CS Paper Radar

Advanced 400G-SerDes Modulations and Equalizers for GPU Cluster in AI Era

Sheng Chen, Zhengxiang Cheng, Ji Zhou, Haide Wang, Mengqi Guo, Weiping Liu, Liangchuan Li, Xiangjun Xin

eess.SP ·submitted 2026-09-21 13:35 UTC · v1

Abstract

High-speed GPU cluster interconnects are evolving from 200 to 400 Gbps to meet the growing computing demands of artificial intelligence. We investigate high-order modulation and advanced equalization for 400 Gbps interconnects. Theoretical bit error rate (BER) expressions for 4/8-ary pulse amplitude modulation (PAM) and approximate expressions for six PAM6 formats generated from 32-ary quadrature amplitude modulation (32QAM) are derived. In additive white Gaussian noise, PAM6 generated by framed-cross 32QAM achieves the best BER performance among the PAM6 formats. PAM6 and PAM8 incur peak signal-to-noise ratio (PSNR) penalties of approximately 4.2 and 7.2 dB, respectively, relative to PAM4 at the KP4 forward error correction (KP4-FEC) limit. Simulations compare PAM4, PAM6, and PAM8 at a line rate of 440 Gbps (net rate of 400G) under different bandwidth limitations. As bandwidth becomes more constrained, bandwidth requirements increasingly dominate performance over noise tolerance. PAM4 requires the lowest PSNR to reach the KP4-FEC limit in mildly bandwidth-limited channels, whereas PAM6 performs best under moderate limitations. PAM8 offers a significant advantage under severe limitations because of its lower bandwidth requirement and reduced susceptibility to high-frequency attenuation. With maximum likelihood sequence estimation, PAM6 and PAM8 reach the KP4-FEC limit under all evaluated channel conditions, while PAM6 requires a lower PSNR in most channels, highlighting its potential for 400G-SerDes systems.

Closest papers

Nearest neighbours by meaning across the whole index.

An Interleaved Parallel Dependent Quantization Hardware Architecture for H.266/VVC

cs.AR ·2026-10-07 ·Jun Zhang, Weizhi Bian, Hao Zhang
similarity 0.57
Abstract

While dependent quantization in H.266/VVC delivers a high compression ratio, its strong serial nature and high complexity result in poor real-time performance, making it difficult to deploy in practical scenarios. To improve the real-time performance of dependent quantization with minimal degradation to its compression performance, we propose a interleaved parallel dependent quantization hardware architecture with low BDBR loss, which achieves four-channel parallel dependent quantization by time-division multiplexing most combinational logic. This architecture adopts the proposed intra-CG context simplification scheme and the encoding scheme that skips decAbslevel during rate estimation. The proposed design incurs a BDBR loss of only 0.42% under the All Intra configuration and 0.38% under the Random Access configuration, respectively. Implemented in Verilog HDL, the dependent quantization hardware architecture achieves quantization speeds of 4K@33.2, 91.4, 331.2, and 454.1 fps at QP = 22, 27, 32, and 37, respectively, when implemented on the Xilinx XCZU19 FPGA. When implemented on ASIC using the TSMC 28nm process standard cell library, the corresponding quantization speeds reach 4K@84.0, 231.0, 837.0, and 1147.7 fps.

0.13

Low-complexity Soft-decision LLR Calculations for Next-generation IM-DD Systems with RIN

eess.SP ·2026-08-20 ·Felipe Villenas, Yunus Can Gültekin, Alex Alvarado
similarity 0.56
Abstract

The demand for higher speeds in intra-data center interconnects will eventually require high-order pulse amplitude modulation (PAM) combined with soft-decision (SD) forward error correction (FEC). The laser relative intensity noise (RIN) is an important noise impairment that limits the performance of high-speed intensity-modulation (IM) and direct-detection (DD) systems, as it induces a channel with signal-dependent noise. In this paper, we show that an accurate calculation of the log-likelihood ratios (LLRs) is critical for the performance of the SD-FEC decoder in RIN-dominated IM-DD systems. First, we show that assuming signal-independent additive white Gaussian noise (AWGN) statistics to compute LLRs results in a significant penalty in performance. As an alternative, we propose a low-complexity piecewise linear approximation of the exact LLRs of Gray-coded PAM-4 and PAM-8 for the RIN-dominated IM-DD channel. We show using the generalized mutual information that our approximation results in no performance loss versus using exact LLRs, unlike the AWGN-like assumption. Furthermore, we validate the analysis with bit error rate (BER) performance of SD decoding. We show that our approximation matches the BERs achieved using exact LLRs. Therefore, our approximation avoids a BER error floor penalty of up to 7.2 times using an extended Hamming code with PAM-4, and up to 2.41 dB of optical modulation amplitude penalty using high-code-rate low-density parity-check codes with PAM-8 for the same target BER.

