CS Paper Radar

Power Scaling Across Link Utilization with GPAM-4 Signaling and Event-Driven Reception

Maya Mekel, Jeries Mattar, Nicolas Wainstein

cs.ET ·submitted 2026-11-14 07:00 UTC · v1
unusual

Abstract

This work highlights the potential of combining event-based signaling with event-driven reception to achieve receiver power scaling across link utilization, without requiring wake-up, locking, or data-rate reconfiguration. The approach is demonstrated using the proposed four-level Gaussian pulse-amplitude modulation (GPAM-4) scheme and a corresponding event-driven receiver. By employing a resettable ring voltage-controlled oscillator (RRVCO) as its front end, the receiver achieves inherently event-driven symbol measurement, initiated directly by each received pulse. Symbols are decoded directly from the final RRVCO phase state, eliminating a counter-based back end. Simulated in 28-nm CMOS, the receiver power is evaluated across a $100\times$ range of effective data rates---from 0.15 mW at the peak rate of 8 Gb/s, down to 2.5 $μ$W under active/idle operation and 1.6 $μ$W under data rate change at 80 Mb/s. The receiver thus achieves power reductions of $59.5\times$ and $90.0\times$, while its energy per bit increases by only $1.68\times$ and $1.11\times$, respectively.

Closest papers

Nearest neighbours by meaning across the whole index.

Advanced 400G-SerDes Modulations and Equalizers for GPU Cluster in AI Era

eess.SP ·2026-09-21 ·Sheng Chen, Zhengxiang Cheng, Ji Zhou, Haide Wang, Mengqi Guo +3 more
similarity 0.54
Abstract

High-speed GPU cluster interconnects are evolving from 200 to 400 Gbps to meet the growing computing demands of artificial intelligence. We investigate high-order modulation and advanced equalization for 400 Gbps interconnects. Theoretical bit error rate (BER) expressions for 4/8-ary pulse amplitude modulation (PAM) and approximate expressions for six PAM6 formats generated from 32-ary quadrature amplitude modulation (32QAM) are derived. In additive white Gaussian noise, PAM6 generated by framed-cross 32QAM achieves the best BER performance among the PAM6 formats. PAM6 and PAM8 incur peak signal-to-noise ratio (PSNR) penalties of approximately 4.2 and 7.2 dB, respectively, relative to PAM4 at the KP4 forward error correction (KP4-FEC) limit. Simulations compare PAM4, PAM6, and PAM8 at a line rate of 440 Gbps (net rate of 400G) under different bandwidth limitations. As bandwidth becomes more constrained, bandwidth requirements increasingly dominate performance over noise tolerance. PAM4 requires the lowest PSNR to reach the KP4-FEC limit in mildly bandwidth-limited channels, whereas PAM6 performs best under moderate limitations. PAM8 offers a significant advantage under severe limitations because of its lower bandwidth requirement and reduced susceptibility to high-frequency attenuation. With maximum likelihood sequence estimation, PAM6 and PAM8 reach the KP4-FEC limit under all evaluated channel conditions, while PAM6 requires a lower PSNR in most channels, highlighting its potential for 400G-SerDes systems.

0.23

A LoRa-Compatible Receiver with Programmable Noise-Power Trade-Off and Integrated Wake-Up Mode

cs.AR ·2026-10-14 ·Marco Gonzalez, Pol Maistriaux, Jérôme Louveaux, David Bol
similarity 0.52
Abstract · 13 pages, 19 figures, removed mentions to IEEE

Programmable receivers allow an optimal performance in the variable conditions of the wireless channel. An extensive analysis of their noise-power trade-off enables the development of a main receiver with embedded wake-up circuitry. This makes the seamless integration of wake-up receivers (WuRXs) in RF receivers possible, avoiding power, area, complexity, and cost overheads in the system. In this paper, we propose the first LoRa-compatible receiver with an integrated wake-up mode and a programmable noise-power trade-off. In main-receiver mode, it consumes 4.57 mW for a sensitivity of -138 dBm, but it can save up to 62.6% of power consumption at the cost of an 8.3-dB sensitivity degradation. In wake-up mode, sensitivity down to -126 dBm is achieved for a 32-ms latency and 1.5 mW of power consumption. The power consumption remains relatively high due to a sub-optimal design of the the phase-locked loop (PLL). In the end, the wake-up mode consumes 3X less than the lowest-noise configuration in main-receiver mode.

