CS Paper Radar

Dataset-Free Compliant Humanoid Loco-Manipulation with Dynamic Online Posture

Seungho Yeom, Zhenyu Wu, Jaeyoung Huh, Diego Williams, Yuheng Zhi, Soofiyan Atar, Michael Yip

cs.RO ·submitted 2026-10-05 01:44 UTC · v1

Abstract

Most humanoid loco-manipulation controllers require human motion data to learn whole-body coordination and posture, leaving policies reliant on external sources to provide this data. We present OCLO (Online-posture Compliant LOco-manipulation), a humanoid loco-manipulation system trained without human motion data and commanded only through two end-effector targets. Because these targets do not uniquely determine whole-body posture, OCLO generates pelvis height and torso orientation online using an analytic reachability prior, further refined through policy-in-the-loop sampling with a task-agnostic cost. OCLO also learns whole-body compliance by displacing end-effector references according to measured forces through a spring-damper model, encouraging the legs, waist, and pelvis to yield to external loads. In simulation, using the reachability prior leads to a 77.8% success rate in acquiring the commanded reference, a vast improvement over the 37.8% success rate accomplished without the prior. Further, refinement reduces end-effector orientation error across all evaluated tasks. The same posture module improves a pretrained SONIC controller on four of five tasks. Without compliance training, policies tend to lose balance under disturbances rather than sacrifice tracking. On a Unitree G1, OCLO maintains balance under end-effector disturbances that cause its ablations to fail and performs seven loco-manipulation tasks, including crouched walking and picking up a box from a low surface. Project website: https://oclo-humanoid.github.io/

Closest papers

Nearest neighbours by meaning across the whole index.

CompliantBot: Learning Whole-Body Compliance across Task Interfaces for Humanoid Control

cs.RO ·2026-11-01 ·Haoyang Li, Keqi Zhu, Zhanxiang Cao, Yang Zhang, Yizhi Chen +2 more
similarity 0.78
Abstract · 12 pages, 8 figures, 5 tables

Humanoid controllers need the ability to yield to external forces while retaining the capacity to resume their original tasks. However, tracking objectives penalize the deviations needed for yielding, while relaxing tracking goals persistently can make task recovery harder. Existing approaches often rely on task-specific interaction command interfaces or constructed compliant motion data and reference trajectories, limiting the direct reuse of their compliance-training mechanisms across different task interfaces. We introduce CompliantBot, a compliance-training framework for motion tracking and velocity-command locomotion. It preserves the original task inputs and requires no preconstructed compliant data or target trajectories. A state-dependent interaction force field couples applied loads to the robot's motion, enabling local articulation and whole-body movement to change the forces experienced. A complementary force-magnitude reward encourages lower interaction loads, while task rewards are downweighted during loading and restored after release to coordinate yielding and task resumption. The trained policies use task inputs and proprioceptive history without explicit external-force measurements. Across both task interfaces, CompliantBot yields farther under constant pulls and experiences lower spring interaction loads than matched baselines, while resuming task tracking after force removal. CompliantBot achieves the highest task completion among the compared methods under stronger pulls. Power evaluations further show that CompliantBot has the lowest mean joint mechanical power among the compared methods. Real-robot demonstrations further illustrate compliant responses through arm motion, stepping, and body reorientation.

0.23

CEER2: Directional and Tunable End-Effector and Root Compliance for Humanoid Loco-Manipulation

cs.RO ·2026-09-30 ·Xinyuan Luo, Chunyuan Yang, Boyuan Chen, Xianyi Cheng
similarity 0.77
Abstract · 8 Pages, 5 figures

Humanoids are increasingly capable of tracking complex whole-body motions, but physical interaction introduces a different challenge. When a robot makes contact with a person or the environment, it needs to respond to external forces while preserving the motion needed for the task. This response can vary across directions in the end-effectors and on the body. For example, an end effector may need to accommodate contact force in one direction while maintaining motion accuracy in another, while the robot body may resist an external force or move with it. We present a compliance framework for humanoid loco-manipulation that combines directional and tunable end-effector (EE) compliance with selectable root compliance for external force rejection or force following. A hierarchical reinforcement learning controller modulates a fixed whole-body tracking policy through high-level EE and root commands, while interaction forces are estimated from proprioceptive history. Our simulation and real-world experiments on a humanoid demonstrate directional stiffness control, online stiffness adjustment, distinct root compliance, compliant manipulation, and collaborative carrying.

