CS Paper Radar

Xona Pulsar Compatibility with Spaceborne GNSS Receivers

Argyris Kriezis, Max Turner, Claire Mah, Michael O'Meara, Tyler G. R. Reid

eess.SP ·submitted 2026-09-15 13:37 UTC · v1
published

Abstract

Low Earth Orbit (LEO) Positioning, Navigation, and Timing (PNT) systems operating in L-band Radionavigation-Satellite Service (RNSS) spectrum are rapidly emerging through both commercial and governmental initiatives. These systems are intended to complement traditional Medium Earth Orbit (MEO) constellations, such as GPS and Galileo, by providing improved satellite geometry, higher received signal power, and greater orbital diversity. As with any new RNSS deployment, ensuring compatibility with existing systems is essential to prevent harmful interference and preserve established services. While compatibility assessments for terrestrial GNSS receivers have been studied extensively, compatibility with spaceborne receivers has received comparatively little attention due to the large separation distances between MEO GNSS constellations and most spacecraft. In contrast, LEO PNT systems operate in close proximity to other satellites in LEO, making spaceborne receiver compatibility an important consideration. This paper extends the established ITU-R compatibility assessment methodology, originally developed for terrestrial receivers, to spaceborne GNSS users. The analysis evaluates the factors affecting carrier-to-noise ratio (C/N0) degradation of legacy GNSS signals in orbital environments. Results show that, although spaceborne receivers may experience higher received power levels from nearby LEO PNT satellites, such as Xona's Pulsar constellation, they can operate compatibly alongside legacy RNSS.

Comment
10 pages, 3 figures. ION GNSS+ 2026

Closest papers

Nearest neighbours by meaning across the whole index.

Pulsar Constellation Evolution and PPP Convergence using LEO GNSS

eess.SP ·2026-10-05 ·Claire Mah, Thyagaraja Marathe, Ananya Vishwanath, Matteo Gala, Tyler G. R. Reid +1 more
published similarity 0.68
Abstract · 15 pages, 14 figures, ION GNSS+ 2026

The objective of this paper is to demonstrate the future impact of a dedicated low-earth-orbit (LEO) Global Navigation Satellite System (GNSS) on positioning, navigation, and timing (PNT), in addition to a reflective discussion on how common GNSS evaluation methods can best reflect LEO satellite dynamics. This paper will feature Xona's LEO constellation, Pulsar, at various stages of deployment in a case study comparing GPS, LEO-augmented GPS, and standalone LEO. Results include visibility and dilution of precision (DOP) analysis for Pulsar at four stages of constellation deployment, as well as two cases exploring how precise point positioning (PPP) convergence is affected by Pulsar's LEO satellite dynamics. Pulsar is highlighted in this paper for its purposeful design that allows for both GNSS augmentation through compatible signals and GNSS independence (Gala et al., 2026). As dedicated LEO satellite-based positioning becomes more prominent in the PNT industry, it is important to consider which methods are used to evaluate constellation geometry and positioning performance. By evaluating the constellation through a variety of different methods in this paper, a discussion on the future evolution of LEO navigation constellations is offered. Pulsar is compared to MEO GNSS, both as an augmentation and a standalone service, through availability, dilution of precision, and PPP convergence.

0.31

Broadband LEO Satellite Constellations for Next-Generation Navigation: Potentials, Enabling Technologies, and Challenges

eess.SP ·2026-10-02 ·Zhendong Li, Mingze Zhu, Jiahao Liu, Zhou Su, Dong Fu +2 more
survey similarity 0.64
Abstract

The rapid deployment of broadband low Earth orbit (LEO) constellations provides new opportunities for next-generation navigation. Compared with conventional global navigation satellite systems (GNSS), broadband LEO systems provide stronger received signals, wider bandwidths, rapidly varying satellite geometry, and larger constellation scales, offering new capabilities for positioning, navigation, and timing (PNT). Meanwhile, their communication-oriented waveforms, high dynamics, and resource-constrained architectures introduce new challenges that are fundamentally different from those in GNSS. This article provides a comprehensive overview of broadband LEO constellations for next-generation navigation, covering their fundamental characteristics, representative use cases, key enabling technologies, and open challenges. We first compare broadband LEO systems with conventional GNSS and summarize the main technical routes for LEO-based PNT. We then discussed the emerging use cases in GNSS-challenged, multipath-dominant, and integrated communication and navigation (ICAN) scenarios. Key enabling technologies including waveform design, high-dynamic signal processing, and constellation resource scheduling are further reviewed. As a representative case study, the navigation-oriented optimization of the Starlink primary synchronization sequence demonstrates that subcarrier power allocation can improve multipath resistance while maintaining ranging accuracy. Finally, several challenges and future directions of broadband LEO-based navigation are discussed, aiming to provide reference for future researches.

