CS Paper Radar

Real-Time Music Source Separation on a Low-Power Audio DSP

Jianan Li, Li Liu, Ken Malsky, Gabby Yi

cs.SD ·submitted 2026-09-10 20:55 UTC · v1
unusual

Abstract

Real-time music source separation is validated on desktop CPUs and GPUs. Does any published system fit the embedded audio hardware it targets? On a commercial audio DSP (2 MB SRAM, 2.07 GMAC/s measured), none does, and the constraints eliminate different models: memory rules out the 16-51 M parameter TasNet/X-UMX family, per-frame compute rules out RT-STT, needing 5.5x the available MAC rate. Parameter count predicts neither: weight reuse spans 1x to 345x. We then build one that fits. Training on continuous rather than block-padded convolution context proves essential: a model scoring 3.93 dB block-wise otherwise collapses to silence within 2 s frame-by-frame. A gated complex FIR deep filter adds a latency knob, gaining 0.38 dB even when strictly causal. It reaches 4.70 dB cSDR on MUSDB18-HQ and runs in 10.43 ms of an 11.6 ms hop, 0.5-0.7 dB behind systems that do not fit.

Comment
5 pages, 3 figures, 2 tables. Submitted to ICASSP 2027

Closest papers

Nearest neighbours by meaning across the whole index.

Adapting offline models to a streaming context for music source separation

eess.SP ·2026-09-28 ·Dylan Sechet, Marc Evrard, Matthieu Kowalski
similarity 0.72
Abstract

Real-time music source separation must satisfy two constraints: a bound on algorithmic latency and a bound on computational cost. Offline separators are usually omitted from real-time comparisons or credited with a latency equal to their full input length. We show that this latency is set by where the output is read, not by the length of the separator's input. An unmodified offline model can therefore run in a streaming setting, without retraining. At each step, the input slides by one STFT hop, and one output hop is read out. The resulting latency can be as low as one STFT hop (23 ms), and the computational cost does not increase as latency shrinks. We identify a theoretical model-dependent latency boundary below which separation quality should drop steeply, and confirm this experimentally across three architectures. At equal algorithmic latency, streamed off-the-shelf checkpoints for HT-Demucs and SCNet match the published results of dedicated real-time models in terms of separation quality. Streamed models remain far less computationally efficient: only HT-Demucs runs faster than real time on a GPU.

0.15

LiteCASS: A Lightweight End-to-End Network for Real-Time Stereo Cinematic Audio Source Separation

cs.SD ·2026-09-20 ·Yuanxin Guo, Qiang Ji, Mengmei Liu, Yuhan Lv, Ningning Pan +1 more
similarity 0.68
Abstract · 5 pages, 2 figures, 3 tables

Cinematic audio source separation (CASS) decomposes a soundtrack into dialogue, music, and sound-effects (SFX) stems. Existing CASS methods, however, suffer from two critical limitations: they rely on heavily parameterized network architectures and GPU-class hardware, limiting their use in real-time and resource-constrained scenarios, and they are overwhelmingly designed for monaural signals, leaving the stereo scenario largely unexplored. We present LiteCASS, to our knowledge the first lightweight end-to-end network for real-time stereo CASS. LiteCASS combines deterministic STFT subband rearrangement with two jointly trained compact U-Nets: the first extracts dialogue, and the second separates music and SFX from the predicted non-speech component. A multi-task waveform-domain L1 loss supervises all stems. On a spatialized stereo extension of DnR v3, LiteCASS-K8 uses only 1.06M parameters and 0.72G MACs per second, while achieving the highest averaged SI-SDR among the compared CASS baselines.

