CS Paper Radar

Cross-Room Passive WiFi Tracking: Joint Estimation of Target Trajectory and Virtual Transmitter Location

Heping Wang, Zhongqin Wang, Henk Wymeersch, J. Andrew Zhang

eess.SP ·submitted 2026-09-28 10:01 UTC · v1

Abstract

Indoor bistatic WiFi sensing must often operate across rooms, where intervening walls block the direct line-of-sight (LOS) path between the transmitter (Tx) and receiver (Rx). Recovering a human trajectory from channel-state-information (CSI)-derived delay, angle-of-arrival (AoA), and Doppler estimates is difficult because the Tx position is often unknown and NLOS propagation is inconsistent with direct-path geometry. This paper presents CoTrack, a self-calibrating passive WiFi tracking scheme that does not require the Tx position. CoTrack extracts one dominant human-induced response and represents its transmitter-side propagation by a virtual Tx, which it estimates jointly with the human trajectory. Because similar measurements can be explained by different virtual-Tx--trajectory pairs, CoTrack uses multi-start nonlinear least squares and accepts an initialization only when the best-fitting candidates concentrate around a common virtual-Tx position. It then applies online alternating optimization for continuous tracking. We analyze the local identifiability of the joint estimation problem and derive the corresponding Cramér--Rao bound. Across six LOS and cross-room NLOS experiments, CoTrack achieves a median trajectory error of 1.14m(80th percentile: 1.42m) and a median virtual-Tx discrepancy of 0.47m(80th percentile: 0.54m).

Closest papers

Nearest neighbours by meaning across the whole index.

Bistatic Delay-Doppler Sensing for 3D Target Localization in Distributed Wi-Fi Systems

eess.SP cs.IT ·2026-10-11 ·Kyungmin Hong, Moein Ahmadi, Thomas Stifter, Mounim A. El Yacoubi, Bhavani Shankar Mysore R
published similarity 0.72
Abstract · 6 pages, 6 figures, 2 tables. Accepted for presentation at the 1st IEEE Conference on Integrated Sensing and Communications (ISAC), Lisbon, …

This paper investigates how bistatic delay information improves the observability and localization performance of 3D moving targets in distributed Wi-Fi sensing. Motivated by emerging IEEE 802.11bf WLAN sensing, we consider one transmitter, multiple distributed receivers, and a single target with unknown position and velocity. We compare Doppler-only sensing with delay-Doppler sensing, in which delay-capable receivers provide additional bistatic path-length information for target localization. We derive the Fisher information matrix (FIM) and the position equivalent FIM (EFIM) for both sensing formulations. The resulting observability analysis shows that Doppler-only localization generically requires six receivers, whereas delay-Doppler localization can become locally identifiable with three receivers under non-degenerate geometry. We further study mixed receiver architectures in which only a subset of receivers provides delay estimates. Simulations with Wi-Fi-like bandwidths confirm the transition and quantify the roles of bandwidth, Doppler noise, receiver geometry, and delay-capable receiver availability.

0.32

Self-Supervised Passive WiFi CSI-Based Motion Tracking with Physics-Informed Deep SSM

eess.SP ·2026-10-25 ·Yifan Feng, Haiyao Yu, Geng Wang, Yunkai Hu, Shenghong Li +3 more
similarity 0.65
Abstract

Inferring target position from WiFi channel state information (CSI) is challenging due to the noisy and heterogeneous nature of CSI-derived observations. Measurements such as angle, delay, and Doppler provide only imperfect information about target position and velocity, particularly in dynamic multipath environments where observation reliability varies. Motivated by this challenge, this paper proposes a physics-informed Bayesian state space framework for passive CSI-based tracking. We introduce a context-conditioned deep state space model (DSSM) that captures temporal motion and environmental dynamics, while adaptively modeling time-varying observation uncertainties. By incorporating geometric constraints, this framework enables heterogeneous CSI measurement modalities to jointly regularize the consistency and confidence of the tracking process. Experimental results demonstrate that the proposed framework yields smoother trajectory estimates with reduced temporal fluctuations and outperforms existing methods in tracking accuracy.

