CS Paper Radar

Potential-Field Action Representation for Reinforcement Learning in Contact-Rich Manipulation

Xinyu Liu, Gökhan Solak, Arash Ajoudani

cs.RO cs.AI ·submitted 2026-09-18 10:46 UTC · v1

Abstract

Model-free reinforcement learning can acquire contact-rich robotic manipulation skills through trial-and-error interaction, but it often requires the policy to learn both task strategy and low-level motion generation. In this setting, the action representation is critical because it determines how policy outputs are converted into robot motion, shaping both exploration and physical execution. Direct Cartesian command interfaces require the policy to generate motion at every decision step, coupling task-level adaptation with continuous low-level control and increasing the learning burden. We propose PA-RL, a reinforcement-learning framework that uses artificial potential fields as the action representation. Instead of commanding motion directly, the policy adapts the parameters of an energy-like potential field, which generates a state-dependent guidance direction executed through a Cartesian impedance controller. We evaluate PA-RL on peg-in-hole insertion, a representative contact-rich task with nonlinear dynamics and discontinuous contact transitions. In simulation, PA-RL is compared with Cartesian velocity, Cartesian pose, and variable-impedance action spaces using the same RL algorithm. PA-RL is the only method to reach a 100% evaluation success rate within the allotted training time, while the best baseline reaches 92.6%. It also reduces joint-torque variation by 55.4% and Cartesian acceleration variation by 70.8% relative to the best baseline, without explicit motion-quality penalties in the reward. The simulation-trained policy further completes 9/9 real-robot insertions without fine-tuning, demonstrating the deployment feasibility of the learned potential-field interface.

Closest papers

Nearest neighbours by meaning across the whole index.

Learning Reflexive Behavior for Contact-Rich Manipulation

cs.RO ·2026-10-02 ·Quan Nguyen, Yunho Kim, Joonho Lee
similarity 0.77
Abstract

During contact-rich manipulation, interactions between a robot and its environment carry information about local geometry: a surface prevents penetration, a bore guides a peg. A controller that exploits these interactions can comply with environmental constraints while preserving task intent. Robot-earning systems commonly use position, hybrid force-position, or Cartesian impedance control. Their prescribed tracking objectives, stiffness, or force-control directions may not match local constraints and may degrade performance. We learn a proprioceptive reflex policy in simulation on three simple interaction primitives: a spring, a plane, and a rail. The policy maps task-space commands to joint-position targets using state history, without direct force or geometrical measurements. Once trained, it serves as a frozen execution layer beneath higher-level controllers. We evaluate it in dual-arm box lifting, peg insertion, and surface following. In box lifting, the reflex kept the force below the threshold while the baseline failed. In rough-surface following it stayed below the 10 N reference, on par with tuned hybrid force-position control. In 0.02 mm peg insertion It reduced mean estimated contact force to less than half that of the baseline while increasing hardware success rates from at most 22 % to 36-58 %. By separating contact response from command generation, the reflex policy provides motion planners, learned policies, and teleoperators with robust contact-rich execution.

0.15

Manifold Generative Annealing for Contact Constraint-aware Impedance Control with Reinforcement Learning Prior

cs.RO ·2026-10-15 ·Zhilin He, Guoquan Qi, Changliu Liu
similarity 0.77
Abstract

Contact-rich robotic tasks require coordinated motion and impedance under uncertain interaction dynamics and physical constraints. While recent methods on learned policies provide useful interaction strategies, they may fail when contact conditions differ from those encountered during training. Model-based generative methods show promising receding-horizon trajectories optimization results, but often lack structured behavioral guidance and refinement that jointly accounts for constraint geometry and actual contact responses. To this end, we propose Manifold Generative Annealing (MGA), a joint model-free and model-based generative framework for motion--impedance optimization. MGA first organizes pretrained reinforcement learning policies into structured sequence proposals, retaining task-specific interaction strategies without committing to their execution. It then evaluates these proposals alongside exploratory samples through model-based rollouts for refinement or separate execution selection. Crucially, realization-aware manifold refinement aligns updates from the refinement bank with both task constraints and locally achievable physical responses, allowing learned experience to guide online adaptation under changing contact conditions. Experiments cover surface scanning, peg insertion, and humanoid pushing, with improved safety success rate of impedance control under nominal and sensing-shift conditions.

