CS Paper Radar

Multi-UAV Tracking Evaluation Using 5G Uplink Signals on an O-RAN ISAC Simulation Testbed

Arun K. Gurung, Satha K. Sathananthan

cs.NI eess.SP ·submitted 2026-08-11 10:43 UTC · v1

Abstract

We evaluate multi-target detection, association and tracking end to end on an O-RAN simulation testbed built from OpenAirInterface, FlexRIC and Sionna RT that repurposes the 5G NR uplink sounding reference signal as a passive radar waveform, and against what a counter-UAS command-and- control (C2) consumer requires rather than by detection alone. Three UAVs differing in altitude, velocity and radar cross section (-8 to -20 dBsm) fly one bistatic pair with an 8-element planar receive array. Once every target is detected the binding limit is contention, not sensitivity - two targets share one nearest detection in about 74% of coherent processing intervals, and targets are detected far more often than they are tracked. Elevation from that array cannot separate targets sharing a range-Doppler cell, but it decides association in 58% of intervals. Concurrent tracks are exported from the RAN Intelligent Controller (RIC) xApp to a C2 fusion node over a SAPIENT interface carrying a calibrated detection confidence, validated at schema level against a mock fusion node. The evaluation is emulation-only on one geometry with 10 noise seeds, the mechanisms are characterized and analyzed to identify the key factors influencing multi-target tracking performance.

Comment
25 pages, 3 figures, 12 tables

Closest papers

Nearest neighbours by meaning across the whole index.

6G ISAC Drone Detection: Signal Processing and Experimental Validation at FR1

eess.SP ·2026-11-03 ·Enrique T. R. Pinto, Marcus Henninger, Lucas Giroto, Markku Juntti, Silvio Mandelli
similarity 0.65
Abstract

Integrated sensing and communications (ISAC) enables mobile networks to detect passive targets such as drones at minimal additional cost. However, in ISAC, a small drone must be detected against strong ground clutter with the limited radio resources left by communications. In this paper, we propose two ISAC target detectors: a coherent detector, which combines all frames and beam dwells of a revisit, and a non-coherent detector, robust to inter-frame clock phase drift. The algorithms leverage per-dwell clutter whitening and the adaptive coherence estimator (ACE) detection statistic to improve performance. Both detectors estimate the range, radial velocity, and azimuth of targets in real time on a laptop graphics processing unit (GPU). Measurements with an FR1 ISAC proof-of-concept system based on a commercial base station show that the coherent detector outperforms the non-coherent one and recovers the full track.

0.32

Controller-Only False Confirmation in Passive RF UAV Link Detection

cs.CR ·2026-09-21 ·Rajendra Upadhyay, Rajendra Paudyal, Al Nahian Bin Emran, Duminda Wijesekera
similarity 0.64
Abstract

Passive radio frequency (RF) sensing is widely used for counter-unmanned-aerial-vehicle (counter-UAV) detection. Existing studies commonly report high accuracy against background RF or WiFi/Bluetooth interference, but rarely isolate controller-only operation without a linked aircraft. We present a dual-band software-defined radio (SDR) measurement study with ambient, controller-only, and linked states for three commercial UAV platforms (DJI Phantom 3 4K, Hubsan H501S, DJI Mavic Mini). Two USRP B210 receivers simultaneously scan eight 2.4 GHz and twelve 5.8 GHz observation windows across twenty rounds. We first train an energy-based detector using linked and ambient scans only. At four ranked concurrent dwell steps (8 s), it achieves 0.992 linked-versus-ambient balanced accuracy but false-confirms 30 out of 60 controller-only scans (FCRctrl = 0.500). We then include controller-only scans in training and use confirm, reject, and defer outputs under an explicit controller-only false-confirmation-rate (FCR) constraint. For the pooled all-platform analysis, the constraint reduces observed FCRctrl from 0.350 to 0.050, while confirm-linked TPR decreases from 0.900 to 0.400 and 42.1% of scans are deferred. The corresponding compact scan performs substantially better for Hubsan and Mavic than for Phantom. A hardware-in-loop experiment reduces measured wall-clock time from 82.9 s to 28.9 s. These measurements show that linked-versus-background accuracy does not measure controller-only false confirmation and that this error should be reported separately.

