CS Paper Radar

Channel Knowledge Maps for FR3 UAV Base Stations: Dataset and ML-based Modeling

Guillem Moreno~Garcia, Sergi Abadal, Evgenii Vinogradov

eess.SP ·submitted 2026-10-05 13:54 UTC · v1
published

Abstract

This paper introduces a dense upper mid-band Frequency Range (FR3) Channel Knowledge Map (CKM) dataset for Uncrewed Aerial Vehicles (UAVs) with an on-board base station (UxNB). It contains 16,180 CKM samples from 3,236 urban locations in 66 cities at 7.125 GHz and UxNB heights of up to 500 meters. Every 513x513 sample stores the building geometry, the line-of-sight (LOS) state, attenuation, delay spread, angular spread, and variable transmitter height. As a focused first use-case, we propose an interpretable height-aware attenuation model. Its LOS branch combines free-space loss, two-ray term, and compact data-based height/range calibration. Its non-LOS (NLOS) branch combines a COST 231-Hata basis with local environment-specific linear calibration. The proposed model reaches 1.93 dB overall root mean square error, with 1.74 dB in LOS and 3.54 dB in NLOS on over 500 unique locations in 14 unseen cities (2,590 samples in total). The result provides attenuation data for FR3 UxNB deployments and a physical anchor for future FR3 modeling efforts.

Comment
6 pages, accepted for IEEE Globecom'26 Workshops

Closest papers

Nearest neighbours by meaning across the whole index.

Joint Air Corridor and BS Coverage Planning for Large-Scale High-Density Low-Altitude Aerial Networks via Channel Knowledge Maps

eess.SP ·2026-11-10 ·Jiaxuan Li, Yilong Chen, Yuan Guo, Fan Liu, Jie Xu
similarity 0.63
Abstract

This paper studies the joint air corridor and base station (BS) coverage planning problem for high-density low-altitude aerial networks supported by terrestrial cellular infrastructures. In the considered system, unmanned aerial vehicles (UAVs) operate within a structured air corridor planned over a grid-based airspace, and each BS serves selected corridor grid cells by sharing its communication resources among all UAVs therein. Each BS's traffic load depends on both the number of covered corridor cells and the UAV density, thereby affecting the communication rate available to each UAV. We exploit the channel knowledge map (CKM) to characterize the channel gains between BSs and candidate airspace cells and evaluate desired signals and inter-cell interference for environment-aware offline planning. Based on CKM, we jointly optimize the corridor layout and BS coverage to minimize a weighted objective balancing corridor length and the supportable average UAV density along the entire corridor, subject to minimum communication rate requirements for all UAVs along the air corridor. The joint design is formulated as a mixed-integer linear program (MILP), which can be optimally solved using off-the-shelf solvers. For large maps, we develop a scalable suboptimal algorithm based on Lagrangian relaxation and A* search. Specifically, we incorporate BS resource constraints into A* corridor search via Lagrangian relaxation, and then jointly optimize BS coverage and UAV density along the generated corridors under the original rate constraints. Numerical results demonstrate the benefits of the proposed joint design in supporting high-density UAV operations and show that the proposed algorithm obtains high-quality solutions with substantially reduced computation time.

0.15

UrbanEMF: City-Scale EMF Mapping over a Continuous Urban Area with Real-World Base-Station Deployment

eess.SP ·2026-10-01 ·Shuangning Li, Chenxin Luo, Shanshan Wang, Yarui Zhang, Paul Lagouanelle +1 more
benchmarkdatasetcode/data similarity 0.61
Abstract

Electromagnetic Fields (EMF) mapping is essential for wireless propagation modeling and are fundamental to a wide range of applications, including spectrum awareness, network planning, and integrated sensing and communication (ISAC). However, existing datasets are often limited to spatially separated 2D scenes without real base station (BS) information. To address this gap, we present UrbanEMF, a city-scale EMF mapping dataset constructed from real world urban geometry and physical BS deployments using ray tracing. Unlike conventional single scene-based datasets, UrbanEMF preserves continuous city-scale urban coverage and realistic transmitter location information. It further extends traditional 2D maps by incorporating multiple receiver heights. In addition, both aggregated received signal strength (RSS) maps and path loss maps are provided to characterize complementary aspects of the radio environment. This work provides a realistic and flexible benchmark for developing and evaluating learning-based methods in large-scale urban wireless environments. The code for this work is available at: https://github.com/lemonstudy/UrbanEMF