0.14

One-Shot Learning from Demonstration of Contact-Rich Robotic Manipulation by Identifying Physical Interactions

cs.RO ·2026-08-25 ·A. H. G. Overbeek, H. van der Kooij, M. Vlutters
similarity 0.76
Abstract

Learning from Demonstration (LfD) allows robots to learn manipulation tasks directly from humans, thereby supporting the versatile application of robots. Most LfD methods do not explicitly model the physical interactions between a robot and its environment, such as the making and breaking of contact, while these are crucial during manipulation tasks. Because the same basic physical interactions recur often, they can be a basis for robust, generalizable, and adaptive task reproduction. We propose an LfD method that explicitly uses what physical interactions take place where and when. Using that information, a hybrid position-force controller tracks demonstrated trajectories until contact-based transition conditions from the demonstrations are met. We evaluate our method in real robot experiments consisting of opening doors and locks, bolt picking and screwing, dislodging, and surface contouring. We show that explicitly modeling physical interactions benefits LfD in four ways. First, by allowing reproduction of complex, sequential, and contact-rich manipulation tasks using only a single demonstration and no prior knowledge of the task. Second, by facilitating robustness to unknown geometric variations in the environment. Third, by facilitating generalization when geometric variations are known. Fourth, by facilitating online adaptation using geometric information explored during task reproduction. We discuss how robustness, generalization, and adaptivity can be explicitly implemented, which is generally lacking in the LfD literature. Thereby, our work aims to close a gap in interpretable few-shot LfD of robotic manipulation.

0.07

Constraint-Grounded Reinforcement Learning for Variable Impedance Control in Contact-Rich Robotic Insertion

cs.RO ·2026-09-11 ·Lin He, Min Deng
similarity 0.76
Abstract · 16 pages, 7 figures

In robotic insertion under uncertain contact, the axial force limit and the appropriate controller gain vary across tasks. As a result, a single fixed gain is unlikely to remain suitable across different task conditions, making conventional impedance controllers reliant on manual retuning. To eliminate manual retuning, we propose Constraint-Grounded Reinforcement Learning (CG-RL), a variable impedance framework for online gain adaptation. Conditioned on the force limit and contact feedback, the policy outputs a residual motion, an insertion rate, and a requested gain. The controller projects this gain into the admissible range without exposing the range itself to the policy. This separation allows a single policy to operate under different force limits without retraining or manual retuning. We evaluate CG-RL on simulated oblique insertion across five training seeds. CG-RL achieves an $85.8\pm7.7\%$ (mean $\pm$ SD) success rate of insertions without violating the force limit, while keeping the applied gain within the admissible range. As a comparison, a fixed-gain baseline using the midpoint gain achieves a success rate of $50.1\%$. The policy adapts its insertion rate continuously to the specified force limit and further generalizes to more permissive force limits above the training range. In contrast, the same actor without force-limit input does not exhibit this adaptation. The applied gain is guaranteed to remain within the admissible range, while force-limit satisfaction is validated empirically rather than guaranteed formally.

0.53

Contact Trajectory Prompting: In-Context Transfer of Contact-Rich Behaviors from a Single Demonstration

cs.RO ·2026-10-13 ·Xian Nie, Yujie Zang, Yuhang Zheng, Yupeng Zheng, Songen Gu +6 more
similarity 0.73
Abstract

In-context robot learning enables robots to acquire new behaviors from demonstrations without test-time parameter updates. However, visual and kinematic specifications alone may not distinguish contact-rich behaviors that share similar motions but require different interaction intensities or patterns. We propose Contact Trajectory Prompting (CTP), a framework for one-shot transfer of contact-rich manipulation behaviors. CTP encodes motion and contact information from a single demonstration into an ordered contact trajectory prompt that captures their temporal evolution and specifies the desired physical interaction behavior. During execution, the policy uses online sensory feedback to retrieve interaction-relevant information from the prompt, conditioning closed-loop action generation on the demonstrated contact behavior. Across real-world wiping, rotation, and insertion tasks on objects excluded from training, CTP achieves 78.7% overall success, outperforming the strongest evaluated baseline by 13.0 percentage points. Changing only the reference demonstration enables CTP to follow contact specifications for both intensity and direction, including an intermediate wiping force level and clockwise or counterclockwise cap rotation. These results demonstrate that contact trajectories serve as effective behavioral specifications, extending in-context robot learning beyond motion imitation to physical interaction transfer. Project website: https://ctp-robotics.github.io/project_page.

