution. By mapping the posterior error covariance $\mathbf{P}_{k\mid k}$ into an uncertainty-dependent modulation operator, the EA mechanism dynamically scales feedback authority, performing anisotropic attenuation along weakly observed state directions to prevent false error corrections. Validated across six distinct control paradigms, the proposed approach demonstrates substantial performance gains across all baselines. In particular, when integrated into an Incremental Nonlinear Dynamic Inversion (INDI) architecture, the EA mechanism reduces tracking and estimation errors by 24.34% and 33.24%, respectively, at a high flight speed of 10 m/s.

0.20

Project SCOUT: Interceptor Drone for Perimeter Defense

cs.RO ·2026-09-17 ·Azmain Yousuf, Siwei Cai, Knut Peterson, Lifeng Zhou, David Han
publishedcode/data similarity 0.55
Abstract · Accepted at SSRR 2026

The rapid proliferation of unauthorized unmanned aerial vehicles (UAVs) has created a growing need for robust, jamming-resistant counter-UAV systems for perimeter defense. This paper presents \textbf{SCOUT} (Spatial Computation for Optimized UAV Tracking), a ROS-integrated onboard perception and control framework for real-time aerial defense against incoming UAVs. SCOUT performs visual detection, target association, track filtering, and control command generation directly onboard the defender UAV, without relying on external sensing infrastructure or ground-station computation. To provide stable control inputs, the perception pipeline combines TensorRT-accelerated drone detection with ByteTrack-based association and a lightweight track-retention state machine. The state machine rejects abrupt target jumps and maintains short-term target continuity during temporary detection degradation, reducing unstable control responses caused by false detections or target switching. We evaluate the proposed architecture through an integrated hardware deployment executing a planar ``goalkeeping'' interception strategy. In this setting, the defender UAV tracks the incoming target and adjusts its motion to maintain a blocking configuration near the protected boundary. Real-world flight results show that SCOUT maintains valid target detections for 92.2\% of frames while operating at real-time onboard detection rates, demonstrating the feasibility of visual tracking and closed-loop control for UAV perimeter defense. A video demonstration of the end-to-end perimeter defense operation is available online. https://figshare.com/s/497befc033091fc0b84f

0.44

Vision-Based Control of a Tether-Suspended Aerial Radiation Sensing Payload

cs.RO ·2026-09-23 ·Ian Snider, Brian J. Quiter, Emil Rofors, Mark W. Mueller
survey similarity 0.55
Abstract · 7 pages, 7 figures, 2 tables. Submitted to IEEE ICRA 2027

Aerial radiation surveys achieve higher sensitivity when the radiation detector is held close to the ground. Detector sensitivity falls off roughly with the inverse square of the distance to the source, so a detector flown high is slower to reach a given minimum detectable activity. Flying the vehicle low puts the propellers near the ground, where downwash can disturb the surveyed area and resuspend contaminated particulates. Tether suspension decouples the detector from the vehicle altitude, but leaves the payload unactuated and only indirectly controllable. We therefore present a vision-based control approach for an aerial sensing payload suspended on a tether beneath a heavy-lift drone. Because a survey plan is decided as radiation detections arrive, we design a pilot aid for commanding the survey trajectory manually with a handheld transmitter. The controller regulates the payload, rather than the vehicle, onto that trajectory. The system uses onboard sensors with a downward-facing camera fixed to the drone body tracking a ring marker on the payload. A four-state Kalman filter estimates the tether swing angles and rates from payload bearing measurements, and a linear quadratic regulator with integral action takes the payload position as the regulated output. In outdoor flight tests under wind, the payload-aware controller reduced payload tracking error during transit by 20% when compared against a vehicle-referenced baseline, with the cost of higher peak error on arrival at a waypoint.

0.30

Dynamic Modeling and LQR Control of a Single Coaxial Drone with 2DOF Thrust Vectoring Mechanism

cs.RO eess.SY ·2026-09-17 ·Ali Jokar, Amin Talaeizadeh, Aria Alasty
similarity 0.55
Abstract

Coaxial rotor drones have generated considerable interest because of energy efficiency and small size, but they are afflicted with inherent underactuation for roll and pitch control, although systems like swashplates have circumvented this limitation at the cost of greater mechanical complexity. This work presents a novel coaxial drone supplemented by a two-degreesof-freedom pendulum mechanism for active thrust vectoring that offers a less mechanically complicated alternative. We develop a comprehensive Lagrangian dynamic model that does not ignore the inertial contributions of all the components, including body, servo arms, and motor assembly. A Linear Quadratic Regulator(LQR) is designed based on the linearized dynamics around the hover equilibrium. High-fidelity simulations taking actuator dynamics and sensor noise into account validate the proposed architecture. An Extended Kalman Filter (EKF) blends GPS, barometer, and IMU estimates with high accuracy for state estimation. The findings verify the potential and reliability of this approach for power-saving, rapid coaxial UAVs.

0.13