CS Paper Radar

Resolving the Discontinuity of Continuous-Time AFDM Waveforms

Yewen Cao, Yulin Shao

eess.SP cs.IT ·submitted 2026-09-07 13:35 UTC · v1

Abstract

Continuous-time affine frequency division multiplexing (AFDM) waveforms, constructed via frequency wrapping and phase correction, are known to be sample-wise equivalent to the widely adopted discrete AFDM framework. In this paper, we uncover a fundamental and previously overlooked flaw in this construction: its complex envelope is inherently discontinuous for generic chirp parameters. We show that these discontinuities are the direct cause of the high out-of-band emission (OOBE). To resolve this issue, we propose a fundamentally different continuous-time waveform, termed stepped frequency division multiplexing (SFDM). Unlike conventional approaches that allow continuous frequency variation, SFDM freezes the instantaneous frequency at the midpoint of the underlying chirp trajectory within each Nyquist sampling interval. This design yields a complex envelope that is strictly continuous over the entire symbol duration while preserving exact sample-wise equivalence with discrete AFDM. A unified spectral analysis reveals that the superior OOBE performance of SFDM stems from the absence of internal jump discontinuities, which otherwise dominate the far-out spectral roll-off. Numerical results confirm that SFDM consistently achieves significantly lower OOBE across a wide range of chirp rates.

Comment
Keywords: AFDM, continuous-time waveform, SFDM, out-of-band emission

Closest papers

Nearest neighbours by meaning across the whole index.

Receiver Design for Continuous-Time AFDM based on Pre-Filter De-Chirp

eess.SP ·2026-10-18 ·Qingyu Li, Shuangyang Li, Guanghui Liu, Fuchen Xu, Hongjun Liu
hot direction similarity 0.62
Abstract · Submitted to IEEE International Conference on Communications (ICC 2027)

Affine frequency division multiplexing (AFDM) is a promising waveform for future high-mobility communications due to its Doppler robustness and diversity gain. However, existing continuous-time AFDM relies on chirp-dependent wideband receive filtering, which increases noise power and causes channel-energy leakage. In this paper, we propose an AFDM reception scheme based on pre-filter de-chirp for doubly selective channels. The coupling between de-chirp and the channel is first characterized, yielding an equivalent path representation with delay-coupled effective Doppler shifts. The discrete affine Fourier transform (DAFT)-domain equivalent channel is then derived under general transmit pulse shaping and linear time-invariant receive filtering, showing that the effective filtering kernel depends only on the relative sample offset and avoids the additional spreading caused by conventional chirp-dependent filtering. The receive-noise power is further analyzed, and an explicit expression for the signal-to-noise ratio (SNR) gap is obtained by the required receive-filter bandwidths. Simulations verify the theoretical SNR analysis and show that the proposed scheme significantly outperforms the conventional scheme while approaching ideal discrete-time AFDM.

0.25

Pilot-Based Sensing With OFDM and AFDM: A Resource-Matched Performance Comparison

eess.SP ·2026-10-16 ·Siyi Tang, Yin Xu, Aimin Tang, Dazhi He, Wenjun Zhang
similarity 0.60
Abstract

As a waveform candidate for next-generation wireless systems, affine frequency division multiplexing (AFDM) has often been compared with orthogonal frequency division multiplexing (OFDM) under different configurations, while a systematic comparison of their pilot-based sensing performance remains lacking. This paper establishes a comparison with the same bandwidth, frame duration, pilot energy, and reserved-resource overhead. OFDM-random, OFDM-fixed-comb, and OFDM-shifted-comb pilots are compared with AFDM pilots surrounded by guard resources using aperiodic ambiguity functions without cyclic prefix/chirp-periodic prefix (CP/CPP) and cyclic ambiguity functions with CP/CPP, followed by target detection experiments. The results show that OFDM-fixed-comb exhibits low range sidelobes but periodic range ambiguity peaks, while AFDM and OFDM-shifted-comb effectively suppress zero-Doppler range ambiguities. Within the common unambiguous region, all pilot configurations for both waveforms exhibit similar detection thresholds in strong-target detection, while structured OFDM and AFDM pilot placements outperform OFDM-random in weak-target detection. At high mobility, the AFDM receiver using the discrete affine Fourier transform (DAFT) can resolve integer Doppler beyond the conventional slow-time maximum unambiguous velocity, outperforming the tested conventional OFDM and AFDM receivers at the increased search complexity. These results separate the effects of waveform, pilot placement, and receiver processing, providing a basis for AFDM and OFDM pilot-based sensing design.

