CS Paper Radar

Stay Seated: Learning Omnidirectional Humanoid Locomotion on a Passive Mobile Chair with Casters

Kango Yanagida, Kazuki Miyazawa, Takato Horii

cs.RO ·submitted 2026-08-28 08:58 UTC · v1

Abstract

Humanoid robots with quasi-direct-drive actuators continuously generate joint torque while standing, whereas seated humans delegate weight support to chairs during desk work. As a first step toward seated loco-manipulation, we study omnidirectional seated locomotion on a passive mobile chair, requiring unfixed pelvis-seat contact and intermittent foot-floor propulsion of the robot-chair system. We extend a standard standing velocity-tracking environment with a passive-chair model, seated-state rewards, critic-only chair observations, and task-tailored contact settings. The policy is learned without motion-imitation rewards; its actor uses only proprioception and velocity commands, without contact sensing or chair states. In random-command evaluation, the policies tracked omnidirectional commands through nearly all 20-s rollouts, and the best seated policies could outperform the Standing policy in velocity tracking. Across four training seeds, a $2^3$ full-factorial comparison of symmetry regularization (SY), foot-slip regularization (FS), and command curriculum (CC) showed that FS reduced CoT but increased tracking error and that some FS-only policies converged to stationary local optima. Combining FS with either SY or CC avoided this failure without retuning FS, while SY improved bilateral leg symmetry during longitudinal motion. Direction-resolved analysis showed CoT ordered backward $<$ lateral $\ll$ forward, with planted-leg extension in backward and lateral motion and knee flexion following heel contact in forward motion. The learned policy achieved zero-shot sim-to-real transfer to a Unitree G1 and generated omnidirectional seated locomotion.

Closest papers

Nearest neighbours by meaning across the whole index.

Natural Sit-to-Stand Motion Synthesis For Humanoids via Guided Assistance Curricula and Staged Rewards

cs.RO ·2026-08-21 ·Meet Pal Singh, Vyankatesh Ashtekar, Ashish Dutta
hot direction similarity 0.81
Abstract

A humanoid has infinitely many ways to stand up from sitting while maintaining balance, making sit-to-stand (STS) a challenging control problem. We synthesise natural humanoid STS motion from scratch using reinforcement learning, without demonstrations or reference trajectories. A single Proximal Policy Optimisation policy learns smooth, human-like rising driven by three complementary components. (i) A coupled force/chair-height curriculum is used. A vertical pelvis-assist force aids early trajectory exploration and decays over training. Taller chairs are unlocked with decaying assisting force. This ensures that the policy masters a viable STS trajectory at each chair height before being exposed to harder ones, avoiding the premature distribution shift that otherwise collapses generalisation. (ii) Motion robustness is achieved by randomly sampling from a large number of inverse kinematics-generated initial and target poses spanning over eight chair heights. (iii) A set of rewards is defined inspired from biomechanics and optimal control studies. They shape the robot's angular momentum for seat-off, and enable support-region transition via centre of pressure attraction function to ensure smooth low-effort actuation. On a deterministic force-free evaluator, the policy attains more than 97% balanced-standing success across eight chair heights. The policy generalises smooth motion across chair heights and enables the robot to rise from substantially deep-seated postures as compared to the state of the art.

0.27

Dataset-Free Compliant Humanoid Loco-Manipulation with Dynamic Online Posture

cs.RO ·2026-10-05 ·Seungho Yeom, Zhenyu Wu, Jaeyoung Huh, Diego Williams, Yuheng Zhi +2 more
similarity 0.77
Abstract

Most humanoid loco-manipulation controllers require human motion data to learn whole-body coordination and posture, leaving policies reliant on external sources to provide this data. We present OCLO (Online-posture Compliant LOco-manipulation), a humanoid loco-manipulation system trained without human motion data and commanded only through two end-effector targets. Because these targets do not uniquely determine whole-body posture, OCLO generates pelvis height and torso orientation online using an analytic reachability prior, further refined through policy-in-the-loop sampling with a task-agnostic cost. OCLO also learns whole-body compliance by displacing end-effector references according to measured forces through a spring-damper model, encouraging the legs, waist, and pelvis to yield to external loads. In simulation, using the reachability prior leads to a 77.8% success rate in acquiring the commanded reference, a vast improvement over the 37.8% success rate accomplished without the prior. Further, refinement reduces end-effector orientation error across all evaluated tasks. The same posture module improves a pretrained SONIC controller on four of five tasks. Without compliance training, policies tend to lose balance under disturbances rather than sacrifice tracking. On a Unitree G1, OCLO maintains balance under end-effector disturbances that cause its ablations to fail and performs seven loco-manipulation tasks, including crouched walking and picking up a box from a low surface. Project website: https://oclo-humanoid.github.io/