0.23

Power Scaling Across Link Utilization with GPAM-4 Signaling and Event-Driven Reception

cs.ET ·2026-11-14 ·Maya Mekel, Jeries Mattar, Nicolas Wainstein
unusual similarity 0.54
Abstract

This work highlights the potential of combining event-based signaling with event-driven reception to achieve receiver power scaling across link utilization, without requiring wake-up, locking, or data-rate reconfiguration. The approach is demonstrated using the proposed four-level Gaussian pulse-amplitude modulation (GPAM-4) scheme and a corresponding event-driven receiver. By employing a resettable ring voltage-controlled oscillator (RRVCO) as its front end, the receiver achieves inherently event-driven symbol measurement, initiated directly by each received pulse. Symbols are decoded directly from the final RRVCO phase state, eliminating a counter-based back end. Simulated in 28-nm CMOS, the receiver power is evaluated across a $100\times$ range of effective data rates---from 0.15 mW at the peak rate of 8 Gb/s, down to 2.5 $μ$W under active/idle operation and 1.6 $μ$W under data rate change at 80 Mb/s. The receiver thus achieves power reductions of $59.5\times$ and $90.0\times$, while its energy per bit increases by only $1.68\times$ and $1.11\times$, respectively.

0.26

Real-Time Low-Complexity Zak-OTFS with Superimposed Spread Pilots on GPUs

eess.SP ·2026-11-12 ·Chung-Hsuan Tung, Junyao Zheng, Vineetha Yogesh, Mudasir Ahmad Sheikh, Danish Nisar +2 more
similarity 0.53
Abstract

Orthogonal time frequency space (OTFS) modulation offers robust performance under high-mobility scenarios. Spread pilots distribute pilot energy across the delay-Doppler grid and are superimposed with data symbols, enabling full-grid resource utilization. However, pilot-data separation challenges the design of the real-time receiver pipeline: cross-ambiguity in channel sensing incurs high computational complexity, and pilot-data interference cancellation requires repeated processing through turbo iterations. Leveraging the chirp structure of OTFS spread pilots, we reduce cross-ambiguity to a single 2D IFFT with element-wise chirp operations, achieving over 7000x speedup compared to partially vectorized direct evaluation on GPUs at a frame size of (M, N)=(2053, 31). Our real-time GPU baseband processing pipeline for OTFS with superimposed spread pilots supports (M, N)=(2053, 31) with one turbo iteration within a 1.03 ms latency budget. We further show that larger frames increase processing gain, allowing lower pilot power and near-converged bit error rate (BER) after one turbo iteration.

0.27

Chimera: A Configurable LLM Decode Accelerator Architecture with Compute-Memory-Floorplan Co-Design for HBM-Equipped Multi-Die FPGAs

cs.AR ·2026-11-14 ·Zhiheng Chen, Yifan Zhang, Yu-An Chou, Ye Qiao, Sitao Huang
benchmark similarity 0.51
Abstract

GPUs are widely used for LLM inference, but single-request decoding is memory-bound, leaving their compute underutilized while they draw substantial power. HBM-equipped FPGAs are well suited to LLM decoding: their customizable datapaths use memory bandwidth more energy-efficiently than GPUs. However, high memory bandwidth alone does not ensure high decode performance: exploiting it requires parallel compute and memory interfaces, whose resource costs and placement on the chip can limit the throughput. We present Chimera, a configurable LLM decode accelerator architecture that co-designs compute, memory access, and floorplan. Specifically, HBM Proxy Ports extend HBM access to compute lanes on every super logic region (SLR) die, and tiered expert storage holds mixture-of-experts weights beyond the HBM capacity. In addition, a unified configuration analysis estimates per-token latency and per-SLR resource use and guides the design of each configuration within resource budgets. On an AMD Alveo U280, we build ten designs for eight dense, mixture-of-experts, hybrid linear/standard-attention, and ternary LLMs, up to an 80B-parameter mixture-of-experts LLM on four memory tiers. Chimera's designs achieve a geometric mean of 1.6$\times$ the token throughput of prior state-of-the-art FPGA implementations and 3.0$\times$ and 1.5$\times$ the energy efficiency of the RTX 3090 and A100 GPUs, setting a new benchmark for LLM decoding on HBM-equipped FPGAs.

