CS Paper Radar

Reactive Humanoid Multi-Contact Using Learned Stability Models

Stephen McCrory, Beomyeong Park, Nicholas Kitchel, Nehar Poddar, Robert Griffin

cs.RO ·submitted 2026-09-30 23:33 UTC · v1

Abstract

We present a planning and control approach to reactively use hand contacts to stabilize a humanoid in low stability scenarios, where only using feet contacts may result in a fall. Candidate contacts are sampled within the robot's reachable workspace, and a preview is computed by rolling out the centroidal dynamics through pre-impact, impact and post-impact phases. Sampled points are scored based on the Center of Pressure (CoP) control authority at the post-impact phase. Central to our approach is a learned model of the robot's CoP region during post-impact, which enables rapid evaluation of candidate contact points compared to traditional optimization-based methods. The presented planner has two stages: the first selects an optimal bracing region and the second computes an optimal bracing point within the region. Our simulation results demonstrate an average increase in impulse resilience of 89% over recovery without hand contacts and 17% over a naive planning strategy (closest reachable region). We validate our framework on hardware, performing push tests while standing and walking. The standing trials show an average 43% reduction in stabilization time compared to naive hand placement and the walking trials demonstrate a 18% reduction compared to baseline recovery (without hand contacts).

Closest papers

Nearest neighbours by meaning across the whole index.

Demonstration-Guided Humanoid Stand-Up on an Emulated Deformable Surface

cs.RO ·2026-08-21 ·Aniruddh Kushwah, Vyankatesh Ashtekar, Ashish Dutta
similarity 0.75
Abstract

This paper presents a reference-guided reinforcement learning framework to generate stand-up motion for a 29-DOF Unitree G1 humanoid on deformable soft ground, using a human demonstration recorded on hard ground. The terrain compliance is modelled using solref and solimp parameters from MuJoCo's rigid body soft-contact model. The rewards consists of (i) reference motion tracking through residual joint-position control and (ii) explicit recovery objectives such as pelvis height, torso uprightness, and the final posture. First, the policy is trained with the specified rewards considering hard ground. Next, the terrain stiffness is lowered by updating solref and the nominal surface penetration zone is expanded using solimp. Subsequent training enables the policy to adapt to the delayed support force generation due to significant surface penetration during contact-intensive phases while preserving the original demonstration pattern. The learned policy successfully completes the fallen-to-standing task in simulation, reaching the targeted pelvis height and uprightness, with a maximum contact penetration of approximately 40 mm during the process. The proposed method is demonstrated on two stand-up sequences and successfully achieves the final recovery objective on both hard and soft ground. Ablation studies show that reference tracking alone is insufficient for successful stand-up, and that explicit recovery rewards are essential.

0.24

Brace Yourself: Task-Conditioned Environmental Bracing for Forceful Humanoid Manipulation

cs.RO ·2026-09-21 ·Zongyuan Zhang, Christopher Lehnert, Will N. Browne, Jonathan M. Roberts
similarity 0.73
Abstract · Submitted to IEEE Robotics and Automation Letters (RA-L). 8 pages, 6 figures. Video demonstration: https://youtu.be/zPrGLxWJzI4. This work h…

Forceful manipulation is challenging for humanoid robots because interaction forces can disturb whole-body balance. We introduce the Supporting Hand Strategy (SHS), which enables a humanoid to brace against the environment with one hand while performing forceful manipulation with the other. SHS optimises a task-conditioned support configuration that guides two synchronous reinforcement-learning policies, without human motion data or online whole-body trajectory planning. On a Unitree G1, SHS achieved usable contact forces up to 60 N, compared with a maximum sustained force of 13.5 N without environmental bracing, while substantially improving force tracking over a task-independent support configuration. The same policies generalised to different task regions without retraining. SHS therefore provides a simple mechanism for substantially extending humanoid forceful-manipulation capability.

