CS Paper Radar

Receiver-Informed Transmitter for 200Gbps C-Band Direct-Detection PON With FFE-Free ONU

Safiya Dabwan, Geraldo Gomes, Stylianos Sygletos

cs.IT physics.optics ·submitted 2026-09-29 17:44 UTC · v1
publishedunusual

Abstract

We introduce and numerically demonstrate receiver-informed transmitter (RITX) waveform design for 200 Gb/s PAM-4 C-band direct-detection PON. Using 50 GHz optoelectronics, RITX achieves N1/E1 loss classes with FFE-Free ONU, enabling 40 km reach and 48.1%/66.7% network-wide complexity savings at 1:64/1:128 splits

Comment
Accepted for poster presentation at ECOC 2026. Fig.1(b-c) axes typo is revised

Closest papers

Nearest neighbours by meaning across the whole index.

Burst-mode timing recovery based on fourth-power phase detector for passive optical networks

cs.NI ·2026-09-14 ·Ji Zhou, Haide Wang, Xiaofeng Zhang, Zhiyang Liu, Miao Yu +3 more
publishedunusual similarity 0.51
Abstract

Driven by the ever-increasing capacity demands, 50G passive optical network (50G-PON) is ready for practical application. It is highly challenging to realize 50GHz burst-mode analog components; therefore, based on 25GHz burst-mode analog devices, burst-mode digital signal processing (DSP) is introduced to achieve the reception and processing of 50Gb/s on-off keying burst signals. To optimize the power consumption and area of the DSP chip, a one-sample-per-symbol (1-SPS) analog-to-digital converter has been applied in 50G-PON. One of the main challenges is implementing burst-mode timing recovery (BM-TR) for the 1-SPS burst signal in 50G-PON. In this paper, we first propose a BM-TR based on the fourth-power phase detector (4PPD) for 50G-PON. We mathematically verify that 4PPD can directly compute the timing phase offset (TPO) from the 1-SPS signal without using training sequences, allowing for immediate BM-TR initialization within 20 cycles to prevent long convergence times. After the initialization, the feedback loop structure tracks the TPO changes based on the sign of 4PPD, the loop filter, and the numerically controlled oscillator. In conclusion, training-sequence-free 4PPD-based BM-TR achieves low burst overhead via fast convergence and is particularly effective for handling burst signals in 50G-PON.

0.37

Low-complexity Soft-decision LLR Calculations for Next-generation IM-DD Systems with RIN

eess.SP ·2026-08-20 ·Felipe Villenas, Yunus Can Gültekin, Alex Alvarado
published similarity 0.46
Abstract

The demand for higher speeds in intra-data center interconnects will eventually require high-order pulse amplitude modulation (PAM) combined with soft-decision (SD) forward error correction (FEC). The laser relative intensity noise (RIN) is an important noise impairment that limits the performance of high-speed intensity-modulation (IM) and direct-detection (DD) systems, as it induces a channel with signal-dependent noise. In this paper, we show that an accurate calculation of the log-likelihood ratios (LLRs) is critical for the performance of the SD-FEC decoder in RIN-dominated IM-DD systems. First, we show that assuming signal-independent additive white Gaussian noise (AWGN) statistics to compute LLRs results in a significant penalty in performance. As an alternative, we propose a low-complexity piecewise linear approximation of the exact LLRs of Gray-coded PAM-4 and PAM-8 for the RIN-dominated IM-DD channel. We show using the generalized mutual information that our approximation results in no performance loss versus using exact LLRs, unlike the AWGN-like assumption. Furthermore, we validate the analysis with bit error rate (BER) performance of SD decoding. We show that our approximation matches the BERs achieved using exact LLRs. Therefore, our approximation avoids a BER error floor penalty of up to 7.2 times using an extended Hamming code with PAM-4, and up to 2.41 dB of optical modulation amplitude penalty using high-code-rate low-density parity-check codes with PAM-8 for the same target BER.