0.16

Fluxion: A Differentiable DSP Runtime from Training GPU to Real-Time Edge

eess.SP cs.SDeess.AS ·2026-10-17 ·Matteo Spanio, Antonio Rodà
code/data similarity 0.63
Abstract · IEEE International Symposium on the Internet of Sounds (IS2) 2026

Native real-time audio engines meet audio deadlines but are hard to connect to machine-learning workflows, while tensor frameworks integrate with machine learning but process audio as offline batches without timing guarantees; runtime layers built on them inherit the host's scheduling and deployment footprint. This paper presents Fluxion, a Rust audio DSP runtime for cascaded second-order sections, FIR filters, and delay-line effects. Fluxion implements the parts that are specific to DSP: closed-form filter design, forward kernels, analytic adjoints for the recursion, and stability checks. It relies on existing libraries for the autodiff graph, GPU code generation (tested here on CUDA), and array interchange. One graph algebra is lowered to a differentiable training engine and to an allocation-free real-time engine; between them, a trained graph is checked for stability and frozen into a versioned artifact that an edge device checks again before playback. We compare Fluxion with six framework-hosted and native baselines under one float32 protocol. Among the systems that compute the exact recursion, Fluxion has the highest GPU throughput when data stays on the device and the highest throughput on most CPU workloads, while its CPU training step is slower than those of torchaudio and GRAFX. Its test suite checks the audio thread for allocations with an instrumented allocator, and we report measured latency tails. Fluxion is open source at \url{https://github.com/matteospanio/fluxion}.

0.29

Efficient Streaming Audio-Visual Target Speaker Extraction for Real-World Acoustic Scenes

cs.SD ·2026-10-23 ·Wendi Sang, Kai Li, Yifan Li, Jianqiang Huang, Xiaolin Hu
benchmarkcode/datacommunity pick similarity 0.62
Abstract · 28 pages

Streaming audio-visual target speaker extraction (AVTSE) is essential for latency-sensitive applications. However, current causal systems face two coupled gaps. First, standard benchmarks fix the number of speakers at two and ignore the near-/far-field interference, reverberation, and sudden noise of real scenes. Second, high-performance causal architectures are too heavy for edge deployment. Lightweight alternatives try to reclaim capacity by repeatedly invoking a small separator, which offsets the savings. To address the first gap, we release RealSSA, a realistic AVTSE benchmark consisting of RealSSA-Sim and RealSSA-Real. RealSSA-Sim provides controllable simulated scenes with 1--5 dynamic near-field interfering speakers; scenes with far-field interference additionally include 10--15 far-field interfering speakers. RealSSA-Real provides a held-out real-recorded evaluation set. To address the second gap, we propose Falcon, a causal AVTSE method. Its Separator performs multi-scale time-frequency separation in a single encoder--decoder pass. We train Falcon with an encoder-space speaker contrastive loss. This loss suppresses near-field leakage at zero inference cost and transfers across backbones. Falcon achieves state-of-the-art extraction quality on RealSSA-Sim, LRS2-2Mix, LRS3-2Mix, and VoxCeleb2-2Mix. Compared with the causal AV-TFGridNet baseline, it cuts parameters by 91.9%, computation by 20.2 times, and GPU inference latency by 11.1 times. Code and demo are available at https://cslikai.cn/Falcon/.

0.36

Learning Where to Split: Dynamic Band Splitting for Audio Source Separation

cs.SD ·2026-10-10 ·Bingzhe Zhang, Kai Li, Xiaolin Hu
code/datacommunity pick similarity 0.61
Abstract · 25 pages, 11 figures, including appendices. Code and audio demos: https://cslikai.cn/Dynamic-Band-Splitting

Audio source separation models must preserve fine spectral structure while keeping the cost of the separator tractable. Band-split architectures reduce this cost by manually partitioning the spectrum into predefined frequency bands and encoding each band as a token, but the same boundaries are used for every mixture. Because informative spectral structure varies with source content, fixed boundaries can merge discriminative components or spend tokens where little resolution is needed. We introduce Dynamic Band Splitting (DBS), an end-to-end framework that adapts boundary locations and band widths to each mixture under a fixed band-token budget. DBS predicts content-conditioned boundary scores within frequency blocks, selects a prescribed number of boundaries using hard Top-$K$, and applies content-dependent pooling to obtain compact band tokens. After separation, it smooths and expands these tokens to the original STFT grid, refines them along frequency, and decodes complex masks with a frequency-shared head. DBS improved separation over the corresponding static models on DnR v2, MUSDB18-HQ, and EchoSet, with DBS-BSRNN achieving relative gain of 29.0% in average SI-SDR on DnR v2. These results and boundary analyses on DnR v2 show that content-adaptive frequency partitioning benefits multiple separator backbones under a fixed band-token budget. Code and audio demos are available at https://cslikai.cn/Dynamic-Band-Splitting

