CS Paper Radar

SmartBAN on Silicon by Structured Behavioral Modeling

Masato Yoshimi, Takahiro Ito, Kento Tanaka, Hirokazu Tanaka

cs.NI ·submitted 2026-08-29 04:04 UTC · v2
published

Abstract

Wireless body area networks (WBANs) underpin the Internet of Medical Things (IoMT). IEC/ETSI SmartBAN defines a lightweight time-division multiple access (TDMA) protocol, yet published implementations on commercial hardware remain partial. The standard specifies frame formats but leaves device-internal behavior in phase control, connection lifecycle, and slot timing unspecified. We present an operational SmartBAN realization on a commercial wireless system-on-chip (Nordic nRF54L15, Arm Cortex-M33, Zephyr RTOS) that implements initial connection, scheduled uplink, and timeout-based disconnection detection through a four-layer software architecture whose hardware abstraction layer is the intended portability boundary. Hub and Node Mealy automata supply one concrete design for the unspecified phase control and connection lifecycle, as a blueprint for the firmware's event-driven dispatch. Validation with 16 concurrent Nodes over 25 hours shows conformance across every transition the build exercises (all but one), >99.99% packet delivery, and timeout-triggered reconnection after the single observed disconnection. An analytical current model fits the measurements once it uses measured state currents; with datasheet currents it underestimates the average, mostly in the radio-off state, whose current we attribute to implementation-level overhead rather than the hardware. A same-SoC comparison with Bluetooth Low Energy (BLE) shows how each protocol departs from its schedule: SmartBAN, configured to send a fresh sample every interval instead of retransmitting, kept each Node's frame spacing within 1.1 ms of the interval but lost some frames; BLE lost none but deferred some by one or two intervals, and drew less than half SmartBAN's average current.

Comment
10 pages, 6 figures, 8 tables. Accepted for publication in IEEE Internet of Things Journal; v2 is the accepted version (revised after peer review)

Closest papers

Nearest neighbours by meaning across the whole index.

Demo: Matter-Based IoMT Telemetry and Security Analysis

cs.AR cs.ETcs.RO ·2026-11-12 ·Muhammad Hassan, Masooda Bashir, Carl Gunter
similarity 0.56
Abstract

Connected health devices increasingly support health monitoring outside clinical settings, making secure and accessible physiological data important for patients and caregivers. However, device-specific applications and interfaces complicate the integration of readings from different devices. The Matter standard provides standardized device commissioning and protected communication, but its cluster library does not represent the health attribute measurement. We present a preliminary demo study of a Matter-based IoMT testbed with a specific HealthVitals cluster. Implemented in the connectedhomeip SDK on a Raspberry~Pi~5, the cluster exposes simulated heart rate, blood oxygen saturation, and body temperature. We examine commissioning, attribute retrieval, communication under simulated packet loss, and operational traffic through a reference controller. The study demonstrates that this custom telemetry model can operate within the tested Matter configuration without modifying commissioning or secure-session mechanisms. The resulting testbed gives researchers and device developers a concrete platform for investigating health-oriented extensions. It also supports exploration of local telemetry integration that could help patients and caregivers access readings across connected devices.

0.26

Goal-Oriented Communication and Control Co-Design via Semantic Push-Pull in Industrial IoT

cs.IT ·2026-09-18 ·Muhammad Azeem Khan, Yuriy Zacchia Lun, Aamir Mahmood, Piergiuseppe Di Marco, Mikael Gidlund +1 more
published similarity 0.54
Abstract · 6 pages, 3 figures, accepted in IEEE Globecom 2026

Emerging 6G industrial IoT architectures require wireless networked control systems capable of stabilizing diverse control loops over tightly constrained radio resources. Conventional periodic and Age-of-Information (AoI) based scheduling guarantees bounded staleness at the cost of persistent channel saturation. Conversely, pure event-triggered (PureET) strategies minimize transmissions but risk catastrophic silent deterioration when local sensor-side thresholds fail to reflect critical state evolution. To bridge this gap, we propose a communication-control co-design framework governed by a 6G Semantic Layer that independently arbitrates uplink and downlink resources. Instead of relying on freshness, our architecture evaluates the actual control impact of a packet using the state-to-error ratio (SER). We unify this control confidence with channel reliability in terms of signal-to-noise ratio (SNR) to orchestrate a threshold-based sensor push and a state-aware controller pull mechanism. To ensure equitable resource allocation across dynamically heterogeneous plants, the proposed framework explicitly scales actuation deadbands according to local plant dynamics. Simulations over Rayleigh-faded channels demonstrate that this approach fundamentally shifts the Pareto frontier between transmission rate and control quality. The proposed scheme achieves tracking accuracy comparable to periodic schedulers at a reduced communication overhead, while mitigating the estimation errors characteristic of PureET.

