CS Paper Radar

Robustness Guarantees for Optimal RIS Placement in Self-Localization Under Placement Errors

Mahdi Koloushani, Omid Rezaei, Seyed Mohammad Karbasi, Mohammad Mahdi Naghsh, Mohammad Mahdi Nayebi

eess.SP ·submitted 2026-09-23 17:06 UTC · v1
theory

Abstract

This paper studies the effect of Reconfigurable Intelligent Surface (RIS) placement errors on optimal RIS deployment for Time-of-Flight (ToF)-based self-localization. We consider a setup in which a source transmits a signal, receives the RIS-reflected echo, and estimates its own position from the corresponding ToF measurements. Under the conditions of moderate, i.i.d. Gaussian RIS position errors and i.i.d. Gaussian ToF noise, we demonstrate that the placement uncertainty manifests as a geometry-independent scaling factor in the Cramér-Rao Bound (CRB). Consequently, we prove that the optimal RIS placement remains unchanged by the presence of RIS position errors. This result is established for A-, D-, and E-optimality criteria. Simulation results verify the analysis and show that optimized RIS deployments retain their advantage even in the presence of placement uncertainty.

Closest papers

Nearest neighbours by meaning across the whole index.

Robust Design of Sensing-Assisted Secure Transmission for RIS-Aided ISAC System under Eavesdropper 3D Positioning Uncertainty

eess.SP ·2026-10-16 ·Jie Li, Zhendong Li, Wen Chen, Wei Xu, Ning Wang
benchmarktheory similarity 0.64
Abstract · 12 pages, 7 figures

Localization errors in estimating the position of a potential eavesdropper (Eve) pose a critical challenge to secure transmission in reconfigurable intelligent surface (RIS)-assisted integrated sensing and communication (ISAC) systems. To address this issue, this paper proposes a sensing-assisted robust secure transmission framework that exploits ISAC sensing to characterize the positioning uncertainty induced by these errors. The RIS is partitioned into a reflection region and a sensing reception region, supporting sensing and communication through spatial separation. By jointly exploiting observations collected at the base station (BS) and the RIS sensing reception region, maximum likelihood estimation (MLE) is employed to estimate the arrival angles, from which Eve's three-dimensional (3D) position is obtained through cross localization. The resulting localization Cramer-Rao lower bound (CRLB) is then used to construct an ellipsoidal uncertainty region around the estimated position. A two-stage optimization strategy is developed. In Stage I, the sensing beamformer and RIS reflection coefficients are jointly optimized to improve localization accuracy. In Stage II, the resulting positioning uncertainty is incorporated into a robust secure transmission design, where the communication beamformer and RIS reflection coefficients are jointly optimized to maximize the worst-case secrecy rate. Simulation results demonstrate that the proposed approach outperforms benchmark schemes without RIS assistance and with random RIS configurations in terms of secrecy performance. The proposed framework effectively mitigates secrecy performance degradation caused by localization errors in Eve's position.

0.26

Positioning with Flexible Reflectors: Solution and Performance Analysis

cs.IT ·2026-08-14 ·Jiajun He, Han Yu, Danyan Lin, Gaofeng Pan, Hing Cheung So +2 more
publishedtheory similarity 0.61
Abstract

Flexible reflectors (FRs) have emerged as a low-cost and energy-efficient solution for reshaping electromagnetic propagation environments across a wide range of applications. This paper investigates FR-swarm-assisted target localization in scenarios where line-of-sight (LoS) paths are unavailable. By leveraging the virtual LoS paths created by the FRs, a simple yet accurate estimator is proposed for localization under severe blockage conditions. To characterize the performance limits of the proposed scheme, we derive the Cramer-Rao lower bound (CRLB) and use it to optimize the positions and orientations of the FRs. Furthermore, by accounting for random FR deployment, we characterize the CRLB distribution and reveal how different network configurations affect localization accuracy. Simulation results demonstrate that the developed scheme closely approaches the CRLB performance, while the derived analytical results provide useful guidelines for FR deployment and network design.