0.37

Leaning Over to Reach Far-Away Objects

cs.RO ·2026-11-14 ·Allen Devaraj, William Xie, Nikolaus Correll
code/data similarity 0.71
Abstract · 8 pages, 9 figures, 1 table. Under review at ICRA 2027. Videos and code at https://h12leaner.github.io/

We study supported reaching to extend a humanoid robot's workspace by bracing against the environment for stabilization using a straightforward yet capable whole-body model predictive control (MPC) approach, exclusively with local sensing and fiducial markers. While typical solutions for whole body humanoid control aim at avoiding or accommodating contact, contact is explicitly required to reach objects placed on surfaces far out of normal reach. We employ sampling-based MPC for whole-body leaning, bracing, reaching, and recovery on a Unitree H1-2 humanoid. The controller runs in real-time at 34 Hz on a laptop, transfers sim-to-real, extends reach by about 50 cm beyond the unbraced standing workspace, and sustains the loaded posture for over four minutes, before pose estimation drifts. The controller reaches the commanded target in 89% of trials and completes the full reach-and-recovery cycle in 81%, across 54 trials spanning six targets and three table heights. We further characterize why such a small real-time sampling budget is sufficient, finding that temporal persistence of sampled actions and exploration scale strongly govern success, while CEM provides the widest operating region over planning rate and model mismatch. These results establish a real-world baseline for online, contact-rich humanoid manipulation. Code, videos, and full hardware details are available at https://h12leaner.github.io/

0.35

Contact-UAN: Unsupervised Actuator Networks as a Residual World Model for Humanoid Control

cs.RO ·2026-10-13 ·Nolan Fey, Khai Nguyen, Yash Prabhu, Gabriel B. Margolis, Pulkit Agrawal
similarity 0.70
Abstract · Project website: https://contact-uan.csail.mit.edu/

Humanoid policies trained in simulation can transfer qualitatively to hardware while failing to transfer the force interactions learned during training, compromising torque efficiency, load regulation, and robustness to impacts. This failure can arise from actuator sim-to-real gaps because forces depend on actuator torques. We introduce Contact-UAN, a residual world model that preserves a simulator's physics priors while correcting actuator dynamics to align simulated rollouts with recorded hardware rollouts. For humanoid motion with contact, this requires contact-consistent replay: if hardware playback in simulation begins with misaligned contact wrenches, the residual model learns to correct reset artifacts rather than actuator discrepancies. Using only onboard proprioception, Contact-UAN infers the simulator-side stance-foot pose needed to initialize replay with consistent contact forces. We show that a UAN trained on 6.5 minutes of real-world walking data generalizes to tasks that benefit from accurate force and impulse regulation and produces policies that transfer seamlessly to the real world, yielding 20% lower running torque, 43% lower force-tracking error, extreme compliance, accurate impedance control, and dynamic, robust jumps.

0.28

ROOF: Learning Humanoid Fall Recovery under Overhead Constraints

cs.RO ·2026-10-30 ·Yidan Lu, Jiayuan Yu, Zongrui Cai, Jingwen Sun, Jinrui Han +3 more
code/data similarity 0.68
Abstract · 8 pages, 4 figures

A fallen humanoid beneath an overhead obstacle faces a coupled recovery problem. It must create clearance while organizing support for a stable rise, since attempting to stand before making room can further increase obstruction. We introduce a reinforcement learning method with contact-supported geometric escape guidance, which rewards incremental reduction of robot-obstacle overlap without prescribing an escape path. To achieve this, a learned motion prior, together with posture-dependent support and joint-stall costs, is proposed to shape a single policy that learns when to clear the obstacle, how to establish support, and when to complete the rise, all using proprioception alone. In simulation, it recovers in 88.5% of trials beneath plates that can only be lifted, compared with 18.9% without geometric guidance, and in 98.6% of trials beneath free plates with randomized size, mass and placement. On a Unitree G1, the deployed policy recovered in 95 of 150 attempts across seven real-world obstacle scenes, including furniture and multi-object arrangements absent from training. Project page: https://lu-yidan.github.io/ROOF/

0.25

Online iLQR-MPC with Whole-Body Control for Robust Humanoid Locomotion

cs.RO ·2026-11-03 ·Xiang Li, Linlin Ou, Ruihan Wu, Xinyi Yu
similarity 0.67
Abstract

