CS Paper Radar

AFDM-Enabled ISAC in Dynamic Environments: Fundamentals, Technologies and Opportunities

Linchu Chen, Zhendong Li, Zhou Su, Lin Chen, Wen Chen

eess.SP ·submitted 2026-09-04 08:34 UTC · v1

Abstract

Dynamic environments pose fundamental challenges to integrated sensing and communication (ISAC), particularly due to severe Doppler effects, rapidly time-varying channels, and the intricate coupling between delay and Doppler shifts. Affine frequency-division multiplexing (AFDM), with its inherent capability of characterizing and separating delay and Doppler effects, has emerged as a promising waveform for dynamic ISAC. This article provides a comprehensive overview on AFDM-enabled ISAC in dynamic environments, covering its fundamental principles, distinctive advantages, representative application scenarios, and key enabling technologies. We first characterize the key features of ISAC in dynamic environments and introduce the fundamentals of AFDM, followed by an analysis of scenarios where AFDM can provide significant performance benefits. Then, several key enabling technologies for AFDM-based ISAC in dynamic environments are elaborated upon, accompanied by case studies on the critical aspects therein. Finally, open challenges and promising future research directions are discussed, aiming to provide a comprehensive reference for researchers and practitioners while inspiring further innovation in this emerging field.

Closest papers

Nearest neighbours by meaning across the whole index.

Impact of PA Nonlinearities on AFDM Sensing: A Matched Filtering Perspective

eess.SP ·2026-09-12 ·Eya Gourar, Yahia Medjahdi, Laurent Clavier, Abdul Karim Gizzini, Patrick Sondi
published similarity 0.66
Abstract · The manuscript was previously deposited in HAL (hal-05573928). Accepted for presentation at the 2026 IEEE International Conference on Integr…

Affine Frequency Division Multiplexing (AFDM) is a promising waveform for integrated sensing and communications (ISAC) due to its Doppler resilience. However, such waveforms exhibit a high peak-to-average power ratio (PAPR), and they require highly linear Power Amplifiers (PAs), which conflicts with ISAC requirements, where high transmit power for sensing is always beneficial. This paper investigates the impact of PA nonlinearities on the sensing performance of AFDM. Using the Bussgang decomposition of the nonlinearly amplified AFDM signal, we analyze the delay-Doppler ambiguity function for the sensing matched filtering and show that AFDM's sidelobes remain nearly unaffected. Simulation results confirm that AFDM outperforms OFDM in target detection under high Doppler and nonlinear amplification, highlighting its suitability for the sensing task.

0.41

2D Coprime Pilots for Delay-Doppler Sensing in OFDM-ISAC Systems

eess.SP ·2026-10-08 ·Guanping Shang, Zeyan Zhuang, Anzheng Tang, Shenghui Song, Chi-Ying Tsui
similarity 0.65
Abstract · This paper has been submitted to IEEE journal

Integrated Sensing and Communication (ISAC) is envisioned to endow future 6G systems with seamless sensing capabilities. To support efficient sensing with minimum communication overhead, sparse pilots embedded within communication frames have emerged as a promising solution. Along this line of research, existing studies have achieved engaging results in maximizing the unambiguous sensing region. However, jointly maximizing the sensing region and sensing accuracy remains challenging due to the lack of a unified performance metric and an effective pilot design framework. This paper jointly optimizes the unambiguous sensing region and sensing accuracy for estimating delay-Doppler (DD) parameters in Orthogonal Frequency Division Multiplexing (OFDM)-ISAC systems, where sensing mutual information (SMI) is adopted as a unified performance metric to characterize the overall sensing capability. Specifically, the joint optimization is formulated as an SMI maximization problem by systematically resolving sensing ambiguity and optimizing sensing accuracy. In particular, based on the generalized Bezout identity, we derive a 2D (timefrequency) coprime condition, which, as far as the authors know, is the first necessary and sufficient condition to achieve the unique estimation of DD parameters in the literature. Under this unambiguous condition, we further propose an Adam-Guided Iterative Refinement (AGIR) algorithm to optimize the sensing accuracy. Numerical results demonstrate the advantage of the proposed framework over existing designs, owing to the freedom offered by the 2D coprime condition in optimizing the sensing accuracy.