0.20

CompliantWBC: Whole-Body Compliance for Heavy Humanoids via Force Latent Estimation and Residual Impedance Targets

cs.RO ·2026-09-27 ·Tan-Dzung Do, Cuc T. Trinh, Tuan Dat Phuong, Chien Le, Thanh Ly +2 more
similarity 0.77
Abstract · Project website: https://dotandung.github.io/compliantwbc/

Whole-body compliant control is essential for deploying heavy humanoids under high payload in human-centric environments. Most prior force-aware learning-based pipelines focus on end-effector resistance, per-link upper-body springs, or end-effector stiffness modulation, leaving arbitrary-site perturbations on heavy platforms with lower-body engagement largely unaddressed. We close this gap with CompliantWBC comprising: (1) A base policy trained with RL to maximize compliance-fidelity reward, guided by a multi-site whole-body impedance reference controller, extending classical Cartesian impedance to any controlled link; (2) A bounded residual policy that edits the per-link impedance equilibrium over a frozen base, correcting the coarse but structured wrench estimate supplied by a force encoder co-trained behind a gradient barrier; (3) A Phong-weighted force-origin sampler with an axis-decoupled pelvis anchor induces lower-body-inclusive compliance curriculum training via two interpretable parameters. We evaluate CompliantWBC in simulation against both compliant and stiff baselines, achieving best compliant fidelity of 2.58cm deviation from analytical solutions, and demonstrate it on a real heavy humanoid across static/dynamic force reaction, board wiping, squat under payload, and cooperative payload transport. Project website: https://dotandung.github.io/compliantwbc/

0.46

Stay Seated: Learning Omnidirectional Humanoid Locomotion on a Passive Mobile Chair with Casters

cs.RO ·2026-08-28 ·Kango Yanagida, Kazuki Miyazawa, Takato Horii
similarity 0.77
Abstract

Humanoid robots with quasi-direct-drive actuators continuously generate joint torque while standing, whereas seated humans delegate weight support to chairs during desk work. As a first step toward seated loco-manipulation, we study omnidirectional seated locomotion on a passive mobile chair, requiring unfixed pelvis-seat contact and intermittent foot-floor propulsion of the robot-chair system. We extend a standard standing velocity-tracking environment with a passive-chair model, seated-state rewards, critic-only chair observations, and task-tailored contact settings. The policy is learned without motion-imitation rewards; its actor uses only proprioception and velocity commands, without contact sensing or chair states. In random-command evaluation, the policies tracked omnidirectional commands through nearly all 20-s rollouts, and the best seated policies could outperform the Standing policy in velocity tracking. Across four training seeds, a $2^3$ full-factorial comparison of symmetry regularization (SY), foot-slip regularization (FS), and command curriculum (CC) showed that FS reduced CoT but increased tracking error and that some FS-only policies converged to stationary local optima. Combining FS with either SY or CC avoided this failure without retuning FS, while SY improved bilateral leg symmetry during longitudinal motion. Direction-resolved analysis showed CoT ordered backward $<$ lateral $\ll$ forward, with planted-leg extension in backward and lateral motion and knee flexion following heel contact in forward motion. The learned policy achieved zero-shot sim-to-real transfer to a Unitree G1 and generated omnidirectional seated locomotion.

0.03

Precise SE(3) End-Effector Tracking in Whole-Body Humanoid Control

cs.RO eess.SY ·2026-10-07 ·Joohwan Seo, Xiaofeng Guo, Jinkun Cao, Roberto Horowitz, Rocky Duan +2 more
similarity 0.76
Abstract

Precise end-effector tracking during humanoid whole-body motion is challenging due to floating-base oscillations, gravity, dynamic coupling, and locomotion-induced disturbances. We propose ResGAC, a whole-body humanoid controller for precise end-effector pose tracking that combines geometric admittance control (GAC) with residual reinforcement learning. GAC provides structured $\SE$ task-space feedback and generates nominal arm joint-position targets, while residual RL compensates for unmodeled dynamics and coordinates locomotion and balance in the shared joint-position action space. The left-invariant geometric formulation allows the same GAC law to be used across manipulation reference frames. This enables the use of a ground-attached heading frame that preserves planar locomotion while removing pelvis roll, pitch, and heave from the manipulation reference, thereby reducing reference-induced end-effector motion during locomotion. ResGAC is validated on a real Unitree G1 humanoid. Across four standing end-effector tracking benchmarks, ResGAC consistently outperforms representative baselines, including SONIC, achieving lower translational and rotational errors. Real-world experiments further demonstrate reduced propagation of pelvis motion to the desired end-effector pose using the proposed ground-attached heading frame. ResGAC achieves $90\%$ success in a standing peg-in-hole task compared with $50\%$ for SONIC, and accurate world-frame $\SE$ end-effector pose tracking during lower-body motion. Experimental videos are included in the supplementary material and are also available on the project website: https://resgac.github.io/ResGAC-website/.