0.17

Unified Constrained Geometric Configuration Optimization for Source Localization Systems: A Riemannian Manifold-Based Approach

eess.SP ·2026-09-11 ·Xin Cheng, Feng Shu, Gangle Sun, Xinrui Li, Yuqi Chen +1 more
similarity 0.60
Abstract

Time of arrival (TOA), time difference of arrival (TDOA), received signal strength (RSS), received signal strength difference (RSSD) and angle of arrival (AOA) are commonly used techniques for source localization. The positioning accuracy of these systems depends heavily on the geometric configuration of sensors, which is typically constrained by practical conditions. This paper presents a unified framework for optimizing sensor geometry across all five localization systems, explicitly incorporating both distance and angle constraints on sensor positions. First, the Cramér-Rao lower bounds (CRLBs) of these systems are transformed to obtain a unified expression. Based on this expression, a unified constrained geometric configuration optimization problem is formulated. The problem is then simplified into a compact form by replacing the sensor-target angles with an orientation matrix. Subsequently, a Riemannian manifold-based constrained geometric configuration optimization algorithm (RM-CGCOA) is proposed to optimize the sensor-target distances and the orientation matrix. This algorithm casts the orientation matrix onto a product manifold of unit circles. An adaptive pullback is further proposed to strictly enforce angle-related inequality constraints, ensuring that all iterates remain feasible when updating the orientation matrix via the Riemannian gradient. Within RM-CGCOA, analytical optimal distances are derived for TOA, TDOA, RSS and AOA, whereas for RSSD, the distances are updated using projected gradient descent (PGD) together with the orientation matrix. Experimental results demonstrate that the proposed RM-CGCOA consistently achieves a significantly lower position error bound (PEB) compared with the existing strategies and yields a similar PEB to the near-optimal search algorithm, but with a much faster running time.

0.22

Movable Beyond-Diagonal RIS for ISAC: Optimal Placement and Pareto Boundary

eess.SP ·2026-10-28 ·Chandan Kumar Sheemar, Sourabh Solanki, Symeon Chatzinotas
similarity 0.60
Abstract

This letter investigates integrated sensing and communication using a movable beyond-diagonal reconfigurable intelligent surface (BD-RIS). Under a rank-one line-of-sight BS--RIS channel, we derive the exact communication--sensing Pareto boundary of a fully-connected BD-RIS in terms of user--target channel correlation. For line-of-sight RIS links, maximizing this correlation yields the optimal placement. We characterize the minimum track aperture that eliminates the illumination trade-off and show that a movable diagonal RIS then attains the same optimum. Below this threshold, a dynamic program offers certified placement accuracy. Numerical results examine hardware connectivity, angular mismatch, and Rician fading.

0.26

NLOS-Aware TDOA-Based UAV Localization: Cramér-Rao Bounds, Measurement Modeling, and Experimental Validation

eess.SP ·2026-10-21 ·Cole Dickerson, Saad Masrur, Özgür Özdemir, Ismail Güvenç
similarity 0.60
Abstract · Submitted to IEEE Transactions on Aerospace and Electronic Systems (TAES) on October 21st, 2026

Passive time-difference-of-arrival (TDOA) localization is well suited for tracking non-cooperative unmanned aerial vehicles (UAVs) that do not report their positions. However, its accuracy degrades under the mixed line-of-sight (LOS) and non-line-of-sight (NLOS) propagation that is typical of low-altitude flight. In this paper, we develop NLOS-aware Cramér--Rao lower bounds (CRLBs) and an empirically calibrated measurement model for TDOA-based UAV localization, and we evaluate both with measurements from five UAV flights on the Aerial Experimentation and Research Platform for Advanced Wireless (AERPAW). The analysis yields an identifiability condition that relates the number of sensors to the number of NLOS links, together with a bias-induced error floor that a wider bandwidth cannot remove. The model parameters are estimated by matching simulated and measured error distributions. Experimental results show that the error depends most strongly on the number of sensors in LOS, while a higher altitude and a wider bandwidth lower the median error. Relocating a sensor that is always in NLOS into the open flight area can lower the median horizontal bound by two orders of magnitude if the relocated sensor is in LOS. The fitted model reproduces the median errors of the 2.5 MHz and 5 MHz flights but underestimates the heaviest error tails. Finally, rejecting outlier fixes lowers the error far more than Kalman or particle filtering, because the remaining error is dominated by bias.

