CS Paper Radar

Joint PAPR and OOBE Reduction for AFDM via Chirp Parameter Tuning

Vincent Savaux, Hyeon Seok Rou, Zeping Sui, Giuseppe Thadeu Freitas de Abreu, Zilong Liu

eess.SP ·submitted 2026-09-01 13:49 UTC · v1

Abstract

This paper addresses the joint reduction of the peak-to-average power ratio (PAPR) and out-of-band emissions (OOBE) in affine frequency division multiplexing (AFDM) systems by selecting the pre-chirp parameter c2. While existing approaches typically optimize either PAPR or OOBE independently, the proposed method jointly considers both metrics. To this end, a weighted cost function combining PAPR and OOBE is introduced to evaluate the trade-off between the two objectives. A pre-chirp selection scheme, inspired by the selected mapping (SLM) technique, is then employed to identify the optimal c2 value from a finite set of candidates, yielding a Pareto-optimal operating point within a discrete set. Simulation results demonstrate that the proposed approach simultaneously reduces both PAPR and OOBE compared with conventional AFDM. Moreover, its performance remains close to that of methods specifically optimized for a single objective, with only about a 1 dB degradation in PAPR reduction and a 2-3 dB degradation in OOBE suppression.

Closest papers

Nearest neighbours by meaning across the whole index.

Joint PAPR Reduction and Over-the-Air Computing in Multi-User OFDMA Systems

eess.SP ·2026-11-02 ·Getuar Rexhepi, Kuranage Roche Rayan Ranasinghe, Giuseppe Thadeu Freitas de Abreu, David González G
benchmark similarity 0.57
Abstract · ISITA 2026

We consider the peak-to-average power ratio (PAPR) reduction challenge of orthogonal frequency division multiplexing (OFDM) systems utilizing tone reservation (TR) under an over-the-air computing constraint, such that the signals placed in the reserved tones simultaneously enable distributed computation at the receiver. To that end, the problem is cast as a fractional programming problem and solved via the iterative quadratic transform (QT), which guarantees convergence to a stationary point. A key contribution is the decomposition of the reserved-tone vector into an orthogonal pair of components: one satisfying the sum-computation constraint and the other providing the remaining degrees of freedom for PAPR reduction. This decomposition reveals that the proposed method and the benchmark sacrifices the same number of degrees of freedom. However, the proposed design distributes the computational payload across all reserved tones, yielding superior robustness against multi-user interference and quantization noise. Analytical and simulation results confirm that the proposed method matches the benchmark in PAPR reduction while outperforming it in computation accuracy, particularly in multi-user scenarios.

0.24

AFDMA with Heterogeneous Post-Chirp Parameters: Supporting User-Specific Waveform Configurations

eess.SP ·2026-11-04 ·Hengyou Kong, Xiaoli Xu, Zilong Liu, Yanqun Tang, Yong Zeng
theory similarity 0.57
Abstract · 13 pages, 10 figures

This paper investigates a downlink affine frequency division multiple access (AFDMA) framework supporting flexible user-specific waveform configurations with heterogeneous post-chirp parameters. The proposed framework is in sharp contrast to conventional disjoint chirp-subcarrier allocation, which may destroy inter-user orthogonality when users employ heterogeneous post-chirp parameters. Such a loss of orthogonality manifests as cross-basis leakage onto user-allocated chirp subcarriers, which we characterize by analyzing the cross-projection between user-specific discrete affine Fourier transform bases. Specifically, we express the cross-projection entries as quadratic Gauss sums whose quadratic coefficients depend on pairwise post-chirp differences. This yields a sufficient pairwise residue-class orthogonality rule that preserves inter-user orthogonality by satisfying the leakage-free condition. The resulting chirp-subcarrier allocation problem with pairwise modular constraints is reduced to the residue-class level. To solve this problem, we develop a two-stage framework that recursively searches for a feasible representative allocation and deterministically assigns the remaining residue classes. We prove that the problem is either infeasible or admits an optimal full-loading solution. Simulations show that the proposed allocation avoids the bit error rate (BER) floors and signal-to-interference-plus-noise ratio (SINR) ceiling of conventional localized allocation, achieves near-single-user BER, and provides comparable BER while reducing receiver complexity compared with conventional common-maximum-post-chirp AFDMA.

