CS Paper Radar

Cascaded Non-Line-of-Sight Imaging

Diego Royo, María Peña, Forrest B. Peterson, Andreas Velten, Julio Marco, Diego Gutierrez

cs.GR cs.CV ·submitted 2026-09-03 21:12 UTC · v1
top venue

Abstract

Time-of-flight non-line-of-sight (NLOS) imaging recovers information from hidden objects by analyzing the time of flight of indirect photons scattered on a visible (relay) wall. Most methods make the simplifying assumption that photons travel exclusively three-bounce paths, thus ignoring other useful information encoded in higher-order photons (with, e.g., four- or five-bounce paths). We present a novel cascaded NLOS imaging approach that leverages higher-order information and allows imaging a broader range of single- and multi-corner scenarios. We combine ultra-fast laser scanning with recent time-gated 2D sensor arrays to capture the scene's impulse response on a visible relay wall. From the captured impulse response, our method computes an analogous virtual impulse response at any other hidden wall. This effectively allows us to concatenate a second, virtual NLOS imaging system that leverages higher-order illumination. We validate our cascaded imaging method both in simulation and with a real prototype, demonstrating NLOS imaging with fourth- and fifth-bounce illumination of objects in challenging orientations and hidden around two corners. We also analyze how wave-based NLOS imaging interacts with rough hidden walls, which explains and helps overcome existing visibility limitations. We further illustrate how to image hidden objects from different perspectives, thus observing previously unseen features, by relying on multiple hidden walls.

Comment
18 pages, 21 figures. See https://graphics.unizar.es/projects/CascadedNLOS/
Journal ref
ACM Transactions on Graphics. 45, 6, Article 205 (SIGGRAPH Asia 2026)
DOI
10.1145/3842503

Closest papers

Nearest neighbours by meaning across the whole index.

Simulation-Driven Approach for Occlusion-Based Non-Line-Of-Sight Detection Using a Low-Cost Flash LiDAR

eess.IV ·2026-11-02 ·Peizhao Qiu, Emmanuel A Olowe, Zhenya Zang, Istvan Gyongy, Danial Chitnis
hot direction similarity 0.62
Abstract

Non-line-of-sight (NLOS) imaging aims to sense objects outside the direct line of sight. While most previous work focuses on the canonical around-the-corner configuration, this work considers a more challenging occlusion-based NLOS setting in which targets are hidden by scene geometry. To avoid the challenge of collecting large real-world datasets, we have developed a photon-based Monte Carlo simulator to generate diverse synthetic training data and validate against experimental data. We trained an AI model to identify multi-bounce photon patterns associated with hidden targets. The model achieves an Average Precision (AP) of 0.91 on synthetic test data and, when transferred directly to 180 real measurements acquired with a TMF8829 SPAD flash LiDAR, achieves 86.67% accuracy and an AP of 0.95. These results show that simulated transient data can support hidden-target detection with a low-cost commercial sensor and provide an initial step toward more general occlusion-based NLOS sensing and, ultimately, hidden-scene reconstruction.

0.29

Measurement-Adaptive Light-Cone Transform for Robust Non-Line-of-Sight Imaging

eess.IV cs.CV ·2026-10-16 ·Lianfang Wang, Xueying Liu, Junnan Dong, Qinghua Zhang, Jun Liu +2 more
published similarity 0.60
Abstract

Practical non-line-of-sight (NLOS) measurements are affected by noise and deviations from idealized light transport, which can degrade reconstruction with conventional light-cone transform (LCT) methods. We propose the Measurement-Adaptive Light-Cone Transform (MALCT), a physics-guided framework that retains the efficient Fourier-domain inversion structure of LCT. {Within a unified variational formulation, MALCT combines the analytical response with a shared learned response through measurement-conditioned weighting and predicts a measurement-conditioned, frequency-dependent regularization map.} An attention-enhanced spatio-temporal feature extraction module captures long-range temporal dependencies and local spatial correlations to support reconstruction under low-signal conditions. Experiments on synthetic data and real measurements from different NLOS systems demonstrate improved reconstruction quality. Controlled evaluations further assess robustness to temporal-response broadening and reduced acquisition time. MALCT also preserves scene structures with spatial sampling grids down to $32\times32$, supporting its potential for NLOS imaging under limited acquisition budgets.

