CS Paper Radar

Some Practical Issues of the Tracking Process in GNSS Receivers

S. V. Shafran, I. A. Kudryavtsev, A. A. Kumarin

eess.SP ·submitted 2026-08-20 11:41 UTC · v1
published

Abstract

The accuracy and noise immunity of GNSS receivers are largely determined by the performance of their tracking modules. To optimize performance, designers should take into account several key issues: the choice of integration intervals, the time delay (spacing) between the early and late correlator channels, and the parameters of tracking loop filters. This article presents the results of an analysis of these important practical aspects. The obtained results display some ways of improv-ing the parameters of transient processes, which occur in tracking modules. The study was conducted on an experimental navigation receiver, processing GPS L1 signals. Experimental data were obtained using the simulation software package, developed by the authors, Xilinx environment Vivado, as well as the processing of recordings of real navigation signals obtained in full-scale tests.

Comment
8 pages, 17 figures
Journal ref
published in the journal "Infokommunikacionnye Tehnologii" by Povolzhskiy State University of Telecommunications and Informatics (Samara) No.1 2026

Closest papers

Nearest neighbours by meaning across the whole index.

Application of the Phase Correction Method in Tracking Modules of Navigation Receivers

eess.SP ·2026-11-10 ·Kudryavtsev I. A., Shafran S. V., Balmasova M. A
published similarity 0.67
Abstract · 15 pages, 17 figures. The paper is accepted for publication in the journal "Radiotechnika" (Radio engineering)

One of the problems of the tracking modules is their significant inertia in case of narrow bandwidth, which is desirable to mitigate signal noise. The paper describes a method of phase correction, improving accuracy and dynamic characteristics of the tracking process in GNSS receivers. The pivotal idea of the method supposes correction of the phase deviation between the received signal and its local copy at the end of every integration period. This correction is performed directly over the phase accumulator of a DDS system. This approach reduces inertial effects crucially. Application of phase correction method with narrow filter bandwidth is much more efficient when FLL-assisted PLL tracking is used. It is shown that in this case a separate FLL discriminator is not needed, and the resulting filter structure can be significantly simplified.

0.29

Beyond Legacy L1 C/A: Characterizing Advanced Multi-Frequency Spoofing Against Multi-Frequency GPS Receivers for Autonomous Navigation

eess.SP physics.space-phstat.AP ·2026-09-21 ·Minhaj Uddin Ahmad, Muhammad Sami Irfan, Sagar Dasgupta, Mizanur Rahman, Thejesh N. Bandi
published similarity 0.61
Abstract · Accepted at GNSS+ 2026

Autonomous vehicles increasingly rely on high-end multi-frequency GNSS receivers that track modernized civil signals, such as L2C, L5, and L1C, alongside legacy GPS L1~C/A. Although multi-frequency operation improves robustness against natural error sources, its resilience against synchronous multi-band spoofing attacks remains insufficiently characterized. This paper presents a method for quantifying the inter-band alignment accuracy required for a coherent spoofer to evade cross-frequency consistency monitoring that a resilient receiver may employ. As a foundational study, the presented method is implemented and evaluated using the GPS L1 C/A and L2C signal pair within a controlled software-defined environment. This environment encompasses deterministic signal synthesis, programmable inter-band code offsets realized through fractional-delay filtering, and processing by a dual-frequency GNSS-SDR receiver. An inter-frequency pseudorange-difference consistency detector is defined and calibrated using a constant-false-alarm-rate (CFAR) approach, yielding a threshold of approximately 19 m at a false-alarm probability of $10^{-3}$. Signal fidelity and receiver capture are verified through correlation-function analysis using a multi-tap correlator bank. The inter-band code offset is then swept from one code chip to 0.005 chips to characterize detector performance. Results show that a perfectly aligned coherent attack yields a detection probability of zero, while detection probability increases rapidly with inter-band misalignment, reaching approximately 50% at 0.05 chips (about 15 m) and approaching unity for offsets of 0.2 chips or greater. These results quantify the alignment precision required for successful coherent dual-frequency spoofing and establish a practical framework for future evaluation of L5, L1C, and hardware-based multi-frequency spoofing scenarios.

