CS Paper Radar

Application of the Phase Correction Method in Tracking Modules of Navigation Receivers

Kudryavtsev I. A., Shafran S. V., Balmasova M. A

eess.SP ·submitted 2026-11-10 12:46 UTC · v1
published

Abstract

One of the problems of the tracking modules is their significant inertia in case of narrow bandwidth, which is desirable to mitigate signal noise. The paper describes a method of phase correction, improving accuracy and dynamic characteristics of the tracking process in GNSS receivers. The pivotal idea of the method supposes correction of the phase deviation between the received signal and its local copy at the end of every integration period. This correction is performed directly over the phase accumulator of a DDS system. This approach reduces inertial effects crucially. Application of phase correction method with narrow filter bandwidth is much more efficient when FLL-assisted PLL tracking is used. It is shown that in this case a separate FLL discriminator is not needed, and the resulting filter structure can be significantly simplified.

Comment
15 pages, 17 figures. The paper is accepted for publication in the journal "Radiotechnika" (Radio engineering)

Closest papers

Nearest neighbours by meaning across the whole index.

Some Practical Issues of the Tracking Process in GNSS Receivers

eess.SP ·2026-08-20 ·S. V. Shafran, I. A. Kudryavtsev, A. A. Kumarin
published similarity 0.67
Abstract · 8 pages, 17 figures

The accuracy and noise immunity of GNSS receivers are largely determined by the performance of their tracking modules. To optimize performance, designers should take into account several key issues: the choice of integration intervals, the time delay (spacing) between the early and late correlator channels, and the parameters of tracking loop filters. This article presents the results of an analysis of these important practical aspects. The obtained results display some ways of improv-ing the parameters of transient processes, which occur in tracking modules. The study was conducted on an experimental navigation receiver, processing GPS L1 signals. Experimental data were obtained using the simulation software package, developed by the authors, Xilinx environment Vivado, as well as the processing of recordings of real navigation signals obtained in full-scale tests.

0.41

Beyond Legacy L1 C/A: Characterizing Advanced Multi-Frequency Spoofing Against Multi-Frequency GPS Receivers for Autonomous Navigation

eess.SP physics.space-phstat.AP ·2026-09-21 ·Minhaj Uddin Ahmad, Muhammad Sami Irfan, Sagar Dasgupta, Mizanur Rahman, Thejesh N. Bandi
published similarity 0.55
Abstract · Accepted at GNSS+ 2026

Autonomous vehicles increasingly rely on high-end multi-frequency GNSS receivers that track modernized civil signals, such as L2C, L5, and L1C, alongside legacy GPS L1~C/A. Although multi-frequency operation improves robustness against natural error sources, its resilience against synchronous multi-band spoofing attacks remains insufficiently characterized. This paper presents a method for quantifying the inter-band alignment accuracy required for a coherent spoofer to evade cross-frequency consistency monitoring that a resilient receiver may employ. As a foundational study, the presented method is implemented and evaluated using the GPS L1 C/A and L2C signal pair within a controlled software-defined environment. This environment encompasses deterministic signal synthesis, programmable inter-band code offsets realized through fractional-delay filtering, and processing by a dual-frequency GNSS-SDR receiver. An inter-frequency pseudorange-difference consistency detector is defined and calibrated using a constant-false-alarm-rate (CFAR) approach, yielding a threshold of approximately 19 m at a false-alarm probability of $10^{-3}$. Signal fidelity and receiver capture are verified through correlation-function analysis using a multi-tap correlator bank. The inter-band code offset is then swept from one code chip to 0.005 chips to characterize detector performance. Results show that a perfectly aligned coherent attack yields a detection probability of zero, while detection probability increases rapidly with inter-band misalignment, reaching approximately 50% at 0.05 chips (about 15 m) and approaching unity for offsets of 0.2 chips or greater. These results quantify the alignment precision required for successful coherent dual-frequency spoofing and establish a practical framework for future evaluation of L5, L1C, and hardware-based multi-frequency spoofing scenarios.