0.35

Resolving Mixed Single-Photon LiDAR Returns for Foreground-View and Hidden Scene Reconstruction

cs.CV ·2026-10-01 ·Ziting Wen, Runrong Deng, Zili Zhang, Haitao Zheng, Yuecong Xu +3 more
similarity 0.57
Abstract

Partially transmissive screens and protective covers are common in robotic inspection, but they create mixed LiDAR returns from both the foreground material and the scene behind it. Conventional peak-based LiDAR usually discards weak hidden returns, while single-photon LiDAR records time-resolved histograms that preserve attenuated and overlapping echoes. However, existing transient reconstruction methods typically fit a single scene representation to the measured waveform. Under occlusion, weak or nearby foreground--hidden echoes can form a broad peak or subtle shoulder. Because such waveforms can also be explained by a displaced single surface or a thick density distribution, accurate transient fitting does not necessarily imply correct geometry. We propose a state-aware framework for foreground-view and hidden scene reconstruction from occluded single-photon histograms. For each ray, we estimate local echo evidence, identifying no reliable surface evidence, single-return evidence, or two returns. The inferred echo state routes supervision for a two-head neural field: all rays constrain waveform reconstruction, while reliable anchors provide geometry localization. We also introduce a real paired single-photon LiDAR occlusion dataset with occluded and clean captures at fixed poses. Experiments on a real dataset show improved hidden scene depth and point-cloud accuracy over baselines. Our results demonstrate single-photon layered reconstruction as a practical route for 3D perception through partially transmissive occluders.

0.23

High-Flux Count-Free Single-Photon 3D Cameras

cs.CV ·2026-08-18 ·Kaustubh Sadekar, Vivek K Goyal, David Maier, Atul Ingle
published similarity 0.57
Abstract · Presented at IEEE ICCP 2026 (Best Paper Award Winner). To appear in IEEE Transactions on Pattern Analysis and Machine Intelligence (TPAMI)

Single-photon cameras based on single-photon avalanche diode (SPAD) technology are gaining popularity for 3D sensing, thanks to their extreme sensitivity and time resolution. There are two key challenges with single-photon cameras that limit their widespread use: (i) they suffer from non-linear distortions called ''pile-up'' when operated in high-photon-flux conditions, and (ii) they generate a large volume of raw photon data, creating a severe data bottleneck at each sensor pixel. In this work, we show that while compressive capture techniques successfully mitigate data transfer challenges, they exacerbate the effects of dead-time distortion because they fail to retain sufficient information about the photon detection history to allow post-processing pile-up correction via existing methods. We propose a new computational-imaging method that combines free-running capture with an analysis-by-synthesis software pipeline to mitigate pile-up distortions. Our results with hardware emulations and full-scene and single-pixel simulations show that our method can reliably capture scene distance and reflectance over a wide range of illumination conditions. Our work will enable high-resolution SPAD cameras that are severely bandwidth-constrained to operate in real-world high-flux scenarios.

0.41

Noctif3R: Feed-Forward Monocular Real-Time SLAM for Photon-Limited Scenes on Embedded Hardware

cs.RO ·2026-09-17 ·Mihir Chauhan, Aditya Uday Abhang, Kevin Biju Mathew, Aniket Bera
similarity 0.56
Abstract

Robots carrying out tasks in dark environments need to localize from a single RGB camera, in light so low that the per-pixel signal approaches the sensor's own noise, on a power-constrained onboard computer, in real time. Each of these constraints has matured pipelines, but the intersection does not. Offline low-light reconstruction now recovers structure below -4 dB but is far too slow to run in real time, while the real-time monocular systems a robot can actually carry (DROID-SLAM, DPV-SLAM, etc.) degrade or fail when SNR gets low. We measured how they fail: across the nine lowest darkness levels of our scenes, DROID-SLAM returns a full-length trajectory carrying no information about the camera's motion on all nine, VGGT-SLAM and CUT3R on eight, pi^3 on seven, and DPV-SLAM on four. We present SYS, a monocular pipeline built on a low-light feed-forward pointmap front end with an explicit match gate, which returns three tracked trajectories and no uninformative ones, at the lowest error of any method where it tracks (24-47% of the no-information ceiling against 56-73% for the strongest baseline), and at the narrowest coverage. On a real robot video take in which 86.5% of delivered frames are entirely black, every configuration of ours stops after the lit beginning, while DROID-SLAM and DPV-SLAM each emit a pose for all 1178 frames. Our method contribution is an embedded execution path for the Jetson AGX Orin: running the map, keyframes and backend at 384 pixels with tracking at 256, together with two fixes to the per-frame pose solve, is a replicated Pareto improvement, 1.28x throughput at 0.964x error on one scene and 1.42x at 0.68x on a second, with 47% less peak GPU memory and 29% less energy per pose. We evaluate on a calibrated, bit-exact regenerable noise ladder, on relabelled real-world dark exposures, and on a new dark-room video ladder recorded from a Boston Dynamics Spot robot.