0.57

A Resilient Runtime-Verification Fabric for Security Monitoring of Critical Edge-IoT Infrastructure

cs.CR cs.DC ·2026-10-05 ·Nikolaos Kekatos, Marinelio Chintri, Panagiotis Katsaros, Alexios Lekidis, Tom Nianios +3 more
publishedhighly cited similarity 0.54
Abstract · 21 pages, 2 figures. Accepted at the 21st International Conference on Critical Information Infrastructures Security (CRITIS 2026)

Protecting critical infrastructure increasingly depends on continuously verifying large IoT fleets against formal security specifications at runtime. Yet the runtime-verification (RV) pipelines proposed for this task are typically single-host prototypes whose monitors read a shared log file, with no resilience to the failures such deployments incur: a crash or overload silently drops events, clock skew corrupts the ordering metric monitors require, a time-triggered "node has gone silent" property cannot fire when the network itself falls silent, and one slow consumer stalls the pipeline. Each failure is silent: the monitor keeps emitting verdicts over a corrupted view. We present RV-Fabric, a resilient delivery layer that carries the hierarchy over two brokers (MQTT for device ingest, a durable stream broker for backend delivery) and re-establishes five continuity guarantees: durable delivery under crashes, a trusted event order, progress under total silence, consumer isolation and flow control under bounded overload, each an invariant conditioned on broker durability. Above the transport, RV-Fabric makes evidence completeness part of runtime-verification semantics: every verdict carries a status (sound, degraded, incomplete or unavailable) derived from delivery gaps, retention pressure and liveness, so an incomplete stream cannot yield an unqualified all-clear. Under controlled fault injection on a containerised testbed, measured against a fault-free oracle using the real MonPoly engine, the shared-log baseline misses six of seven injected incidents, reporting each as an unqualified all-clear, whereas RV-Fabric preserves all seven; removing a delivery mechanism reintroduces silent loss, removing isolation costs only timeliness. Two published critical-infrastructure datasets, water-SCADA and IoT/IIoT, replay end-to-end.

0.59

Hybrid Hierarchical Runtime Verification for Edge-IoT Security: Combining MonPoly and RTLola

cs.CR cs.DCcs.LO ·2026-10-07 ·Nikolaos Kekatos, Marinelio Chintri, Panagiotis Katsaros, Alexios Lekidis, Tom Nianios +3 more
publishedhighly cited similarity 0.54
Abstract · 19 pages, 2 figures, 7 tables. Published in Availability, Reliability and Security (ARES 2026), EU Projects Symposium Workshops, Springer LN…

Security monitoring of edge-IoT fleets faces three structural challenges. (i) A per-node monitor is cheap but cannot see attacks that coordinate across devices. (ii) A cloud monitor sees the full fleet but pays for that view in bandwidth. (iii) Even at the cloud, a monitor built on a single RV engine can be fooled by an attacker who compromises a device, raises one malicious request, and then goes silent: once the events stop, an event-triggered monitor has nothing left to evaluate. We propose a three-layer hierarchical runtime-verification framework that addresses all three. The edge layer classifies events as they happen, the gateway layer aggregates short windows of per-device behaviour, and the cloud layer runs two complementary RV engines. MonPoly handles first-order temporal correlation over the merged alert stream: coordinated overflow (which genuinely quantifies across devices) plus per-device multi-vector APT, escalation, and persistent-campaign patterns. RTLola handles a time-triggered silent-node property that an event-triggered engine cannot detect within a bounded delay under fleet silence. We evaluate the framework on a 15-actor Docker testbed covering eight attack profiles plus a silent-bypass scenario. In the controlled labelled testbed, every device-attributable incident the framework raises names an attacker-labelled device, and the RTLola tier catches silent-bypass attempts the event-triggered tier misses. Per-event monitoring stays in the microsecond range at the edge and gateway, with low end-to-end alert-to-incident latency at the cloud.

0.58

Latency-Neutral Passive Cyber Monitoring for Grid-Edge Operational Technology Networks

eess.SY cs.CR ·2026-10-20 ·Damian Byrne, Emad Abukhousa, Jason Reed, Saman Zonouz
published similarity 0.52
Abstract · 5 pages, 4 figures, 2 tables. Accepted for presentation at the IEEE PES Grid Edge Technologies Conference and Exposition 2027

Deterministic industrial networks often present an operational trade-off between maintaining microsecond timing of primary control loops and capturing security telemetry. This work investigates the engineering feasibility of the Operational Technology Supervisor (OTSV), a three-tier passive monitoring framework designed to resolve this visibility challenge within timing-sensitive grid-edge infrastructure. By utilizing a Layer-3-unconfigured passive ingestion mode on bare-metal hardware via a physical switched port analyzer (SPAN) loop, the deep packet inspection engine is isolated from the production network, implementing a software-enforced unidirectional export policy. Performance validation conducted over a continuous audit comprising 32,927 active-monitoring round-trip time (RTT) samples yielded stable latency distributions across a laboratory power-monitoring loop running Modbus TCP and IEC 61850 MMS protocols. The measured latency delta between the unmonitored baseline and the active monitoring state was less than 0.12 milliseconds, supporting the feasibility of continuous high-fidelity security observation alongside stringent grid-edge metering timing bounds without measurably degrading the monitored reporting path.