0.30

Cooperative Target Localization in RIS-Enabled ISAC Systems

eess.SP ·2026-09-30 ·Rouhollah Amiri, Abdollah Ajorloo, Mohammad Mahdi Mojahedian, Ahmad Reza Hassanshahi, Fabiola Colone
similarity 0.58
Abstract

This paper develops a cooperative integrated sensing and communication (ISAC) framework in which a multi-antenna base station (BS) simultaneously localizes a target and serves multiple communication users, a subset of which is equipped with reconfigurable intelligent surfaces (RISs). The Fisher information matrix (FIM) for target positioning is derived, explicitly characterizing its dependence on the BS beamforming coefficients, RIS phase profiles, and bistatic sensing geometry. Under the stated scaling assumptions, coherent RIS phase alignment yields a Fisher-information gain that scales quadratically with the number of RIS elements, whereas independent random phases provide a linear gain in expectation. We formulate a sensing-centric joint active and passive beamforming problem that minimizes the position error bound (PEB) subject to per-user signal-to-interference-plus-noise ratio (SINR) and transmit-power constraints. The resulting non-convex problem is addressed through an iterative successive convex approximation (SCA) procedure that solves a sequence of convex subproblems. We further develop a target localization estimator that fuses one direct time-of-arrival (ToA) measurement, one angle-of-arrival (AoA) measurement, and multiple RIS-assisted indirect ToA measurements. Under small measurement errors and asymptotically efficient first-stage ToA/AoA estimation, the estimator covariance approaches the Cramér--Rao bound (CRB) to first order. Numerical results validate the analytical scaling laws and demonstrate the localization gains enabled by cooperative RIS-equipped users.

0.13

Target Localization and Self-Calibration in a Multistatic Radar System

eess.SP ·2026-08-16 ·Ahmad Musallam, Husheng Li
publishedtheory similarity 0.54
Abstract

Target localization in a multistatic radar system, where multiple receivers cooperate to improve target positioning accuracy, has many applications, including cooperative simultaneous localization and mapping (SLAM) and autonomous robot networks. A key challenge in these applications is the uncertainty in the position and orientation (pose) of the radar receivers due to platform mobility. This work investigates the achievable improvements in both target localization and receiver pose estimation by deriving the Cramer-Rao lower bound (CRLB) for a multistatic radar system performing bistatic range and bearing measurements. We propose an alternating weighted least-squares algorithm that jointly optimizes target and receiver parameters. Monte Carlo simulations demonstrate that the algorithm performance approaches the CRLB for low to moderate noise levels.

0.52

Intelligent Reflecting Surface for ISAC: From Beamforming to Joint Design With Surface Orientation

eess.SP ·2026-11-07 ·Qiaoyan Peng, Qingqing Wu, Guangji Chen, Yong Zeng, Sai Huang +3 more
similarity 0.54
Abstract

Rotatable semi-passive intelligent reflecting surfaces (SIRSs) provide an additional spatial degree of freedom (DoF) by proactively adjusting the orientation, while dedicated sensors directly receive target echoes. To exploit this DoF for integrated sensing and communication (ISAC), we investigate the joint optimization of SIRS rotation, base station (BS) transmit beamforming, and SIRS phase-shifts to minimize the Cramér-Rao bound (CRB) for target's spatial-frequency estimation subject to per-user communication signal-to-interference-plus-noise ratio (SINR) constraints. We first establish an orientation-dependent system model that characterizes the effective aperture gains, based on which the CRB is derived. To gain useful insights, closed-form expressions of the beamforming and rotation designs are derived in the sensing-only and communication-only cases. For the co-located user and target case, we further characterize the condition under which the sensing-oriented rotation design also satisfies the communication requirement. In the single-user single-target case with ideal unit aperture gains, we analyze the channel correlation and its impact on ISAC performance. For the general multi-user case, an effective method based on the genetic algorithm is developed. Numerical results demonstrate the superiorities of the rotatable SIRS over the fixed-orientation SIRS and show that jointly optimizing the SIRS orientation and beamforming can improve the effective aperture gains and the correlation between communication and sensing channels.

0.24