0.32

An All-Digital Coherent AFSK Demodulator for CubeSat Applications

eess.SP ·2026-11-13 ·Rubem Vasconcelos Pacelli, Rodrigo de Lima Florindo, Felix Antreich, Antônio Macilio Pereira de Lucena
published similarity 0.54
Abstract · Preprint of an article published in Digital Signal Processing (Elsevier), 2025

Audio frequency-shift keying (AFSK) is a widely adopted modulation scheme for CubeSat systems due to its favorable bandwidth efficiency and implementation simplicity. However, coherent detection usually is avoided because synchronization impairments, caused by intense line-of-sight (LOS) dynamics inherent in low Earth orbit (LEO), may significantly degrade the bit error rate (BER). This paper presents a new all-digital coherent AFSK demodulator based on a Kalman filter (KF) for carrier phase and timing delay synchronization and the Viterbi algorithm for bit detection. The Viterbi algorithm is employed for maximum likelihood sequence detection, and the detected bit statistics are fed back to the KF to estimate phase shift, Doppler frequency shift, and Doppler drift induced by the LOS dynamics. Original mathematical analyses are derived to provide a theoretical foundation for the proposed demodulator's operation, specifically addressing its synchronization accuracy in dynamic LEO environments. The proposed demodulator is evaluated considering an additive white Gaussian noise channel with real CubeSat orbits. The performance results obtained through computer simulations demonstrate that the proposed model can withstand such scenarios with a gain of 5 dB in terms of BER compared to the conventional noncoherent AFSK demodulator. The KF performance is assessed using a moving root-mean-square error (MRMSE) statistic and the trace of its state error covariance matrix estimate.

0.56

Gain Before Tracking: Compensating Power-Amplifier Nonlinearity and Phase Noise in AFDM Uplinks

eess.SP ·2026-10-24 ·Mohammad Tasin, Sadman Sakib Rahman
similarity 0.52
Abstract

Affine frequency division multiplexing (AFDM) is a candidate waveform for fast-moving vehicles and satellites, but real transmitters add power-amplifier (PA) compression and oscillator phase noise, and no AFDM receiver corrects both. We show that AFDM's transform treats every component equally in magnitude, so the PA's effect reduces to one gain shared by all components and phase noise to a common rotation that OFDM's standard tracker removes. The order matters: the tracker relies on symbol decisions that PA compression corrupts, so the gain should be corrected first. On a six-path, fractional-Doppler channel with 256 subcarriers and a standard-compliant PA back-off, doing so lowers the uncoded bit-error rate by 7.5-12% for AFDM and about 5% for OFDM, and saves 0.5 dB at 10% block error with a rate-3/4 code; the effect is not significant at light back-off. A closed-form gain matches a blind estimate and, without pilots, performs comparably to a pilot-based joint gain estimate that costs 6% overhead. Controls show that AFDM's edge over OFDM is mostly spreading across the channel, not Doppler robustness: single-carrier DFT-s-OFDM matches it at equal back-off.

0.18

GNSS Receiver Operating Point Comparison Between Vector and Scalar Tracking Under High-Dynamics

eess.SP eess.SY ·2026-10-30 ·J. Fermín Llorente, Ernesto M. López, Javier A. Smidt, Pedro A. Roncagliolo
code/data similarity 0.50
Abstract

This paper presents a measurement noise adaptation mechanism for Kalman filter-based carrier tracking in a navigation-aided GNSS receiver designed for launch-vehicle applications. The tracking loop is tuned for 20\,g acceleration steps, which requires a wide bandwidth that makes the loop vulnerable to noise-driven pull-out at low carrier-to-noise density ratios. To resolve this tradeoff, the measurement noise covariance, $R$, is inflated via a two-layer gate: a sigmoid envelope keyed to the signal $C/N_0$, modulated by a dynamics indicator derived from the discriminator output statistics of the Loop Bandwidth Control Algorithm. During noise-dominated periods the gate inflates~$R$, reducing the Kalman gain so the filter coasts on the navigation-aided prediction; when dynamics are detected the gate opens within one epoch, restoring the high-bandwidth tuning. The navigation aiding is formulated as a stochastic control input whose uncertainty is propagated from the navigation EKF covariance. Simulation results on a 20\,g acceleration step scenario show that the adapted vector architecture doubles the lock-retention rate relative to the standalone scalar filter at $C/N_0 = 31$\,dB-Hz. The receiver is implemented in MSGR, an open-source MATLAB GNSS software-defined receiver.

