CS Paper Radar

Signal Design Impacts on GNSS and LEO-PNT L1 Band Acquisition Complexity: A Case Study with Xona Pulsar

Jérôme Leclère, Rajnesh Joshi, Thyagaraja Marathe, Tyler G. R. Reid

eess.SP ·submitted 2026-10-19 13:17 UTC · v1
published

Abstract

GNSS signal acquisition is the process of detecting and estimating signal parameters by exploiting correlation operations that provide processing gain and enable the detection of signals below the noise floor. The design of an acquisition engine requires balancing achievable sensitivity, computational complexity, memory requirements, power consumption, and implementation complexity. In particular, increasing coherent and non-coherent integration times improves sensitivity but can significantly increase receiver processing requirements, limiting its applicability in low-power and resource-constrained receivers. This paper presents a comparative analysis of L1-band signal acquisition complexity by evaluating the required integration time and corresponding implementation requirements for different signal designs under equivalent acquisition performance targets. The analysis considers the impact of signal characteristics, including spreading codes, secondary codes, modulation, and signal bandwidth, on coherent and non-coherent acquisition performance. For a given attenuation level and target probability of false alarm and detection, the required integration times are derived and translated into acquisition complexity metrics, including arithmetic operations, processing time, and memory requirements. The analysis is applied to Pulsar X1, a LEO-enabled PNT signal, and representative GNSS L1 signals to determine under which attenuation, assistance, and integration conditions the higher received power of LEO-PNT translates into reduced receiver acquisition workload. By relating the required integration to arithmetic operations, processing time, and memory requirements, the study provides a receiver-level comparison relevant to both conventional and snapshot-based receivers, where reducing acquisition processing can directly contribute to lower energy consumption.

Journal ref
Proceedings of the 39th International Technical Meeting of the Satellite Division of the Institute of Navigation (ION GNSS+ 2026), Orlando, Florida, September 2026, pp. 2525-2593
DOI
10.33012/2026.20902

Closest papers

Nearest neighbours by meaning across the whole index.

Xona Pulsar Compatibility with Spaceborne GNSS Receivers

eess.SP ·2026-09-15 ·Argyris Kriezis, Max Turner, Claire Mah, Michael O'Meara, Tyler G. R. Reid
published similarity 0.60
Abstract · 10 pages, 3 figures. ION GNSS+ 2026

Low Earth Orbit (LEO) Positioning, Navigation, and Timing (PNT) systems operating in L-band Radionavigation-Satellite Service (RNSS) spectrum are rapidly emerging through both commercial and governmental initiatives. These systems are intended to complement traditional Medium Earth Orbit (MEO) constellations, such as GPS and Galileo, by providing improved satellite geometry, higher received signal power, and greater orbital diversity. As with any new RNSS deployment, ensuring compatibility with existing systems is essential to prevent harmful interference and preserve established services. While compatibility assessments for terrestrial GNSS receivers have been studied extensively, compatibility with spaceborne receivers has received comparatively little attention due to the large separation distances between MEO GNSS constellations and most spacecraft. In contrast, LEO PNT systems operate in close proximity to other satellites in LEO, making spaceborne receiver compatibility an important consideration. This paper extends the established ITU-R compatibility assessment methodology, originally developed for terrestrial receivers, to spaceborne GNSS users. The analysis evaluates the factors affecting carrier-to-noise ratio (C/N0) degradation of legacy GNSS signals in orbital environments. Results show that, although spaceborne receivers may experience higher received power levels from nearby LEO PNT satellites, such as Xona's Pulsar constellation, they can operate compatibly alongside legacy RNSS.

0.37

Pulsar Constellation Evolution and PPP Convergence using LEO GNSS

eess.SP ·2026-10-05 ·Claire Mah, Thyagaraja Marathe, Ananya Vishwanath, Matteo Gala, Tyler G. R. Reid +1 more
published similarity 0.51
Abstract · 15 pages, 14 figures, ION GNSS+ 2026