0.18

Signal Design Impacts on GNSS and LEO-PNT L1 Band Acquisition Complexity: A Case Study with Xona Pulsar

eess.SP ·2026-10-19 ·Jérôme Leclère, Rajnesh Joshi, Thyagaraja Marathe, Tyler G. R. Reid
published similarity 0.60
Abstract

GNSS signal acquisition is the process of detecting and estimating signal parameters by exploiting correlation operations that provide processing gain and enable the detection of signals below the noise floor. The design of an acquisition engine requires balancing achievable sensitivity, computational complexity, memory requirements, power consumption, and implementation complexity. In particular, increasing coherent and non-coherent integration times improves sensitivity but can significantly increase receiver processing requirements, limiting its applicability in low-power and resource-constrained receivers. This paper presents a comparative analysis of L1-band signal acquisition complexity by evaluating the required integration time and corresponding implementation requirements for different signal designs under equivalent acquisition performance targets. The analysis considers the impact of signal characteristics, including spreading codes, secondary codes, modulation, and signal bandwidth, on coherent and non-coherent acquisition performance. For a given attenuation level and target probability of false alarm and detection, the required integration times are derived and translated into acquisition complexity metrics, including arithmetic operations, processing time, and memory requirements. The analysis is applied to Pulsar X1, a LEO-enabled PNT signal, and representative GNSS L1 signals to determine under which attenuation, assistance, and integration conditions the higher received power of LEO-PNT translates into reduced receiver acquisition workload. By relating the required integration to arithmetic operations, processing time, and memory requirements, the study provides a receiver-level comparison relevant to both conventional and snapshot-based receivers, where reducing acquisition processing can directly contribute to lower energy consumption.

0.35

gr-ntnisac: An Open GNU Radio Testbed for NTN-ISAC

eess.SP eess.SY ·2026-10-08 ·Soham Dhiren Desai
published similarity 0.60
Abstract · Vol. 11 No. 1 (2026): Proceedings of the 16th GNU Radio Conference / Articles

A passive receiver can sense nearby objects from the echoes of a 5G downlink. When the transmitter is a low-Earth-orbit (LEO) satellite, one transmitter covers a wide area, but the receiver must handle tens of kHz of Doppler and a direct-path delay that changes within every observation interval. Such a receiver should be tested where the correct answer is known before it is tried on a satellite. This paper presents gr-ntnisac, an open GNU Radio testbed that applies an emulated LEO channel to a standard 5G New Radio downlink, sends it through two cabled USRPs, and scores the receiver against the delay and Doppler commanded for every path. The same receiver code runs in simulation, on recorded captures, and on hardware. As a first use, we measure cancellation of the direct path, the strong satellite signal that masks weak echoes. Depth is 34.8 dB on hardware and 37.6 dB in a matched simulation without radios, so the radios are not the main limit. Controlled simulation shows that the emulator's 8-tap fractional-delay filter and a simulated rotating blade at almost the direct path's delay each limit depth to about 40 dB; without either, depth reaches 71.0 dB. A diagnostic canceller that also removes the per-subcarrier response and per-symbol phase reaches 72.7 dB on the same captures. On a conducted capture, a payload-aided receiver detects a -25 dB moving path in 76.9 percent of dwells.

0.31

Toward Pseudorange-Based PNT with Starlink: A Mock Fused LEO GNSS Implementation

eess.SP astro-ph.IMeess.SY ·2026-11-10 ·Samuel C. Morgan, Zacharias M. Komodromos, Wenkai Qin, Andrew Graff, Zachary L. Clements +2 more
similarity 0.59
Abstract

We present experimental results from Starlink for pseudorange-based positioning, navigation, and timing (PNT), emulating a system that fuses a primary communications mission with a secondary low-Earth orbit (LEO) PNT mission. Legacy global navigation satellite system (GNSS) constellations faceinherent vulnerabilities and signal limitations, prompting growing interest in broadband LEO constellations---such as SpaceX's Starlink---for resilient PNT. However, opportunistic use of stand-alone Starlink signals fails to achieve GNSS-competitive accuracy due to frame timing irregularities and reliance on uncorrected poor-quality publicly available ephemeris data. To overcome these limitations, we present a mock implementation of a fused LEO GNSS architecture. Our method extracts time-of-arrival observables from live Starlink Ku-band downlinks and pairs them with high-fidelity, beam-specific orbit and clock models distributed as if provided natively by the constellation operator. In a field campaign, and despite constraints imposed by consumer-grade receiver hardware, the method yields 95% error bounds of 2.33 m horizontally (semi-major axis), 3.37 m vertically, and 11.19 ns in timing, with the actual solution errors falling well within these bounds.