0.24

Vehicle and UAV Detection and Tracking with LTE Downlink Reference Signals: A Ray-Traced Evaluation on a Mapped Suburban Site with Licensed Base-Station Records

cs.NI ·2026-11-01 ·Arun K. Gurung, Satha K. Sathananthan
similarity 0.63
Abstract · 18 pages, 7 figures, 14 tables. Revised version

Passive sensing on the cellular downlink places the receiver at the user equipment and changes nothing in the network. We report simulation results for an LTE band-3 cell-specific reference signal arm on a ray-traced channel. On a synthetic street canyon the arm is compared with an uplink sounding reference signal arm on the same band, target and scorer: missed-detection probabilities of 0.667 and 0.772. On a surveyed site built from OpenStreetMap footprints and the licensed site record, nine receiver positions along the street track the vehicle at coverage between 29.9 % and 61.7 %; a 283 m lap separates target height from trajectory at 1.6 to 30 m; a 137 m lap on the built-up street tracks a vehicle and a 15 m airborne target on every cell, and 8 receivers at 135 m spacing carry one illuminator's coverage over 1140 m of the street. Potential future work includes extending the analysis to multiple illuminators and varying receiver configurations, and confirmation through over-the-air measurements.

0.34

Bistatic UAV-Based 3D SAR Imaging Using Integrated Sensing and Communications Transceivers

eess.SP ·2026-11-09 ·Akanksha Sneh, Krishna Ayyagari, Vivaswan Nawani, Shobha Sundar Ram
similarity 0.63
Abstract

Integrated sensing and communication (ISAC) frameworks enable autonomous systems to jointly perform radar sensing and wireless communication using common spectral and hardware resources. Prior art on ISAC-enabled UAV for SAR focused on monostatic configurations for two-dimensional target imaging. In this work, we propose a bistatic UAV tomographic SAR framework in which the IEEE~802.11ad waveform, RF hardware, and spectral resources are jointly utilized for communication and radar sensing for three-dimensional (3D) localization of complex targets. Specifically, we demonstrate how communication packets transmitted from a master ISAC transceiver UAV to a passive receiver UAV are exploited for timing and frequency synchronization, motion compensation, and 3D localization of targets, without requiring auxiliary infrastructure on the passive receiver for these tasks. We evaluate the proposed framework for localizing automotive targets over elevated terrain, with Monte Carlo simulations modeling synchronization and platform motion errors. The results demonstrate improved localization accuracy compared with conventional InSAR-based localization. The interplay between radar and communication performances are further evaluated using diverse modulation schemes.

0.11

Early UAV Detection Using 5G NR LEO Downlinks for Passive ISAC

cs.NI eess.SP ·2026-11-16 ·Mohamed Hamad, Nizar Zorba, Tamer Khattab, Hamid Saeedi, Halim Yanikomeroglu
similarity 0.62
Abstract

5G New Radio (NR) low-Earth-orbit (LEO) downlinks enable passive integrated sensing and communication (ISAC) for unmanned aerial vehicle (UAV) detection. Weak echoes require motion-compensated accumulation, but exhaustive searches postpone alerts. We propose a receiver that combines selective Doppler-rate search, early UAV alerts and continued delay-Doppler estimation. Classical, statistical and neural configurations select rates of Doppler change to search, while a shared correlation score determines detection. Simulated echo delay, Doppler and power follow the moving satellite-UAV-receiver geometry, propagation loss, assumed scattering and antenna response. In a line-of-sight scene with acquired beams and UAVs at 5-8 km horizontal distance, all three configurations match exhaustive search at 92.9% correct final detections, with 0.10-0.13% observed false alerts on no-UAV recordings. The neural configuration reduces mean time to the first correct alert by 36.5% versus exhaustive search and 21.9% versus the closest literature baseline, averaging over successfully detected UAVs. These results demonstrate earlier UAV alerts while preserving exhaustive search's final detection accuracy, supporting passive sensing over cellular satellites.