0.29

Effects of Residual Chirp Rate on DAFT-s-AFDM Uplink Performance

eess.SP ·2026-10-07 ·Henrique L. Senger, Gustavo P. Gonçalves, Bruno S. Chang, Hyeon Seok Rou, Giuseppe Thadeu Freitas de Abreu
similarity 0.55
Abstract

Affine frequency division multiplexing (AFDM) is robust to doubly dispersive channels in high-mobility 6G systems but, like orthogonal frequency division multiplexing (OFDM), suffers from a high peak-to-average power ratio (PAPR). Spreading with a discrete affine Fourier transform (DAFT) yields DAFT-s-AFDM, whose precoder and modulator chirps can be chosen independently. For a single user with zero-offset localized allocation, we show that these two chirps merge into a single residual chirp whose rate, with the other two chirp rates fixed, alone determines their effect. At the transmitter, this rate defines a circulant spreading kernel whose fourth moment quantifies the envelope fluctuation; symmetries reduce its characterization to rates in [0, 1/4]. At a linear minimum mean-square error (MMSE) receiver, the residual chirp redistributes the mean- square error across symbols without changing its total; under a Gaussian approximation, a more uniform per-symbol error lowers the uncoded bit error rate (BER). In uncoded QPSK simulations, a zero rate yields the lowest PAPR, whereas a generic rate reduces the signal-to-noise ratio required for a BER of $10^{-3}$ by 4.4 dB at a 3.33 dB PAPR cost (exceedance probability $10^{-3}$);a rate of 1/3 captures 2.8 dB of this gain for only 0.88 dB of that cost.

0.25

Index Modulation Aided Phase-Rotated AFDM for Efficient Integrated Sensing and Communication: Framework, Optimization and Performance Analysis

eess.SP ·2026-09-27 ·Shiqi Cui, Zeping Sui, Tianqi Mao, Yuanshuo Gang, Guangyao Liu +5 more
theory similarity 0.55
Abstract · 13 pages, 8 figures

Affine frequency division multiplexing (AFDM) has emerged as a competitive waveform for integrated sensing and communication (ISAC) in high-mobility scenarios, but its data-dependent high peak-to-average power ratio (PAPR) and ambiguity function (AF) sidelobes may degrade the power-amplifier efficiency as well as the sensing performance. To mitigate the issues, one promising candidate is the phase-rotation optimization philosophy, which necessitates auxiliary side information (SI) to guarantee successful data recovery at the receiver. However, using additional signalling overhead to deliver the SI degrades the spectral efficiency. Against the background, this paper proposes a power level index modulation (PLIM)-aided phase-rotated AFDM (PLIM-PR-AFDM) scheme, which embeds the phase-rotation SI within the transmitted block. At the transmitter, the proposed scheme jointly optimizes the waveform by coordinating the PLIM power allocation, phase rotation, and embedding of SI. Specifically, subcarriers are flexibly allocated with different transmit power levels. High-power subcarriers are phase-rotated to suppress the PAPR and fast-slow-time AF sidelobes. By decomposing the fast-slow-time AF sidelobe energy into per-block periodic autocorrelation function (PACF) terms, the sensing objective can be formulated as a PACF-weighted integrated sidelobe level (WISL) minimization problem, while selected low-power subcarriers embed the phase bits as SI through constellation labels. Furthermore, the PLIM power patterns of each transmitted block can convey additional index bits, which compensates for the spectral efficiency loss caused by SI transmission. Moreover, the error performance is analyzed by deriving an upper bound of the average bit error probability (ABEP) and identifying the condition for full diversity.

0.17

When Do Pilots Matter for OFDM Sensing? Pilot-Data Resource Design for ISAC

cs.IT ·2026-09-11 ·Shengcai Zhou, Luping Xiang, Yi Wang, Kun Yang
similarity 0.55
Abstract

Practical OFDM-based integrated sensing and communication (ISAC) signals contain deterministic pilots and random data payloads, yet how these two types of resources jointly affect matched-filter sensing performance remains insufficiently understood. This paper establishes an analytical and optimization framework for pilot-data (P-D) OFDM sensing. We first derive a closed-form mean-square periodic autocorrelation function (MS P-ACF), which characterizes the respective contributions of the average subcarrier power spectrum and data-symbol randomness to sensing sidelobes. Based on this result, we reveal that pilot placement has no impact on normalized sidelobes under uniform power allocation or on the normalized global expected integrated sidelobe level (EISL), whereas it becomes an effective design degree of freedom for reshaping sidelobes under nonuniform power allocation. We further derive the globally optimal two-level pilot-data power allocation for global EISL minimization and characterize pilot placement for peak sidelobe suppression. For region-of-interest (ROI) sensing, we jointly optimize pilot placement and subcarrier power allocation to minimize the normalized ROI-EISL. A strictly uniform pilot placement is proved globally optimal under specified conditions, while a bisection-and-branch-and-bound algorithm is developed for general resource configurations. Numerical results validate the theoretical analysis and demonstrate that the proposed design reduces the ROI sidelobe level by up to 2.19 dB compared with optimized uniform-pilot OFDM, while improving ranging accuracy at an SNR of -10 dB by 84.3$\%$. These results reveal when and how pilot placement can be exploited to regulate the sensing behavior of random OFDM communication signals, providing practical resource-design principles for OFDM-based ISAC.

