CS Paper Radar

Adaptive Orbit-Aided Vector Tracking for Orbit Determination of LEO Satellites

Zihong Zhou, Bing Xu

eess.SP eess.SY ·submitted 2026-10-28 07:18 UTC · v1

Abstract

Reliable orbit determination for CubeSats is essential for emerging low-Earth-orbit positioning, navigation, and timing (LEO-PNT) applications. However, onboard orbit determination remains constrained by single-frequency GNSS code-based receivers, intermittent signal reception, and highly dynamic orbital conditions. This paper proposes an adaptive orbit-aided vector tracking (OAVT) algorithm for LEO-PNT CubeSat orbit determination under these conditions. The method employs a GNSS vector tracking loop (VTL) as the primary navigation estimator and loosely couples it with a low-fidelity orbital dynamics model (ODM), which provides auxiliary position and velocity pseudo-measurements. The contribution of the ODM is regulated through adaptive covariance assignment based on GNSS stress and the residual consistency between the ODM and GNSS solutions. Under nominal conditions, OAVT preserves the accuracy advantage of VTL over the conventional scalar tracking loop. The 3D position root-mean-square error (RMSE) is reduced from 2.631\,m for STL to 1.081\,m, while the 3D velocity RMSE decreases from 0.3985\,m/s to 0.1023\,m/s. Under degraded conditions, OAVT provides substantially greater robustness than both STL and standalone VTL. The 3D position RMSE remains bounded at 8.27\,m during a complete signal outage, 10.17\,m during gradual signal loss and reacquisition, and 26.65\,m under variable visibility, whereas STL fails to produce valid solutions and standalone VTL loses lock. These results demonstrate that OAVT substantially improves solution robustness and state continuity with only a moderate increase in computational burden, making it suitable for CubeSat orbit determination and future LEO-PNT missions.

Closest papers

Nearest neighbours by meaning across the whole index.

Geometric Analysis of Doppler-Based Navigation with Low Earth Orbit Satellites

cs.IT ·2026-09-10 ·Carlos Caravaca Gallego, Pini Gurfil, Hector Rotstein
similarity 0.64
Abstract

The increasing vulnerability of Global Navigation Satellite Systems has motivated renewed interest in Doppler-based navigation using low Earth orbit satellites, which can determine position, velocity, clock bias, and clock drift from carrier Doppler measurements. However, the geometric dilution of precision (GDOP) in this eight-state problem behaves fundamentally differently from the GDOP in pseudorange-based navigation. In particular, volume-based satellite selection, effective for pseudorange-based GDOP minimization, has been empirically found to perform poorly for Doppler GDOP. This paper establishes a geometric foundation for Doppler GDOP characterization. A closed-form geometric parameterization of the Doppler measurement Jacobian in terms of elevation, azimuth, inclination, and altitude ratio is derived. It is shown that the clock bias sensitivity depends on elevation, altitude, and the angle between the satellite velocity vector and the line of sight. This sensitivity produces a correlation with the clock drift that no geometric arrangement can remove. A Schur complement decomposition of the eight-state information matrix is performed, yielding an exact GDOP inflation formula, governed by a collinearity coefficient that measures the alignment between the clock bias column and a seven-state subspace. It is proven that the geometric coupling that renders clock bias observable is the same coupling that inflates estimation covariance, and that satellite altitude diversity reduces the collinearity by separating satellites at equal elevation onto distinct sensitivity bands. An example employing a two-shell satellite configuration illustrates the analysis.

0.27

Clock-Shift-Aided Blind Doppler Matching in Passive SDR Monitoring Data for LEO Doppler Positioning

eess.SP ·2026-11-02 ·Seunghyeon Park, Gaeun Kim, Jiwon Seo
similarity 0.60
Abstract · Submitted to IEEE NAVICON 2026

Low Earth orbit (LEO) satellite signals have recently attracted increasing attention as opportunistic signals for positioning, navigation, and timing. Most Doppler-based LEO positioning studies rely on tracked satellite signals or raw in-phase/quadrature (IQ) samples that preserve signal-level structures for acquisition, Doppler tracking, or satellite association. In contrast, passive software-defined radio (SDR) monitoring systems often retain only time-frequency power scans, in which LEO Doppler traces appear as unlabeled ridges without raw IQ samples or identifiable signal structures. This paper proposes a clock-shift-aided segment-based blind Doppler matching method that associates unlabeled Doppler traces with candidate satellites predicted using two-line element (TLE) data. The proposed framework consists of slope-consistent Doppler segment generation, clock-shift-aided temporal alignment, and multi-metric satellite matching based on Doppler-rate and trajectory-shape consistency. The proposed method was evaluated using a three-hour subset of open Starlink/OneWeb monitoring data collected in the United Kingdom. The clock-offset search selected an effective offset of +19 s, for which 56 of 69 segments had at least one slope-compatible candidate, compared with 19 segments at zero shift. Using the resulting satellite associations, the batch positioning error over the full three-hour period was 104.2 m, whereas the RMSE-based and slope-based simple-segment baselines failed to converge near the reference receiver location.