Humanoid locomotion requires deciding where to step and how to distribute contact forces. However, a disturbance can invalidate the nominal plan, requiring coordinated revision under constraints that switch with every footfall. To solve this online, the proposed approach employs the single-rigid-body model, which retains attitude dynamics and the full contact wrench. An iterative linear-quadratic-regulator MPC (iLQR-MPC) then jointly optimizes contact forces and footstep locations in a single receding-horizon problem, without a separate step planner. Specifically, contact and motion constraints are incorporated into the backward pass through augmented-Lagrangian and relaxed-barrier penalties. A whole-body controller subsequently maps the plan to joint torques at 500 Hz while preserving contact feasibility. The model-based formulation makes disturbance responses interpretable through explicit costs and constraints, and requires no platform-specific policy training. In MuJoCo simulations, the iLQR-MPC replans at 100 Hz (mean solve time 8.9 ms); the Unitree G1 sustains steady-state walking and recovers from impulsive 245 N forward and 175 N lateral pushes.

0.18

PingpongDuo: Agile Humanoid Table Tennis Doubles with Safe Team Coordination

cs.RO ·2026-10-14 ·Haoran Jiang, Yichao Zhong, Kai Zhang, Cheng Liu, Yixuan Pan +4 more
code/data similarity 0.66
Abstract · 9 pages, 6 figures. Project page: https://www.archon.tech/research/PingpongDuo

Unlike singles, humanoid table tennis doubles requires teammates to strike in strict alternation while sharing a confined workspace. Rapid repositioning can compromise striking accuracy, while uncoordinated teammate movements introduce collision risks. We present PingpongDuo, a hierarchical framework for agile humanoid doubles with safe team coordination. At the team level, a planner jointly selects positioning targets and uses learned risk estimates to filter risky proposals, preferentially preserving the current striker's target. At the individual level, separate footwork and striking skills combine agile movement with precise racket control. The skills are guided by human motion references, including footwork collected from human doubles play, and trained from states produced by one another to support rapid transitions. A racket-arm residual further refines strikes after movement using return feedback from a simulator calibrated with real ball-flight and contact measurements. In simulation, PingpongDuo improves the ball-return success rate by 13.2% over the state-of-the-art baseline, while achieving approximately 2 cm positioning error during clearance. In real-world experiments, a robot completes a 2.15 m clearance-and-recovery cycle in 2.4 s with a peak speed of 2.23 m/s, while two robots sustain more than 10 consecutive strikes in strict alternation.

0.40

ReContact: Reconstruct and Retarget Human Contacts from Video for Contact-Rich Humanoid Manipulation

cs.RO ·2026-11-02 ·Zhongkai Gu, Yang Liu, Wei Zhu, Mitsuhiro Hayashibe
similarity 0.66
Abstract

Contact transitions allow humanoid robots to redistribute object support across the whole body, enabling manipulation beyond hand-only grasps. Human videos provide a scalable source of such transitions for robots to learn from. However, body occlusion disrupts object pose tracking and corrupts retargeted motion. Moreover, accurately reproducing the object trajectory does not ensure that the robot applies stabilizing forces at the intended contacts, risking slips or drops in later phases. To address these challenges, we propose ReContact, which reconstructs and retargets human-object interactions through an object-centric contact plan. The plan specifies contact phases, contact pairs, anchors, pressing directions, and sticking or sliding modes. Contact priors stabilize object pose reconstruction through occlusion. A residual policy over a frozen whole-body tracker is rewarded for making contact at planned anchors with forces aligned to the specified directions. In simulation, on a thigh-supported regrasp task, ReContact achieves the planned two-palm bottom hold in 83.5 of episodes over three training seeds, versus 0.16% for the best adapted baseline. One policy trained on 247 references re-solved for new placements raises in-workspace tube-transfer success from 20.4% (source reference only) to 97.8%. On a real Unitree G1, policies execute seven contact-rich manipulation and two loco-manipulation tasks.

0.08