0.21

Receiver Design for Continuous-Time AFDM based on Pre-Filter De-Chirp

eess.SP ·2026-10-18 ·Qingyu Li, Shuangyang Li, Guanghui Liu, Fuchen Xu, Hongjun Liu
hot direction similarity 0.55
Abstract · Submitted to IEEE International Conference on Communications (ICC 2027)

Affine frequency division multiplexing (AFDM) is a promising waveform for future high-mobility communications due to its Doppler robustness and diversity gain. However, existing continuous-time AFDM relies on chirp-dependent wideband receive filtering, which increases noise power and causes channel-energy leakage. In this paper, we propose an AFDM reception scheme based on pre-filter de-chirp for doubly selective channels. The coupling between de-chirp and the channel is first characterized, yielding an equivalent path representation with delay-coupled effective Doppler shifts. The discrete affine Fourier transform (DAFT)-domain equivalent channel is then derived under general transmit pulse shaping and linear time-invariant receive filtering, showing that the effective filtering kernel depends only on the relative sample offset and avoids the additional spreading caused by conventional chirp-dependent filtering. The receive-noise power is further analyzed, and an explicit expression for the signal-to-noise ratio (SNR) gap is obtained by the required receive-filter bandwidths. Simulations verify the theoretical SNR analysis and show that the proposed scheme significantly outperforms the conventional scheme while approaching ideal discrete-time AFDM.

0.25

Resolving the Discontinuity of Continuous-Time AFDM Waveforms

eess.SP cs.IT ·2026-09-07 ·Yewen Cao, Yulin Shao
similarity 0.54
Abstract · Keywords: AFDM, continuous-time waveform, SFDM, out-of-band emission

Continuous-time affine frequency division multiplexing (AFDM) waveforms, constructed via frequency wrapping and phase correction, are known to be sample-wise equivalent to the widely adopted discrete AFDM framework. In this paper, we uncover a fundamental and previously overlooked flaw in this construction: its complex envelope is inherently discontinuous for generic chirp parameters. We show that these discontinuities are the direct cause of the high out-of-band emission (OOBE). To resolve this issue, we propose a fundamentally different continuous-time waveform, termed stepped frequency division multiplexing (SFDM). Unlike conventional approaches that allow continuous frequency variation, SFDM freezes the instantaneous frequency at the midpoint of the underlying chirp trajectory within each Nyquist sampling interval. This design yields a complex envelope that is strictly continuous over the entire symbol duration while preserving exact sample-wise equivalence with discrete AFDM. A unified spectral analysis reveals that the superior OOBE performance of SFDM stems from the absence of internal jump discontinuities, which otherwise dominate the far-out spectral roll-off. Numerical results confirm that SFDM consistently achieves significantly lower OOBE across a wide range of chirp rates.

0.23

Impact of PA Nonlinearities on AFDM Sensing: A Matched Filtering Perspective

eess.SP ·2026-09-12 ·Eya Gourar, Yahia Medjahdi, Laurent Clavier, Abdul Karim Gizzini, Patrick Sondi
published similarity 0.54
Abstract · The manuscript was previously deposited in HAL (hal-05573928). Accepted for presentation at the 2026 IEEE International Conference on Integr…

Affine Frequency Division Multiplexing (AFDM) is a promising waveform for integrated sensing and communications (ISAC) due to its Doppler resilience. However, such waveforms exhibit a high peak-to-average power ratio (PAPR), and they require highly linear Power Amplifiers (PAs), which conflicts with ISAC requirements, where high transmit power for sensing is always beneficial. This paper investigates the impact of PA nonlinearities on the sensing performance of AFDM. Using the Bussgang decomposition of the nonlinearly amplified AFDM signal, we analyze the delay-Doppler ambiguity function for the sensing matched filtering and show that AFDM's sidelobes remain nearly unaffected. Simulation results confirm that AFDM outperforms OFDM in target detection under high Doppler and nonlinear amplification, highlighting its suitability for the sensing task.

0.41