CS Paper Radar

GNSS Receiver Operating Point Comparison Between Vector and Scalar Tracking Under High-Dynamics

J. Fermín Llorente, Ernesto M. López, Javier A. Smidt, Pedro A. Roncagliolo

eess.SP eess.SY ·submitted 2026-10-30 09:52 UTC · v1
code/data

Abstract

This paper presents a measurement noise adaptation mechanism for Kalman filter-based carrier tracking in a navigation-aided GNSS receiver designed for launch-vehicle applications. The tracking loop is tuned for 20\,g acceleration steps, which requires a wide bandwidth that makes the loop vulnerable to noise-driven pull-out at low carrier-to-noise density ratios. To resolve this tradeoff, the measurement noise covariance, $R$, is inflated via a two-layer gate: a sigmoid envelope keyed to the signal $C/N_0$, modulated by a dynamics indicator derived from the discriminator output statistics of the Loop Bandwidth Control Algorithm. During noise-dominated periods the gate inflates~$R$, reducing the Kalman gain so the filter coasts on the navigation-aided prediction; when dynamics are detected the gate opens within one epoch, restoring the high-bandwidth tuning. The navigation aiding is formulated as a stochastic control input whose uncertainty is propagated from the navigation EKF covariance. Simulation results on a 20\,g acceleration step scenario show that the adapted vector architecture doubles the lock-retention rate relative to the standalone scalar filter at $C/N_0 = 31$\,dB-Hz. The receiver is implemented in MSGR, an open-source MATLAB GNSS software-defined receiver.

Closest papers

Nearest neighbours by meaning across the whole index.

Some Practical Issues of the Tracking Process in GNSS Receivers

eess.SP ·2026-08-20 ·S. V. Shafran, I. A. Kudryavtsev, A. A. Kumarin
published similarity 0.61
Abstract · 8 pages, 17 figures

The accuracy and noise immunity of GNSS receivers are largely determined by the performance of their tracking modules. To optimize performance, designers should take into account several key issues: the choice of integration intervals, the time delay (spacing) between the early and late correlator channels, and the parameters of tracking loop filters. This article presents the results of an analysis of these important practical aspects. The obtained results display some ways of improv-ing the parameters of transient processes, which occur in tracking modules. The study was conducted on an experimental navigation receiver, processing GPS L1 signals. Experimental data were obtained using the simulation software package, developed by the authors, Xilinx environment Vivado, as well as the processing of recordings of real navigation signals obtained in full-scale tests.

0.41

Adaptive Orbit-Aided Vector Tracking for Orbit Determination of LEO Satellites

eess.SP eess.SY ·2026-10-28 ·Zihong Zhou, Bing Xu
similarity 0.57
Abstract

Reliable orbit determination for CubeSats is essential for emerging low-Earth-orbit positioning, navigation, and timing (LEO-PNT) applications. However, onboard orbit determination remains constrained by single-frequency GNSS code-based receivers, intermittent signal reception, and highly dynamic orbital conditions. This paper proposes an adaptive orbit-aided vector tracking (OAVT) algorithm for LEO-PNT CubeSat orbit determination under these conditions. The method employs a GNSS vector tracking loop (VTL) as the primary navigation estimator and loosely couples it with a low-fidelity orbital dynamics model (ODM), which provides auxiliary position and velocity pseudo-measurements. The contribution of the ODM is regulated through adaptive covariance assignment based on GNSS stress and the residual consistency between the ODM and GNSS solutions. Under nominal conditions, OAVT preserves the accuracy advantage of VTL over the conventional scalar tracking loop. The 3D position root-mean-square error (RMSE) is reduced from 2.631\,m for STL to 1.081\,m, while the 3D velocity RMSE decreases from 0.3985\,m/s to 0.1023\,m/s. Under degraded conditions, OAVT provides substantially greater robustness than both STL and standalone VTL. The 3D position RMSE remains bounded at 8.27\,m during a complete signal outage, 10.17\,m during gradual signal loss and reacquisition, and 26.65\,m under variable visibility, whereas STL fails to produce valid solutions and standalone VTL loses lock. These results demonstrate that OAVT substantially improves solution robustness and state continuity with only a moderate increase in computational burden, making it suitable for CubeSat orbit determination and future LEO-PNT missions.

