CS Paper Radar

6G ISAC Drone Detection: Signal Processing and Experimental Validation at FR1

Enrique T. R. Pinto, Marcus Henninger, Lucas Giroto, Markku Juntti, Silvio Mandelli

eess.SP ·submitted 2026-11-03 15:18 UTC · v1

Abstract

Integrated sensing and communications (ISAC) enables mobile networks to detect passive targets such as drones at minimal additional cost. However, in ISAC, a small drone must be detected against strong ground clutter with the limited radio resources left by communications. In this paper, we propose two ISAC target detectors: a coherent detector, which combines all frames and beam dwells of a revisit, and a non-coherent detector, robust to inter-frame clock phase drift. The algorithms leverage per-dwell clutter whitening and the adaptive coherence estimator (ACE) detection statistic to improve performance. Both detectors estimate the range, radial velocity, and azimuth of targets in real time on a laptop graphics processing unit (GPU). Measurements with an FR1 ISAC proof-of-concept system based on a commercial base station show that the coherent detector outperforms the non-coherent one and recovers the full track.

Closest papers

Nearest neighbours by meaning across the whole index.

Reliable Doppler Estimation in Asynchronous Moving ISAC Devices via IMU Integration

eess.SP ·2026-09-30 ·Zaman Bhalli, Jacopo Pegoraro, Gianmaria Ventura, Paolo Casari, Michele Rossi
similarity 0.65
Abstract · 6 pages, 5 figures. Submitted to IEEE VTC2027-Spring

We present an Integrated Sensing And Communication (ISAC) framework for the joint estimation of the Doppler frequency of a passive mobile target in a bistatic scenario with clock-asynchronous nodes and where the Receiver (RX) is static but the Transmitter (TX) is mobile. In such a setup, previous geometric solutions are integrated with an Inertial Measurement Unit (IMU) device at the TX, coming up with a truly joint data fusion and estimation algorithm based on extended Kalman filtering. The approach jointly estimates the target Doppler frequency, along with the speed and direction of motion of the TX and it is robust to the unavailability of static paths between the TX and RX pair, a condition that makes previous solutions ineffective. The developed extended Kalman filter strikes a balance between the accuracy of ISAC and the IMU reliability. The proposed solution is validated via numerical simulations, obtaining a median Doppler error of 1.2% with a smartphone-grade IMU under realistic operating conditions.

0.36

Multi-UAV Tracking Evaluation Using 5G Uplink Signals on an O-RAN ISAC Simulation Testbed

cs.NI eess.SP ·2026-08-11 ·Arun K. Gurung, Satha K. Sathananthan
similarity 0.65
Abstract · 25 pages, 3 figures, 12 tables

We evaluate multi-target detection, association and tracking end to end on an O-RAN simulation testbed built from OpenAirInterface, FlexRIC and Sionna RT that repurposes the 5G NR uplink sounding reference signal as a passive radar waveform, and against what a counter-UAS command-and- control (C2) consumer requires rather than by detection alone. Three UAVs differing in altitude, velocity and radar cross section (-8 to -20 dBsm) fly one bistatic pair with an 8-element planar receive array. Once every target is detected the binding limit is contention, not sensitivity - two targets share one nearest detection in about 74% of coherent processing intervals, and targets are detected far more often than they are tracked. Elevation from that array cannot separate targets sharing a range-Doppler cell, but it decides association in 58% of intervals. Concurrent tracks are exported from the RAN Intelligent Controller (RIC) xApp to a C2 fusion node over a SAPIENT interface carrying a calibrated detection confidence, validated at schema level against a mock fusion node. The evaluation is emulation-only on one geometry with 10 noise seeds, the mechanisms are characterized and analyzed to identify the key factors influencing multi-target tracking performance.