0.18

Physics-Informed WiFi Sensing for Robust 3D Human Pose Estimation in Mobile and Cross-Environment Settings

eess.SP ·2026-08-25 ·Kaixuan Huang, Yuanbo Chen, Guangjin Pan, Shiyi Mu, Tao Yu +2 more
similarity 0.59
Abstract · 12pages 6figures

Device-free human pose estimation using commodity WiFi signals has emerged as a promising paradigm for pervasive sensing in mobile computing systems. However, existing approaches often suffer from severe performance degradation when deployed across heterogeneous environments due to complex multipath propagation and domain shifts in wireless signals. In this paper, we present a physics-informed WiFi sensing framework for robust 3D human pose estimation under mobile and cross-environment settings. Our approach explicitly models wireless signal propagation characteristics and incorporates multipath-aware attention to capture environment-dependent signal variations. To further improve generalization, we introduce a disentangled representation learning scheme that separates pose-related features from environment-specific factors, enabling effective cross-domain adaptation without requiring extensive retraining. We implement our system using commodity WiFi devices and evaluate it on multiple public benchmarks, including Person-in-WiFi-3D and MM-Fi, as well as real-world deployments across diverse indoor environments. Experimental results demonstrate that our framework significantly improves robustness and generalization performance compared to state-of-the-art methods, particularly under cross-environment scenarios. These results highlight the potential of physics-informed wireless sensing for enabling reliable, scalable, and infrastructure-free human-centric applications in mobile computing systems.

0.12

A Tutorial on Infrastructure Self-Calibration for Radio-Based Indoor Positioning

eess.SP ·2026-11-11 ·Paul Schwarzbach
code/data similarity 0.59
Abstract

Radio positioning needs the positions of its anchors, access points, base stations, or reconfigurable intelligent surfaces, and manual surveying is costly and error-prone. Calibrating this infrastructure from its own measurements is one estimation problem, studied in at least four communities as self-calibration, auto-positioning, anchor self-localization, network localization, or radio simultaneous localization and mapping. This tutorial teaches the problem through one factor graph. The measurement topology sets its factors, the reference information enters as priors, and other measurement models add nuisance states. The tutorial shows what ranges can identify, from rigidity to the motion a mobile device must contribute, and presents multidimensional scaling, nonlinear least squares, recursive filters, and convex relaxations as inference engines over this graph. One session of a ten-anchor ultra-wideband deployment is carried through every step, and recordings from a second, harsher deployment and a public partial mesh serve as contrasts. The examples illustrate three lessons. On a full mesh, choose a robust loss and set its scale first, and calibrate with the engine of the positioning system, since the engines then reach similar errors. On thinned or partial meshes, test the result at surveyed check points, because the start decides which minimum a solver reaches. On a line-of-sight deployment, estimate range offsets, which lower the error floor that a systematic ranging bias sets and a robust loss cannot remove. A decision tree and a table of their effects turn them into deployment guidance. Code and result tables are openly released, and the data are published separately.

0.32

Cross-Domain Inference for Human Localization: Applying Wi-Fi RSSI Data to CSI-Trained Models

cs.CR cs.LGcs.NI ·2026-09-15 ·Ariel Duschanek-Myers, Thomas Welsh, Helmut Neukirchen
top venue similarity 0.59
Abstract

Wi-Fi signal data can be used to compromise the privacy of individuals. While many existing approaches rely on Channel State Information (CSI), collecting this data on typical IoT devices often requires elevated operating system permissions and specialized drivers. Consequently, this paper investigates the feasibility of utilizing Received Signal Strength Indicator (RSSI) data to predict human locations. RSSI was selected because it is accessible even on devices with limited user permissions, and therefore is more applicable to a wider array of IoT devices. To bypass the tedious process of obtaining training data needed to train an RSSI-based model, an existing Wi-Fi pose prediction project was used in this research. However, that project assumed CSI data as input. Therefore, we investigate the feasibility of cross-domain inference, i.e., feeding RSSI data into that existing CSI-based model. We collected an RSSI dataset, synchronized with video ground-truth of a person moving within a room, to evaluate the model's performance. This evaluation confirmed that RSSI data can predict locations with approximately 80% confidence when human movement is present. This demonstrates that a model trained on CSI data can be used to evaluate low-granularity RSSI data consisting of decibel-milliwatt (dBm) values to roughly locate people in the collection space. These results imply that a wide range of IoT devices can be used for privacy invasion in Wi-Fi-dense environments.