0.45

Pulsar Constellation Evolution and PPP Convergence using LEO GNSS

eess.SP ·2026-10-05 ·Claire Mah, Thyagaraja Marathe, Ananya Vishwanath, Matteo Gala, Tyler G. R. Reid +1 more
published similarity 0.60
Abstract · 15 pages, 14 figures, ION GNSS+ 2026

The objective of this paper is to demonstrate the future impact of a dedicated low-earth-orbit (LEO) Global Navigation Satellite System (GNSS) on positioning, navigation, and timing (PNT), in addition to a reflective discussion on how common GNSS evaluation methods can best reflect LEO satellite dynamics. This paper will feature Xona's LEO constellation, Pulsar, at various stages of deployment in a case study comparing GPS, LEO-augmented GPS, and standalone LEO. Results include visibility and dilution of precision (DOP) analysis for Pulsar at four stages of constellation deployment, as well as two cases exploring how precise point positioning (PPP) convergence is affected by Pulsar's LEO satellite dynamics. Pulsar is highlighted in this paper for its purposeful design that allows for both GNSS augmentation through compatible signals and GNSS independence (Gala et al., 2026). As dedicated LEO satellite-based positioning becomes more prominent in the PNT industry, it is important to consider which methods are used to evaluate constellation geometry and positioning performance. By evaluating the constellation through a variety of different methods in this paper, a discussion on the future evolution of LEO navigation constellations is offered. Pulsar is compared to MEO GNSS, both as an augmentation and a standalone service, through availability, dilution of precision, and PPP convergence.

0.31

Lunar Surface Receiver Clock Synchronization Using GNSS and Satellite Nadir Angle

eess.SP ·2026-10-01 ·Minju Han, Seunghyeon Park, Joon Hyo Rhee
similarity 0.59
Abstract · Submitted to ICCE-Asia 2026

The use of signals from Earth-orbiting Global Navigation Satellite System (GNSS) constellations for positioning, navigation, and timing on the lunar surface was recently demonstrated by the Lunar GNSS Receiver Experiment (LuGRE) aboard Blue Ghost Mission 1. For receiver clock synchronization using GNSS, Kalman filter performance depends on the satellite-specific measurement uncertainty used to construct the measurement noise covariance. Terrestrial measurement weighting commonly relies on receiver elevation angle, but the elevation angles in the analyzed LuGRE data are confined to 24.2-31.5 degrees, providing limited discrimination of measurement quality. In contrast, satellite nadir angles span 12.1-66.6 degrees, and the measurement variability increases substantially at small nadir angles. Based on this observation, we propose a measurement weighting model that combines satellite nadir angle with C/N0 for lunar surface receiver clock synchronization. The proposed model is evaluated against three weighting methods adopted from the literature using seven LuGRE operation periods (OPs). It achieves the lowest receiver clock bias root mean square error (RMSE) in six of the seven OPs and an overall RMSE of 5.78 m, which is 19.5% lower than that of the best comparison model. The proposed model also provides the lowest clock bias prediction RMSE under simulated measurement outages.

0.25

An All-Digital Coherent AFSK Demodulator for CubeSat Applications

eess.SP ·2026-11-13 ·Rubem Vasconcelos Pacelli, Rodrigo de Lima Florindo, Felix Antreich, Antônio Macilio Pereira de Lucena
published similarity 0.58
Abstract · Preprint of an article published in Digital Signal Processing (Elsevier), 2025

Audio frequency-shift keying (AFSK) is a widely adopted modulation scheme for CubeSat systems due to its favorable bandwidth efficiency and implementation simplicity. However, coherent detection usually is avoided because synchronization impairments, caused by intense line-of-sight (LOS) dynamics inherent in low Earth orbit (LEO), may significantly degrade the bit error rate (BER). This paper presents a new all-digital coherent AFSK demodulator based on a Kalman filter (KF) for carrier phase and timing delay synchronization and the Viterbi algorithm for bit detection. The Viterbi algorithm is employed for maximum likelihood sequence detection, and the detected bit statistics are fed back to the KF to estimate phase shift, Doppler frequency shift, and Doppler drift induced by the LOS dynamics. Original mathematical analyses are derived to provide a theoretical foundation for the proposed demodulator's operation, specifically addressing its synchronization accuracy in dynamic LEO environments. The proposed demodulator is evaluated considering an additive white Gaussian noise channel with real CubeSat orbits. The performance results obtained through computer simulations demonstrate that the proposed model can withstand such scenarios with a gain of 5 dB in terms of BER compared to the conventional noncoherent AFSK demodulator. The KF performance is assessed using a moving root-mean-square error (MRMSE) statistic and the trace of its state error covariance matrix estimate.