0.33

FTN Signaling: Spectral Efficiency from BPSK to 16-QAM

cs.IT eess.SP ·2026-10-08 ·Emre Cerci, Adem Cicek, Melda Yuksel, Gokhan M. Guvensen, Enver Cavus +2 more
benchmark similarity 0.46
Abstract · 5 pages, 5 figures, 2 tables. Submitted to IEEE Communications Letters

Faster-than-Nyquist (FTN) signaling can improve spectral efficiency by transmitting symbols closer together than the Nyquist limit, at the cost of additional inter-symbol interference (ISI). In this letter, we study the finite-alphabet symbol-wise achievable information rate (AIR) of FTN signaling for BPSK, QPSK, and 16-QAM under a transmit-power constraint and a common minimum mean square error (MMSE) channel-shortening (CS) detection framework, cross-validated for BPSK against an independent reduced-state Ungerboeck Bahl-Cocke-Jelinek-Raviv (BCJR) benchmark. Our results show a clear trend. Lower-order constellations can benefit from more aggressive time acceleration, while higher-order constellations become less tolerant of acceleration and achieve their best spectral efficiency closer to the Nyquist limit. At a reference signal-to-noise ratio (SNR) of 6 dB the optimum acceleration factor shifts from $τ^\star\approx0.65$ for BPSK to 0.75 for QPSK and 0.90 for 16-QAM. We further show that this trend is preserved in coded systems and remains robust to the detector memory. The impact of FTN operation on the instantaneous-to-average power ratio (IAPR) is also examined. Overall, the results highlight how constellation order should be considered when selecting the operating point for FTN signaling.

0.19

Advanced 400G-SerDes Modulations and Equalizers for GPU Cluster in AI Era

eess.SP ·2026-09-21 ·Sheng Chen, Zhengxiang Cheng, Ji Zhou, Haide Wang, Mengqi Guo +3 more
similarity 0.45
Abstract

High-speed GPU cluster interconnects are evolving from 200 to 400 Gbps to meet the growing computing demands of artificial intelligence. We investigate high-order modulation and advanced equalization for 400 Gbps interconnects. Theoretical bit error rate (BER) expressions for 4/8-ary pulse amplitude modulation (PAM) and approximate expressions for six PAM6 formats generated from 32-ary quadrature amplitude modulation (32QAM) are derived. In additive white Gaussian noise, PAM6 generated by framed-cross 32QAM achieves the best BER performance among the PAM6 formats. PAM6 and PAM8 incur peak signal-to-noise ratio (PSNR) penalties of approximately 4.2 and 7.2 dB, respectively, relative to PAM4 at the KP4 forward error correction (KP4-FEC) limit. Simulations compare PAM4, PAM6, and PAM8 at a line rate of 440 Gbps (net rate of 400G) under different bandwidth limitations. As bandwidth becomes more constrained, bandwidth requirements increasingly dominate performance over noise tolerance. PAM4 requires the lowest PSNR to reach the KP4-FEC limit in mildly bandwidth-limited channels, whereas PAM6 performs best under moderate limitations. PAM8 offers a significant advantage under severe limitations because of its lower bandwidth requirement and reduced susceptibility to high-frequency attenuation. With maximum likelihood sequence estimation, PAM6 and PAM8 reach the KP4-FEC limit under all evaluated channel conditions, while PAM6 requires a lower PSNR in most channels, highlighting its potential for 400G-SerDes systems.

0.23

Low-Complexity SVD-Based Precoding over Zero-Padded ISI Channels

cs.IT ·2026-10-08 ·Shuiyin Liu, Amin Sakzad
similarity 0.45
Abstract · 6 pages, 1 figure

We propose a low-complexity SVD-based transceiver for zero-padded memory-$1$ ISI channels. Appending a single zero-padding symbol to an $n$-symbol block yields an $n\times(n-1)$ channel matrix with an \emph{exact symmetric tridiagonal Toeplitz Gram matrix}. This structure provides closed-form singular values and vectors, enabling exact SVD precoding and equalization via FFTs without explicitly forming dense SVD matrices. The resulting implementation has $O(n\log n)$ complexity and incurs only a $1/n$ rate penalty. The resulting parallel scalar subchannels enable joint adaptive PAM and power allocation for SER minimization, followed by exact soft-information computation for LDPC decoding. At comparable code rates near $0.945$, simulations show that our proposed scheme outperforms a conventional TX-FFE/RX-DFE system with hard-decision Reed-Solomon (RS) decoding by approximately $5$ dB at FER $10^{-5}$. At high SNR, it achieves nearly the same FER performance as a SOVA-based receiver with LDPC decoding, while replacing trellis-based detection with fast SVD precoding and exact scalar soft-output computation.

