CS Paper Radar

Vehicle and UAV Detection and Tracking with LTE Downlink Reference Signals: A Ray-Traced Evaluation on a Mapped Suburban Site with Licensed Base-Station Records

Arun K. Gurung, Satha K. Sathananthan

cs.NI ·submitted 2026-11-01 02:46 UTC · v1

Abstract

Passive sensing on the cellular downlink places the receiver at the user equipment and changes nothing in the network. We report simulation results for an LTE band-3 cell-specific reference signal arm on a ray-traced channel. On a synthetic street canyon the arm is compared with an uplink sounding reference signal arm on the same band, target and scorer: missed-detection probabilities of 0.667 and 0.772. On a surveyed site built from OpenStreetMap footprints and the licensed site record, nine receiver positions along the street track the vehicle at coverage between 29.9 % and 61.7 %; a 283 m lap separates target height from trajectory at 1.6 to 30 m; a 137 m lap on the built-up street tracks a vehicle and a 15 m airborne target on every cell, and 8 receivers at 135 m spacing carry one illuminator's coverage over 1140 m of the street. Potential future work includes extending the analysis to multiple illuminators and varying receiver configurations, and confirmation through over-the-air measurements.

Comment
18 pages, 7 figures, 14 tables. Revised version

Closest papers

Nearest neighbours by meaning across the whole index.

mmWave UE Positioning Under Blockage: Limits for ISAC-Assisted Handover

cs.NI eess.SP ·2026-10-30 ·Seyed Bagher Hashemi Natanzi, Bo Tang
similarity 0.67
Abstract

Proactive handover can save a millimeter-wave (mmWave) link before a passing body blocks it, but only if the network knows where the user is. We ask whether the radio units that serve a user can localize it accurately enough from its uplink sounding reference signals. We derive position error bounds that include synchronization and array calibration errors, with and without reflected paths known from a digital twin, and test two estimators in a ray-traced street canyon on held-out scenarios. Three findings stand out. First, with line of sight to both radio units, array calibration, not bandwidth, limits the bound. Second, blockage degrades the line-of-sight-only bound sharply, whereas known reflections keep the map-aided bound low. Third, a simple dominant-path estimator fails where it matters most: its errors grow sharply around blockage, and proactive handover becomes worse than the 3GPP baseline. A map-aided multipath tracker cuts the median error from 12 to 3.7 cm and removes this significant penalty at link margins of 15 dB and above, but does not yet beat the baseline.

0.35

Wireless Networks That See: Integrated Sensing and Communication in Complex Environments

cs.NI ·2026-11-01 ·Xingqin Lin
similarity 0.66
Abstract · 7 pages, 6 figures

The same radio interactions that complicate wireless communication can reveal what is happening around a network. Integrated sensing and communication (ISAC) turns these interactions into opportunities to observe unmanned aerial vehicles (UAVs), road vehicles, and industrial mobile robots. Yet a strong echo is not necessarily a reliable object observation: stationary background can conceal motion, reflections can create virtual objects, and one viewpoint can leave part of an object's motion unobserved. This tutorial explains how known cellular signals are used to estimate propagation, suppress stationary background, interpret reflected paths, and combine observations from different sites. UAV examples under a Third Generation Partnership Project (3GPP) stochastic channel model and ray tracing in a San Francisco urban scene illustrate the mechanisms through spatial layouts, channel profiles, and before/after range--Doppler maps. Local checks reduce false outputs, with some loss of detection. Cooperation improves position accuracy for UAVs detected by both a single site and cooperating sites. The examples show how signal resources, measurement reporting, and application needs shape sensing performance, providing practical guidance for sensing services in complex environments.