0.28

Belief-Adaptive Online Autonomy for Quadrotor UAV Navigation under GNSS Degradation in Urban Environments

cs.RO eess.SY ·2026-09-13 ·Deepak Kumar Panda, Weisi Guo
similarity 0.57
Abstract

Reliable online autonomy is critical for quadrotor operation in urban airspaces, where global navigation satellite systems (GNSS) measurements suffer from multipath, blockage, and latency issues, introducing non-stationary, temporally correlated errors that degrade conventional GNSS-IMU fusion. This paper presents a belief-adaptive online autonomy framework that augments an extended Kalman filter (EKF) with explicit GNSS trust modelling, second-order online belief adaptation, and latency-aware out-of-sequence measurement handling. GNSS trust is represented as a latent belief state that modulates measurement weighting and multipath bias uncertainty, and is updated online using EKF consistency signals. Unlike reactive covariance tuning, the proposed approach enables proactive and stable sensor trust adaptation without prior environmental knowledge or offline training. Evaluation in simulated urban air mobility scenarios with correlated multipath, stochastic latency, and obstacle constraints demonstrates improved belief convergence, smoother trajectories, and reduced estimation and tracking errors compared to naive, adaptive, and first-order baselines. The framework preserves classical GNSS-IMU fusion structure and can be integrated directly into existing flight control pipelines, supporting robust online autonomy in GNSS degraded environments.

0.16

Reinforcement Learning for Target Jerk Estimation in Interceptor Homing Phase

eess.SY ·2026-11-11 ·Brian Gaudet, Dalton Durant, Roberto Furfaro
similarity 0.54
Abstract · Submitted to Journal of Spacecraft and Rockets

We demonstrate the use of reinforcement meta-learning (meta-RL) to optimize a target jerk estimation policy, which is then used as the target acceleration rate of change in the propagation model of an unscented Kalman filter (UKF). The policy is learned through simulated engagements of a terminal phase high-altitude endoatmospheric interception of a highly maneuverable target, with a hit-to-kill accuracy requirement. As benchmarks, we tuned both a standard UKF and an interacting multiple model (IMM) filter, where the IMM uses a different constant jerk assumption for each model. The benchmarks and the proposed augmented UKF with the target jerk policy are tested in a 6-DOF simulation environment, which has sufficient fidelity to capture most factors relevant to guidance, navigation, and flight control. The augmented UKF demonstrates significant improvement in target interception rate, with more challenging maneuvers giving the largest performance differential. The meta-RL jerk policy is then tested on an expanded engagement scenario, with increased initial state estimate uncertainty and novel target maneuvers, demonstrating that the meta-RL policy generalizes well to conditions not seen during optimization.

0.35

A Field-Deployable GNSS-based Navigation Stack for Outdoor Mobile Robots

cs.RO eess.SY ·2026-09-24 ·Yiyuan Lin, Cole Regnier, Yu Jiang
code/data similarity 0.52
Abstract

Outdoor robots require more than an accurate receiver and a path-tracking law: the navigation system must preserve geometric consistency from geographic waypoints to actuator commands, expose measurement validity and timing, and respond to invalid or stale state information. This work presents a ROS~2 navigation stack with interchangeable single-GNSS--IMU and dual-antenna-GNSS localization front ends. Both provide a common local East--North--Up state interface for pure pursuit, virtual-point cross-track PID, finite-horizon nonlinear model predictive control (NMPC), and a segment-dependent hybrid dispatcher. The architecture specifies coordinate conventions, datum initialization, asynchronous state construction, waypoint geometry, controller equations, quality gates, command arbitration, and watchdog behavior. Independent physical field runs collected during 2025 and 2026 grape-vineyard deployments support a balanced evaluation of 800 runs, with 100 runs for each of eight controller--localization combinations on an approximately 199.6-m route. The row-hybrid mode yields the lowest run-averaged post-acquisition mean absolute cross-track error (MAE) in the evaluated dataset: 0.00952~m with single GNSS+IMU and 0.00846~m with dual GNSS. These findings characterize deviations of the recorded positions from the reference route under the evaluated conditions. The open-source navigation software and deployment instructions are available in the https://github.com/YiyuanLinXX/PPBv2/tree/main/PPBv2_Navigation.