0.37

SubRoformer: Subband Time-Domain Representation for Music Source Separation

eess.AS cs.SDeess.SP ·2026-11-05 ·Chunyat Wu, Chuang Ding, Paris Smaragdis, Qiuqiang Kong
code/data similarity 0.60
Abstract · 13 pages, 4 figures, 5 tables. Submitted to IEEE/ACM Transactions on Audio, Speech, and Language Processing

Music source separation extracts vocals and instruments from a mixed recording, enabling remixing, content production, and music analysis. Existing systems commonly operate on waveforms or full-band spectrograms. Waveform inputs contain many samples even in short segments, whereas a single spectrogram resolution imposes a shared time-frequency resolution trade-off across frequency ranges. We propose SubRoFormer, a Transformer-based system comprising a subband module and a residual RoFormer module. The subband module decomposes the mixture into frequency-localized, lower-rate signals for separation. It then reconstructs the target waveforms from the estimated subbands. The residual RoFormer module models temporal and cross-band relationships on temporally compressed features. It combines this context with fine-rate features through gated residual fusion to estimate source-specific complex masks. On the MUSDB18-HQ test set, training only on MUSDB18-HQ yields an average signal-to-distortion ratio (SDR) of 10.63 dB across four stems using target-specific models, achieving state-of-the-art performance among the compared systems without extra training data. With 500 additional training songs, a single model jointly separating all four stems achieves an average SDR of 11.59 dB, establishing state-of-the-art performance among the compared single-model multi-stem systems trained with extra data. Code and checkpoints are released at https://github.com/ArchiMickey/SubRoformer.

0.29

Investigating the Performance and Energy Costs of Replicating Band-Split RNN for Music Source Separation

cs.SD ·2026-09-18 ·Paul Magron, Romain Serizel, Constance Douwes
similarity 0.60
Abstract

Band-split recurrent neural network (BSRNN) is a popular music source separation model that yields close to state-of-the-art results using reasonable computational resources and public datasets. It is therefore interesting from a reproducible research perspective, but achieving its performance is not straightforward since its full code is not available. In this paper, we conduct a replication of BSRNN via implementing the full pipeline. We extend the original paper's analysis by experimentally studying various design choices about data preprocessing, the optimization protocol, and architectural parameters. We report and discuss this project's energy cost, and we underline how its footprint could have been substantial lower upon availability of the full pipeline, which advocates for more reproducible research practices. To comply with this objective, we publicly release our code and pre-trained models.

0.58

TAPE: Learning General Audio Effect Representations

cs.SD cs.AIcs.LGeess.AS ·2026-10-29 ·Phillip Long, Yongyi Zang, Qihui Yang, Christodoulos Benetatos, Junfei Liu +3 more
similarity 0.60
Abstract · Submitted to Transactions of Machine Learning Research; 25 pages, 5 figures, 18 tables

Musicians and mixing engineers often can decipher the signal processing chain they hear on a reference recording, then adapt it to new material. We present TAPE (Transformations of Audio Parameter Embeddings), which estimates this processing from the processed reference audio alone. An encoder trained to identify processors in eight major effect families maps the reference to an embedding. A differentiable digital signal processing (DSP) chain decodes the embedding into editable parameters in one forward pass and applies them to a different unprocessed recording. Its modules are equalization, compression, waveshaping, a small residual network, and reverberation. TAPE achieves lower spectral error than DeepAFx-ST, the previous state of the art for single-step regression, and lower spectral error than per-example search over a chain approximating ST-ITO's, while running 275$\times$ faster than that search. Because the decoder outputs DSP parameters, its chain can also run causally: a C++ implementation with the trained weights processed 128-sample buffers 1.8$\times$ faster than real time, with no missed deadlines.

0.22