0.43

AFDM-ISAC With Fractional Delay-Doppler Coupling

cs.IT ·2026-08-12 ·Shaohua Li, Cunhua Pan, Hong Ren, Ruizhe Wang, Jiangzhou Wang
similarity 0.65
Abstract

Affine frequency division multiplexing (AFDM) is a promising chirp-based multicarrier waveform for high-mobility integrated sensing and communication (ISAC). Accurate angle, delay, and Doppler estimation is essential for AFDM sensing. Since target delays and Doppler shifts are generally continuous-valued, representing them on a discrete delay--Doppler grid causes energy leakage and peak displacement in the discrete affine Fourier transform (DAFT) domain. The AFDM chirp also induces delay--Doppler coupling in the DAFT-domain response. The resulting DAFT-domain matching-score surface exhibits a local ridge that is not aligned with the normalized-delay and normalized-Doppler axes. To address these issues, this paper investigates joint estimation of angle and continuous-valued delay--Doppler parameters for a colocated AFDM-ISAC sensing architecture. A transform-domain sparse sensing model is formulated from the fractional DAFT-domain response. Based on this model, a coupled-coordinate Newtonized orthogonal matching pursuit (CC-NOMP) estimator is developed. CC-NOMP uses the AFDM-induced coupling coordinate to parameterize the dominant local ridge. It combines coupled-coordinate Newton refinement with safeguarded updates, coupling-aligned delay refinement, and cyclic multi-target refinement to estimate angle, continuous normalized delay, and normalized Doppler. A deterministic Cramér--Rao bound and a dominant-order complexity analysis are also derived. Simulation results with continuous-valued off-grid target parameters show that CC-NOMP achieves lower delay and Doppler error floors than the considered baselines while maintaining comparable angle-estimation accuracy.

0.04

Delay-Doppler Sensing Performance Analysis for MIMO-OFDM ISAC Systems

eess.SP ·2026-09-01 ·Peishi Li, Rang Liu, Qian Liu, Ming Li
published similarity 0.64
Abstract · Accepted by IEEE Globecom 2026

In communication-centric integrated sensing and communication (ISAC), delay-Doppler sensing reuses data-bearing orthogonal frequency division multiplexing (OFDM) signals rather than dedicated radar probing waveforms. Consequently, the resulting range-Doppler map (RDM) is shaped not only by target parameters, but also by communication-symbol randomness and, in multi-antenna transmissions, by spatial beamforming. While existing analyses have largely focused on single-antenna OFDM-ISAC, the delay-Doppler sensing behavior of multi-antenna OFDM-ISAC remains insufficiently understood. This paper analyzes a multi-input multi-output (MIMO)-OFDM-ISAC system in which multiple data streams jointly illuminate a sensing target. We derive second-order moment expressions for the RDM under matched filtering (MF) and reciprocal filtering (RF), and use them to characterize the dynamic range (DR). The analysis reveals two key multi-stream effects. First, under MF, the random superposition of multiple beamformed streams creates an additional RDM floor beyond the modulation-dependent and receiver-noise terms; therefore, constant-modulus signaling no longer eliminates the data-induced pedestal as in single-antenna OFDM-ISAC. Second, under RF, the matched-angle data-induced floor is removed, but the noise floor is amplified according to the reciprocal-power statistics of the beamformed target illumination. These results show that the user-target angular geometry directly governs the MF/RF tradeoff: MF is more robust under weak illumination, whereas RF can achieve a higher DR when reciprocal-noise amplification is mild. Numerical results validate the analysis and demonstrate the distinct geometry-dependent behaviors of MF and RF.

0.14

AFDM Channel Parameter Estimation: Exploiting its Shift Properties and Input-Output Relationship

eess.SP ·2026-10-08 ·Jialiang Zhu, Zeping Sui, Zilong Liu, Arman Farhang
hot direction similarity 0.64
Abstract

Affine frequency division multiplexing (AFDM) has attracted significant attention owing to its excellent backwards compatibility, full diversity achievability, as well as strong resilience to high Doppler and various hardware impairments. Existing AFDM channel parameter estimation methods, however, either require large pilot overhead or rely on computationally intensive grid search methods. This paper proposes a grid-search-independent, low-overhead, impulse-pilot-based channel parameter estimation method for AFDM systems by exploiting its inherent shift properties. Specifically, we show that the effect of a Doppler shift on the impulse pilot is equivalent to a delay shift in the time domain with a phase rotation. Additionally, both delay and Doppler shifts lead to cyclic shifts in the affine domain. By utilizing these properties in both the time and affine domains, two linear equations are formed to estimate the integer delay and Doppler of each path. The fractional part of the Doppler is estimated from the Doppler-induced leakage around the impulse pilot by exploiting the AFDM input-output relationship. For multipath channels, a successive interference cancellation (SIC) framework is developed, in which the strongest propagation path is first estimated, reconstructed, and canceled before the remaining paths are successively estimated. Simulation results demonstrate that the proposed method significantly reduces computational complexity and allows lower pilot overhead than the benchmarks. The proposed method also achieves improved channel parameter estimation and

0.26

AFDM-ISAC Design Amalgamating FMCW Radar and Carrier Aggregation

eess.SP ·2026-10-29 ·Qu Luo, Qihao Peng, Zihuai Lin, Maged Elkashlan, Pei Xiao +2 more
publishedhot direction similarity 0.64
Abstract