0.27

ForPC: Force-Aware Whole-Body Control for Precise Humanoid Cart Pushing

cs.RO ·2026-11-05 ·ZhenYu Zou, Xing Liu, ShiChuang Wang, YunLong Dong, LiNan Deng +3 more
similarity 0.73
Abstract · 14 pages, 7 figures, 4 tables. Project website: https://roboforpc.github.io/. Corresponding author: Cheng Cheng

Humanoid robots are expected to take over strenuous material handling in manufacturing, logistics, and healthcare, where operating existing wheeled carts would let them move heavy loads without modifying the workplace. However, humanoid cart pushing remains challenging because the bimanual grasp closes a force-coupled loop in which the contact wrenches that drive the cart also disturb the robot's balance, and payload changes alter the coupled dynamics. We propose ForPC, a force-aware whole-body control framework that regulates cart velocity through two-stage reinforcement learning. A locomotion prior is first trained under varied hand loads and upper-body postures to provide balance support. A force latent and a state latent are then inferred from onboard observations, without external force sensors, and fed to a residual policy that coordinates bounded arm, waist, and leg adjustments with base-velocity commands. Multi-objective rewards penalize bimanual internal opposition, grasp slip, and actuator saturation, encouraging the policy to apply contact force on demand without human demonstrations. Sim-to-sim experiments show that ForPC reduces cart-velocity RMSE by up to 68.2% relative to a locomotion-only baseline (Loco-only) and cross-track RMSE by up to 74.2% on the multi-bend route. Trained solely in simulation, the policy also transfers to a physical Unitree G1 without real-world training or fine-tuning and, with no payload-specific adjustment, pushes a cart carrying up to 30 kg at 0.5 m/s. These results suggest that humanoid robots could eventually replace humans for efficient material handling in daily life.

0.21

Humanoid Rickshaw Pulling: Whole-Body Locomotion under Coupled Wheeled Loads

cs.RO cs.LG ·2026-10-03 ·Yangzhi Yang, Xiansheng Lin, Zhaoming Xie, Xiaobin Xiong
similarity 0.73
Abstract

Humanoid robots could transport payloads substantially heavier than themselves by pulling passive wheeled vehicles instead of carrying the load. This capability, however, creates a coupled locomotion problem: the robot must maintain persistent upper-body contact while adapting to unknown, configuration-dependent forces arising from the payload, vehicle, and terrain. We present a whole-body control framework for humanoid rickshaw pulling that tracks commanded vehicle motion while preserving balance and stable grasps under uncertain load dynamics. During training, a privileged teacher exploits vehicle states, interaction forces, and load properties. Its actions and latent are distilled into a history-conditioned student that implicitly infers coupled dynamics from proprioceptive responses, followed by reinforcement-learning fine-tuning. Comparisons with \emph{No History} and \emph{Only History} baselines show that the resulting policy achieves accurate vehicle tracking while reducing vehicle oscillation, torso tilt, and actuation cost. Behavioral analysis shows that Unitree G1 propels the rickshaw and generates gait-synchronized whole-body reactions that stabilize its lateral and roll motions. Moreover, pulling redistributes joint effort and yields a lower robot-normalized cost-of-transport proxy than unloaded walking over most tested load--speed conditions. On hardware, a single policy performs starting, sustained pulling, turning, and stopping with both rigid payloads and human passengers, handling a loaded rickshaw mass of up to 115~kg without load-specific retuning. These results demonstrate robust heavy-load transportation through coordinated and persistent humanoid--vehicle interaction.

0.21

Driving the Style: Velocity-Conditioned Whole-Body Control from Motion Demonstrations

cs.RO ·2026-11-16 ·Murad Dawood, Oezge Drama Berkenkamp, Antonio Gonzales Marin, Nutan Chen
similarity 0.72
Abstract