0.32

GNSS Receiver Operating Point Comparison Between Vector and Scalar Tracking Under High-Dynamics

eess.SP eess.SY ·2026-10-30 ·J. Fermín Llorente, Ernesto M. López, Javier A. Smidt, Pedro A. Roncagliolo
code/data similarity 0.61
Abstract

This paper presents a measurement noise adaptation mechanism for Kalman filter-based carrier tracking in a navigation-aided GNSS receiver designed for launch-vehicle applications. The tracking loop is tuned for 20\,g acceleration steps, which requires a wide bandwidth that makes the loop vulnerable to noise-driven pull-out at low carrier-to-noise density ratios. To resolve this tradeoff, the measurement noise covariance, $R$, is inflated via a two-layer gate: a sigmoid envelope keyed to the signal $C/N_0$, modulated by a dynamics indicator derived from the discriminator output statistics of the Loop Bandwidth Control Algorithm. During noise-dominated periods the gate inflates~$R$, reducing the Kalman gain so the filter coasts on the navigation-aided prediction; when dynamics are detected the gate opens within one epoch, restoring the high-bandwidth tuning. The navigation aiding is formulated as a stochastic control input whose uncertainty is propagated from the navigation EKF covariance. Simulation results on a 20\,g acceleration step scenario show that the adapted vector architecture doubles the lock-retention rate relative to the standalone scalar filter at $C/N_0 = 31$\,dB-Hz. The receiver is implemented in MSGR, an open-source MATLAB GNSS software-defined receiver.

0.44

Adaptive Orbit-Aided Vector Tracking for Orbit Determination of LEO Satellites

eess.SP eess.SY ·2026-10-28 ·Zihong Zhou, Bing Xu
similarity 0.57
Abstract

Reliable orbit determination for CubeSats is essential for emerging low-Earth-orbit positioning, navigation, and timing (LEO-PNT) applications. However, onboard orbit determination remains constrained by single-frequency GNSS code-based receivers, intermittent signal reception, and highly dynamic orbital conditions. This paper proposes an adaptive orbit-aided vector tracking (OAVT) algorithm for LEO-PNT CubeSat orbit determination under these conditions. The method employs a GNSS vector tracking loop (VTL) as the primary navigation estimator and loosely couples it with a low-fidelity orbital dynamics model (ODM), which provides auxiliary position and velocity pseudo-measurements. The contribution of the ODM is regulated through adaptive covariance assignment based on GNSS stress and the residual consistency between the ODM and GNSS solutions. Under nominal conditions, OAVT preserves the accuracy advantage of VTL over the conventional scalar tracking loop. The 3D position root-mean-square error (RMSE) is reduced from 2.631\,m for STL to 1.081\,m, while the 3D velocity RMSE decreases from 0.3985\,m/s to 0.1023\,m/s. Under degraded conditions, OAVT provides substantially greater robustness than both STL and standalone VTL. The 3D position RMSE remains bounded at 8.27\,m during a complete signal outage, 10.17\,m during gradual signal loss and reacquisition, and 26.65\,m under variable visibility, whereas STL fails to produce valid solutions and standalone VTL loses lock. These results demonstrate that OAVT substantially improves solution robustness and state continuity with only a moderate increase in computational burden, making it suitable for CubeSat orbit determination and future LEO-PNT missions.

0.28

Lunar Surface Receiver Clock Synchronization Using GNSS and Satellite Nadir Angle

eess.SP ·2026-10-01 ·Minju Han, Seunghyeon Park, Joon Hyo Rhee
similarity 0.56
Abstract · Submitted to ICCE-Asia 2026

The use of signals from Earth-orbiting Global Navigation Satellite System (GNSS) constellations for positioning, navigation, and timing on the lunar surface was recently demonstrated by the Lunar GNSS Receiver Experiment (LuGRE) aboard Blue Ghost Mission 1. For receiver clock synchronization using GNSS, Kalman filter performance depends on the satellite-specific measurement uncertainty used to construct the measurement noise covariance. Terrestrial measurement weighting commonly relies on receiver elevation angle, but the elevation angles in the analyzed LuGRE data are confined to 24.2-31.5 degrees, providing limited discrimination of measurement quality. In contrast, satellite nadir angles span 12.1-66.6 degrees, and the measurement variability increases substantially at small nadir angles. Based on this observation, we propose a measurement weighting model that combines satellite nadir angle with C/N0 for lunar surface receiver clock synchronization. The proposed model is evaluated against three weighting methods adopted from the literature using seven LuGRE operation periods (OPs). It achieves the lowest receiver clock bias root mean square error (RMSE) in six of the seven OPs and an overall RMSE of 5.78 m, which is 19.5% lower than that of the best comparison model. The proposed model also provides the lowest clock bias prediction RMSE under simulated measurement outages.