Carrier-aggregation (CA)-assisted affine frequency division multiplexing (AFDM) is conceived for integrated sensing and communication (ISAC) systems. A frequency-modulated continuous-wave (FMCW)-inspired dechirping receiver is developed to exploit the inherent pulse-compression property of AFDM chirp subcarriers for accurate delay-Doppler estimation. To further enhance sensing performance, a pair of CA schemes is proposed. The Type-I CA scheme improves sensing accuracy by aggregating echo signals across multiple CA bands prior to radar processing, thereby reducing estimation error with low hardware overhead. The Type-II CA scheme enhances range resolution by effectively enlarging the sensing bandwidth, where chirps from different CA bands are designed to form a continuous set of chirp signals. Based on this principle, variable subcarrier sensing and asynchronous sensing schemes are developed. For the communication receiver, the generalized input-output relationship of AFDM is derived under both fractional delay and fractional Doppler (FDFD) channels. To address the challenge of FDFD estimation, a cross-domain sensing-assisted channel estimation (CDS-CE) scheme is proposed to facilitate time-domain delay-Doppler parameter estimation and affine-domain channel coefficient recovery. Simulation results demonstrate that the proposed framework achieves significant improvements in sensing accuracy and resolution, as well as in channel estimation performance compared with state-of-the-art methods.

0.35

FM-OFDM: A Constant-Envelope Sensing Waveform with Phase-Differencing Receiver Processing

eess.SP ·2026-09-22 ·Amir Bouziane, Hüseyin Arslan
similarity 0.63
Abstract

Cyclic-prefix orthogonal frequency-division multiplexing (CP-OFDM) is widely adopted as a reference waveform for integrated sensing and communication (ISAC). However, its high peak-to-average power ratio (PAPR) requires power amplifier back-off, thereby reducing the available sensing link budget. Frequency-modulated OFDM (FM-OFDM) provides a constant-envelope signal with 0 dB PAPR and has demonstrated reliable communication performance in high-mobility scenarios, but its sensing characteristics remain largely unexplored. This paper characterizes FM-OFDM as a sensing waveform based on its bandwidth, ambiguity function, sidelobe behavior, and Doppler estimation capability. The analysis shows that its data dependent sidelobe floor is incoherent and decreases through across frame integration, whereas the corresponding CP-OFDM floor remains unchanged. Consequently, under equal occupied bandwidth and transmit power, frame-level integration reverses the single-symbol performance ordering and provides FM-OFDM with approximately 20 dB of additional dynamic range for weak-target detection. Moreover, the zero-delay cut of the FMOFDM ambiguity function is shown to be deterministic and independent of the transmitted data realization, in contrast to linearly modulated waveforms, while a closed-form expression is derived for the sidelobe floor away from the zero-delay cut. Since the nonlinear mapping between the data symbols and time-domain samples prevents the direct application of the conventional CP-OFDM range-Doppler processing chain, a weighted phase-increment Doppler estimator is developed. The proposed estimator enables closed-form prediction of the sensing floor and its crossover point with a minimum computational complexity.

0.32

IMNet: Intercarrier Interference Mitigation Network for Integrated Sensing and Communication in Spectrally Efficient FDM Systems

eess.SP ·2026-08-24 ·Hyeonho Noh
similarity 0.63
Abstract

Spectrally efficient frequency-division multiplexing (SEFDM) is an attractive waveform to improve communication spectral efficiency by compressing the subcarrier spacing, yet its use for integrated sensing and communication (ISAC) poses a fundamental sensing challenge. Specifically, the intentional loss of subcarrier orthogonality generates SEFDM-induced intercarrier interference (S-ICI), which combines with Doppler-induced ICI (D-ICI) from moving targets to blur range--velocity maps and severely degrade sensing accuracy. Building on multi-user multi-input-multi-output (MIMO) SEFDM systems, this paper develops a model-driven ISAC framework that supports spectrally efficient multi-user communication while mitigating both S-ICI and D-ICI in sensing. To this end, an intercarrier interference mitigation network (IMNet) is proposed, which exploits the distinct physical structures of the two interferences. A bank of Doppler correction filters first compensates the velocity-dependent D-ICI over multiple Doppler hypotheses, and an axial-attention network subsequently suppresses the residual D-ICI and the long-range S-ICI to recover reliable sensing signals. To further improve range and velocity estimation accuracy, IMNet with local refinement (IMNet-LR) is proposed, which performs maximum-likelihood refinement with nuisance projection around the IMNet detections to achieve sub-cell precision without an exhaustive global search. Simulation results show that IMNet-LR achieves near-maximum-likelihood range and velocity estimation accuracy with more than three orders of magnitude lower execution time compared to conventional detection methods.

0.26