0.31

Making Time-Sensitive Networking Deployable: A Comprehensive Lifecycle Architecture

cs.NI ·2026-08-20 ·Rubi Debnath, Paul Pop, Silviu S. Craciunas, Marc Boyer, Sebastian Steinhorst
publishedsurvey similarity 0.51
Abstract · Accepted for publication in the proceedings of the 2026 IEEE/ACM International Conference on Embedded Software (EMSOFT), October 2026

Time-Sensitive Networking (TSN) provides deterministic guarantees and bounded latency for safety-critical applications across different domains. While the IEEE 802.1 TSN standards provide a comprehensive set of mechanisms for time synchronization, shaping, scheduling, resource reservation, and reliability, deploying TSN in real-world applications remains a complex, multi-step engineering task. Existing research primarily focuses on optimizing individual objectives, such as increasing schedulability, reducing latency, accelerating solution generation, or improving performance analysis. However, whether these extensively researched solutions can be deployed in real-world systems remains unanswered, as the assumptions made in these methodologies often differ from practical hardware constraints. Therefore, a broader, holistic view of end-to-end TSN deployment and management remains an open research question. Currently, there is a lack of a unified perspective, consensus, and coordinated research efforts focusing on a comprehensive end-to-end TSN deployment workflow. We present a comprehensive overview of the TSN deployment lifecycle, current challenges, limitations of existing tools, and future research directions for TSN deployment and management. Lastly, we identify key research gaps from a deployment perspective and provide guidance for the development of next-generation deployable TSN networks.

0.25

Hybrid Monitoring for Early Fault Detection in Cloud-Native 5G Systems

cs.NI cs.DC ·2026-09-11 ·Anton Andersson, Sai Akshara Naineni, Mats Jansborg, Yixing Zhang, Romaric Duvignau
similarity 0.51
Abstract

This paper presents the design implementation and evaluation of NetMon a hybrid network monitoring system designed for Kubernetes-based 5G packet core deployments specifically evaluated on Ericssons Access and Mobility Management Function AMF clusters NetMon combines eBPF-based passive kernel-level traffic observation with active TCP probing and centralized correlation to detect and localize network degradation within seconds The evaluation results demonstrate that the system detects faults as subtle as 10ms of added latency or 5 packet loss correctly attributes them to the affected infrastructure component and maintains this capability under application loads up to 50 simulated UE load The total resource overhead of 34 millicores CPU and 45 MiB memory per pod suggests that the approach is promising for further validation without impacting the monitored workload The hybrid approach addresses a gap in existing monitoring tools standard health checks cannot detect partial degradation scrape-based systems introduce detection delays measured in tens of seconds and purely passive tools cannot verify idle network paths By combining these complementary techniques and centralizing the analysis the system provides the early detection and fault localization capabilities required for maintaining service quality in cloud-native 5G infrastructure.

0.27

Efficient Co-simulator Integration with Application to Smart Grids

cs.NI ·2026-09-02 ·Talha Ibn Aziz, Jihoon Og, Ioanis Nikolaidis, Omid Ardakanian
benchmark similarity 0.51
Abstract · 12 pages

The evolution of the electric power grid towards a ``smart grid'' is an example of an emerging large-scale cyber-physical system. To study the potential of cyberattacks or other sources of extreme events, high-fidelity co-simulation is one of the few realistic strategies. In this work, we demonstrate a practical and high-performance co-simulation strategy for smart grids, which provides lessons about co-simulation integration that can be carried over to other cyber-physical systems. Specifically, we present a co-simulation platform based on the Mosaik framework that integrates several federates including OpenDSS for power flow, a refined NS-3 for communication networks, and custom Python-based simulators for on-load tap changer control, distributed state estimation, and data collection. We compare synchronization strategies -- exhaustive lock-step time advancement versus an optimized event-driven approach that exploits lower-bound time stamps (LBTS) and next-event prediction -- and introduce targeted refinements to NS-3 event handling and relevance filtering of internal events. Performance is evaluated on two standard IEEE benchmark systems: the 13-node test feeder with tap-changer voltage regulation and a large-scale 33-bus system augmented with 32 European low-voltage feeders (1,793 nodes total) performing distributed state estimation with thousands of phasors and smart meters. Experimental results demonstrate that the refined event-based synchronization that uses LBTS-based NS-3 event filtering reduces execution time by up to 50\% over non-filtered LBTS, and more than 4$\times$ in the tap control scenario compared to naïve lock-step methods, while strictly preserving temporal correctness and simulation accuracy.

0.27