0.42

TiamiTwin: A Digital Twin for Bistatic ISAC Drone Sensing, Validated Against Measurements

eess.SP cs.NI ·2026-09-19 ·Mehdi Zafari, Saeede Enayati, A. Lee Swindlehurst, Amitav Mukherjee
similarity 0.63
Abstract · Accepted for presentation at the IEEE MILCOM 2026 Workshop on Integrated Sensing and Communication for Critical Infrastructure Protection (I…

Monitoring lower airspace over critical infrastructure using cellular signals of opportunity is highly practical because transmitters are pre-deployed, licensed, and continuously active. Digital twins can evaluate the feasibility of such integrated sensing and communication (ISAC) architectures, but their predictive accuracy must be validated against real-world data. This paper reports validation results for TiamiTwin, a digital twin developed for bistatic ISAC drone sensing, using empirical measurements from an operational 5G deployment featuring a commercial band n41 gNB and a receiver separated by 572.8 m over a non-line-of-sight (NLOS) channel. TiamiTwin incorporates three parallel channel representations evaluated on a 240-subcarrier grid: the 3GPP TR 38.901 (Release 19) bistatic ISAC model, a ray-traced site model, and the captured field measurements. Empirical results demonstrate that both statistical and ray-tracing models under-predict the measured root-mean-square (RMS) delay spread by approximately a factor of three. Furthermore, target reflections sit 68 dB below static clutter in power, making target detection entirely dependent on Doppler separation to isolate the drone from zero-Doppler background returns. Despite this severe clutter environment, the target remains separable along 88% of the flight path in the delay, Doppler, or joint delay-Doppler domains.

0.19

Bistatic UAV-Based 3D SAR Imaging Using Integrated Sensing and Communications Transceivers

eess.SP ·2026-11-09 ·Akanksha Sneh, Krishna Ayyagari, Vivaswan Nawani, Shobha Sundar Ram
similarity 0.62
Abstract

Integrated sensing and communication (ISAC) frameworks enable autonomous systems to jointly perform radar sensing and wireless communication using common spectral and hardware resources. Prior art on ISAC-enabled UAV for SAR focused on monostatic configurations for two-dimensional target imaging. In this work, we propose a bistatic UAV tomographic SAR framework in which the IEEE~802.11ad waveform, RF hardware, and spectral resources are jointly utilized for communication and radar sensing for three-dimensional (3D) localization of complex targets. Specifically, we demonstrate how communication packets transmitted from a master ISAC transceiver UAV to a passive receiver UAV are exploited for timing and frequency synchronization, motion compensation, and 3D localization of targets, without requiring auxiliary infrastructure on the passive receiver for these tasks. We evaluate the proposed framework for localizing automotive targets over elevated terrain, with Monte Carlo simulations modeling synchronization and platform motion errors. The results demonstrate improved localization accuracy compared with conventional InSAR-based localization. The interplay between radar and communication performances are further evaluated using diverse modulation schemes.

0.14

Vision--RF Cooperative ISAC for Dynamic V2I Networks: Adaptive Beam Management and Semantic Clutter Suppression

eess.SP ·2026-10-19 ·Wenqi~Fan, Ning~Wei, Xiangyu Dong, Ahmad~Bazzi, Guan Gui +3 more
similarity 0.61
Abstract

We develop a vision--radio-frequency (RF) cooperative integrated sensing and communication (ISAC) framework that jointly uses visual priors and RF observations for transmit-side beam control and receiver-side clutter suppression. Within a narrowband snapshot model, visual target priors and historical RF detections guide control in dynamic vehicle-to-infrastructure networks with roadside clutter. In this framework, posterior angular uncertainty determines beam control and the selection between communication-for-sensing and sensing-for-sensing modes. To reduce sensing overhead while accommodating unreliable visual information, we develop a reliability-adaptive beam scanning scheme that allocates a bounded scan budget according to visual target probabilities and RF history, while reserving an adaptive fraction for exploration. At the receiver, visual geometry identifies clutter support, and RF observations estimate the corresponding complex reflection coefficients. Motion-aware residual filtering is then applied before angle--Doppler detection to suppress clutter while preserving slow-moving targets. Furthermore, communication and sensing power allocation is formulated as a per-direction linear program, subject to signal-to-interference-plus-noise ratio constraints evaluated at angles sampled from the posterior distribution and a total-power budget. Simulation results show that the proposed framework improves tracking over static and vision-only beam control and reduces sensing overhead relative to full scanning. The proposed scanning scheme also provides greater robustness to visual blockage than fixed-weight scanning, while the receiver better preserves slow-moving targets than temporal cancellation when visual target information is available.