Achieving human-like behavior on humanoid robots has advanced rapidly by leveraging motion-capture demonstrations rather than hand-crafted cost functions. Adversarial imitation supplies a style signal that lets a policy fulfill a task while adhering to a desired style, but is difficult to transfer to hardware. Whole-body tracking through reinforcement learning instead deploys reliably and imitates demonstrations faithfully, but the resulting policies are conditioned on the future reference, so they require a reference trajectory at runtime and can fail when the motion differs from the training data. We train a humanoid policy directly with whole-body tracking rewards while restricting its actor to compact locomotion commands and robot observations. Reference motion supervises the reward and privileged critic, without supplying reference joint trajectories to the actor or requiring teacher distillation. The demonstrated style is thereby encoded in the policy through the tracking reward, so the robot reproduces the whole-body style under commanded velocities. Trained on a single random-walk motion and commanded with velocity profiles from held-out motions, our policy reaches at least 98\% success in simulation and completes every trial on the Unitree G1. On held-out slow walking, whole-body tracking drops to 2\% success and command-conditioned distillation to 56\%, and both fail on the real robot. On the trained motions, the joint position error of our policy stays within 8\% of whole-body tracking, and it has a higher style coverage than adversarial motion priors (AMP), which fell on the real robot without a safety crane.

0.20

Terrain-Indexed Motion Priors and Geometric Support for Extreme Humanoid Parkour

cs.RO ·2026-11-05 ·Chenghao Sun, Youhao Lyu, Zizheng Li, Shuting Zhang, Ziyang Dong +1 more
similarity 0.72
Abstract

We present a progressive imitation framework that learns terrain-appropriate humanoid parkour skills and subsequently adapts their hand--knee support. Human demonstrations provide traversal behaviors, but their contact patterns need not suit a robot's proportions or the available support surfaces. Our framework changes the role of demonstrations across three stages: privileged imitation produces physically executable robot references; terrain-indexed adversarial motion priors guide skill acquisition; and geometric support guidance with a reduced motion-prior weight enables contact adaptation. Candidate-based precontact attraction and actual-contact evaluation guide support without prescribing a contact sequence. The deployed policy selects behaviors from onboard depth, proprioception, and velocity commands without an external skill label. On the Noetix E1, the policy achieves 96.34\% hybrid success in simulation and transfers without real-world policy fine-tuning, completing 29 of 30 individual obstacle trials and four of five hybrid courses. Support-adaptation ablations show higher traversal success for the complete adaptation stage on the tested terrains, while qualitative observations show changes in contact placement. These results support acquiring skills from demonstrations before relaxing their influence to accommodate robot-specific support configurations.

0.11

STRIDE: Learning Humanoid Locomotion in Minutes with Acceleration-Based Rewards

cs.RO cs.LG ·2026-11-06 ·Nico Bohlinger, Jan Peters
similarity 0.71
Abstract

Learning locomotion directly on a humanoid robot is a promising direction to avoid the sim-to-real gap. However, locomotion rewards in Reinforcement Learning (RL) typically track the base velocity, which cannot be measured onboard without an external motion capture system or well-calibrated state estimator. This is why we introduce \method{}, which learns humanoid locomotion from minutes of samples with a reward that only requires the onboard Inertial Measurement Unit (IMU). Instead of tracking the base velocity, STRIDE rewards the robot for following a commanded acceleration profile. To learn efficiently from this reward, we use the off-policy RL algorithm XQC and combine a high gain setting for the joint position controllers with left-right symmetry augmentation. In simulation, STRIDE learns to walk on the Unitree G1 and Booster T1 humanoids within 14 minutes of samples. Compared to learning without these two components, it reduces the falls during training by 81%, while without them the robot learns only in over an hour.

0.11

ReCo: Response-Consistent Locomotion with Policy-Aware MPC for Legged Manipulation

cs.RO ·2026-10-01 ·Kuankuan Sima, Yichao Gao, Chenxi Gu, Kefan Zhao, Lin Zhao
benchmark similarity 0.71
Abstract

Continuous legged manipulation requires accurate end-effector tracking while the base keeps walking. Combining reinforcement learning (RL) with model predictive control (MPC) suits this task: the learned policy provides robust locomotion, while MPC coordinates the base and arm to compensate for tracking errors. However, MPC can compensate only for base motion that it can predict, and a learned policy's command response varies with gait phase, contact, and payload. We present ReCo, a framework that couples response-consistent locomotion with policy-aware MPC for legged manipulation. Response shaping trains the policy to respond to commands consistently and repeatably across randomized dynamics. An identified closed-loop response model then lets MPC jointly plan locomotion commands and arm motion. On the simulation benchmark, ReCo reduces position and orientation root-mean-square error (RMSE) by 28.7% and 27.4% relative to the best baseline for each metric. Real-world experiments demonstrate onboard continuous legged manipulation with coordinated base and arm motion.

0.17