The objective of this paper is to demonstrate the future impact of a dedicated low-earth-orbit (LEO) Global Navigation Satellite System (GNSS) on positioning, navigation, and timing (PNT), in addition to a reflective discussion on how common GNSS evaluation methods can best reflect LEO satellite dynamics. This paper will feature Xona's LEO constellation, Pulsar, at various stages of deployment in a case study comparing GPS, LEO-augmented GPS, and standalone LEO. Results include visibility and dilution of precision (DOP) analysis for Pulsar at four stages of constellation deployment, as well as two cases exploring how precise point positioning (PPP) convergence is affected by Pulsar's LEO satellite dynamics. Pulsar is highlighted in this paper for its purposeful design that allows for both GNSS augmentation through compatible signals and GNSS independence (Gala et al., 2026). As dedicated LEO satellite-based positioning becomes more prominent in the PNT industry, it is important to consider which methods are used to evaluate constellation geometry and positioning performance. By evaluating the constellation through a variety of different methods in this paper, a discussion on the future evolution of LEO navigation constellations is offered. Pulsar is compared to MEO GNSS, both as an augmentation and a standalone service, through availability, dilution of precision, and PPP convergence.

0.31

Broadband LEO Satellite Constellations for Next-Generation Navigation: Potentials, Enabling Technologies, and Challenges

eess.SP ·2026-10-02 ·Zhendong Li, Mingze Zhu, Jiahao Liu, Zhou Su, Dong Fu +2 more
survey similarity 0.50
Abstract

The rapid deployment of broadband low Earth orbit (LEO) constellations provides new opportunities for next-generation navigation. Compared with conventional global navigation satellite systems (GNSS), broadband LEO systems provide stronger received signals, wider bandwidths, rapidly varying satellite geometry, and larger constellation scales, offering new capabilities for positioning, navigation, and timing (PNT). Meanwhile, their communication-oriented waveforms, high dynamics, and resource-constrained architectures introduce new challenges that are fundamentally different from those in GNSS. This article provides a comprehensive overview of broadband LEO constellations for next-generation navigation, covering their fundamental characteristics, representative use cases, key enabling technologies, and open challenges. We first compare broadband LEO systems with conventional GNSS and summarize the main technical routes for LEO-based PNT. We then discussed the emerging use cases in GNSS-challenged, multipath-dominant, and integrated communication and navigation (ICAN) scenarios. Key enabling technologies including waveform design, high-dynamic signal processing, and constellation resource scheduling are further reviewed. As a representative case study, the navigation-oriented optimization of the Starlink primary synchronization sequence demonstrates that subcarrier power allocation can improve multipath resistance while maintaining ranging accuracy. Finally, several challenges and future directions of broadband LEO-based navigation are discussed, aiming to provide reference for future researches.

0.18

An HFM-Inspired Random Access Preamble Design for NTN under High Doppler

eess.SP ·2026-08-14 ·Mehwish Bibi, Saira Rafique, Ahmed Naeem, Huseyin Arslan
similarity 0.50
Abstract

Non-terrestrial networks (NTNs) are a key enabler of ubiquitous 6G connectivity, but the high orbital velocity and long propagation distances in low-Earth orbit (LEO) NTN operation introduce large Doppler shifts and substantial delay uncertainty that challenge New Radio (NR) physical random access channel (PRACH) design. Conventional Zadoff Chu (ZC) and linear frequency modulated (LFM) preambles are particularly vulnerable, as Doppler induced ambiguity and delay Doppler coupling degrade timing estimation and preamble identification. This paper proposes a hyperbolic frequency modulation (HFM) inspired PRACH preamble for robust synchronization and reliable identification under uncompensated or unknown Doppler, detected with a conventional matched filter receiver so that the gains reflect the preamble design. A unified delay Doppler ambiguity function framework characterizes the self and cross ambiguity behavior of ZC, LFM, and HFM inspired preambles, and a scaling-factor based codebook ensures multi-user separability. Simulation results under NTN channel conditions confirm higher detection probability, lower timing root mean square error (RMSE), and improved peak to sidelobe and integrated sidelobe levels compared with ZC and frequency-domain superposed LFM baselines.

0.04

Hardware-friendly Baseband Design and Performance Analysis for LEO Broadband LoS-MIMO Systems

eess.SP ·2026-10-14 ·Peixin Zhang, Fengkui Gong, Guo Li, Tony Q. S. Quek
similarity 0.50
Abstract · 6 pages, 5 figures

High-frequency and broadband line-of-sight multiple-input multiple-output (LoS-MIMO) is a key solution for massive space-to-Earth data downlinks. However, in low Earth orbit (LEO) scenarios, it faces spatial rank deficiency from time-frequency coupling correlation and clock deviations from distributed oscillators. This paper establishes a dynamic effective channel throughput (ECT) framework incorporating waterfall characteristics of forward error correction. A hardware-friendly OFDM-based transceiver architecture with subband-adaptive truncation and dynamic timing recovery to achieve robust spatial decoupling is proposed. Through rigorous closed-form derivations, the equivalent signal-to-interference-plus-noise ratio (SINR) under joint errors is quantified, and an optimal scheduling algorithm combining truncation with variable coding and modulation is proposed to maximize ECT. Simulations confirm that the design circumvents outages caused by spatial notches with low complexity, stably enhancing the potential average throughput of a single dual-polarized beam to over 100 Gbps, providing a reliable theoretical foundation and baseband solution for next-generation high-throughput satellites.