0.28

Modulation Augmentation and Constellation Shaping for LDPC-Coded QPSK

cs.IT ·2026-09-30 ·Heping Wan, Joonyoung Cho, Sandesh Rao Mattu, Jamin Shah, Nishant Mehrotra +2 more
similarity 0.51
Abstract

While constellation shaping improves spectral efficiency, its application to quadrature phase-shift keying (QPSK) remains limited. We address this limitation by incorporating a short shaping code into low-density parity-check (LDPC)-coded QPSK systems. Specifically, a subset of LDPC codeword bits is used as shaping bits and mapped by the shaping code to a sparse codeword that enables probabilistic shaping by controlling non-equiprobable selection between lower- and higherenergy QPSK constellations. Because zeros dominate the sparse codeword, lower-energy constellation points are transmitted more frequently, yielding a Gaussian-like symbol distribution. By exploiting the channel-code protection of the shaping bits, we develop receiver algorithms that refine shaping-bit log-likelihood ratios (LLRs) using LDPC decoder feedback. Joint optimization of the shaping codebook, bit-to-symbol mapping and constellations enables the proposed shaping scheme to achieve gains of up to 0.6 and 0.53 dB over 5G New Radio (NR) LDPC-coded QPSK and QAM-16, respectively.

0.20

EventSpikeSeg: Memory-Aware Mixed-Signal Architecture for Event-Camera Spiking Segmentation

cs.AR cs.CVcs.NE ·2026-11-13 ·Amir Mohammad Khadem Hosseini, Sattar Mirzakuchaki
similarity 0.51
Abstract

Event-camera segmentation requires persistent neural state despite sparse input events, making memory organization a central constraint on embedded implementation. We present EventSpikeSeg, a mixed-signal architecture combining resident capacitor memory with shared analog processing in GF180MCU 180-nm CMOS. Its 25-population spiking encoder-decoder has 143,824 synaptic weights but requires 30,976,000 membrane states at 440 x 640 resolution. The mapping specifies chronological 5-ms model updates, digital event/address services and 64-state capacitor banks. Characterization covers 22 module families and 74 operating points, distinguishing transistor simulations from digital-library estimates. Nominal results include 41.711 microwatts biased neuron-core power, 3.338-pJ positive terminal energy for a 1.4-microsecond cell read, and 0.531-mV selected-state drift over a 5-ms extracted-tile hold. Commit and coupling errors are reported separately. The software checkpoint records 27.976% mean intersection-over-union on a held-out six-class DSEC split; this is not hardware accuracy. Component layouts and simulation evidence quantify local implementation costs and expose storage replication and service scheduling as scaling constraints. A detailed SPICE-calibrated behavioral forward simulation of one full-resolution DSEC frame achieves 24.26% mean intersection-over-union, versus 26.22% for the matched PyTorch reference, using a compact 5-fF bank variant and external count/voltage calibration. Physical full-network operation, system energy and mismatch robustness remain unverified.

0.28

FTN Signaling: Spectral Efficiency from BPSK to 16-QAM

cs.IT eess.SP ·2026-10-08 ·Emre Cerci, Adem Cicek, Melda Yuksel, Gokhan M. Guvensen, Enver Cavus +2 more
benchmark similarity 0.50
Abstract · 5 pages, 5 figures, 2 tables. Submitted to IEEE Communications Letters

Faster-than-Nyquist (FTN) signaling can improve spectral efficiency by transmitting symbols closer together than the Nyquist limit, at the cost of additional inter-symbol interference (ISI). In this letter, we study the finite-alphabet symbol-wise achievable information rate (AIR) of FTN signaling for BPSK, QPSK, and 16-QAM under a transmit-power constraint and a common minimum mean square error (MMSE) channel-shortening (CS) detection framework, cross-validated for BPSK against an independent reduced-state Ungerboeck Bahl-Cocke-Jelinek-Raviv (BCJR) benchmark. Our results show a clear trend. Lower-order constellations can benefit from more aggressive time acceleration, while higher-order constellations become less tolerant of acceleration and achieve their best spectral efficiency closer to the Nyquist limit. At a reference signal-to-noise ratio (SNR) of 6 dB the optimum acceleration factor shifts from $τ^\star\approx0.65$ for BPSK to 0.75 for QPSK and 0.90 for 16-QAM. We further show that this trend is preserved in coded systems and remains robust to the detector memory. The impact of FTN operation on the instantaneous-to-average power ratio (IAPR) is also examined. Overall, the results highlight how constellation order should be considered when selecting the operating point for FTN signaling.