0.22

Improper Signaling for Clutter-Limited Angle Estimation in ISAC

eess.SP ·2026-11-04 ·Victor Augusto Del Monego, Poliana Basso, Murilo Capponi, Bruno S. Chang, Yahia Medjahdi +2 more
hot direction similarity 0.61
Abstract · 6 pages, 4 figures, submitted to the IEEE International Conference on Communications (ICC), 2027

Integrated sensing and communication (ISAC) transmit designs typically optimize the transmit covariance under proper signaling, leaving the potential sensing benefits of pseudo-covariance unexplored. This paper investigates the conditions under which transmit pseudo-covariance can influence the angle Cramer-Rao bound (CRB) of a deterministic target in the presence of clutter. For a prescribed transmit covariance and a single clutter patch, we establish that CRB sensitivity occurs if and only if the clutter is illuminated, exhibits nonzero non-circularity, and overlaps the angle-informative component of the target response. This characterization demonstrates that angular separation alone does not determine whether transmit impropriety can improve sensing performance. We derive a closed-form optimal incident-field pseudo-variance that minimizes the angle CRB over the set of feasible transmit pseudo-covariances. Under fully non-circular clutter scattering, the optimal design eliminates the clutter-induced CRB penalty. Numerical results for a 32-antenna ISAC system show CRB reductions of up to 99% relative to proper sensing under complete overlap and 30% under partial overlap, as well as up to approximately 7 dB lower clutter-induced CRB penalty across target-clutter separations. These findings identify transmit pseudo-covariance as a conditional sensing design resource whose effectiveness depends on clutter statistics and projected target-clutter geometry.

0.30

Wireless Networks That See: Integrated Sensing and Communication in Complex Environments

cs.NI ·2026-11-01 ·Xingqin Lin
similarity 0.60
Abstract · 7 pages, 6 figures

The same radio interactions that complicate wireless communication can reveal what is happening around a network. Integrated sensing and communication (ISAC) turns these interactions into opportunities to observe unmanned aerial vehicles (UAVs), road vehicles, and industrial mobile robots. Yet a strong echo is not necessarily a reliable object observation: stationary background can conceal motion, reflections can create virtual objects, and one viewpoint can leave part of an object's motion unobserved. This tutorial explains how known cellular signals are used to estimate propagation, suppress stationary background, interpret reflected paths, and combine observations from different sites. UAV examples under a Third Generation Partnership Project (3GPP) stochastic channel model and ray tracing in a San Francisco urban scene illustrate the mechanisms through spatial layouts, channel profiles, and before/after range--Doppler maps. Local checks reduce false outputs, with some loss of detection. Cooperation improves position accuracy for UAVs detected by both a single site and cooperating sites. The examples show how signal resources, measurement reporting, and application needs shape sensing performance, providing practical guidance for sensing services in complex environments.

0.54

Fourth-Order Co-Channel Interference-Aware OFDM-ISAC Sensing in Cluttered Environments

eess.SP ·2026-09-12 ·Tri Nhu Do, Yosefine Triwidyastuti, Gunes Karabulut Kurt
similarity 0.60
Abstract

In this paper, we develop a sensing-centric receiver for monostatic orthogonal frequency-division multiplexing integrated sensing and communication (OFDM-ISAC) in the simultaneous presence of passive clutter and a non-cooperative co-channel OFDM transmitter. We show that removing the known ISAC symbols maps target and clutter echoes to deterministic delay-Doppler components, while the non-cooperative waveform remains a random, non-Gaussian, generically full-rank residual. Guided by this distinction, we combine moving-target indication for zero-Doppler clutter with a centered diagonal fourth-order statistic for interference identification. To obtain an unbiased fourth-order estimate from phase-aligned proper snapshots, we derive additive and multiplicative finite-sample bias corrections and pair the corrected statistic with a second-order moment to separate interference from Gaussian noise. Fourth order provides identification and presence testing, whereas second order provides the diagonal disturbance-power proxy used for weighting. We further introduce diagonally loaded weights that enforce a range-Doppler aperture-efficiency floor. Simulations show that the interference estimate approaches its theoretical profile as coherent support grows and remains insensitive to deterministic echoes, that the presence test resolves interference well below the level at which weighting matters, and that loaded processing improves target detection while controlling point-spread-function degradation.

0.08