0.11

Enhancing 5G NTN VSAT RACH in GNSS-Denied environments

eess.SP ·2026-09-24 ·Francesco Menzione, Alejandro Gonzalez-Garrido, Flavien Ronteix-Jacquet, Ottavio M. Picchi
published similarity 0.58
Abstract

The 3GPP 5G non-terrestrial networks (NTN) technology fundamentally relies on a global navigation satellite system (GNSS) fix at the user equipment (UE) to pre-compensate for user-link delay and Doppler shifts prior to any transmission, including the random-access procedure for initial access. In GNSS-denied or interfered environments, this dependency triggers preamble collisions and connection dropouts, undermining satellite-based global connectivity. To address this vulnerability, this paper introduces a novel single-satellite positioning framework designed for higher-frequency (Ku- or Ka-band) 5G NTN very small aperture terminals (VSATs) equipped with a phased-array antenna. The multi-step scheme derives an initial coarse position from angle of arrival (AoA) observables, extracts frequency of arrival (FoA) and time of arrival (ToA) measurements from low Earth orbit (LEO) downlink reference signals, and hybridizes them within a Levenberg-Marquardt navigation filter. Systematic evaluations across static grids and realistic dynamic urban trajectories detail the incremental gains of transitioning from single-epoch AoA error minimization to multi-epoch angular tracking, followed by the integration of Doppler and ranging observables. Grounded in a realistic error budget, the proposed framework reduces initial positioning uncertainty from tens of kilometres down to a few kilometres. This level of positioning accuracy, combined with the GNSS-resilient features introduced in 3GPP Release 20 NR NTN specifications, enables robust initial access in compromised operational environments with minimal relaxation of 3GPP standards.

0.32

Half-Slot Link Scheduling for Open GNSS with $x$-Tx $y$-Rx Multibeam Phased Array Antennas

eess.SY ·2026-10-22 ·Huan Yan, Kanglian Zhao, Wenfeng Li, Jinjun Zheng, Ziyu Wang +1 more
similarity 0.57
Abstract · 20 pages and 10 figs

Global Navigation Satellite Systems (GNSSs) are evolving from closed navigation constellations toward open space infrastructure capable of serving extensive spacecraft users. This evolution requires the constellation to support navigation ranging, telemetry (TM) return, and telecommand (TC) delivery for users while preserving its own ranging and communication functions.Existing phased-array payloads onboard BeiDou satellites provide one transmit (Tx) beam and one receive (Rx) beam. Such a configuration was designed mainly for intra-constellation operation, and can become a resource bottleneck when a large number of users share the same link opportunities. Upgrading GNSS satellites to phased-array terminals with $x$-Tx and $y$-Rx beams is therefore a natural enhancement. This paper develops a staged dynamic half-slot link scheduling framework (SDHSS) for open GNSS with $x$-Tx $y$-Rx multibeam phased-array antennas. The framework models navigation, TM, and TC as three different services, reserves the essential ranging and ground-access opportunities required by the GNSS constellation, and then allocates the remaining half-slot beam resources according to current service demand. To support multibeam concurrency, feasible links are selected through dynamic service-layer ordering and beam-copy matching. Simulations based on a BeiDou constellation show that the proposed method protects GNSS baseline operation and provides stronger external navigation, TM, and TC performance than fair contact planning. The results further show that additional Tx and Rx beams can be effectively converted into multi-service capability. This work establishes a link-scheduling approach for extending GNSS from constellation-internal operation to large-scale spacecraft service support.

0.30

Lunar Surface Receiver Clock Synchronization Using GNSS and Satellite Nadir Angle

eess.SP ·2026-10-01 ·Minju Han, Seunghyeon Park, Joon Hyo Rhee
similarity 0.57
Abstract · Submitted to ICCE-Asia 2026

The use of signals from Earth-orbiting Global Navigation Satellite System (GNSS) constellations for positioning, navigation, and timing on the lunar surface was recently demonstrated by the Lunar GNSS Receiver Experiment (LuGRE) aboard Blue Ghost Mission 1. For receiver clock synchronization using GNSS, Kalman filter performance depends on the satellite-specific measurement uncertainty used to construct the measurement noise covariance. Terrestrial measurement weighting commonly relies on receiver elevation angle, but the elevation angles in the analyzed LuGRE data are confined to 24.2-31.5 degrees, providing limited discrimination of measurement quality. In contrast, satellite nadir angles span 12.1-66.6 degrees, and the measurement variability increases substantially at small nadir angles. Based on this observation, we propose a measurement weighting model that combines satellite nadir angle with C/N0 for lunar surface receiver clock synchronization. The proposed model is evaluated against three weighting methods adopted from the literature using seven LuGRE operation periods (OPs). It achieves the lowest receiver clock bias root mean square error (RMSE) in six of the seven OPs and an overall RMSE of 5.78 m, which is 19.5% lower than that of the best comparison model. The proposed model also provides the lowest clock bias prediction RMSE under simulated measurement outages.

0.25