0.20

AFDM-ISAC Design Amalgamating FMCW Radar and Carrier Aggregation

eess.SP ·2026-10-29 ·Qu Luo, Qihao Peng, Zihuai Lin, Maged Elkashlan, Pei Xiao +2 more
publishedhot direction similarity 0.59
Abstract

Carrier-aggregation (CA)-assisted affine frequency division multiplexing (AFDM) is conceived for integrated sensing and communication (ISAC) systems. A frequency-modulated continuous-wave (FMCW)-inspired dechirping receiver is developed to exploit the inherent pulse-compression property of AFDM chirp subcarriers for accurate delay-Doppler estimation. To further enhance sensing performance, a pair of CA schemes is proposed. The Type-I CA scheme improves sensing accuracy by aggregating echo signals across multiple CA bands prior to radar processing, thereby reducing estimation error with low hardware overhead. The Type-II CA scheme enhances range resolution by effectively enlarging the sensing bandwidth, where chirps from different CA bands are designed to form a continuous set of chirp signals. Based on this principle, variable subcarrier sensing and asynchronous sensing schemes are developed. For the communication receiver, the generalized input-output relationship of AFDM is derived under both fractional delay and fractional Doppler (FDFD) channels. To address the challenge of FDFD estimation, a cross-domain sensing-assisted channel estimation (CDS-CE) scheme is proposed to facilitate time-domain delay-Doppler parameter estimation and affine-domain channel coefficient recovery. Simulation results demonstrate that the proposed framework achieves significant improvements in sensing accuracy and resolution, as well as in channel estimation performance compared with state-of-the-art methods.

0.35

Effects of Residual Chirp Rate on DAFT-s-AFDM Uplink Performance

eess.SP ·2026-10-07 ·Henrique L. Senger, Gustavo P. Gonçalves, Bruno S. Chang, Hyeon Seok Rou, Giuseppe Thadeu Freitas de Abreu
similarity 0.59
Abstract

Affine frequency division multiplexing (AFDM) is robust to doubly dispersive channels in high-mobility 6G systems but, like orthogonal frequency division multiplexing (OFDM), suffers from a high peak-to-average power ratio (PAPR). Spreading with a discrete affine Fourier transform (DAFT) yields DAFT-s-AFDM, whose precoder and modulator chirps can be chosen independently. For a single user with zero-offset localized allocation, we show that these two chirps merge into a single residual chirp whose rate, with the other two chirp rates fixed, alone determines their effect. At the transmitter, this rate defines a circulant spreading kernel whose fourth moment quantifies the envelope fluctuation; symmetries reduce its characterization to rates in [0, 1/4]. At a linear minimum mean-square error (MMSE) receiver, the residual chirp redistributes the mean- square error across symbols without changing its total; under a Gaussian approximation, a more uniform per-symbol error lowers the uncoded bit error rate (BER). In uncoded QPSK simulations, a zero rate yields the lowest PAPR, whereas a generic rate reduces the signal-to-noise ratio required for a BER of $10^{-3}$ by 4.4 dB at a 3.33 dB PAPR cost (exceedance probability $10^{-3}$);a rate of 1/3 captures 2.8 dB of this gain for only 0.88 dB of that cost.

0.25

Characterizing the Narrowband Ambiguity Function of Frequency Modulated OFDM Waveforms

eess.SP ·2026-10-07 ·David A. Hague
published similarity 0.58
Abstract · Accepted for presentation at the IEEE ISAC Conference

This paper characterizes the spectral and Ambiguity Function (AF) properties of Frequency Modulated Orthogonal Frequency Division Multiplexing (FM-OFDM) waveforms employing Phase-Shift Keying (PSK). The mainlobe structure of the AF is well approximated by the Ellipse of Ambiguity (EOA) model. The EOA produces exact closed-form expressions that describe the AF mainlobe width in time-delay and Doppler as well as the degree of coupling between them. These expressions yield three fundamental insights into the spectral and AF shapes of FM-OFDM waveforms employing PSK: (1) these waveforms possess a fixed Root Mean Square (RMS) bandwidth for a given modulation index $h$, pulse-length $T$, and number of sub-carriers $L$, (2) they are roughly twice as spectrally efficient as Constant Envelope OFDM (CE-OFDM) waveforms with the same RMS bandwidth, and (3) for practical waveform design parameters will always possess a ``Thumbtack-Like'' AF shape. Finally, this paper demonstrates a waveform optimization technique that minimizes the FM-OFDM waveform's Auto-Correlation Function (ACF) sidelobes using only a subset of the sub-carrier symbols as sensing ``pilot'' symbols leaving the rest for communications. This pilot optimization technique is then demonstrated via two illustrative design examples.