0.54

Multi-UAV Tracking Evaluation Using 5G Uplink Signals on an O-RAN ISAC Simulation Testbed

cs.NI eess.SP ·2026-08-11 ·Arun K. Gurung, Satha K. Sathananthan
similarity 0.63
Abstract · 25 pages, 3 figures, 12 tables

We evaluate multi-target detection, association and tracking end to end on an O-RAN simulation testbed built from OpenAirInterface, FlexRIC and Sionna RT that repurposes the 5G NR uplink sounding reference signal as a passive radar waveform, and against what a counter-UAS command-and- control (C2) consumer requires rather than by detection alone. Three UAVs differing in altitude, velocity and radar cross section (-8 to -20 dBsm) fly one bistatic pair with an 8-element planar receive array. Once every target is detected the binding limit is contention, not sensitivity - two targets share one nearest detection in about 74% of coherent processing intervals, and targets are detected far more often than they are tracked. Elevation from that array cannot separate targets sharing a range-Doppler cell, but it decides association in 58% of intervals. Concurrent tracks are exported from the RAN Intelligent Controller (RIC) xApp to a C2 fusion node over a SAPIENT interface carrying a calibrated detection confidence, validated at schema level against a mock fusion node. The evaluation is emulation-only on one geometry with 10 noise seeds, the mechanisms are characterized and analyzed to identify the key factors influencing multi-target tracking performance.

0.42

Beyond RSRP Coverage: UAV Serviceability in Interference-Limited Urban 5G NR Networks

eess.SY ·2026-09-18 ·Md Sharif Hossen, Vijay K. Shah, Ismail Guvenc
similarity 0.62
Abstract · 6 pages, 4 figures

Reference signal received power (RSRP) is commonly used to assess 5G cellular coverage, but it may substantially overestimate the connectivity available to cellular-connected unmanned aerial vehicles (UAVs) under strong inter-cell interference (ICI). As a UAV ascends, reduced blockage can strengthen the serving signal, while increased line-of-sight visibility to neighboring sectors can intensify ICI. This paper develops a trajectory-aware, 3GPP-based system-level framework for evaluating UAV radio serviceability during a three-dimensional flight in an urban 5G New Radio network. The framework jointly evaluates RSRP, reference signal received quality (RSRQ), and signal-to-interference-plus-noise ratio (SINR) in a 19-site, 57-sector deployment. We introduce the concept of coverage-serviceability gap to quantify the difference between RSRP availability and joint service availability. Under RSRP, RSRQ, and SINR thresholds of -100 dBm, -18 dB, and 0 dB, respectively, an inter-site distance (ISD) of 500 m provides 99.9% RSRP availability but only 13.6% joint service availability, yielding a coverage-serviceability gap of 86.3 percentage points. With RSRQ and SINR thresholds of -22 dB and -6 dB, respectively, joint availability increases to 55.0% and 63.1% for ISDs of 500 m and 1000 m, respectively. These results demonstrate that RSRP-based coverage substantially overestimates joint UAV serviceability under both evaluation configurations, with SINR remaining the limiting metric.

0.45

Integrated Sensing and Communication in 3GPP: Standardization, Performance Evaluation, and Experimental Validation Toward 6G

eess.SP ·2026-10-16 ·Gosan Noh, Gebremeskel Seiley Abraha, Joshua Yabana, Nathaniel Foli, Michael Ankomah Asare +8 more
similarity 0.62
Abstract

Integrated sensing and communication (ISAC) is evolving from a primarily physical-layer research into a standardized cellular-network capability spanning channel modeling, radio procedures, network architecture, and the delivery of sensing services. We review this progression within the Third Generation Partnership Project (3GPP), from Release 19 service requirements and target-aware channel modeling to the Release 20 New Radio (NR) sensing evaluation framework, radio access network procedures, and system architecture, and discuss future directions toward 6G. We then present two 3GPP-aligned simulation case studies to demonstrate the corresponding evaluation approaches. The first case study compares hard-decision, soft-decision, and hybrid fusion for unmanned aerial vehicle (UAV) sensing using multiple transmission and reception points (TRPs). Detection, false alarms, and conditional position and velocity accuracy are evaluated using receiver-derived angle estimates and separately calibrated method-specific thresholds. The second case study compares ideal and practical sensing-assisted predictive handover with conventional handover, while accounting for sensing error and information age. We further present a testbed-based measurement study that characterizes monostatic and bistatic UAV radar cross sections across frequencies, platforms, and observation angles and provides empirical support for correlated target-response modeling. Finally, we discuss open challenges and future research directions in multi-node fusion, resource and interference management, network evolution, security, privacy, and reproducible evaluation. Together, these components connect calibrated channel models, link- and system-level simulation, real-time prototypes, controlled measurements, and field trials through a staged evaluation roadmap.