0.44

Adaptive Orbit-Aided Vector Tracking for Orbit Determination of LEO Satellites

eess.SP eess.SY ·2026-10-28 ·Zihong Zhou, Bing Xu
similarity 0.50
Abstract

Reliable orbit determination for CubeSats is essential for emerging low-Earth-orbit positioning, navigation, and timing (LEO-PNT) applications. However, onboard orbit determination remains constrained by single-frequency GNSS code-based receivers, intermittent signal reception, and highly dynamic orbital conditions. This paper proposes an adaptive orbit-aided vector tracking (OAVT) algorithm for LEO-PNT CubeSat orbit determination under these conditions. The method employs a GNSS vector tracking loop (VTL) as the primary navigation estimator and loosely couples it with a low-fidelity orbital dynamics model (ODM), which provides auxiliary position and velocity pseudo-measurements. The contribution of the ODM is regulated through adaptive covariance assignment based on GNSS stress and the residual consistency between the ODM and GNSS solutions. Under nominal conditions, OAVT preserves the accuracy advantage of VTL over the conventional scalar tracking loop. The 3D position root-mean-square error (RMSE) is reduced from 2.631\,m for STL to 1.081\,m, while the 3D velocity RMSE decreases from 0.3985\,m/s to 0.1023\,m/s. Under degraded conditions, OAVT provides substantially greater robustness than both STL and standalone VTL. The 3D position RMSE remains bounded at 8.27\,m during a complete signal outage, 10.17\,m during gradual signal loss and reacquisition, and 26.65\,m under variable visibility, whereas STL fails to produce valid solutions and standalone VTL loses lock. These results demonstrate that OAVT substantially improves solution robustness and state continuity with only a moderate increase in computational burden, making it suitable for CubeSat orbit determination and future LEO-PNT missions.

0.28

Finite-State Uncertainty-Aware Widely-Linear Equalization for Aeronautical GMSK Links

eess.SP ·2026-10-28 ·Ahmad Tanha, Ali Khalesi
similarity 0.49
Abstract

Aeronautical and unmanned aerial vehicle (UAV) receivers must equalize doubly selective channels under synchronization uncertainty and limited onboard computation and memory. We propose a finite-state, uncertainty-aware widely-linear (WL) equalization algorithm for Gaussian minimum-shift keying (GMSK) links. The algorithm uses synchronization estimates and their reliability descriptors to select one of a small number of precomputed filters, avoiding repeated online coefficient synthesis. Using a finite-memory Laurent model, we design the stored affine WL filters from conditional physical-state moments. We derive an exact characterization of excess mean-square error (MSE) relative to adaptation to continuous side information, Lloyd-type conditions for finite-state design, local timing--frequency mismatch certificates, and an orthogonal decomposition of design and information losses. On a reference channel at $E_b/N_0=8$~dB under high synchronization-estimation uncertainty, a $16$-state bank reduces pseudo-symbol MSE by $51.9\%$ relative to point-estimate WL time-varying MMSE equalization and by $6.6\%$ relative to posterior-mean (PM) substitution. With identical partitioning, routing, and storage, conditional-moment filters reduce MSE by $10.1\%$ and full-waveform average bit error rate (ABER) by $15.6\%$ relative to representative-state filters. Across $18$ synthetic three-path channels with individually fitted banks, MSE and ABER decrease by $5.3\%$ and $12.9\%$, respectively, relative to PM substitution. The $16$-state receiver stores $2048$ real coefficients. Posterior integration, robustness sweeps, and software timing measurements quantify the tradeoff between equalization accuracy, online computational cost, and bank refresh.

0.27

Integrated Optical Receiver for Communication and Fine Tracking in Inter-Satellite Links

eess.SP ·2026-09-22 ·Meysam Ghanbari, Mohammad Taghi Dabiri, Akram Alomainy, Qammer H. Abbasi, Mazen O. Hasna +1 more
benchmark similarity 0.49
Abstract

Inter-satellite optical links demand high-precision fine tracking while preserving sufficient received power for data communication, yet these functions are often treated separately at the receiver. This paper proposes a dual-function optical receiver that integrates data reception and fine tracking on a shared, intentionally defocused receiver plane. The architecture combines a central data lens with an annular four-segment tracking detector, creating a fundamental tradeoff between datapower collection and angular-estimation capability. A scalar Fresnel wave-optical model is developed together with nonlinear two-dimensional calibration and a noise-aware worstcase angular-accuracy framework. The receiver geometry is then jointly optimized to maximize the guaranteed fine-tracking range subject to a minimum data-power constraint. Results demonstrate that appropriate co-design of the central aperture and defocus substantially enlarges the usable fine-tracking region while maintaining the required communication-path power. The proposed framework provides a receiver-level benchmark for analyzing and designing integrated communication-and-tracking architectures in future optical inter-satellite terminals.

0.23