0.47

Memory-efficient GPU pipelines for real-time non-line-of-sight reconstruction

cs.DC cs.CV ·2026-08-28 ·Alfonso López-Ruiz, Diego Royo
similarity 0.56
Abstract

Non-line-of-sight (NLOS) imaging reconstructs scenes hidden around a corner from indirect light recorded by a single-photon avalanche diode (SPAD). A single reconstruction is a large inverse problem: billions of photon timestamps must be binned, moved through memory, transformed and inverted. As SPAD arrays raise acquisition throughput, reconstruction becomes the limiting stage. We rebuild the GPU execution of two established wave-based algorithms, f-k migration and phasor-fields, for both streaming and offline processing. On the phasor-fields side we assemble the ring-and-radius kernels of previous work once and offline, using the analytic Fourier transform of a ring, so the propagation kernel never exists in dense form at runtime, reducing the memory and bandwidth. We reorganize the pipeline of both algorithms with fused kernels, warp-level photon binning, batched transforms, CUDA graph replay, and FP16 storage applied only where it reduces the actual bottleneck. Our implementations are up to 42x faster than the reference streaming pipeline and up to 14x faster than the fastest published GPU baseline, all while using a fraction of the memory (down to 2.5%), enabling vastly larger and finer reconstructions on the same hardware, or comparable ones within a much lower memory budget. We report an ablation of each implementation choice and propose three denoising strategies enabled by the resulting frame budget for next-generation NLOS video processing.

0.20

On-Device Super-Resolution Imaging for a Low-Cost SPAD Array on a 640-KB-SRAM Microcontroller

eess.IV ·2026-10-06 ·Zhenya Zang, Istvan Gyongy, Mike Davies
similarity 0.54
Abstract

This work presents a super-resolution (SR) deep-learning (DL) architecture to simultaneously upscale low-resolution (LR) depth and intensity images acquired by a consumer-grade VL53L9CX time-of-flight (ToF) sensor, a compact single-photon avalanche diode (SPAD) ranging device, while targeting deployment on a resource-constrained microcontroller (MCU) with only 640 KB SRAM and 2 MB Flash. The VL53L9CX provides 54 $\times$ 42 depth and intensity measurements. The proposed framework performs $\times$4 spatial SR to reconstruct 216 $\times$ 168 depth and intensity images simultaneously. The network employs separate reconstruction branches for intensity and high-resolution (HR) depth. We train the network with efficient loss functions and investigate the performance by testing multiple compact, hardware-oriented backbones, including Spatially Adaptive Feature Modulation (SAFM), Swift Parameter-Free Attention Network (SPAN), and Residual Local Feature Network (RLFN). We evaluate the network on both synthetic and real measurements, with particular attention to constrained activation and memory storage. We export the selected network to ONNX, quantize it to INT8, generate C inference code for an STM32H563ZI Arm Cortex-M33 MCU, and integrate it with our simplified sensor's firmware. This work is the first to demonstrate a compact DL SR model on a low-cost bare-metal MCU for a consumer-grade LR SPAD sensor, integrated with customized MCU firmware to enable on-device SR inference.

0.22

Spatiotemporal Flux Probing for Single-Photon Videography

cs.CV ·2026-09-18 ·Jerry Yan, Matteo Forlivesi, Bowen Tan, Andrew Xie, Siddharth Somasundaram +1 more
top venuecode/datahot direction similarity 0.54
Abstract · ECCV 2026, Project page: https://jerukan.github.io/spt-flux-probing

We address the problem of recovering high-speed videos from dynamic scenes under extreme photon sparsity. Existing methods rely on aggregating photon detections in local spatiotemporal windows to improve signal-to-noise ratio; however, this local grouping discards global structure and fails in low-light regimes where photon detections are sparse in space and time. In this work, we show that the information needed to recover both motion and illumination is encoded in correlations over the full space-time pattern of photon arrivals. Building on this insight, we develop a spatiotemporal flux probing theory and an algorithm that estimates the Fourier coefficients of the underlying intensity directly from the photon stream. We demonstrate that our approach (1) recovers fast motion and temporal illumination dynamics with substantially fewer photons than prior methods, (2) enables velocity-selective videography that automatically refocuses video onto specific detected motions, and (3) generalizes across sensing modalities including single-photon, event, and spike cameras.

0.62