0.23

From Radio Measurements to Sensing Services: A 3GPP Perspective on Multi-UAV Tracking with Networked ISAC

cs.NI ·2026-11-07 ·Xingqin Lin
similarity 0.62
Abstract · 7 pages, 6 figures

Integrated sensing and communication (ISAC) can turn radio measurements into networked sensing services, but accurate position estimates alone do not ensure useful tracking. Missed targets, late acquisition, track interruptions and aging observations also shape the information available to an application. This article examines tracking of noncooperative unmanned aerial vehicles (UAVs) from a Third Generation Partnership Project (3GPP) perspective. It connects sensing-service requirements and network architecture to three information interfaces: receiver search regions, measurement context and track validity. A five-UAV case study in a 3GPP urban scenario and a ray-traced San Francisco scene illustrates the tradeoff between target coverage and extra outputs, the distinction between acquisition and ongoing continuity, and the value of testing a static mission envelope before adding adaptation. An observation-age example explains how a state predicted to the present can still rely on old evidence. The resulting lessons are to align receiver search with requested coverage, preserve measurement time and uncertainty, and assess coverage, ambiguity and timeliness together. We conclude by pointing out fruitful avenues for further work in sensing design, calibration and service validation.

0.21

TiamiTwin: A Digital Twin for Bistatic ISAC Drone Sensing, Validated Against Measurements

eess.SP cs.NI ·2026-09-19 ·Mehdi Zafari, Saeede Enayati, A. Lee Swindlehurst, Amitav Mukherjee
similarity 0.62
Abstract · Accepted for presentation at the IEEE MILCOM 2026 Workshop on Integrated Sensing and Communication for Critical Infrastructure Protection (I…

Monitoring lower airspace over critical infrastructure using cellular signals of opportunity is highly practical because transmitters are pre-deployed, licensed, and continuously active. Digital twins can evaluate the feasibility of such integrated sensing and communication (ISAC) architectures, but their predictive accuracy must be validated against real-world data. This paper reports validation results for TiamiTwin, a digital twin developed for bistatic ISAC drone sensing, using empirical measurements from an operational 5G deployment featuring a commercial band n41 gNB and a receiver separated by 572.8 m over a non-line-of-sight (NLOS) channel. TiamiTwin incorporates three parallel channel representations evaluated on a 240-subcarrier grid: the 3GPP TR 38.901 (Release 19) bistatic ISAC model, a ray-traced site model, and the captured field measurements. Empirical results demonstrate that both statistical and ray-tracing models under-predict the measured root-mean-square (RMS) delay spread by approximately a factor of three. Furthermore, target reflections sit 68 dB below static clutter in power, making target detection entirely dependent on Doppler separation to isolate the drone from zero-Doppler background returns. Despite this severe clutter environment, the target remains separable along 88% of the flight path in the delay, Doppler, or joint delay-Doppler domains.

0.19

Enhancing 3GPP Urban Channel Models For Terrestrial-to-Non-Terrestrial Communication

eess.SP ·2026-08-28 ·Gerhard Schreiber, Chenrui Sun, Joerg Schaepperle, Le-Hang Nguyen, Thorsten Wild
code/data similarity 0.61
Abstract

We have developed enhanced models for large-scale channel parameters intended for terrestrial-to-non-terrestrial (NTN) communication in Urban environments for supporting devices above ground levels, such as drones. The models are formulated as functions of terminal height above ground and elevation angle, applicable to S-Band and Ka-Band frequencies. To ensure realistic models, an open-source 3D scene generator was utilized to create a diverse set of urban scenes across Europe. Sionna ray-tracing was employed to generate path-gain samples for outdoor terminals, covering a range of heights up to 300 meters and elevation angles up to 90°. Our proposed analytical functions show excellent agreement to ray-tracing data for line-of-sight (LOS) probability, shadow-fading (SF), and clutter-loss (CL). Furthermore, a comparative coupling gain analysis with existing 3GPP models reveals notable differences, particularly caused by smaller CL and higher LOS probabilities from proposed models. Designed for ease of use, these models can be seamlessly integrated into simulation tools, offering a practical solution for researchers and engineers.

0.35