0.29

DUET: Decoupled Upper- and Lower-Body Execution for Task-Agnostic Humanoid Loco-Manipulation

cs.RO cs.LG ·2026-09-19 ·Kapalik Khanal, Biswash Khatiwada, Stephen Afrifa, Fan Wu, Ramesh Bahadur Bist
similarity 0.75
Abstract

Changing a humanoid robot's manipulation policy should not require retraining the controller that maintains the robot's balance. This study introduces DUET, a decoupled execution framework that enables locomotion and manipulation controllers to operate simultaneously by combining their commands only at the robot interface. A reinforcement-learning locomotion policy controls the 12 leg joints and a waist yaw joint, tracking planar velocity, turning rate, and pelvis height from deep crouching to upright standing on a 23-degree-of-freedom Unitree G1. The 10 arm joints are excluded from the action space, while their positions and velocities are included only as observations, so that any compatible manipulation policy that generates arm-joint targets can control the upper body, and the locomotion policy keeps the lower body stable without requiring shared training or direct coordination. This study demonstrates the modular approach on hardware by pairing the same locomotion checkpoint with two different vision-language-action models, GR00T N1.7 and pi0.5. In simulation evaluation, the locomotion controller kept the robot's lower body stable with no falls while tracking the commanded planar velocity, yaw rate, and pelvis height with errors of 0.186 m/s, 0.142 rad/s, and 0.016 m, respectively. Ablation studies identify the upper-body pose curriculum as the dominant component, and removing this training step reduces episode survival from 20.0 to 7.4 seconds and increases the fall rate to 6.06 per environment minute. Robustness tests show no falls under pushes of up to 1.0 m/s within the trained payload range, and no falls at twice the payload limit for pushes below 0.7 m/s. These results show that a manipulation policy can be exchanged without retraining, restarting, or otherwise touching the layer that keeps the robot upright.

0.22

Natural Sit-to-Stand Motion Synthesis For Humanoids via Guided Assistance Curricula and Staged Rewards

cs.RO ·2026-08-21 ·Meet Pal Singh, Vyankatesh Ashtekar, Ashish Dutta
hot direction similarity 0.75
Abstract

A humanoid has infinitely many ways to stand up from sitting while maintaining balance, making sit-to-stand (STS) a challenging control problem. We synthesise natural humanoid STS motion from scratch using reinforcement learning, without demonstrations or reference trajectories. A single Proximal Policy Optimisation policy learns smooth, human-like rising driven by three complementary components. (i) A coupled force/chair-height curriculum is used. A vertical pelvis-assist force aids early trajectory exploration and decays over training. Taller chairs are unlocked with decaying assisting force. This ensures that the policy masters a viable STS trajectory at each chair height before being exposed to harder ones, avoiding the premature distribution shift that otherwise collapses generalisation. (ii) Motion robustness is achieved by randomly sampling from a large number of inverse kinematics-generated initial and target poses spanning over eight chair heights. (iii) A set of rewards is defined inspired from biomechanics and optimal control studies. They shape the robot's angular momentum for seat-off, and enable support-region transition via centre of pressure attraction function to ensure smooth low-effort actuation. On a deterministic force-free evaluator, the policy attains more than 97% balanced-standing success across eight chair heights. The policy generalises smooth motion across chair heights and enables the robot to rise from substantially deep-seated postures as compared to the state of the art.

0.27

ReCo: Response-Consistent Locomotion with Policy-Aware MPC for Legged Manipulation

cs.RO ·2026-10-01 ·Kuankuan Sima, Yichao Gao, Chenxi Gu, Kefan Zhao, Lin Zhao
benchmark similarity 0.75
Abstract

Continuous legged manipulation requires accurate end-effector tracking while the base keeps walking. Combining reinforcement learning (RL) with model predictive control (MPC) suits this task: the learned policy provides robust locomotion, while MPC coordinates the base and arm to compensate for tracking errors. However, MPC can compensate only for base motion that it can predict, and a learned policy's command response varies with gait phase, contact, and payload. We present ReCo, a framework that couples response-consistent locomotion with policy-aware MPC for legged manipulation. Response shaping trains the policy to respond to commands consistently and repeatably across randomized dynamics. An identified closed-loop response model then lets MPC jointly plan locomotion commands and arm motion. On the simulation benchmark, ReCo reduces position and orientation root-mean-square error (RMSE) by 28.7% and 27.4% relative to the best baseline for each metric. Real-world experiments demonstrate onboard continuous legged manipulation with coordinated base and arm motion.

0.17