0.32

Site-specific Channel Modeling Based on Remote-Sensing Maps for 6G Space--Air--Ground Digital Twins

eess.SP ·2026-08-31 ·Peijie Liu, Pan Tang, Jianhua Zhang, Lei Tian, Bin Ao +2 more
similarity 0.59
Abstract · 17 pages, 23 figures, 4 tables

Site-specific channel models are essential for wireless digital twins of 6G space--air--ground communication systems. However, 3D maps are difficult to obtain over wide areas, which limits large-area site-specific channel modeling. To address this issue, this paper proposes a remote-sensing-based augmented ray-tracing channel modeling framework. The framework comprises a deterministic RT branch, a measurement-statistical branch, and an RT augmentation branch. To overcome the difficulty of acquiring large-area 3D maps, the deterministic RT branch reconstructs a 3D RT scene from satellite remote-sensing imagery and calibrates its electromagnetic material parameters using measured path loss. To provide the statistical parameters required for RT augmentation, the measurement-statistical branch establishes the marginal distributions and interparameter dependence models of the channel parameters. Specifically, a wideband UAV channel measurement campaign is conducted at 4.60 GHz, and a proposed multipath estimation method estimates the complex amplitudes, delays, and Doppler shifts of the measured multipath. To bridge the gap between RT predictions and measurements, the RT augmentation branch organizes the RT multipath into LoS, LoS-tail, and NLoS components, generates additional short-delay LoS-tail paths, and reallocates the component and path powers according to the measurement-derived statistics while preserving the total RT received power. The validation results show that the proposed framework reduces the path loss RMSE from 5.45 to 4.35 dB and, relative to calibrated RT, decreases the RMS delay spread and normalized Doppler spread RMSEs by 53.03 and 26.48, respectively. The proposed framework provides a site-specific channel modeling approach for 6G space--air--ground digital-twin studies.

0.26

Beyond TR 38.811 for 6G NTN Channel Models

eess.SP ·2026-11-02 ·Kuan-Po Chiu, Aaron Jacob Buck, Sumit Roy
similarity 0.59
Abstract

As the 3rd Generation Partnership Project (3GPP) expands 6G non-terrestrial network (NTN) to S, Ku, and Ka bands for integration with existing terrestrial cellular networks, the necessary satellite channel model for link and network performance evaluation remains tied to TR 38.811, last revised in 2020. We identify issues on multiple fronts: inappropriate parameter specifications based on very limited site-specific environments considered, omission of satellite-induced Doppler spread and directional antenna effects and lack of a transparent channel model generation procedure. To address these limitations, we re-derive the channel parameters using ray tracing (RT) over urban and rural environments based on ITU-R building statistics. Our results show that TR 38.811 substantially overestimates the K-factor at low elevations and predicts a decreasing trend with elevation, which is inconsistent with RT. The Ka-band clutter loss (CL) also exceeds the RT estimates by more than 15 dB in urban cases. It also underestimates rural delay spread (DS) at low elevations and predicts an elevation trend inconsistent with RT. We further quantify the previously neglected satellite-induced Doppler spread. Finally, we demonstrate that the conventional TR 38.811 channel generator significantly underestimates the K-factor in the presence of directional antenna (beamforming), while our modified generator substantially reduces this discrepancy.

0.30

Enhancing 3GPP Urban Channel Models For Terrestrial-to-Non-Terrestrial Communication

eess.SP ·2026-08-28 ·Gerhard Schreiber, Chenrui Sun, Joerg Schaepperle, Le-Hang Nguyen, Thorsten Wild
code/data similarity 0.59
Abstract

We have developed enhanced models for large-scale channel parameters intended for terrestrial-to-non-terrestrial (NTN) communication in Urban environments for supporting devices above ground levels, such as drones. The models are formulated as functions of terminal height above ground and elevation angle, applicable to S-Band and Ka-Band frequencies. To ensure realistic models, an open-source 3D scene generator was utilized to create a diverse set of urban scenes across Europe. Sionna ray-tracing was employed to generate path-gain samples for outdoor terminals, covering a range of heights up to 300 meters and elevation angles up to 90°. Our proposed analytical functions show excellent agreement to ray-tracing data for line-of-sight (LOS) probability, shadow-fading (SF), and clutter-loss (CL). Furthermore, a comparative coupling gain analysis with existing 3GPP models reveals notable differences, particularly caused by smaller CL and higher LOS probabilities from proposed models. Designed for ease of use, these models can be seamlessly integrated into simulation tools, offering a practical solution for researchers and engineers.