0.33

A Sliding Window Filter on the Galilean Group for Consistent Aided Inertial Navigation with Unknown Measurement Delays

cs.RO ·2026-08-30 ·Jonathan Kelly
published similarity 0.52
Abstract · Accepted to the IEEE International Conference on Multisensor Fusion and Integration (MFI), Pilsen, Czechia, Sep 2-4, 2026

We study aided inertial navigation when the aiding sensor measurements are subject to an unknown constant delay. The goal is to estimate the delay and navigation state jointly so that delayed measurements correct the trajectory at the appropriate times, yielding a more accurate navigation solution. We formulate the problem on the special Galilean group, which provides a natural state-space structure for aided navigation with uncertainty in both motion and timing. We then examine the observability of joint delay and state estimation and show that, for a single delayed measurement, the model admits an exact symmetry in which a change in the delay can be compensated by a change in the navigation state, leaving the measurement unchanged. Processing measurements individually allows spurious information to `leak' along the corresponding null direction of the measurement Jacobian, producing overconfident and inconsistent estimates. Applying measurements from multiple times together can eliminate this direction when the trajectory is informative enough. Motivated by this result, we develop a sliding window filter that retains a short history of navigation states and applies delayed aiding corrections jointly across the active window. We conduct a series of simulation studies to characterize estimator accuracy and consistency. The simulations demonstrate that an estimator that does not maintain an adequate window can rapidly become highly inconsistent, whereas even a short sliding window markedly improves consistency by providing the temporal support that observability requires.

0.51

Uncertainty-Aware Vision-Based Autonomous Aerial Refueling

eess.SY ·2026-10-05 ·Minhyuk Jang, Thinh Nguyen, Vivek Khatana, Sandeep Banik, Naira Hovakimyan +1 more
similarity 0.52
Abstract

Probe-and-drogue refueling (PDR) requires accurate terminal alignment of a receiver probe with an uninstrumented, dynamically moving drogue despite uncertainty in both relative-state estimation and closed-loop motion. Existing vision-based docking approaches provide relative-state estimates, but generally do not quantify estimation and operational uncertainty in a way that informs the control authority required for robust docking performance. We present an uncertainty-aware vision-based PDR docking architecture that fuses keypoint-based drogue measurements, differential GPS, and avionics in an extended Kalman filter. Split conformal calibration characterizes near-contact error in the fused probe-to-drogue displacement estimate, while a covariance-based operational uncertainty quantification designs position-dispersion limits along with corrective-command variance budgets under modeled handoff variability and disturbances. The resulting uncertainty statistics define geometric and command margins for a range-conditioned deterministic predictive controller. In high-fidelity FlightGear/JSBSim simulations with four controller variants and 50 runs per variant, the combined-margin controller achieved 45/50 centered basket-plane crossings versus 34/50 for nominal MPC. Median planar crossing error decreased from 0.231 to 0.175~$\mathrm{m}$ and the empirical 90th percentile from 0.403 to 0.286~$\mathrm{m}$, while the roll-command RMS increased from 0.22$^\circ$ to 0.48$^\circ$.

0.25

Beyond Legacy L1 C/A: Characterizing Advanced Multi-Frequency Spoofing Against Multi-Frequency GPS Receivers for Autonomous Navigation

eess.SP physics.space-phstat.AP ·2026-09-21 ·Minhaj Uddin Ahmad, Muhammad Sami Irfan, Sagar Dasgupta, Mizanur Rahman, Thejesh N. Bandi
published similarity 0.50
Abstract · Accepted at GNSS+ 2026

Autonomous vehicles increasingly rely on high-end multi-frequency GNSS receivers that track modernized civil signals, such as L2C, L5, and L1C, alongside legacy GPS L1~C/A. Although multi-frequency operation improves robustness against natural error sources, its resilience against synchronous multi-band spoofing attacks remains insufficiently characterized. This paper presents a method for quantifying the inter-band alignment accuracy required for a coherent spoofer to evade cross-frequency consistency monitoring that a resilient receiver may employ. As a foundational study, the presented method is implemented and evaluated using the GPS L1 C/A and L2C signal pair within a controlled software-defined environment. This environment encompasses deterministic signal synthesis, programmable inter-band code offsets realized through fractional-delay filtering, and processing by a dual-frequency GNSS-SDR receiver. An inter-frequency pseudorange-difference consistency detector is defined and calibrated using a constant-false-alarm-rate (CFAR) approach, yielding a threshold of approximately 19 m at a false-alarm probability of $10^{-3}$. Signal fidelity and receiver capture are verified through correlation-function analysis using a multi-tap correlator bank. The inter-band code offset is then swept from one code chip to 0.005 chips to characterize detector performance. Results show that a perfectly aligned coherent attack yields a detection probability of zero, while detection probability increases rapidly with inter-band misalignment, reaching approximately 50% at 0.05 chips (about 15 m) and approaching unity for offsets of 0.2 chips or greater. These results quantify the alignment precision required for successful coherent dual-frequency spoofing and establish a practical framework for future evaluation of L5, L1C, and hardware-based multi-frequency spoofing scenarios.

0.32