0.20

Impedance Cloning: Learning Equilibrium Point Parameters for Contact-Rich Manipulation

cs.RO ·2026-09-25 ·Hayato Takahashi, Ryoga Oishi, Yuki Kasuga, Toshiaki Tsuji
similarity 0.73
Abstract · 8 pages, 7 figures, 3 tables. Submitted to IEEE Robotics and Automation Letters (RA-L)

Contact-rich manipulation requires robots to regulate force against surfaces whose geometry deviates unpredictably from training conditions. Trajectory-based imitation learning, which reproduces observable outputs, breaks down under such shifts. We propose Impedance Cloning, which instead imitates the biomechanical priors that generate motion -- the stiffness and equilibrium point -- and thereby passively absorbs contact uncertainty. Because these parameters encode intent rather than outcome, they generalize across surface geometries where trajectory reproduction does not. We extract them from bilateral teleoperation demonstrations via a particle filter without force/torque sensors and evaluate the framework on two CRANE-X7 manipulators. In a wiping task with joint-space actions, the trajectory-based baseline loses contact below -6 cm, whereas the proposed method maintains a consistent 4-5 N contact force above -6 cm, with a gradual decrease below; with Cartesian-space actions, its force-height slope over 0 to +8 cm is 0.13 +/- 0.03 N/cm, versus 0.34-0.83 N/cm for fixed-impedance baselines. In a pick-and-place task with 10 diverse cups (100 trials), the proposed method succeeds in 84 trials, outperforming the fixed-impedance baseline (74/100) and performing comparably to a variable impedance control baseline (82/100) with one demonstration instead of ten. In a grasping task, the representation reduces torque tracking error with both ILBiT and Mamba backbones, confirming its generality across architectures.

0.26

OATH: Object-Agnostic Tracking for Dexterous Hands, Enabling Rapid Physics-based Retargeting

cs.RO ·2026-10-09 ·Solvin Sigurdson, Prasanna Sriganesh, Juan Borbon, Joel Burdick, Dingqi Zhang +1 more
code/data similarity 0.73
Abstract · 8 pages, 7 figures, 3 tables. Project page: https://multiplylabs.github.io/oath/

Retargeting human demonstrations into dynamically feasible dexterous hand trajectories requires resolving complex contact physics, yet current methods either omit physical constraints or rely on computationally expensive sampling-based optimization in simulation. Reinforcement learning has previously been used to achieve planning and control through contact dynamics; however, standard policies require object-specific training and fail to generalize across arbitrary geometries. This work reframes physics-based retargeting as a residual learning problem, where we demonstrate that zero-shot generalization across objects relies on structured state representations. Specifically, formulating the observation space to include a localized contact-error signal guiding each robot link to its target coordinate on the object surface enables a single, unified residual policy to successfully grasp novel, unseen object geometries. Rolling out this policy in simulation on a kinematic reference trajectory yields a physics-based retargeter, OATH. Operating at 0.4 seconds of compute per second of reference, OATH achieves 2.4x faster-than-real-time performance and a 60-350x reduction in computational cost compared to sampling-based methods. The system recovers 58% of held-out and 54% of unseen-object DexYCB trajectories while maintaining a sub-2 cm tracking error.

0.29

HiFun: a Hierarchical Framework for Efficient Functional Dexterous Manipulation Learning

cs.RO ·2026-10-14 ·Linyi Huang, Guowei Huai, Weibin Liu, Shulong Jiang, Ping Tan +3 more
code/data similarity 0.72
Abstract

While multi-fingered dexterous robot hands have the potential to provide human-level dexterity, using them for functional manipulation remains difficult because task success depends on precise contact, coordinated arm-hand motion, and reactive recovery from execution errors. Precise contact depends on complex contact dynamics that are difficult to model accurately in simulation, motivating real-world learning. However, real-world demonstrations in the full arm-hand control space are costly and noisy because each trajectory must coordinate arm motion with high-DoF multi-finger contact. Small execution deviations can further cause slipped contact or premature force application, making recovery from off-nominal contact states important for robust execution. To deal with these challenges, we propose HiFun, a hierarchical real-world RL framework for functional dexterous manipulation tasks. Our key insight is to decouple the control complexity into a functional hand skill for precise contact execution and an arm-hand coordination policy for arm control and hand-skill activation. This design enables effective real-time human intervention for reactive recovery learning and efficient data collection with Dynamic Movement Primitive (DMP) augmentation. Across six real-world tasks on two dexterous hands, HiFun achieves 98.3% average success within one hour of online training and remains robust to dynamic disturbances. The project page is available at https://hly-123.github.io/HiFun/.

0.23