0.26

Quantum-Enhanced Classical Communications for DPMZM-based NG-PON2 Systems

eess.SP quant-ph ·2026-11-06 ·Parvin Kumar, Sourav Banerjee, Neel Kanth Kundu, Umesh Sharma
unusual similarity 0.45
Abstract

This paper presents a framework for integrating quantum detection techniques into a Dual-Parallel Mach-Zehnder Modulator (DPMZM)-based Next Generation Passive Optical Network 2 (NG-PON2) communication system. We present a system model for the DPMZM-based NG-PON2 quantum communication system and characterize its signal-to-noise ratio (SNR), demonstrating its superiority over conventional MZM-based systems. We analyze the performance of various quantum modulation techniques, including binary phase-shift keying, quadrature phase-shift keying, and M-ary quadrature amplitude modulation. A comprehensive analytical framework is developed to evaluate the SNR, BER, and mutual information for both classical and quantum detection schemes within the DPMZM-based NG-PON2 quantum communication system. Our simulation results show that quantum detection significantly outperforms classical detection, and the DPMZM architecture further enhances the performance over the baseline MZM architecture by improving the effective modulation efficiency and receiver sensitivity.

0.36

Iteration-Free Candidate Pruning and an Index-Domain VLSI Architecture for Sort-Free MIMO Box Decoding up to 1024-QAM

eess.SP ·2026-11-04 ·Shengchun Yang, Amit Sravan Bora, Emil Matúš, Gerhard Fettweis
similarity 0.43
Abstract

Wi-Fi~7 and 5G NR use constellations up to $4096$-QAM and $1024$-QAM at multi-gigabit peak rates. The MIMO detector must sustain these rates at a low cost. Linear MMSE detection meets these rates at low cost but loses several dB in SNR. $K$-Best detection recovers this loss, but its per-layer sorting grows with the modulation order and needs large sorting networks or deep pipelines at these rates. Box Decoding is a sort-free tree-search detector whose complexity does not depend on the QAM order, and its deterministic pruning keeps the cost fixed as the MIMO size grows. Single-step candidate pruning (SCP) is fully parallel but less accurate, while iterative candidate pruning (ICP) is more accurate, but its selection loop costs either throughput or area. This paper proposes Max-Min-Exchange Candidate Pruning (MMECP), which replaces the selection loop of ICP with a single max-min exchange without a feedback path and keeps \mbox{near-$K$-Best} performance. The paper also presents a VLSI architecture that represents each candidate by its integer constellation index, so that candidates and their distances are obtained by bit selection instead of operations on symbol values. A $4\times4$ detector synthesized in TSMC $16$\,nm detects one vector per cycle at $1$\,GHz for $64$- to $1024$-QAM and produces up to $40$\,Gb/s, while its gate count grows by $63\%$ over this range. Its normalized hardware efficiency is $2.3\times$, $12\times$ and $14\times$ that of the best compared hard-output detector at $64$-, $256$- and $1024$-QAM.

0.36

Realistic modeling of Photonic Terahertz Communication based on a real-world 30 km 30 Gbps experimental demonstration

eess.SP ·2026-09-26 ·Mingxu Wang, Jianjun Yu, Xianming Zhao, Jiali Chen, Ye Zhou +7 more
publishedbenchmark similarity 0.43
Abstract · 15 pages, 10 figures

Experimental studies have demonstrated that THz links can support multi-kilometer, gigabit-per-second wireless transmission. However, few studies have effectively validated channel models through high-capacity, long-distance experiments. In this work, we experimentally demonstrate a 30 km ultra-long-haul photonic THz wireless communication system. 16 Gbaud quadrature phase shift keying (QPSK) signals are transmitted and tested, achieving a maximum data rate of 30 Gbps. For the first time, we validate two widely used THz channel models using a fully implemented 30 km experimental setup, providing a systematic and thorough analysis that integrates theoretical modeling with experimental results. We also perform an analysis of power consumption in photonic THz communication systems and provide a detailed comparison between simulated and experimental power consumption results. Finally, a detailed performance comparison between the simulation and experimental results, including signal-to-noise ratio (SNR), bit error rate (BER) and data rate, are provided. Our work provides essential insights for the design and energy-efficient deployment of future high-capacity THz networks, establishing a benchmark for subsequent research in channel modeling, experimental verification, and system-level energy efficiency.

0.34