0.25

GNSS Spoofing in Mobile Devices: A Survey on Impact and Countermeasures

cs.CR eess.SPeess.SY ·2026-10-01 ·Robert Argo, Andrea Nardin, Alex Minetto, Pau Closas
survey similarity 0.52
Abstract · 24 pages, 9 figures

Smartphones rely on Global Navigation Satellite System (GNSS)-based positioning for many of the functions they execute everyday. The GNSS receivers embedded in smartphones are susceptible to anthropogenic radio frequency interference attacks in the forms of jamming and spoofing due to the low-power and open-architecture signals they receive from the satellite constellations. While jamming is a practice that denies a GNSS receiver the ability to form a position, velocity, and time (PVT) solution, spoofing represents a more insidious threat by using forged satellite signals that aim at causing the victim receiver to compute a false PVT solution. The ubiquity of smartphones and the sensitive geolocation data they hold make them a primary target for malicious spoofing. However, their hardware constraints and the lack of deep visibility into the GNSS receiver processing chain create significant hurdles for effective countermeasures. Existing surveys comprehensively explore general spoofing countermeasures but fail to address these mobile-specific limitations. This article fills that gap with a novel survey focused on techniques viable within the unique constraints of smartphone architectures. Specifically, we establish a taxonomy for defining GNSS spoofing attack effects and countermeasures, provide a historical review of smartphone vulnerability characterization, and provide an overview of techniques proposed to detect and counteract smartphone spoofing threats, offering a comparative framework to weigh their respective pros and cons on mobile platforms.

0.19

LEO Signals-of-Opportunity for Navigation in Urban Environments: A GLRT-Assisted Off-Grid SBL Approach

cs.IT ·2026-10-06 ·Maedeh Sotoodenia, Mohammad Hossein Kahaei, Alireza Nezamalhosseini
similarity 0.52
Abstract · 11 pages, 5 figures

The vulnerability and unavailability of global navigation satellite system (GNSS) signals in dense urban environments have motivated the use of low earth orbit (LEO) signals of opportunity (SoOP) for positioning, navigation, and timing (PNT). However, multipath and non-ideal noise can significantly degrade delay--Doppler estimation and, consequently, navigation accuracy. This paper proposes a hybrid generalized likelihood ratio test (GLRT) and off-grid sparse Bayesian learning (SBL) framework for LEO-SoOP navigation under multipath and non-Gaussian, temporally correlated noise. First, a GLRT-based framework is developed, demonstrating reliable detection under ideal Gaussian noise but degraded estimation under heavy-tailed or colored noise and unresolved multipath. Next, an off-grid SBL framework is introduced for high-resolution separation and estimation of line-of-sight (LOS) delay--Doppler parameters. The estimated LOS parameters are subsequently tracked and incorporated into an extended Kalman filter (EKF) to obtain the navigation solution. Simulation results demonstrate that, in urban environments, the proposed method reduces delay RMSE by up to 77\% and position RMSE by 88.5\% compared with GLRT-based estimation. These results demonstrate the potential of the proposed framework for robust and accurate LEO-SoOP navigation.

0.28

Pulsar Constellation Evolution and PPP Convergence using LEO GNSS

eess.SP ·2026-10-05 ·Claire Mah, Thyagaraja Marathe, Ananya Vishwanath, Matteo Gala, Tyler G. R. Reid +1 more
published similarity 0.51
Abstract · 15 pages, 14 figures, ION GNSS+ 2026

The objective of this paper is to demonstrate the future impact of a dedicated low-earth-orbit (LEO) Global Navigation Satellite System (GNSS) on positioning, navigation, and timing (PNT), in addition to a reflective discussion on how common GNSS evaluation methods can best reflect LEO satellite dynamics. This paper will feature Xona's LEO constellation, Pulsar, at various stages of deployment in a case study comparing GPS, LEO-augmented GPS, and standalone LEO. Results include visibility and dilution of precision (DOP) analysis for Pulsar at four stages of constellation deployment, as well as two cases exploring how precise point positioning (PPP) convergence is affected by Pulsar's LEO satellite dynamics. Pulsar is highlighted in this paper for its purposeful design that allows for both GNSS augmentation through compatible signals and GNSS independence (Gala et al., 2026). As dedicated LEO satellite-based positioning becomes more prominent in the PNT industry, it is important to consider which methods are used to evaluate constellation geometry and positioning performance. By evaluating the constellation through a variety of different methods in this paper, a discussion on the future evolution of LEO navigation constellations is offered. Pulsar is compared to MEO GNSS, both as an augmentation and a standalone service, through availability, dilution of precision, and PPP convergence.

0.31