0.23

Performance Analysis of Quantization-Aware Neural Channel Estimation with Low-Precision Inference

eess.SP ·2026-11-10 ·Joonas Törmälä, SaiKrishna Saketh Yellapragada, Eeli Susan, Esa Ollila
similarity 0.51
Abstract · Submitted to IEEE Wireless Communications and Networking Conference (WCNC) 2027

Neural channel estimators can improve radio performance of 5G receivers, but real-time deployment in the radio access network (RAN) imposes strict latency and power budgets. Prior studies of quantized neural channel estimators assess this cost through mean-squared error or analytic operation counts. In this paper, we train a 1D convolutional neural network (CNN) channel estimator for the 5G NR physical uplink shared channel (PUSCH) with INT8 and FP8 quantization-aware training (QAT), and we evaluate its radio performance together with its latency, power, and energy on an NVIDIA H100 GPU. On TDL-A and TDL-C channels at user equipment (UE) speeds up to 35 m/s, both 8-bit models stay within 0.025 dB of FP32 at 10% block error rate (BLER). At batch size 128, INT8 reduces the latency by 16%, the incremental GPU power by 33%, and the energy per query by 26%, compared with 6%, 26%, and 21% for FP8. INT8 is therefore the preferred format.

0.30

Code-Domain Grouped Index Modulation for Spectrally Efficient Spread-Spectrum Communications

cs.IT ·2026-08-25 ·Peng Zhang, Jian Dang, Zaichen Zhang
benchmark similarity 0.50
Abstract

Efficient exploitation of spreading resources is important for improving the transmission efficiency of spread-spectrum communications. Code index modulation (CIM) conveys additional information through spreading-code indices without requiring extra radio-frequency chains. The fixed number of code-index branches in existing CIM schemes limits information allocation between the code-index and modulation-symbol domains as the target rate increases. This paper proposes code-domain grouped index modulation (CGIM), which partitions an orthogonal spreading-code bank into multiple groups and maps the in-phase and quadrature components of one quadrature amplitude modulation (QAM) symbol in each group onto two independent code indices. Group-wise despreading enables parallel detection. Group-wise maximum-likelihood (ML) and low-complexity greedy detection (GD) are developed, with both achieving joint ML decisions under the stated conditions. A pairwise error probability (PEP)-based bit error rate (BER) analysis is derived for Rayleigh and Nakagami-$m$ fading, with additive white Gaussian noise (AWGN) as a benchmark. Numerical results show that CGIM achieves better BER performance than traditional CIM benchmark schemes at the same transmission rate, owing to a more balanced distribution of information bits between the code-index and modulation-symbol domains.

0.28

Spectral-Efficient MIMO-OFDM: Low-Complexity Solution based on Random Multiplexing

eess.SP ·2026-08-27 ·Jie Yang, Wanchen Hu, Yi Song, Shuangyang Li, Burak Çakmak +3 more
similarity 0.50
Abstract

This paper presents a low-complexity precoded MIMO-OFDM system for achieving improved spectral efficiency (SE) via intentionally compressing information symbols among subcarriers. Particularly, the proposed scheme leverages the powerful random multiplexing mechanism for precoding, and adopts the linear-complexity orthogonal approximate message passing (OAMP) estimator for symbol detection, where the compatibility with the existing fifth generation (5G) architectures is fully preserved. We further provide the theoretical analysis based on the replica-symmetric (RS) formula. This analysis confirms the advantages of the proposed system with respect to the adopted compression ratios, where an interesting phase transition behavior is verified. Numerical results coincide with our analysis and demonstrate significant improvements in terms of achievable rates and bit error rate (BER) compared to conventional MIMO-OFDM counterpart, making the proposed scheme a promising solution to 6G and beyond wireless networks.

0.13