0.56

Beyond GNSS: Leveraging LEO Satellite Signals of Opportunity for Doppler Positioning

cs.IT eess.SY ·2026-11-02 ·Md. Ali Hasan, M. Humayun Kabir, Sangmin Han, Wonjae Shin, H. Vincent Poor
similarity 0.58
Abstract · 17 pages, 4 figures, 2 tables

Large constellations of low Earth orbit (LEO) satellites provide ubiquitous global connectivity; yet, their rapid motion introduces significant Doppler shift effects. While challenging for communication, these effects can be leveraged for precise user terminal (UT) positioning, particularly in GNSS-denied environments where traditional satellite-based navigation struggles. Unlike GNSS, most LEO satellites lack dedicated navigation signals, motivating signals-of-opportunity (SOPs) approaches that repurpose existing LEO signals and use publicly available two-line element (TLE) files for orbital information, although ephemeris errors can limit accuracy. This article explores the fundamental principles, challenges, and enabling technologies for LEO-based Doppler shift positioning, highlighting its advantages over conventional non-Doppler methods, and discussing future research directions. Furthermore, to facilitate realistic and reproducible performance evaluation beyond stochastic modeling, we propose SionnaNTN-RT, a ray tracing framework for non-terrestrial network (NTN) built upon Sionna, enabling end-to-end simulation of Doppler-based positioning. Simulation results demonstrate that Doppler-based positioning can achieve high positioning accuracy in both urban and open-sky environments, highlighting its promise for next-generation positioning systems.

0.27

Some Practical Issues of the Tracking Process in GNSS Receivers

eess.SP ·2026-08-20 ·S. V. Shafran, I. A. Kudryavtsev, A. A. Kumarin
published similarity 0.57
Abstract · 8 pages, 17 figures

The accuracy and noise immunity of GNSS receivers are largely determined by the performance of their tracking modules. To optimize performance, designers should take into account several key issues: the choice of integration intervals, the time delay (spacing) between the early and late correlator channels, and the parameters of tracking loop filters. This article presents the results of an analysis of these important practical aspects. The obtained results display some ways of improv-ing the parameters of transient processes, which occur in tracking modules. The study was conducted on an experimental navigation receiver, processing GPS L1 signals. Experimental data were obtained using the simulation software package, developed by the authors, Xilinx environment Vivado, as well as the processing of recordings of real navigation signals obtained in full-scale tests.

0.41

LEO Doppler Matching from Power Spectrum Data with Continuity-Based Segmentation and Multi-Position Clock Offset Estimation

eess.SP ·2026-10-01 ·Gaeun Kim, Seunghyeon Park, Jongmin Park
similarity 0.57
Abstract · Submitted to ICCE-Asia 2026

Low Earth orbit (LEO) satellite Doppler measurements extracted from passive software-defined radio (SDR) spectrum data require temporal alignment with predicted satellite trajectories for reliable satellite association. In our previous framework, Doppler slope information was used during both segment generation and clock offset estimation, while the clock offset was estimated at a single coarse receiver position. This study proposes a satellite matching framework based on continuity-based Doppler segmentation and multi-position clock offset estimation to reduce these dependencies. Doppler segments are first generated using only temporal and frequency continuity, thereby separating segment generation from the slope criterion used for clock offset estimation. The clock offset is then estimated using five coarse receiver positions, consisting of one city-level nominal position and four surrounding positions, through a two-stage procedure based on slope compatibility and a combined Doppler cost. The aligned segments are subsequently associated with candidate satellites using a matching score based on the same Doppler slope and bias-removed RMSE metrics, and the resulting associations are evaluated through receiver localization. Experiments using six hours of passive Starlink/OneWeb monitoring data show that continuity-based segmentation alone did not improve receiver localization compared with slope-based segmentation under single-position clock offset estimation. However, applying the proposed multi-position clock offset estimation to the same continuity-based Doppler segments reduced the localization error from 32.99 km to 1.84 km, achieving the lowest error among the evaluated methods. The results for the evaluated dataset show improved spatial consistency of satellite associations when multi-position clock offset estimation is applied to continuity-based Doppler segments.

0.19