0.32

AFDM-Enabled ISAC in Dynamic Environments: Fundamentals, Technologies and Opportunities

eess.SP ·2026-09-04 ·Linchu Chen, Zhendong Li, Zhou Su, Lin Chen, Wen Chen
similarity 0.57
Abstract

Dynamic environments pose fundamental challenges to integrated sensing and communication (ISAC), particularly due to severe Doppler effects, rapidly time-varying channels, and the intricate coupling between delay and Doppler shifts. Affine frequency-division multiplexing (AFDM), with its inherent capability of characterizing and separating delay and Doppler effects, has emerged as a promising waveform for dynamic ISAC. This article provides a comprehensive overview on AFDM-enabled ISAC in dynamic environments, covering its fundamental principles, distinctive advantages, representative application scenarios, and key enabling technologies. We first characterize the key features of ISAC in dynamic environments and introduce the fundamentals of AFDM, followed by an analysis of scenarios where AFDM can provide significant performance benefits. Then, several key enabling technologies for AFDM-based ISAC in dynamic environments are elaborated upon, accompanied by case studies on the critical aspects therein. Finally, open challenges and promising future research directions are discussed, aiming to provide a comprehensive reference for researchers and practitioners while inspiring further innovation in this emerging field.

0.21

Ambiguity Function Analysis of OFDM Signals With Pilots and Data Payloads

eess.SP ·2026-09-15 ·Jialin Wu, Fan Liu, Ying Zhang, Yifeng Xiong, Jie Yang +2 more
theory similarity 0.55
Abstract · 13 pages, 11 figures, submitted to IEEE for possible publication

Practical orthogonal frequency division multiplexing (OFDM) communication frames contain both deterministic pilots and random data payloads, motivating the joint ambiguity function (AF) analysis of the two components when the entire frame is reused for integrated sensing and communication (ISAC). This paper characterizes two discrete AF formulations for different Doppler regimes, namely the discrete periodic AF (DP-AF) and fast-slow-time AF (FST-AF), and derives closed-form expressions for their expected squared values. For the FST-AF, the expected sidelobe level (ESL) is uniform over the delay-Doppler plane and depends only on the pilot count, constellation kurtosis and total number of time-frequency resources, but not on the pilot symbols or pattern. For the DP-AF, we establish attainable lower and upper ESL bounds and show that no pilot design can minimize all sidelobes simultaneously. We further prove that attaining the lower bound at non-zero Doppler requires a periodic pilot pattern, while equally spaced chirp pilots, including Zadoff-Chu (ZC) sequences, maximize the numbers of sidelobes attaining the lower and upper bounds simultaneously. Two representative ZC pilot patterns widely encountered in communication frames are then examined: contiguous placement produces delay-Doppler ridges described by squared Dirichlet kernels, whereas equally spaced placement generates periodic peak-and-notch structures. Both regular patterns exhibit pronounced high sidelobes, suggesting that communication-oriented pilot patterns should be re-designed for delay-Doppler estimation in the context of ISAC. Numerical results validate the analysis and show that irregular pilot placement can suppress high sidelobes and improve target estimation performance.

0.21

Joint PAPR and OOBE Reduction for AFDM via Chirp Parameter Tuning

eess.SP ·2026-09-01 ·Vincent Savaux, Hyeon Seok Rou, Zeping Sui, Giuseppe Thadeu Freitas de Abreu, Zilong Liu
similarity 0.54
Abstract

This paper addresses the joint reduction of the peak-to-average power ratio (PAPR) and out-of-band emissions (OOBE) in affine frequency division multiplexing (AFDM) systems by selecting the pre-chirp parameter c2. While existing approaches typically optimize either PAPR or OOBE independently, the proposed method jointly considers both metrics. To this end, a weighted cost function combining PAPR and OOBE is introduced to evaluate the trade-off between the two objectives. A pre-chirp selection scheme, inspired by the selected mapping (SLM) technique, is then employed to identify the optimal c2 value from a finite set of candidates, yielding a Pareto-optimal operating point within a discrete set. Simulation results demonstrate that the proposed approach simultaneously reduces both PAPR and OOBE compared with conventional AFDM. Moreover, its performance remains close to that of methods specifically optimized for a single objective, with only about a 1 dB degradation in PAPR reduction and a 2-3 dB degradation in OOBE suppression.

0.46