0.19

OFDM-Based Neuromorphic Wake-Up Signal

cs.NI ·2026-10-27 ·Gaspard Goupy, Elias Raninen, Dani Korpi
similarity 0.50
Abstract

Wake-up radios (WURs) reduce energy consumption by continuously monitoring the channel for a wake-up signal (WUS) while the main receiver remains asleep. Neuromorphic computing offers a promising approach to ultra-low-power WUS detection through sparse, event-driven processing. However, realizing these benefits requires spike-like inputs, which conventional orthogonal frequency-division multiplexing (OFDM) waveforms do not naturally provide. To enable neuromorphic WUS detection in OFDM-based systems, we introduce a neuromorphic wake-up signal (nWUS) that can be generated by a standard OFDM transmitter. The proposed design superposes frequency-domain vectors with linear phase progressions across the OFDM subcarriers, producing a time-domain waveform with sparse amplitude peaks at predefined positions. These peaks encode the wake-up signature in a spike-like representation that facilitates neuromorphic processing at the receiver. Building on this structure, we then propose a noncoherent neuromorphic detector that encodes received peaks into spikes and performs sparse correlation only upon spike events. Simulations over a 3GPP urban macro channel show that the proposed approach outperforms on-off keying (OOK) baselines in detection probability while achieving up to 43.5x lower computational cost. During idle periods, event-driven processing further reduces correlation operations by 86% relative to nWUS reception.

0.31

Distributed Fiber Monitoring on a Coherent DSP ASIC: Implementation of Longitudinal Power Monitoring

eess.SP physics.optics ·2026-11-19 ·Takeo Sasai, Yukinobu Nakajima, Minami Takahashi, Runa Kaneko, Masanori Nakamura +3 more
similarity 0.49
Abstract · 11 pages, 19 figures

Coherent DSP ASICs and transceivers to date report a rich set of optical link metrics, yet these remain cumulative over the link and provide no spatial localization. This paper presents the implementation design of fiber-longitudinal power monitoring (LPM), which recovers spatially resolved power profiles from received traffic, on a coherent DSP ASIC chip. We first identify the challenges specific to DSP implementation, and describe the enabling algorithm and architecture. We then present the key design considerations for retaining the estimation fidelity of the on-chip LPM during in-service operation. On this basis, we implement LPM on a coherent DSP, a 3-nm 800G low-power DSP ASIC housed in an OSFP pluggable module, which constitutes, to our knowledge, the first coherent DSP ASIC and transceiver to perform distributed fiber monitoring and data communication simultaneously. The on-chip LPM is experimentally validated over links of up to 1005 km using 400ZR+ and 800ZR+ traffic, with no measurable impact on Q factor or module power consumption. Multi-vendor interoperability is also demonstrated, where the on-chip LPM operates on signals transmitted by third-party transceivers. These results extend coherent DSPs from cumulative to spatially resolved monitoring, allowing pluggable transceivers, deployable from DCI to long-haul, to act not only as cost-efficient transmission elements but also as distributed monitoring points across diverse optical network infrastructure.

0.31

Understanding the Power Consumption of Modern High Bandwidth Memory: Experimental Analysis and Modeling Using Real HBM2 DRAM Chips

cs.AR cs.PF ·2026-10-09 ·Ataberk Olgun, Spiros Galanopoulos, Andreas Kosmas Kakolyris, İsmail Emir Yüksel, Haocong Luo +2 more
top venuecode/data similarity 0.48
Abstract · Extended version of the paper titled "Understanding the Power Consumption of Modern High Bandwidth Memory: Experimental Analysis and Modelin…

We perform the first comprehensive experimental characterization of power consumed by real HBM2 DRAM chips. Our extensive characterization yields 1) the empirical basis for developing new, accurate HBM power models or validating existing power models and 2) key insights into structural and data-pattern-dependent variation of power in HBM2 chips. Out of our 13 new findings and 6 key takeaway messages, we highlight: 1) a read operation consumes significantly higher current than any other operation and 2) the toggled data bus signals in a data transfer burst significantly affect current draw where toggling all HBM2-internal bank group bus signals causes 29.4% higher power consumption than keeping them constant. Leveraging our empirical insights into HBM2 power consumption, we engineer an access pattern that yields 23.6% higher power consumption on average across 36 tested HBM2 chips than the highest-power-consuming JEDEC-specified current measurement loop. Our results have important implications for HBM-based system design and validation. Relying solely on JEDEC- or vendor-specified test loops to bound HBM power could cause system failures and/or thermal throttling in real-world high-power AI/ML workloads. To improve 3D-stacked DRAM power modeling in open source architectural simulation infrastructures, we develop a new HBM power model. Our model predicts the power of 36 real HBM2 chips across diverse workloads (including a real LLM decode workload) with 7.6 -- 8.1% mean absolute percentage error, substantially more accurately than state-of-the-art HBM power models. The power consumption predicted by our model for a power-intensive microbenchmark closely matches (with 2.4% to 5.3% error across HBM3E's specified supply voltage range) the average HBM3E memory power consumed by three tested NVIDIA H200 GPUs. We publicly release our power model at https://github.com/CMU-SAFARI/HBM-Power.

0.56