0.43

Reliable Doppler Estimation in Asynchronous Moving ISAC Devices via IMU Integration

eess.SP ·2026-09-30 ·Zaman Bhalli, Jacopo Pegoraro, Gianmaria Ventura, Paolo Casari, Michele Rossi
similarity 0.58
Abstract · 6 pages, 5 figures. Submitted to IEEE VTC2027-Spring

We present an Integrated Sensing And Communication (ISAC) framework for the joint estimation of the Doppler frequency of a passive mobile target in a bistatic scenario with clock-asynchronous nodes and where the Receiver (RX) is static but the Transmitter (TX) is mobile. In such a setup, previous geometric solutions are integrated with an Inertial Measurement Unit (IMU) device at the TX, coming up with a truly joint data fusion and estimation algorithm based on extended Kalman filtering. The approach jointly estimates the target Doppler frequency, along with the speed and direction of motion of the TX and it is robust to the unavailability of static paths between the TX and RX pair, a condition that makes previous solutions ineffective. The developed extended Kalman filter strikes a balance between the accuracy of ISAC and the IMU reliability. The proposed solution is validated via numerical simulations, obtaining a median Doppler error of 1.2% with a smartphone-grade IMU under realistic operating conditions.

0.36

GLocFM: A Geometry-Aware Foundation Model for 3D Indoor Wireless Localization

eess.SP cs.AI ·2026-08-10 ·Chenghong Bian, Chaozheng Wen, Hongze Chen, Jun Zhang
similarity 0.58
Abstract · 13 pages, single column

Learning-based wireless localizers often fail to utilize geometric information about the propagation environment, limiting their ability to exploit non-line-of-sight (NLoS) propagation and generalize across scenes. To bridge this gap, we propose GLocFM, a Geometry-aware Localization Foundation Model, which jointly exploits WiFi measurements and scene geometry represented as a 3D point cloud. We formulate localization as a maximum-likelihood (ML) estimation problem, where the goal is to find a transmitter position that maximizes the likelihood of the wireless observations conditioned on the scene geometry. The likelihood of a candidate transmitter position is calculated by a learned scoring function that matches the observed delay--angle-of-arrival (AoA) spectrum against the spectrum predicted for that candidate. A hierarchical scene encoder extracts propagation-relevant features to produce geometric priors for LoS and one-bounce reflection paths. For scenarios with imperfect synchronization, we further introduce a time-of-flight (ToF)-robust GLocFM model to handle unknown ToF offsets. GLocFM is trained on a multi-modal synthetic indoor localization dataset comprising 221 diverse scenes whose associated wireless signals are generated using Sionna RT. On both synthetic and the NeRF$^{2}$ dataset based on real measurements, GLocFM reduces mean 3D localization error relative to one of the state-of-the-art localization baselines by 49.5\% and 48.8\%, respectively. Ablations across different number of receiver, bandwidths, and array sizes further demonstrate the effectiveness and robustness of the proposed framework.

0.40

Visual-Wi-Fi Navigation to Signal-Emitting Devices

cs.RO ·2026-10-08 ·Lihao Wang, Tianjian Xu, Tianmin Shu, Renjie Zhao
similarity 0.57
Abstract · Under review

Indoor navigation to task-relevant targets remains difficult when the target is small, occluded, or visually indistinct. Meanwhile, smart appliances, mobile devices, and IoT tags emit Wi-Fi signals during everyday communication, providing a pervasive but underused spatial cue. We study visual-Wi-Fi navigation, where a robot reaches a signal-emitting device in an unmapped environment using onboard visual observations and Wi-Fi packets overheard from the device, without connecting to the device or modifying infrastructure. Realizing this requires pose-dependent Wi-Fi observations during closed-loop policy learning and reliable spatial cues from bearing measurements corrupted by indoor multipath propagation on a moving robot. We present WiFiSpaces, which extends the Habitat embodied simulator with online ray-traced Wi-Fi sensing, rendering Wi-Fi observations for a robot-mounted antenna array at continuous poses during policy rollouts. On top of it, we build ViFiNav, a localization-aware navigation framework: an online source-localization algorithm exploits robot motion to disambiguate and robustly aggregate bearings from multiple viewpoints into a confidence-aware source estimate, and a learned policy fuses this evolving estimate with depth observations and learns to act on it as it is refined. Experiments show that exploiting robot motion is key to accurate source estimates, and that fine-tuning on ray-traced Wi-Fi observations in WiFiSpaces improves the success rate of ViFiNav. The policy transfers zero-shot to unseen scene datasets, and we deploy it on a real robot with a Wi-Fi sensor built from a commodity router, without any real-world training.

0.22