0.35

Vehicle and UAV Detection and Tracking with LTE Downlink Reference Signals: A Ray-Traced Evaluation on a Mapped Suburban Site with Licensed Base-Station Records

cs.NI ·2026-11-01 ·Arun K. Gurung, Satha K. Sathananthan
similarity 0.58
Abstract · 18 pages, 7 figures, 14 tables. Revised version

Passive sensing on the cellular downlink places the receiver at the user equipment and changes nothing in the network. We report simulation results for an LTE band-3 cell-specific reference signal arm on a ray-traced channel. On a synthetic street canyon the arm is compared with an uplink sounding reference signal arm on the same band, target and scorer: missed-detection probabilities of 0.667 and 0.772. On a surveyed site built from OpenStreetMap footprints and the licensed site record, nine receiver positions along the street track the vehicle at coverage between 29.9 % and 61.7 %; a 283 m lap separates target height from trajectory at 1.6 to 30 m; a 137 m lap on the built-up street tracks a vehicle and a 15 m airborne target on every cell, and 8 receivers at 135 m spacing carry one illuminator's coverage over 1140 m of the street. Potential future work includes extending the analysis to multiple illuminators and varying receiver configurations, and confirmation through over-the-air measurements.

0.34

RadioTraj3D: Height-Aware Adaptive Sampling for 3D Radio-Map Reconstruction from Ultra-Sparse Trajectories

eess.SP ·2026-10-30 ·Zixuan Guo, Xiucheng Wang, Wenshuo Chen, Conghao Zhou, Chuan Huang +2 more
similarity 0.58
Abstract

Aerial networks require radio propagation information at unvisited positions and heights to plan routes, select links, and allocate wireless resources. A three-dimensional radio map (3D RM) represents propagation conditions over the service area, enabling these decisions before flight. However, constructing such a map from autonomous aerial vehicle (AAV) measurements is challenging, since radio measurements are available only along the trajectory, whereas the target covers the 3D service volume. Existing methods use fixed AAV trajectories that ignore how building distributions and heights affect electromagnetic propagation, missing the heights most informative for RM reconstruction. To address these issues, we propose RadioTraj3D, which uses building-height information to coordinate measurement selection and layer-wise reconstruction. Building-height variations reveal propagation-sensitive layers that guide height-adaptive sampling. We therefore propose G-METS to select geometry-sensitive heights and allocate an exact budget across edge, corridor, and open regions before channel acquisition. A dual-view reconstructor then integrates local three-dimensional boundaries with full-height context through one bounded coefficient per layer. Simulated outdoor and indoor maps demonstrate state-of-the-art reconstruction across environments and vertical grids. On real-world AAV measurements from the LACN dataset, RadioTraj3D improves peak signal-to-noise ratio by 0.84 dB and reduces normalized mean squared error by 17.5% over Completion AE.

0.32

AI-Enabled Wireless Propagation Modeling and Radio Environment Maps for 5G Aerial Wireless Networks

eess.SP ·2026-09-22 ·Gautham Reddy, Kürşat Tekbıyık, Bryton Petersen, Antoine Lesage-Landry, Gunes Karabulut Kurt +1 more
similarity 0.57
Abstract · Submitted for possible publication in IEEE JSTEAP

With the gaining prominence of aerial mobility applications, their success depends on the seamless integration of terrestrial and non-terrestrial network connectivity. However, providing reliable connectivity from terrestrial telecommunication networks remains challenging due to multi-cell interference from base stations (BSs) under line-of-sight (LoS) conditions to unmanned aerial vehicles (UAVs), coverage holes caused by antenna sidelobe degradation, localized multipath fading effects, and the high-speed dynamics of aerial users. To model such complexities, often exacerbated by sparse real-world data, this work proposes a dual-stage radio environment map (REM) framework. Our approach physically decouples the channel modeling, where a spatial Transformer first anchors the deterministic, large-scale path loss geometry, while a gated recurrent unit (GRU) subsequently extrapolates the stochastic, localized fast- fading deviations. By reformulating 3D spatial interpolation as a 1D radial sequence prediction task, the framework inherently aligns with the physics of propagation. We evaluate the proposed framework against state-of-the-art baselines, including 3D Kriging, UNet, Mamba, and Inception, using empirical 5G datasets. The results demonstrate improved intra-site generalization across diverse altitudes, user dynamics, and reference signal received power (RSRP) datasets, achieving signal-strength predictions with errors near 3 dB and REM spatial-similarity indices exceeding 0.75. Finally, we examine the influence of REMs and channel rank conditions on UAV channel quality, underscoring the necessity of reliable channel modeling for robust aerial connectivity.

0.23