0.23

Some Practical Issues of the Tracking Process in GNSS Receivers

eess.SP ·2026-08-20 ·S. V. Shafran, I. A. Kudryavtsev, A. A. Kumarin
published similarity 0.49
Abstract · 8 pages, 17 figures

The accuracy and noise immunity of GNSS receivers are largely determined by the performance of their tracking modules. To optimize performance, designers should take into account several key issues: the choice of integration intervals, the time delay (spacing) between the early and late correlator channels, and the parameters of tracking loop filters. This article presents the results of an analysis of these important practical aspects. The obtained results display some ways of improv-ing the parameters of transient processes, which occur in tracking modules. The study was conducted on an experimental navigation receiver, processing GPS L1 signals. Experimental data were obtained using the simulation software package, developed by the authors, Xilinx environment Vivado, as well as the processing of recordings of real navigation signals obtained in full-scale tests.

0.41

A Low-Complexity Message-Passing Receiver for FTN-WAFT under Nonlinear Distortion

eess.SP ·2026-09-29 ·Xianle Dai, Qu Luo, Jianguo Li, Bowei Xue, Kai Yang +2 more
published similarity 0.48
Abstract

This letter proposes a faster-than-Nyquist (FTN) weighted affine Fourier transform (WAFT) transmission scheme, termed FTN-WAFT, which combines the peak-to-average power ratio (PAPR) flexibility of WAFT with FTN time compression to improve spectral efficiency and power amplifier (PA) efficiency over high-mobility channels. However, operating the PA at a reduced input back-off (IBO) inevitably introduces nonlinear distortion, which further couples with FTN-induced inter-symbol interference (FTN-ISI) and doubly selective channel dispersion. To address this practical impairment, a multilayer message-passing (MLMP) receiver aided by PA interference cancellation (PA-IC), termed PA-IC-MLMP, is proposed. The proposed receiver reconstructs the dominant PA distortion from soft symbol estimates, cancels the channel-propagated nonlinear interference, and performs MLMP over the WAFT, FTN, channel, and constellation layers. Simulation results show that the proposed receiver improves the bit error rate (BER) and effective throughput under nonlinear PA constraints while maintaining low complexity.

0.32

An All-Digital Coherent AFSK Demodulator for CubeSat Applications

eess.SP ·2026-11-13 ·Rubem Vasconcelos Pacelli, Rodrigo de Lima Florindo, Felix Antreich, Antônio Macilio Pereira de Lucena
published similarity 0.48
Abstract · Preprint of an article published in Digital Signal Processing (Elsevier), 2025

Audio frequency-shift keying (AFSK) is a widely adopted modulation scheme for CubeSat systems due to its favorable bandwidth efficiency and implementation simplicity. However, coherent detection usually is avoided because synchronization impairments, caused by intense line-of-sight (LOS) dynamics inherent in low Earth orbit (LEO), may significantly degrade the bit error rate (BER). This paper presents a new all-digital coherent AFSK demodulator based on a Kalman filter (KF) for carrier phase and timing delay synchronization and the Viterbi algorithm for bit detection. The Viterbi algorithm is employed for maximum likelihood sequence detection, and the detected bit statistics are fed back to the KF to estimate phase shift, Doppler frequency shift, and Doppler drift induced by the LOS dynamics. Original mathematical analyses are derived to provide a theoretical foundation for the proposed demodulator's operation, specifically addressing its synchronization accuracy in dynamic LEO environments. The proposed demodulator is evaluated considering an additive white Gaussian noise channel with real CubeSat orbits. The performance results obtained through computer simulations demonstrate that the proposed model can withstand such scenarios with a gain of 5 dB in terms of BER compared to the conventional noncoherent AFSK demodulator. The KF performance is assessed using a moving root-mean-square error (MRMSE) statistic and the trace of its state error covariance matrix estimate.

0.56