0.23

Emulation of Closely Spaced Spatial Sensing Targets Using a Parabolic Cylindrical Compact Range with a Multi-Feed Amplitude-Phase Controlled Linear Array

eess.SP ·2026-09-14 ·Zhangzhang Jiang, Guokai Jiang, Le Yu, Chunhui Li, Zhengpeng Wang +1 more
similarity 0.61
Abstract · 14 pages, 11 figures

Integrated sensing and communication (ISAC) base stations (BSs) are emerging as critical infrastructure for 6G networks, requiring advanced over-the-air (OTA) testing methodologies that can emulate dynamic, multi-target scenarios under far field (FF) conditions. However, existing testing solutions often suffer from limited angular flexibility, insufficient bandwidth, and prohibitive costs. {To address these challenges, this paper proposes an OTA testing system that integrates a radar target simulator (RTS), a multi-port amplitude and phase modulation (APM) network, and a multi-feed linear array with a single parabolic cylindrical compact range (SPCCR).} The proposed system is capable of emulating closely spaced spatial targets with varying incident azimuth angles. This setup meets the essential conditions for ISAC BS testing, including FF characteristics, wideband and multi-band compatibility, and the capability for sensing multiple dynamic closed-spaced targets. The feasibility of the proposed method is validated through both FEKO simulation and measurement. Experimental results demonstrate that the system successfully emulates multiple closely spaced targets within an azimuth range of $\pm 10^\circ$ with high emulation accuracy while maintaining excellent quiet zone (QZ) performance.

0.25

Federated Calibration of Motion Uncertainty for UAV Tracking in Multi-Operator ISAC Systems

cs.IT eess.SPeess.SY ·2026-09-30 ·Qiming Li, Lei Zhang, Muhammad Ali Imran, Lina Mohjazi
similarity 0.61
Abstract · 13 pages, 6 figures

In integrated sensing and communication (ISAC) systems involving multiple operators, unmanned aerial vehicle (UAV) tracking can benefit from sensing at multiple base stations, while raw sensing records, channel information, and transmit decisions remain local to each operator. The resulting problem is to obtain a reliable UAV prediction from different track estimates and use it to guide transmission without centralizing their data or control variables. To resolve this, we propose a two-timescale framework comprising slow-timescale motion-uncertainty calibration and online track fusion with predictive beamforming. Local radar innovations calibrate the uncertainty assigned by each tracker to unmodeled UAV motion, with only the resulting parameters shared across operators. During online tracking, covariance intersection (CI) combines local estimates without requiring knowledge of correlations between their estimation errors. The fused prediction then guides each operator's transmission design subject to communication QoS, power, and tracking constraints. We further establish exact rank one recovery for the communication covariances and finite interval bounds on local tracking uncertainty. Simulations show improved consistency of tracking uncertainty under substantial motion model mismatch. CI avoids overconfidence under correlated errors, while using the current fused prediction reduces RMSE by about 31% relative to transmission designed for communication alone, with less than 2% additional power. Ablation further shows that the power difference between current and outdated predictions is driven mainly by predictive covariance rather than predictive mean.

0.35

Practical Hardware-Efficient ISAC: Enabling Multi-Target Sensing With Few RF Chains

eess.SP ·2026-10-12 ·Zhenkun Zhang, Cunhua Pan, Hong Ren, Jun Tang, Dongming Wang +1 more
theory similarity 0.61
Abstract

Hybrid analog--digital arrays reduce hardware cost in integrated sensing and communications (ISAC), but spatial compression and beam-dependent scan responses complicate multi-target estimation with few radio-frequency (RF) chains. To address these challenges, this paper proposes a burst beam-scanning multiple-input multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) framework that reuses downlink reference signals for joint range, radial-velocity, elevation, and azimuth estimation. Specifically, a structured global--local dual-tensor estimator separates targets by using scanning observations and refines their parameters from selected-beam RF-chain responses, with delay--Doppler signatures maintaining cross-stage target correspondence. The recovered subarray responses yield closed-form elevation and azimuth estimates through exact sum--difference relations, avoiding small-angle approximations and fine angular grid searches. To further improve Doppler accuracy, spatial-mask-aided weighted least squares exploits the longer inter-burst temporal aperture while resolving phase ambiguity using intra-burst estimates. The joint multi-target Cramér--Rao lower bound (CRLB) and corresponding three-dimensional (3D) positioning bound are also derived to characterize estimation performance. Simulation results show that the proposed scheme achieves near-CRLB estimation accuracy at high transmit powers and centimeter- to millimeter-level 3D positioning with only four RF chains, while maintaining low computational cost.

0.12